Dataset Information

Cyanobacterial Polyhydroxybutyrate (PHB): Screening, Optimization and Characterization.

ABSTRACT: In modern life petroleum-based plastic has become indispensable due to its frequent use as an easily available and a low cost packaging and moulding material. However, its rapidly growing use is causing aquatic and terrestrial pollution. Under these circumstances, research and development for biodegradable plastic (bioplastics) is inevitable. Polyhydroxybutyrate (PHB), a type of microbial polyester that accumulates as a carbon/energy storage material in various microorganisms can be a good alternative. In this study, 23 cyanobacterial strains (15 heterocystous and 8 non-heterocystous) were screened for PHB production. The highest PHB (6.44% w/w of dry cells) was detected in Nostoc muscorum NCCU- 442 and the lowest in Spirulina platensis NCCU-S5 (0.51% w/w of dry cells), whereas no PHB was found in Cylindrospermum sp., Oscillatoria sp. and Plectonema sp. Presence of PHB granules in Nostoc muscorum NCCU- 442 was confirmed microscopically with Sudan black B and Nile red A staining. Pretreatment of biomass with methanol: acetone: water: dimethylformamide [40: 40: 18: 2 (MAD-I)] with 2 h magnetic bar stirring followed by 30 h continuous chloroform soxhlet extraction acted as optimal extraction conditions. Optimized physicochemical conditions viz. 7.5 pH, 30°C temperature, 10:14 h light:dark periods with 0.4% glucose (as additional carbon source), 1.0 gl-1 sodium chloride and phosphorus deficiency yielded 26.37% PHB on 7th day instead of 21st day. Using FTIR, 1H NMR and GC-MS, extracted polymer was identified as PHB. Thermal properties (melting temperature, decomposition temperatures etc.) of the extracted polymer were determined by TGA and DSC. Further, the polymer showed good tensile strength and young's modulus with a low extension to break ratio comparable to petrochemical plastic. Biodegradability potential tested as weight loss percentage showed efficient degradation (24.58%) of PHB within 60 days by mixed microbial culture in comparison to petrochemical plastic.

SUBMITTER: Ansari S

PROVIDER: S-EPMC4928839 | biostudies-literature | 2016

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Cyanobacterial Polyhydroxybutyrate (PHB): Screening, Optimization and Characterization.

Ansari Sabbir S Fatma Tasneem T

PloS one 20160630 6

In modern life petroleum-based plastic has become indispensable due to its frequent use as an easily available and a low cost packaging and moulding material. However, its rapidly growing use is causing aquatic and terrestrial pollution. Under these circumstances, research and development for biodegradable plastic (bioplastics) is inevitable. Polyhydroxybutyrate (PHB), a type of microbial polyester that accumulates as a carbon/energy storage material in various microorganisms can be a good alter ...[more]

PMID: 27359097

Similar Datasets

Project description:BackgroundPlastic plays a crucial role in everyday life of human living, nevertheless it represents an undeniable source of land and water pollution. Polyhydroxybutyrate (PHB) is a bio-based and biodegradable polyester, which can be naturally produced by microorganisms capable of converting and accumulating carbon as intracellular granules. Hence, PHB-producing strains stand out as an alternative source to fossil-derived counterparts. However, the extraction strategy affects the recovery efficiency and the quality of PHB. In this study, PHB was produced by a genetically modified Escherichia coli strain and successively extracted using dimethyl carbonate (DMC) and ethanol as alternative solvent and polishing agent to chloroform and hexane. Eventually, a Life Cycle Assessment (LCA) study was performed for evaluating the environmental and health impact of using DMC.ResultsExtraction yield and purity of PHB obtained via DMC, were quantified, and compared with those obtained via chloroform-based extraction. PHB yield values from DMC-based extraction were similar to or higher than those achieved by using chloroform (≥ 67%). To optimize the performance of extraction via DMC, different experimental conditions were tested, varying the biomass state (dry or wet) and the mixing time, in presence or in absence of a paper filter. Among 60, 90, 120 min, the mid-value allowed to achieve high extraction yield, both for dry and wet biomass. Physical and molecular dependence on the biomass state and solvent/antisolvent choice was established. The comparative LCA analysis promoted the application of DMC/ethanol rather than chloroform/hexane, as the best choice in terms of health prevention. However, an elevated impact score was achieved by DMC in the environmental-like categories in contrast with a minor contribution by its counterpart.ConclusionThe multifaceted exploration of DMC-based PHB extraction herein reported extends the knowledge of the variables affecting PHB purification process. This work offers novel and valuable insights into PHB extraction process, including environmental aspects not discussed so far. The findings of our research question the DMC as a green solvent, though also the choice of the antisolvent can influence the impact on the examined categories.

Project description:Efficient hydrolysis of native poly(3-hydroxybutyrate) (nPHB) granules in vitro by soluble PHB depolymerase of Rhodospirillum rubrum requires pretreatment of nPHB with an activator compound present in R. rubrum cells (J. M. Merrick and M. Doudoroff, J. Bacteriol. 88:60-71, 1964). Edman sequencing of the purified activator (17.4 kDa; matrix-assisted laser desorption ionization-time of flight mass spectrometry) revealed identity to a hypothetical protein deduced from a partially sequenced R. rubrum genome. The complete activator gene, apdA (activator of polymer degradation), was cloned from genomic DNA, expressed as a six-His-tagged protein in recombinant Escherichia coli (M(r), 18.3 x 10(3)), and purified. The effect of ApdA on PHB metabolism was studied in vitro and in vivo. In vitro, the activity of the activator could be replaced by trypsin, but recombinant ApdA itself had no protease activity. Comparative sodium dodecyl sulfate-polyacrylamide gel electrophoresis analysis of the protein patterns of trypsin- and ApdA-treated nPHB granules isolated from different PHB-accumulating bacteria showed that trypsin activated nPHB by removing proteins of the surface layer of nPHB regardless of the origin of nPHB, but ApdA bound to and interacted with the surface layer of nPHB in a nonproteolytic manner, thereby transforming nPHB into an activated form that was accessible to the depolymerase. In vivo, expression of ApdA in E. coli harboring the PHB biosynthetic genes, phaCBA, resulted in significant increases in the number and surface/volume ratio of accumulated PHB granules, which was comparable to the effect of phasin proteins, such as PhaP in Ralstonia eutropha. The amino acid sequence of ApdA was 55% identical to the amino acid sequence of Mms16, a magnetosome-associated protein in magnetotactic Magnetospirillum species. Mms16 was previously reported to be a GTPase with an essential function in magnetosome formation (Y. Okamura, H. Takeyama, and T. Matsunaga, J. Biol. Chem. 276:48183-48188, 2001). However, no GTPase activity of ApdA could be demonstrated. We obtained evidence that Mms16 of Magnetospirillum gryphiswaldense can functionally replace ApdA in R. rubrum. Fusions of apdA and mms16 to gfp or yfp were functionally expressed, and both fusions colocalized with PHB granules after conjugative transfer to R. rubrum. In conclusion, ApdA in vivo is a PHB-bound, phasin-like protein in R. rubrum. The function of Mms16 in magnetotactic bacteria requires further clarification.

Dataset Information

Cyanobacterial Polyhydroxybutyrate (PHB): Screening, Optimization and Characterization.

Publications

Cyanobacterial Polyhydroxybutyrate (PHB): Screening, Optimization and Characterization.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets