Browse
Submit Data
Databases
API
Help

Dataset Information

20 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Liquid crystal display screens as a source for indoor volatile organic compounds.

ABSTRACT: Liquid crystal displays (LCDs) have profoundly shaped the lifestyle of humans. However, despite extensive use, their impacts on indoor air quality are unknown. Here, we perform flow cell experiments on three different LCDs, including a new computer monitor, a used laptop, and a new television, to investigate whether their screens can emit air constituents. We found that more than 30 volatile organic compounds (VOCs) were emitted from LCD screens, with a total screen area-normalized emission rate of up to (8.25 ± 0.90) × 10⁹ molecules ⋅ s^-1 ⋅ cm^-2 In addition to VOCs, 10 liquid crystal monomers (LCMs), a commercial chemical widely used in LCDs, were also observed to be released from those LCD screens. The structural identification of VOCs is based on a "building block" hypothesis (i.e., the screen-emitted VOCs originate from the "building block chemicals" used in the manufacturing of liquid crystals), which are the key components of LCD screens. The identification of LCMs is based upon the detailed information of 362 currently produced LCMs. The emission rates of VOCs and LCMs increased by up to a factor of 9, with an increase of indoor air humidity from 23 to 58% due to water-organic interactions likely facilitating the diffusion rates of organics. These findings indicate that LCD screens are a potentially important source for indoor VOCs that has not been considered previously.

SUBMITTER: Liu Q

PROVIDER: S-EPMC8201953 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Quantitative volatile organic compound sensing with liquid crystal core fibers.

Project description:Polymer fibers with liquid crystals (LCs) in the core have potential as autonomous sensors of airborne volatile organic compounds (VOCs), with a high surface-to-volume ratio enabling fast and sensitive response and an attractive non-woven textile form factor. We demonstrate their ability to continuously and quantitatively measure the concentration of toluene, cyclohexane, and isopropanol as representative VOCs, via the impact of each VOC on the LC birefringence. The response is fully reversible and repeatable over several cycles, the response time can be as low as seconds, and high sensitivity is achieved when the operating temperature is near the LC-isotropic transition temperature. We propose that a broad operating temperature range can be realized by combining fibers with different LC mixtures, yielding autonomous VOC sensors suitable for integration in apparel or in furniture that can compete with existing consumer-grade electronic VOC sensors in terms of sensitivity and response speed.

| S-EPMC8724680 | biostudies-literature

Source-Specific Volatile Organic Compounds and Emergency Hospital Admissions for Cardiorespiratory Diseases.

Project description:Knowledge gaps remain regarding the cardiorespiratory impacts of ambient volatile organic compounds (VOCs) for the general population. This study identified contributing sources to ambient VOCs and estimated the short-term effects of VOC apportioned sources on daily emergency hospital admissions for cardiorespiratory diseases in Hong Kong from 2011 to 2014. We estimated VOC source contributions using fourteen organic chemicals by positive matrix factorization. Then, we examined the associations between the short-term exposure to VOC apportioned sources and emergency hospital admissions for cause-specific cardiorespiratory diseases using generalized additive models with polynomial distributed lag models while controlling for meteorological and co-pollutant confounders. We identified six VOC sources: gasoline emissions, liquefied petroleum gas (LPG) usage, aged VOCs, architectural paints, household products, and biogenic emissions. We found that increased emergency hospital admissions for chronic obstructive pulmonary disease were positively linked to ambient VOCs from gasoline emissions (excess risk (ER%): 2.1%; 95% CI: 0.9% to 3.4%), architectural paints (ER%: 1.5%; 95% CI: 0.2% to 2.9%), and household products (ER%: 1.5%; 95% CI: 0.2% to 2.8%), but negatively associated with biogenic VOCs (ER%: -6.6%; 95% CI: -10.4% to -2.5%). Increased congestive heart failure admissions were positively related to VOCs from architectural paints and household products in cold seasons. This study suggested that source-specific VOCs might trigger the exacerbation of cardiorespiratory diseases.

| S-EPMC7503811 | biostudies-literature

Determining source strength of semivolatile organic compounds using measured concentrations in indoor dust.

Project description:Consumer products and building materials emit a number of semivolatile organic compounds (SVOCs) in the indoor environment. Because indoor SVOCs accumulate in dust, we explore the use of dust to determine source strength and report here on analysis of dust samples collected in 30 US homes for six phthalates, four personal care product ingredients, and five flame retardants. We then use a fugacity-based indoor mass balance model to estimate the whole-house emission rates of SVOCs that would account for the measured dust concentrations. Di-2-ethylhexyl phthalate (DEHP) and di-iso-nonyl phthalate (DiNP) were the most abundant compounds in these dust samples. On the other hand, the estimated emission rate of diethyl phthalate is the largest among phthalates, although its dust concentration is over two orders of magnitude smaller than DEHP and DiNP. The magnitude of the estimated emission rate that corresponds to the measured dust concentration is found to be inversely correlated with the vapor pressure of the compound, indicating that dust concentrations alone cannot be used to determine which compounds have the greatest emission rates. The combined dust-assay modeling approach shows promise for estimating indoor emission rates for SVOCs.The combined dust-assay modeling approach in this study can be used to predict the source strength of indoor released compounds, integrating emissions from consumer products, building materials, and other home furnishings. Our findings show that estimated emission rates are closely related to not only the level of compounds on dust, but also the vapor pressure of the compound. Thus, a fugacity-based indoor mass balance model and measured dust concentrations can be used to estimate the whole-house emission rates from all sources in actual indoor settings, when individual sources of emissions are unknown.

| S-EPMC4018806 | biostudies-literature

Analytical procedure for the determination of very volatile organic compounds (C3-C6) in indoor air.

Project description:The substance group of very volatile organic compounds (VVOCs) is moving into the focus of indoor air analysis, facing ongoing regulations at international and European levels targeting on indoor air quality and human health. However, there exists at present no validated analysis for the identification and quantification of VVOCs in indoor air. Therefore, the present study targeted on the development of an analytical method in order to sample the maximum possible quantity of VVOCs in indoor air on solid sorbents with subsequent analysis by thermal desorption and coupled gas chromatography/mass spectrometry (TDS-GC/MS). For this purpose, it was necessary to investigate the performance of available sorbents and to optimize the parameters of GC/MS analysis. Stainless steel tubes filled with Carbograph 5TD were applied successfully for low-volume sampling (2-4 l) with minimal breakthrough (<?1%). With the developed method, VVOCs between C3 and C6 of different volatility and polarity can be detected even in trace quantities with low limits of quantitation (LOQ; 1-3 ?g m-3). Limitations occur for low molecular weight compounds ?C3, especially for polar substances, such as carboxylic acids and for some aldehydes and alcohols. Consequently, established methods for the quantification of these compounds in indoor air cannot be fully substituted yet. At least three different analytical techniques are needed to cover the large spectrum of relevant VVOCs in indoor air. In addition, unexpected reaction products might occur and need to be taken into account to avoid misinterpretation of chromatographic signals. Graphical abstract Solid sorbent sampling of VVOCs (C3-C6) in indoor air with subsequent TDS-GC/MS analysis.

| S-EPMC5910464 | biostudies-literature

Volatile Organic Compounds in Anatomical Pathology Wards: Comparative and Qualitative Assessment of Indoor Airborne Pollution.

Project description:The impact of volatile organic compounds (VOCs) on indoor air quality and on human health is widely recognized. However, VOC contamination in hospital indoor air is rarely studied and chemical compounds that singularly do not show high toxicity are not submitted to any regulation. This study aimed to compare VOC contamination in two different anatomical pathology wards in the same hospital. Hydrocarbons, alcohols, and terpenes were sampled by passive diffusive samplers. Analytical tests were performed by thermal desorption coupled with gas chromatography and mass spectrometry detector. Results highlighted a different VOC pollution in the two wards, due to the structural difference of the buildings and different organizational systems. The scarcity of similar data in the literature shows that the presence of VOCs in pathology wards is an underestimated problem. We believe that, because of the adverse effects that VOCs may have on the human health, this topic is worth exploring further.

| S-EPMC5486295 | biostudies-literature

Microlayer source of oxygenated volatile organic compounds in the summertime marine Arctic boundary layer.

Project description:Summertime Arctic shipboard observations of oxygenated volatile organic compounds (OVOCs) such as organic acids, key precursors of climatically active secondary organic aerosol (SOA), are consistent with a novel source of OVOCs to the marine boundary layer via chemistry at the sea surface microlayer. Although this source has been studied in a laboratory setting, organic acid emissions from the sea surface microlayer have not previously been observed in ambient marine environments. Correlations between measurements of OVOCs, including high levels of formic acid, in the atmosphere (measured by an online high-resolution time-of-flight mass spectrometer) and dissolved organic matter in the ocean point to a marine source for the measured OVOCs. That this source is photomediated is indicated by correlations between the diurnal cycles of the OVOC measurements and solar radiation. In contrast, the OVOCs do not correlate with levels of isoprene, monoterpenes, or dimethyl sulfide. Results from box model calculations are consistent with heterogeneous chemistry as the source of the measured OVOCs. As sea ice retreats and dissolved organic carbon inputs to the Arctic increase, the impact of this source on the summer Arctic atmosphere is likely to increase. Globally, this source should be assessed in other marine environments to quantify its impact on OVOC and SOA burdens in the atmosphere, and ultimately on climate.

| S-EPMC5474767 | biostudies-literature

Arabidopsis thaliana seedlings: Control vs Erwinia amylovora nicrobial Volatile Organic Compounds

Project description:Arabidopsis seedling were exposed in co-culture to E. amylovora mVOC and data show that mVOCs promote plant growth and early responses

2023-04-04 | GSE223760 | GEO

Indoor levels of volatile organic compounds and formaldehyde from emission sources at elderly care centers in Korea.

Project description:The objective of this study is to characterize indoor and outdoor levels of volatile organic compounds (VOCs) and formaldehyde (HCHO) and identify indoor emission sources in thirty elderly care centers (ECCs) located in the Seoul metropolitan city and Gyeonggi province in Korea. Air monitoring samples from indoor and outdoor environments were collected from January to December in 2007. Statistical analyses of indoor and outdoor VOCs and HCHO levels in three rooms (a bedroom, living, and dining rooms) of each ECC were performed, and these were compared to identify environmental factors associated with an increase of indoor pollution levels. Total volatile organic compounds (TVOC) levels were significantly (p<0.05) different between indoor (230.7±1.7 ?g/m3) and outdoor (137.8±1.9 ?g/m3) environments, with an I/O ratio of 1.67. The indoor HCHO level (20.1±1.6 ?g/m3) was significantly (p<0.05) higher than the outdoor level (8.1±1.9 ?g/m3), with an I/O ratio of 2.48. Indoor VOCs and HCHO levels in the bedrooms were significantly (p<0.05) higher than those in the living and dining rooms. Furthermore, indoor levels of VOCs and HCHO at ECCs were significantly (p<0.05) different depending on environmental factors such as the use of carpet, paint, and wooden furniture. In multiple regression analysis, indoor VOCs and HCHO levels at ECCs were significantly (p<0.05) correlated with two micro-environmental factors: the use of carpet and paint. This study confirmed that indoor VOCs and HCHO levels were significantly higher than those in outdoor environments. These air pollutants were mainly emitted from indoor sources, such as carpet, paint, and construction materials at the ECCs in Korea.

| S-EPMC5991643 | biostudies-literature

Volatile Organic Compounds (VOCs) Profile in Colorectal Cancer Patients and Healthy Controls.

Project description:Volatile organic compounds (VOCs) are low molecular weight (<1 kDa) compounds which represent the final products of cell metabolism. Their composition can be affected by several factors including diet, hormones, environment and the presence of diseases, in particular, cancer. Colorectal cancer (CRC) is one of the commonest tumours and is an important cause of cancer-related mortality. The expression of VOCs in breath that are linked to a patient’s disease state could offers a powerful, non-invasive approach to identifying CRC patients.

| 2326074 | ecrin-mdr-crc

Class specific discrimination of volatile organic compounds using a quartz crystal microbalance based multisensor array.

Project description:The use of quartz crystal microbalance (QCM) sensor arrays for analyses of volatile organic compounds (VOC) has attracted significant interest in recent years. In this regard, a group of uniformed materials based on organic salts (GUMBOS) has proven to be promising recognition elements in QCM based sensor arrays due to diverse properties afforded by this class of tunable materials. Herein, we examine the application of four novel phthalocyanine based GUMBOS as recognition elements for VOC sensing using a QCM based multisensor array (MSA). These synthesized GUMBOS are composed of copper (II) phthalocyaninetetrasulfonate (CuPcS4) anions coupled with ammonium or phosphonium cations respectively (tetrabutylammonium (TBA), tetrabutylphosphonium (P4444), 3-(dodecyldimethyl-ammonio)propanesulfonate (DDMA), and tributyl-n-octylphosphonium (P4448)). These materials were characterized using ESI-MS and FTIR, while thermal properties were investigated using TGA. Vapor sensing properties of these GUMBOS towards a set of common VOCs at three sample flow rate ratios were examined. Upon exposure to VOCs, each sensor generated analyte specific response patterns that were recorded and analyzed using principal component and discriminant analyses. Use of this MSA allowed discrimination of analytes into different functional group classes (alcohols, chlorohydrocarbons, aromatic hydrocarbons, and hydrocarbons) with 98.6% accuracy. Evaluation of these results provides further insight into the use of phthalocyanine GUMBOS as recognition elements for QCM-based MSAs for VOC discrimination.

| S-EPMC6070349 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data