Dataset Information

Improving accuracy through density correction in guided wave tomography.

ABSTRACT: The accurate quantification of wall loss caused by corrosion is critical to the reliable life estimation of pipes and pressure vessels. Traditional thickness gauging by scanning a probe is slow and requires access to all points on the surface; this is impractical in many cases as corrosion often occurs where access is restricted, such as beneath supports where water collects. Guided wave tomography presents a solution to this; by transmitting guided waves through the region of interest and exploiting their dispersive nature, it is possible to build up a map of thickness. While the best results have been seen when using the fundamental modes A0 and S0 at low frequency, the complex scattering of the waves causes errors within the reconstruction. It is demonstrated that these lead to an underestimate in wall loss for A0 but an overestimate for S0. Further analysis showed that this error was related to density variation, which was proportional to thickness. It was demonstrated how this could be corrected for in the reconstructions, in many cases resulting in the near-elimination of the error across a range of defects, and greatly improving the accuracy of life estimates from guided wave tomography.

SUBMITTER: Huthwaite P

PROVIDER: S-EPMC4841668 | biostudies-literature | 2016 Feb

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Improving accuracy through density correction in guided wave tomography.

Huthwaite P P

Proceedings. Mathematical, physical, and engineering sciences 20160201 2186

The accurate quantification of wall loss caused by corrosion is critical to the reliable life estimation of pipes and pressure vessels. Traditional thickness gauging by scanning a probe is slow and requires access to all points on the surface; this is impractical in many cases as corrosion often occurs where access is restricted, such as beneath supports where water collects. Guided wave tomography presents a solution to this; by transmitting guided waves through the region of interest and explo ...[more]

PMID: 27118904

Similar Datasets

Project description:BACKGROUND: UV-vis spectrophotometric optical density (OD) is the most commonly-used technique for estimating chromophore formation and cell concentration in liquid culture. OD wavelength is often chosen with little thought given to its effect on the quality of the measurement. Analysis of the contributions of absorption and scattering to the measured optical density provides a basis for understanding variability among spectrophotometers and enables a quantitative evaluation of the applicability of the Beer-Lambert law. This provides a rational approach for improving the accuracy of OD measurements used as a proxy for direct dry weight (DW), cell count, and pigment levels. RESULTS: For pigmented organisms, the choice of OD wavelength presents a tradeoff between the robustness and the sensitivity of the measurement. The OD at a robust wavelength is primarily the result of light scattering and does not vary with culture conditions; whereas, the OD at a sensitive wavelength is additionally dependent on light absorption by the organism's pigments. Suitably robust and sensitive wavelengths are identified for a wide range of organisms by comparing their spectra to the true absorption spectra of dyes. The relative scattering contribution can be reduced either by measurement at higher OD, or by the addition of bovine serum albumin. Reduction of scattering or correlation with off-peak light attenuation provides for more accurate assessment of chromophore levels within cells. Conversion factors between DW, OD, and colony-forming unit density are tabulated for 17 diverse organisms to illustrate the scope of variability of these correlations. Finally, an inexpensive short pathlength LED-based flow cell is demonstrated for the online monitoring of growth in a bioreactor at culture concentrations greater than 5 grams dry weight per liter which would otherwise require off-line dilutions to obtain non-saturated OD measurements. CONCLUSIONS: OD is most accurate as a time-saving proxy measurement for biomass concentration when light attenuation is dominated by scattering. However, the applicability of OD-based correlations is highly dependent on the measurement specifications (spectrophotometer model and wavelength) and culture conditions (media type; growth stage; culture stress; cell/colony geometry; presence and concentration of secreted compounds). These variations highlight the importance of treating literature conversion factors as rough approximations as opposed to concrete constants. There is an opportunity to optimize measurements of cell pigment levels by considering scattering and absorption-dependent wavelengths of the OD spectrum.

Project description:Background and Objectives: Women with gynecological cancers constitute a high-risk cohort for loss of bone density. International guidance stipulates women undergoing cancer treatments associated with bone loss should have a quantitative assessment of bone density. Access to Dual-energy X-ray Absorptiometry (DXA) is limited. This study aimed to assess the accuracy of opportunistic bone density measurement on staging computed tomography (CT) scans for gynaecological malignancies, in comparison to the gold standard DXA. Materials and Methods: Women with a staging CT scan of the abdomen and pelvis for a new diagnosis of gynecological cancer were recruited. DXA was performed within 6 weeks of treatment for gynaecological cancer. Lumbar bone density was measured by CT attenuation values, in Hounsfield units (HU), of the anterior trabecular region. Correlations between CT and DXA parameters were analysed. Receiver Operating Characteristic(ROC) curves for diagnosis of low bone density and osteoporosis were analysed. Results: Final cohort included 48 of 50 women recruited. There was good diagnostic accuracy for abnormal bone density and osteoporosis, with areas under the ROC curve at L1 of 0.77 (p = 0.002) and 0.80 (p = 0.020) respectively. CT-HU of 170-190 yielded sensitivities of 87-90%, positive predictive values of 75-84% and negative predictive values of 71-75% for the diagnosis of low bone mineral density. CT-HU of 90-110 yielded specificities of 85-93% for the diagnosis of osteoporosis. Moderate correlations were found between CT-HU and both DXA T-scores and diagnostic categories. Conclusions: This is the first study to assess the opportunistic application of CT in the assessment of bone health in women with gynaecological cancer, a cohort at high-risk of osteoporosis. The correlation between bone density assessment in CT-HU and DXA, and strong AUC values for the diagnosis of low bone density (0.77) and osteoporosis (0.80) support this pragmatic solution in resolving the care-gap in cancer treatment-induced bone loss, often associated with poor access to DXA.

Dataset Information

Improving accuracy through density correction in guided wave tomography.

Publications

Improving accuracy through density correction in guided wave tomography.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets