Dataset Information

Determining source strength of semivolatile organic compounds using measured concentrations in indoor dust.

ABSTRACT: Consumer products and building materials emit a number of semivolatile organic compounds (SVOCs) in the indoor environment. Because indoor SVOCs accumulate in dust, we explore the use of dust to determine source strength and report here on analysis of dust samples collected in 30 US homes for six phthalates, four personal care product ingredients, and five flame retardants. We then use a fugacity-based indoor mass balance model to estimate the whole-house emission rates of SVOCs that would account for the measured dust concentrations. Di-2-ethylhexyl phthalate (DEHP) and di-iso-nonyl phthalate (DiNP) were the most abundant compounds in these dust samples. On the other hand, the estimated emission rate of diethyl phthalate is the largest among phthalates, although its dust concentration is over two orders of magnitude smaller than DEHP and DiNP. The magnitude of the estimated emission rate that corresponds to the measured dust concentration is found to be inversely correlated with the vapor pressure of the compound, indicating that dust concentrations alone cannot be used to determine which compounds have the greatest emission rates. The combined dust-assay modeling approach shows promise for estimating indoor emission rates for SVOCs.The combined dust-assay modeling approach in this study can be used to predict the source strength of indoor released compounds, integrating emissions from consumer products, building materials, and other home furnishings. Our findings show that estimated emission rates are closely related to not only the level of compounds on dust, but also the vapor pressure of the compound. Thus, a fugacity-based indoor mass balance model and measured dust concentrations can be used to estimate the whole-house emission rates from all sources in actual indoor settings, when individual sources of emissions are unknown.

SUBMITTER: Shin HM

PROVIDER: S-EPMC4018806 | biostudies-literature | 2014 Jun

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Determining source strength of semivolatile organic compounds using measured concentrations in indoor dust.

Shin H-M HM McKone T E TE Nishioka M G MG Fallin M D MD Croen L A LA Hertz-Picciotto I I Newschaffer C J CJ Bennett D H DH

Indoor air 20131031 3

<h4>Unlabelled</h4>Consumer products and building materials emit a number of semivolatile organic compounds (SVOCs) in the indoor environment. Because indoor SVOCs accumulate in dust, we explore the use of dust to determine source strength and report here on analysis of dust samples collected in 30 US homes for six phthalates, four personal care product ingredients, and five flame retardants. We then use a fugacity-based indoor mass balance model to estimate the whole-house emission rates of SVO ...[more]

PMID: 24118221

Similar Datasets

Project description:Volatile and semivolatile organic compounds in ambient air and occupational settings are of great concern due to their associated adverse human health and environmental impacts. Novel graphene wool samplers have been developed and tested to overcome limitations of commercially available sorbents that can only be used once and typically require solvent extraction. Graphene wool (GW) was synthesized by non-catalytic chemical vapor deposition with optimized conditions, resulting in a novel fibrous graphene wool that is very easy to manage and less rigid than other forms of graphene, lending itself to a wide range of potential applications. Here, the air pollutant sampling capabilities of the GW were of interest. The optimal packing weight of GW inside a glass tube (length 178 mm, i.d. 4 mm, o.d. 6 mm) was investigated by the adsorption of vaporized alkane standards on the GW, using a condensation aerosol generator in a temperature-controlled chamber and subsequent detection using a flame ionization detector. The optimized GW packing density was found to be 0.19 mg mm-3 at a flow rate of 500 mL min-1, which provided a gas collection efficiency of >90% for octane, decane, and hexadecane. The humidity uptake of the sampler is less than 1% (m/m) for ambient humidities <70%. Breakthrough studies showed the favorable adsorption of polar molecules, which is attributed to the defective nature of the graphene and the inhomogeneous coating of the graphene layers on the quartz wool, suggesting that the polar versus non-polar uptake potential of the GW can be tuned by varying the graphene layering on the quartz wool substrate during synthesis. Oxidized domains at the irregular edges of the graphene layers, due to a broken, non-pristine sp2 carbon network, allow for adsorption of polar molecules. The GW was applied and used in a combustion sampling campaign where the samplers proved to be comparable to frequently used polydimethylsiloxane sorbents in terms of sampling and thermal desorption of non-polar semivolatile organic compounds. The total alkane concentrations detected after thermal desorption of GW and PDMS samplers were found to be 17.96 ± 13.27 and 18.30 ± 16.42 μg m-3, respectively; thus, the difference in the alkane sampling concentration between the two sorbent systems was negligible. GW provides a new, exciting possibility for the monitoring of organic air pollutants with numerous advantages, including high sampling efficiencies, simple and cost-effective synthesis of the thermally stable GW, solvent-free and environmentally friendly analysis, and, importantly, the reusability of samplers.

Project description:Mounting evidence from field and laboratory observations coupled with atmospheric model analyses shows that primary combustion emissions of organic compounds dynamically partition between the vapor and particulate phases, especially as near-source emissions dilute and cool to ambient conditions. The most recent version of the Community Multiscale Air Quality model version 5.2 (CMAQv5.2) accounts for the semivolatile partitioning and gas-phase aging of these primary organic aerosol (POA) compounds consistent with experimentally derived parameterizations. We also include a new surrogate species, potential secondary organic aerosol from combustion emissions (pcSOA), which provides a representation of the secondary organic aerosol (SOA) from anthropogenic combustion sources that could be missing from current chemical transport model predictions. The reasons for this missing mass likely include the following: (1) unspeciated semivolatile and intermediate volatility organic compound (SVOC and IVOC, respectively) emissions missing from current inventories, (2) multigenerational aging of organic vapor products from known SOA precursors (e.g., toluene, alkanes), (3) underestimation of SOA yields due to vapor wall losses in smog chamber experiments, and (4) reversible organic compounds-water interactions and/or aqueous-phase processing of known organic vapor emissions. CMAQ predicts the spatially averaged contribution of pcSOA to OA surface concentrations in the continental United States to be 38.6 and 23.6 % in the 2011 winter and summer, respectively. Whereas many past modeling studies focused on a particular measurement campaign, season, location, or model configuration, we endeavor to evaluate the model and important uncertain parameters with a comprehensive set of United States-based model runs using multiple horizontal scales (4 and 12 km), gas-phase chemical mechanisms, and seasons and years. The model with representation of semivolatile POA improves predictions of hourly OA observations over the traditional nonvolatile model at sites during field campaigns in southern California (CalNex, May-June 2010), northern California (CARES, June 2010), the southeast US (SOAS, June 2013; SEARCH, January and July, 2011). Model improvements manifest better correlations (e.g., the correlation coefficient at Pasadena at night increases from 0.38 to 0.62) and reductions in underprediction during the photochemically active afternoon period (e.g., bias at Pasadena from -5.62 to -2.42 μg m-3). Daily averaged predictions of observations at routine-monitoring networks from simulations over the continental US (CONUS) in 2011 show modest improvement during winter, with mean biases reducing from 1.14 to 0.73μg m-3, but less change in the summer when the decreases from POA evaporation were similar to the magnitude of added SOA mass. Because the model-performance improvement realized by including the relatively simple pcSOA approach is similar to that of more-complicated parameterizations of OA formation and aging, we recommend caution when applying these more-complicated approaches as they currently rely on numerous uncertain parameters. The pcSOA parameters optimized for performance at the southern and northern California sites lead to higher OA formation than is observed in the CONUS evaluation. This may be due to any of the following: variations in real pcSOA in different regions or time periods, too-high concentrations of other OA sources in the model that are important over the larger domain, or other model issues such as loss processes. This discrepancy is likely regionally and temporally dependent and driven by interferences from factors like varying emissions and chemical regimes.

Dataset Information

Determining source strength of semivolatile organic compounds using measured concentrations in indoor dust.

Publications

Determining source strength of semivolatile organic compounds using measured concentrations in indoor dust.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets