Acquisition of chemiluminescent signals from immunoblots with a digital single-lens reflex camera.
Ontology highlight
ABSTRACT:
SUBMITTER: Khoury MK
PROVIDER: S-EPMC2808431 | biostudies-literature | 2010 Feb
REPOSITORIES: biostudies-literature
Publications
Acquisition of chemiluminescent signals from immunoblots with a digital single-lens reflex camera.
Khoury Mitri K MK Parker Ian I Aswad Dana W DW
Analytical biochemistry 20090927 1
We found that certain mid-range consumer-level digital single-lens reflex (SLR) cameras using full-frame complementary metal oxide semiconductor (CMOS) sensors outperform X-ray film in acquiring signals from immunoblots that use enhanced chemiluminescence for detection. These cameras exhibit a sensitivity comparable to X-ray film, yet they provide a 3-fold increase in linear dynamic range and substantial cost savings over time, are more convenient to use, and eliminate the chemical waste associa ...[more]
Similar Datasets
Project description:From genomics to transcriptomics to proteomics, microfluidic tools underpin recent advances in single-cell biology. Detection of specific proteoforms-with single-cell resolution-presents challenges in detection specificity and sensitivity. Miniaturization of protein immunoblots to single-cell resolution mitigates these challenges. For example, in microfluidic western blotting, protein targets are separated by electrophoresis and subsequently detected using fluorescently labeled antibody probes. To quantify the expression level of each protein target, the fluorescent protein bands are fit to Gaussians; yet, this method is difficult to use with noisy, low-abundance, or low-SNR protein bands, and with significant band skew or dispersion. In this study, we investigate segmentation-based approaches to robustly quantify protein bands from single-cell protein immunoblots. As compared to a Gaussian fitting pipeline, the segmentation pipeline detects >1.5× more protein bands for downstream quantification as well as more of the low-abundance protein bands (i.e., with SNR ∼3). Utilizing deep learning-based segmentation approaches increases the recovery of low-SNR protein bands by an additional 50%. However, we find that segmentation-based approaches are less robust at quantifying poorly resolved protein bands (separation resolution, Rs < 0.6). With burgeoning needs for more single-cell protein analysis tools, we see microfluidic separations as benefitting substantially from segmentation-based analysis approaches.
| S-EPMC8526408 | biostudies-literature
Project description:Conjunctival examination for trachomatous inflammation-follicular (TF) guides public health decisions for trachoma. Smartphone cameras may allow remote conjunctival grading, but previous studies have found low sensitivity. A random sample of 412 children aged 1-9 years received an in-person conjunctival examination and then had conjunctival photographs taken with 1) a single-lens reflex (SLR) camera and 2) a smartphone coupled to a 3D-printed magnifying attachment. Three masked graders assessed the conjunctival photographs for TF. Latent class analysis was used to determine the sensitivity and specificity of each grading method for TF. Single-lens reflex photo-grading was 95.0% sensitive and 93.6% specific, and smartphone photo-grading was 84.1% sensitive and 97.6% specific. The sensitivity of the smartphone-CellScope device was considerably higher than that of a previous study using the native smartphone camera, without attachment. Magnification of smartphone images with a simple attachment improved the grading sensitivity while maintaining high specificity in a region with hyperendemic trachoma.
| S-EPMC7695070 | biostudies-literature
Project description:With the development of artificial intelligence, neural network provides unique opportunities for holography, such as high fidelity and dynamic calculation. How to obtain real 3D scene and generate high fidelity hologram in real time is an urgent problem. Here, we propose a liquid lens based holographic camera for real 3D scene hologram acquisition using an end-to-end physical model-driven network (EEPMD-Net). As the core component of the liquid camera, the first 10 mm large aperture electrowetting-based liquid lens is proposed by using specially fabricated solution. The design of the liquid camera ensures that the multi-layers of the real 3D scene can be obtained quickly and with great imaging performance. The EEPMD-Net takes the information of real 3D scene as the input, and uses two new structures of encoder and decoder networks to realize low-noise phase generation. By comparing the intensity information between the reconstructed image after depth fusion and the target scene, the composite loss function is constructed for phase optimization, and the high-fidelity training of hologram with true depth of the 3D scene is realized for the first time. The holographic camera achieves the high-fidelity and fast generation of the hologram of the real 3D scene, and the reconstructed experiment proves that the holographic image has the advantage of low noise. The proposed holographic camera is unique and can be used in 3D display, measurement, encryption and other fields.
| S-EPMC10904790 | biostudies-literature
Project description:For many analytic and biomedical applications, the presence of an analyte above or below a critical concentration is more informative for decision making than the actual concentration value. Straightforward analog-to-digital signal conversion does not take full advantage of the precision and dynamic range of modern sensors. Here, we present and experimentally demonstrate an analog-to-multiple-digital signal conversion, reporting digital signals that indicate whether the concentrations of specific DNA sequences exceed respective threshold values. These threshold values can be individually programmed for each target sequence. Experimentally, we showed representation of four DNA targets' information in a single fluorescence channel.
| S-EPMC7293012 | biostudies-literature
Project description:PurposeWe described the system for grading lens opacities using stereoscopic digital fundus reflex photographs in the Age-Related Eye Disease Study 2 (AREDS2) and compared reproducibility with the AREDS lens grading system, which used retroillumination film images.MethodsStereoscopic fundus reflex photographs were acquired in a standardized fashion at baseline and annually. Images were enhanced and evaluated in the red channel at a central reading center. Percentage involvement of cortical and posterior subcapsular (PSC) lens opacities within the central 5 mm diameter zone of a modified AREDS lens grid was estimated. Reproducibility was assessed for contemporaneous variability (ongoing, monthly regrade on 5% of submissions, n = 777 eyes) and temporal drift (regrading a subset of baseline photographs annually, n = 88).ResultsIn the contemporaneous exercise, the agreement for presence of cortical opacities was 93% (κ = 0.86) and for PSC opacities it was 97% (κ = 0.83). Intraclass correlation (ICC) for area of central zone involvement was 0.95 for cortical and 0.99 for PSC opacities. Historic data for contemporaneous regrading of film-based images in AREDS showed an ICC of 0.94 for cortical and 0.82 for PSC. The final annual temporal drift exercise had a reproducibility of 95% for cortical and PSC opacities.ConclusionsDigital grading using fundus reflex images with image enhancing tools has reproducibility comparable to film-based retroillumination images, and may be useful for centralized objective lens opacity assessment in clinical trials using widely available fundus cameras. Red reflex images limit evaluation to cortical and PSC opacities, and do not permit assessment of nuclear opacities. (ClinicalTrials.gov number, NCT00345176.).
| S-EPMC3771555 | biostudies-literature
Project description:A visible-light digital camera is used for taking ordinary photos, but with new operational procedures it can measure the photon energy in the X-ray wavelength region and therefore see chemical elements. This report describes how one can observe X-rays by means of such an ordinary camera - The front cover of the camera is replaced by an opaque X-ray window to block visible light and to allow X-rays to pass; the camera takes many snap shots (called single-photon-counting mode) to record every photon event individually; an integrated-filtering method is newly proposed to correctly retrieve the energy of photons from raw camera images. Finally, the retrieved X-ray energy-dispersive spectra show fine energy resolution and great accuracy in energy calibration, and therefore the visible-light digital camera can be applied to routine X-ray fluorescence measurement to analyze the element composition in unknown samples. In addition, the visible-light digital camera is promising in that it could serve as a position sensitive X-ray energy detector. It may become able to measure the element map or chemical diffusion in a multi-element system if it is fabricated with external X-ray optic devices. Owing to the camera's low expense and fine pixel size, the present method will be widely applied to the analysis of chemical elements as well as imaging.
| S-EPMC5374443 | biostudies-literature
Project description:The fish-eye lens camera offers the advantage of efficient acquisition of image data through a wide field of view. However, unlike the popular perspective projection camera, a strong distortion effect appears as the periphery of the image is compressed. Such characteristics must be precisely analyzed through camera self-calibration. In this study, we carried out a fish-eye lens camera self-calibration while considering different types of test objects and projection models. Self-calibration was performed using the V-, A-, Plane-, and Room-type test objects. In the fish-eye lens camera, the V-type test object was the most advantageous for ensuring the accuracy of the principal point coordinates and focal length, because the correlations between parameters were relatively low. On the other hand, the other test objects were advantageous for ensuring the accuracy of distortion parameters because of the well-distributed image points. Based on the above analysis, we proposed, an accurate fish-eye lens camera self-calibration method that applies the V-type test object. The RMS-residuals of the proposed method were less than 1 pixel.
| S-EPMC6427217 | biostudies-other
Project description:Increased demand for compact devices leads to rapid development of miniaturized digital cameras. However, conventional camera modules contain multiple lenses along the optical axis to compensate for optical aberrations that introduce technical challenges in reducing the total thickness of the camera module. Here, we report an ultrathin digital camera inspired by the vision principle of Xenos peckii, an endoparasite of paper wasps. The male Xenos peckii has an unusual visual system that exhibits distinct benefits for high resolution and high sensitivity, unlike the compound eyes found in most insects and some crustaceans. The biologically inspired camera features a sandwiched configuration of concave microprisms, microlenses, and pinhole arrays on a flat image sensor. The camera shows a field-of-view (FOV) of 68 degrees with a diameter of 3.4?mm and a total track length of 1.4?mm. The biologically inspired camera offers a new opportunity for developing ultrathin cameras in medical, industrial, and military fields.
| S-EPMC6199290 | biostudies-other
Project description:Digital single-molecule technologies are expanding diagnostic capabilities, enabling the ultrasensitive quantification of targets, such as viral load in HIV and hepatitis C infections, by directly counting single molecules. Replacing fluorescent readout with a robust visual readout that can be captured by any unmodified cell phone camera will facilitate the global distribution of diagnostic tests, including in limited-resource settings where the need is greatest. This paper describes a methodology for developing a visual readout system for digital single-molecule amplification of RNA and DNA by (i) selecting colorimetric amplification-indicator dyes that are compatible with the spectral sensitivity of standard mobile phones, and (ii) identifying an optimal ratiometric image-process for a selected dye to achieve a readout that is robust to lighting conditions and camera hardware and provides unambiguous quantitative results, even for colorblind users. We also include an analysis of the limitations of this methodology, and provide a microfluidic approach that can be applied to expand dynamic range and improve reaction performance, allowing ultrasensitive, quantitative measurements at volumes as low as 5 nL. We validate this methodology using SlipChip-based digital single-molecule isothermal amplification with λDNA as a model and hepatitis C viral RNA as a clinically relevant target. The innovative combination of isothermal amplification chemistry in the presence of a judiciously chosen indicator dye and ratiometric image processing with SlipChip technology allowed the sequence-specific visual readout of single nucleic acid molecules in nanoliter volumes with an unmodified cell phone camera. When paired with devices that integrate sample preparation and nucleic acid amplification, this hardware-agnostic approach will increase the affordability and the distribution of quantitative diagnostic and environmental tests.
| S-EPMC4819493 | biostudies-literature
Project description:Since the introduction of digital electrocardiographs, high-pass filters have been necessary for successful analog-to-digital conversion with a reasonable amplitude resolution. On the other hand, such high-pass filters may distort the diagnostically significant ST-segment of the ECG, which can result in a misleading diagnosis. We present an inverting filter that successfully undoes the effects of a 0.05 Hz single pole high-pass filter. The inverting filter has been tested on more than 1600 clinical ECGs with one-minute durations and produces a negligible mean RMS-error of 3.1*10(-8) LSB. Alternative, less strong inverting filters have also been tested, as have different applications of the filters with respect to rounding of the signals after filtering. A design scheme for the alternative inverting filters has been suggested, based on the maximum strength of the filter. With the use of the suggested filters, it is possible to recover the original DC-coupled ECGs from AC-coupled ECGs, at least when a 0.05 Hz first order digital single pole high-pass filter is used for the AC-coupling.
| S-EPMC4777536 | biostudies-other