Browse
Submit Data
Databases
API
Help

Dataset Information

20 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Gas Sensing with Bare and Graphene-covered Optical Nano-Antenna Structures.

ABSTRACT: The motivation behind this work is to study the gas phase chemical sensing characteristics of optical (plasmonic) nano-antennas (ONA) and graphene/graphene oxide-covered versions of these structures. ONA are devices that have their resonating frequency in the visible range. The basic principle governing the detection mechanism for ONA is refractive index sensing. The change in the concentration of the analyte results in a differing amount of adsorbate and correlated shifts in the resonance wavelength of the device. In this work, bare and graphene or graphene oxide covered ONA have been evaluated for gas sensing performance. Four different analytes (ethanol, acetone, nitrogen dioxide and toluene) were used in testing. ONA response behavior to different analytes was modified by adsorption within the graphene and graphene oxide overlayers. This work is a preliminary study to understand resonance wavelength shift caused by different analytes. Results imply that the combination of well-structured ONA functionalized by graphene-based adsorbers can give sensitive and selective sensors but baseline drift effects identified in this work must be addressed for applied measurements.

SUBMITTER: Mehta B

PROVIDER: S-EPMC4756381 | biostudies-literature | 2016 Feb

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Vapour sensing properties of graphene-covered gold nanoparticles.

Project description:We investigated the vapour sensing properties of different graphene-gold hybrid nanostructures. We observed the shifts in the optical spectra near the local surface plasmon resonance of the gold nanoparticles by changing the concentration and nature of the analytes (ethanol, 2-propanol, and toluene). The smaller, dome-like gold nanoparticles proved to be more sensitive to these vapours compared to slightly larger, flat nanoparticles. We investigated how the optical response of the gold nanoparticles can be tuned with a corrugated graphene overlayer. We showed that the presence of graphene increased the sensitivity to ethanol and 2-propanol, while it decreased it towards toluene exposure (at concentrations ≥ 30%). The slope changes observed on the optical response curves were discussed in the framework of capillary condensation. These results can have potential impact on the development of new sensors based on graphene-gold hybrids.

| S-EPMC9417911 | biostudies-literature

Octahedral Molybdenum Iodide Clusters Supported on Graphene for Resistive and Optical Gas Sensing.

Project description:This paper reports for the first time a gas-sensitive nanohybrid based on octahedral molybdenum iodide clusters supported on graphene flakes (Mo6@Graphene). The possibility of integrating this material into two different transducing schemes for gas sensing is proposed since the nanomaterial changes both its electrical resistivity and optical properties when exposed to gases and at room temperature. Particularly, when implemented in a chemoresistive device, the Mo6@Graphene hybrid showed an outstanding sensing performance toward NO2, revealing a limit of quantification of about 10 ppb and excellent response repeatability (0.9% of relative error). While the Mo6@Graphene chemoresistor was almost insensitive to NH3, the use of an optical transduction scheme (changes in photoluminescence) provided an outstanding detection of NH3 even for a low loading of Mo6. Nevertheless, the photoluminescence was not affected by the presence of NO2. In addition, the hybrid material revealed high stability of its gas sensing properties over time and under ambient moisture. Computational chemistry calculations were performed to better understand these results, and plausible sensing mechanisms were presented accordingly. These results pave the way to develop a new generation of multi-parameter sensors in which electronic and optical interrogation techniques can be implemented simultaneously, advancing toward the realization of highly selective and orthogonal gas sensing.

| S-EPMC9801382 | biostudies-literature

Optical Sensing of Humidity Using Polymer Top-Covered Bragg Stacks and Polymer/Metal Thin Film Structures.

Project description:Thin films with nanometer thicknesses in the range 100-400 nm are prepared from double hydrophilic copolymers of complex branched structures containing poly(N,N-dimethyl acrylamide) and poly(ethylene oxide) blocks and are used as humidity sensitive media. Instead of using glass or opaque wafer for substrates, polymer thin films are deposited on Bragg stacks and thin (30 nm) sputtered Au-Pd films thus bringing color for the colorless polymer/glass system and enabling transmittance measurements for humidity sensing. All samples are characterized by transmittance measurements at different humidity levels in the range from 5% to 90% relative humidity. Additionally, the humidity induced color change is studied by calculating the color coordinates at different relative humidity using measured spectra of transmittance or reflectance. A special attention is paid to the selection of wavelength(s) of measurements and discriminating between different humidity levels when sensing is performed by measuring transmittance at fixed wavelengths. The influence of initial film thickness, sensor architecture, and measuring configuration on sensitivity is studied. The potential and advantages of using top covered Bragg stacks and polymer/metal thin film structures as humidity sensors with simple optical read-outs are demonstrated and discussed.

| S-EPMC6630599 | biostudies-literature

Ordered Monolayer Gold Nano-urchin Structures and Their Size Induced Control for High Gas Sensing Performance.

Project description:The synthesis of ordered monolayers of gold nano-urchin (Au-NU) nanostructures with controlled size, directly on thin films using a simple electrochemical method is reported in this study. In order to demonstrate one of the vast potential applications, the developed Au-NUs were formed on the electrodes of transducers (QCM) to selectively detect low concentrations of elemental mercury (Hg(0)) vapor. It was found that the sensitivity and selectivity of the sensor device is enhanced by increasing the size of the nanospikes on the Au-NUs. The Au-NU-12 min QCM (Au-NUs with nanospikes grown on it for a period of 12 min) had the best performance in terms of transducer based Hg(0) vapor detection. The sensor had 98% accuracy, 92% recovery, 96% precision (repeatability) and significantly, showed the highest sensitivity reported to date, resulting in a limit of detection (LoD) of only 32 ?g/m3 at 75 °C. When compared to the control counterpart, the accuracy and sensitivity of the Au-NU-12?min was enhanced by ~2 and ~5 times, respectively. The results demonstrate the excellent activity of the developed materials which can be applied to a range of applications due to their long range order, tunable size and ability to form directly on thin-films.

| S-EPMC4835752 | biostudies-literature

Light Trapping-Mediated Room-Temperature Gas Sensing by Ordered ZnO Nano Structures Decorated with Plasmonic Au Nanoparticles.

Project description:An ordered array of 1D ZnO nanorods obtained by colloidal templating is shown to dramatically enhance the sensing response of NO x at room temperature by confining light and creating periodic structures. The sensitivity is measured for a concentration varying from 2 to 10 ppm (response 53% at 10 ppm) at room temperature under white light illumination with ≈225 nm hole diameter. In contrast, structures with ≈450 nm hole size show better sensing under (response 98% at 10 ppm) elevated temperatures in dark conditions, which is attributed to the increased surface chemical interactions with NO x molecules due to the porous nature and enhanced accessible surface area of ZnO nanorods. Further, the decoration of ZnO Nanorods with gold nanoparticles shows enhanced sensor performance (response 130% at 10 ppm) due to localized surface plasmon resonance under white light illumination. The findings may lead to new opportunities in the visible light-activated room-temperature NO x sensors for healthcare applications.

| S-EPMC6682047 | biostudies-literature

Wide Dynamic Range, Angle-Sensing, Long-Wave Infrared Detector Using Nano-Antenna Arrays.

Project description:We present a new technique for designing angle-sensing, long-wave infrared (LWIR) detectors. Angle detection in the proposed detector is achieved by measuring the ratio of the absorbed power in two closely-spaced, directive infrared antennas. Each directive LWIR antenna is in the form of a three-element Yagi-Uda array sharing a common reflector element with its neighbor. The structure of each antenna is optimized to act both as the collector of the infrared energy from the desired direction and as a distributed bolometer that senses the received radiation. The resistivity of each bolometer-antenna changes as a function of the absorbed power by the antenna. This change of resistance is sensed by biasing each antenna with a constant DC voltage and measuring the change of current passing through the antenna. Following this approach, by measuring the ratio of the resistance change in the two antennas, the angle of arrival of the LWIR signal can be determined. We present the design, fabrication, and measurement results of an angle-sensing detector optimized to operate at the wavelength of λ = 10.6 μm. The proposed detector has subwavelength dimensions occupying an aperture having dimensions of approximately 0.6 λ0 × 0.4λ0. The response of the detector was measured and shows the angle sensing dynamic range of 22 dB within the field of view of ±60°.

| S-EPMC7016179 | biostudies-literature

Electrospun Nanofiber Covered Polystyrene Micro-Nano Hybrid Structures for Triboelectric Nanogenerator and Supercapacitor.

Project description:Recently, tremendous research on small energy supply devices is gaining popularity with the immerging Internet of Things (IoT) technologies. Especially, energy conversion and storage devices can provide opportunities for small electronics. In this research, a micro-nano structured design of electrodes is newly developed for high performing hybrid energy systems with the improved effective surface area. Further, it could be simply fabricated through two-steps synthesis of electrospinning and glass transition of a novel polystyrene (PS) substrate. Herein, the electro-spun nanofiber of polyacrylonitrile (PAN) and Nylon 66 (Nylon) are applied to the dielectric layer of a triboelectric generator (TENG), while the PAN and polyaniline (PANI) composites is utilized as an electroactive material of supercapacitor (SC). As a result, the self-charging power system is successfully integrated with the wrinkled PAN/PS (W-PAN/PS@PANI)-SC and W-TENG by using a rectifier. According to the fabricated hybrid energy systems, the electrical energy produced by W-TENG can be successfully stored into as-fabricated W-PAN/PS@PANI-SC and can also turn on a commercial green LED with the stored energy. Therefore, the micro-nano structured electrode designed for hybrid energy systems can contribute to improve the energy conversion and storage performance of various electronic devices.

| S-EPMC8951335 | biostudies-literature

Thermally reduced kaolin-graphene oxide nanocomposites for gas sensing.

Project description:Highly sensitive graphene-based gas sensors can be made using large-area single layer graphene, but the cost of large-area pure graphene is high, making the simpler reduced graphene oxide (rGO) an attractive alternative. To use rGO for gas sensing, however, require a high active surface area and slightly different approach is needed. Here, we report on a simple method to produce kaolin-graphene oxide (GO) nanocomposites and an application of this nanocomposite as a gas sensor. The nanocomposite was made by binding the GO flakes to kaolin with the help of 3-Aminopropyltriethoxysilane (APTES). The GO flakes in the nanocomposite were contacting neighboring GO flakes as observed by electron microscopy. After thermal annealing, the nanocomposite become conductive as showed by sheet resistance measurements. Based on the conductance changes of the nanocomposite films, electrical gas sensing devices were made for detecting NH3 and HNO3. These devices had a higher sensitivity than thermally annealed multilayer GO films. This kaolin-GO nanocomposite might be useful in applications that require a low-cost material with large conductive surface area including the demonstrated gas sensors.

| S-EPMC5378989 | biostudies-literature

Dielectric Characterization of Non-Conductive Fabrics for Temperature Sensing through Resonating Antenna Structures.

Project description:Seamless integration of electronics within clothing is key for further development of efficient and convenient wearable technologies. Therefore, the characterization of textile and fabric materials under environmental changes and other parametric variations is an important requirement. To our knowledge, this paper presents for the first time the evaluation of dielectric characterization over temperature for non-conductive textiles using resonating structures. The paper describes the effects of temperature variations on the dielectric properties of non-conductive fabrics and how this can be derived from the performance effects of a simple microstrip patch antenna. Organic cotton was chosen as the main substrate for this research due to its broad presence in daily clothing. A dedicated measurement setup is developed to allow reliable and repeatable measurements, isolating the textile samples from external factors. This work shows an approximately linear relation between temperature and textile's dielectric constant, giving to fabric-based antennas temperature sensing properties with capability up to 1 degree Celsius at millimeter-wave frequencies.

| S-EPMC7142631 | biostudies-literature

Gas Sensing Properties of Perovskite Decorated Graphene at Room Temperature.

Project description:This paper explores the gas sensing properties of graphene nanolayers decorated with lead halide perovskite (CH3NH3PbBr3) nanocrystals to detect toxic gases such as ammonia (NH3) and nitrogen dioxide (NO2). A chemical-sensitive semiconductor film based on graphene has been achieved, being decorated with CH3NH3PbBr3 perovskite (MAPbBr3) nanocrystals (NCs) synthesized, and characterized by several techniques, such as field emission scanning electron microscopy, transmission electron microscopy and X-ray photoelectron spectroscopy. Reversible responses were obtained towards NO2 and NH3 at room temperature, demonstrating an enhanced sensitivity when the graphene is decorated by MAPbBr3 NCs. Furthermore, the effect of ambient moisture was extensively studied, showing that the use of perovskite NCs in gas sensors can become a promising alternative to other gas sensitive materials, due to the protective character of graphene, resulting from its high hydrophobicity. Besides, a gas sensing mechanism is proposed to understand the effects of MAPbBr3 sensing properties.

| S-EPMC6832145 | biostudies-literature

OmicsDI is part of the ELIXIR infrastructure

OmicsDI is an Elixir interoperability service. Learn more ›

Tweets

OmicsDI Databases

PRIDE
PeptideAtlas
MassIVE
JPOST Repository
Physiome Model Repository

EGA
EVA
ENA
LINCS
PAXDB
Cell Collective

MetaboLights
Metabolomics Workbench
MetabolomeExpress
GNPS
BioModels
FAIRDOMHub

ArrayExpress
dbGaP
ExpressionAtlas
GEO
NODE

Information

Databases
Help
API
Contact us
Code on GitHub
Terms of use
Submit Data