Dataset Information

Diesel Surrogate Fuels for Engine Testing and Chemical-Kinetic Modeling: Compositions and Properties.

ABSTRACT: The primary objectives of this work were to formulate, blend, and characterize a set of four ultralow-sulfur diesel surrogate fuels in quantities sufficient to enable their study in single-cylinder-engine and combustion-vessel experiments. The surrogate fuels feature increasing levels of compositional accuracy (i.e., increasing exactness in matching hydrocarbon structural characteristics) relative to the single target diesel fuel upon which the surrogate fuels are based. This approach was taken to assist in determining the minimum level of surrogate-fuel compositional accuracy that is required to adequately emulate the performance characteristics of the target fuel under different combustion modes. For each of the four surrogate fuels, an approximately 30 L batch was blended, and a number of the physical and chemical properties were measured. This work documents the surrogate-fuel creation process and the results of the property measurements.

SUBMITTER: Mueller CJ

PROVIDER: S-EPMC4908839 | biostudies-literature | 2016 Feb

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Diesel Surrogate Fuels for Engine Testing and Chemical-Kinetic Modeling: Compositions and Properties.

Mueller Charles J CJ Cannella William J WJ Bays J Timothy JT Bruno Thomas J TJ DeFabio Kathy K Dettman Heather D HD Gieleciak Rafal M RM Huber Marcia L ML Kweon Chol-Bum CB McConnell Steven S SS Pitz William J WJ Ratcliff Matthew A MA

Energy & fuels : an American Chemical Society journal 20160107 2

The primary objectives of this work were to formulate, blend, and characterize a set of four ultralow-sulfur diesel surrogate fuels in quantities sufficient to enable their study in single-cylinder-engine and combustion-vessel experiments. The surrogate fuels feature increasing levels of compositional accuracy (i.e., increasing exactness in matching hydrocarbon structural characteristics) relative to the single target diesel fuel upon which the surrogate fuels are based. This approach was taken ...[more]

PMID: 27330248

Similar Datasets

Project description:In this work, military jet fuel JP-5 surrogates were formulated and tested in comparison to a nominal JP-5 fuel. Combustion experiments were conducted in an advanced engine technology (AET) ignition quality tester (IQT) and a Yanmar L100W Tier 4 diesel engine due to the potential use of jet fuel in diesel engines in military situations. The surrogate development process began with determining the fuel chemical composition based on analyses of 256 JP-5 fuel samples. The physical and chemical properties of density, viscosity, flash point, surface tension, speed of sound, and distillation behavior guided the selection of the surrogate components and their composition. JP-5 differs from other aviation fuels in its properties, but most importantly in flash point, which is higher for safety purposes. Surrogates were prepared from n-dodecane, n-butylbenzene, 1-methylnaphthalene, tetralin, trans-decalin, iso-cetane, and n-butylcyclohexane as representatives of seven of the nine major chemical categories found in jet fuel. The mass fraction of each compound in the surrogates that fell within the range for that chemical class was found in real JP-5 fuels. After optimizing the surrogates for physical and chemical properties, six surrogates were selected for combustion testing in the Yanmar diesel engine, one of which was specifically selected for a low-derived cetane number (DCN). This surrogate performed poorly in the Yanmar engine. Four of the remaining five surrogates performed similarly to the baseline JP-5 in the diesel engine in terms of values and variability of ignition delay, rate of heat release, peak pressure, and the crank angle at which 50% of the fuel is burned. Of the six surrogates tested, the best one in terms of physical properties, chemical properties, and combustion behavior was the one that contained 0.2421, 0.1503, 0.0500, 0.0141, 0.0121, 0.2532, and 0.2782 mass percentages of n-dodecane, n-butylbenzene, 1-methylnaphthalene, tetralin, trans-decalin, iso-cetane, and n-butylcyclohexane, respectively.

Dataset Information

Diesel Surrogate Fuels for Engine Testing and Chemical-Kinetic Modeling: Compositions and Properties.

Publications

Diesel Surrogate Fuels for Engine Testing and Chemical-Kinetic Modeling: Compositions and Properties.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets