Scale-Up Synthesis of Fragrant Nitrogen-Doped Carbon Dots from Bee Pollens for Bioimaging and Catalysis.
Ontology highlight
ABSTRACT:
SUBMITTER: Zhang J
PROVIDER: S-EPMC5115353 | biostudies-literature | 2015 Apr
REPOSITORIES: biostudies-literature
Publications
Scale-Up Synthesis of Fragrant Nitrogen-Doped Carbon Dots from Bee Pollens for Bioimaging and Catalysis.
Zhang Jia J Yuan Yue Y Liang Gaolin G Yu Shu-Hong SH
Advanced science (Weinheim, Baden-Wurttemberg, Germany) 20150226 4
<b>Fragrant nitrogen-doped carbon dots of gram scale</b> can be prepared from commercial bee pollens by a hydrothermal process. These carbon dots of 1-2 nm in size show promising applications in cellular imaging and catalysis/photocatalysis. ...[more]
Similar Datasets
Project description:Fluorescent N,S-CDs with a quantum yield of 37.8% were synthesized via a one-pot solvothermal method. Detailed characterizations on physical, chemical and optical properties have been investigated. N,S-CDs demonstrated remarkably quenched and enhanced fluorescence in acidic and basic media. Direct qualitative analysis in pH sensor and cell imaging were preliminarily studied.
| S-EPMC9057811 | biostudies-literature
Project description:The current research mainly focuses on transforming low-quality waste into value-added nanomaterials and investigating various ways of utilising them. The hydrothermal preparation of highly fluorescent N-doped carbon dots (N-CDs) was obtained from the carboxymethylcellulose (CMC) of oil palm empty fruit bunches and linear-structured polyethyleneimines (LPEI). Transmission electron microscopy (TEM) analysis showed that the obtained N-CDs had an average size of 3.4 nm. The N-CDs were monodispersed in aqueous solution and were strongly fluorescent under the irradiation of ultra-violet light. A detailed description of the morphology and shape was established using Fourier transform infrared (FTIR) spectroscopy and X-ray photoelectron spectroscopy (XPS). It was shown that LPEI were successfully tuned the fluorescence (PL) properties of CDs in both the intrinsic and surface electronic structures, and enhanced the quantum yield (QY) up to 44%. The obtained N-CDs exhibited remarkable PL stability, long lifetime and pH-dependence behaviour, with the excitation/emission maxima of 350/465.5 nm. Impressively, PL enhancement and blue-shifted emission could be seen with the dilution of the original N-CDs solution. The obtained N-CDs were further applied as fluorescent probe for the identification of Cu2+ in aqueous media. The mechanism could be attributed to the particularly high thermodynamic affinity of Cu2+ for the N-chelate groups over the surface of N-CDs and the fast metal-to-ligand binding kinetics. The linear relationship between the relative quenching rate and the concentration of Cu2+ were applied between 1-30 µM, with a detection limit of 0.93 µM. The fluorescent probe was successfully applied for the detection of Cu2+ in real water. Moreover, a solid-state film of N-CDs was prepared in the presence of poly (vinyl alcohol) (PVA) polymer and found to be stable even after 72-h of continuous irradiation to UV-lamp. In contrast to the aqueous N-CDs, the composite film showed only an excitation independent property, with enhanced PL QY of around 47%. Due to the strong and stable emission nature of N-CDs in both aqueous and solid conditions, the obtained N-CDs are ideal for reducing the overall preparation costs and applying them for various biological and environmental applications in the future.
| S-EPMC6835739 | biostudies-literature
Project description:Considerable biosensors have been fabricated on the basis of DNA interaction with carbon nanomaterials, such as graphene oxide (GO) nanosheets. Few studies have focused on the rational design of sensors between carbon dots (CDs) and DNA due to the limited understanding of the real forces behind the adsorption of DNA on CDs. In this work, nitrogen doping-positive CDs (N-CDs), which can quench fluorophore-labeled DNA, were investigated to ascertain the interaction between the CDs and DNA. With reference to DNA adsorption on GO, the adsorption capacity and kinetics of N-CDs for DNA were studied. Desorption of DNA from these surfaces was also measured. Moreover, DNA desorption and anchoring force of N-CDs to DNA were different from those of GO, given that the prepared N-CDs and GO were positively and negatively charged, respectively. Accordingly, DNA was adsorbed on N-CDs mainly via electrostatic adsorption and other forces, such as nucleobase effect, hydrophobic interaction, and van der Waals (vdW) forces. This study enhanced the basic knowledge of DNA adsorption on some CDs for further study in the application of CDs in bioanalysis or biomedicine.
| S-EPMC9063714 | biostudies-literature
Project description:Carbon quantum dots (CQDs) have potential applications in many fields such as light-emitting devices, photocatalysis, and bioimaging due to their unique photoluminescence (PL) properties and environmental benignness. Here, we report the synthesis of nitrogen-doped carbon quantum dots (NCQDs) from citric acid and m-phenylenediamine using a one-pot hydrothermal approach. The environment-dependent emission changes of NCQDs were extensively investigated in various solvents, in the solid state, and in physically assembled PMMA-PnBA-PMMA copolymer gels in 2-ethyl-hexanol. NCQDs display bright emissions in various solvents as well as in the solid state. These NCQDs exhibit multicolor PL emission across the visible region upon changing the environment (solutions and polymer matrices). NCQDs also exhibit excitation-dependent PL and solvatochromism, which have not been frequently investigated in CQDs. Most CQDs are nonemissive in the aggregated or solid state due to the aggregation-caused quenching (ACQ) effect, limiting their solid-state applications. However, NCQDs synthesized here display a strong solid-state emission centered at 568 nm attributed to the presence of surface functional groups that restrict the π-π interaction between the NCQDs and assist in overcoming the ACQ effect in the solid state. NCQD-containing gels display significant fluorescence enhancement in comparison to the NCQDs in 2-ethyl hexanol, likely because of the interaction between the polar PMMA blocks and NCQDs. The application of NCQDs-Gel as a solid/gel state fluorescent display has been presented. This research facilitates the development of large-scale, low-cost multicolor phosphor for the fabrication of optoelectronic devices, sensing, and bioimaging applications.
| S-EPMC9366982 | biostudies-literature
Project description:Carbon dots (CDs) are a rapidly progressing class of nanomaterial which show promise towards applications in solar energy conversion due to their low toxicity, favorable electrochemical properties, and tunability. In recent years there have been a number of reported CD syntheses, both top-down and bottom-up methods, producing a diverse range of CDs with intrinsic properties dependent on the starting materials and utilized dopants. This work presents a citrate buffer-facilitated synthesis of nitrogen-doped carbon dots (NCD) and explores the impact of urea concentration on observed electrochemical and optical properties. Optical absorbance and quantum yield of NCDs were found to increase with the dopant concentrations present in the hydrothermal reaction mixture. Electrochemical analysis demonstrates that increased nitrogen content results in the shifting of carbon dot oxidation potentials without the need of post-synthesis surface modifications. Over the range of molar ratios of dopant-to-citrate tested, the oxidation potentials of NCDs shifted up to 150 mV towards more negative potentials. X-ray photoelectron spectroscopy confirms the addition of pyrrolic and pyridinic nitrogen at different levels in different batches of NCDs, which are likely the source of the observed changes.
| S-EPMC9417309 | biostudies-literature
Project description:A facile synthesis of 3-6 nm, water dispersible, near-infrared (NIR) emitting, quantum dots (QDs) magnetically doped with Fe is presented. Doping of alloyed CdTeS nanocrystals with Fe was achieved in situ using a simple hydrothermal method. The magnetic quantum dots (MQDs) were capped with NAcetyl-Cysteine (NAC) ligands, containing thiol and carboxylic acid functional groups to provide stable aqueous dispersion. The optical and magnetic properties of the Fe doped MQDs were characterized using several techniques. The synthesized MQDs are tuned to emit in the Vis-NIR (530-738 nm) wavelength regime and have high quantum yields (67.5-10%). NIR emitting (738 nm) MQDs having 5.6 atomic% Fe content exhibited saturation magnetization of 85 emu/gm[Fe] at room temperature. Proton transverse relaxivity of the Fe doped MQDs (738 nm) at 4.7 T was determined to be 3.6 mM-1s-1. The functional evaluation of NIR MQDs has been demonstrated using phantom and in vitro studies. These water dispersible, NIR emitting and MR contrast producing Fe doped CdTeS MQDs, in unagglomerated form, have the potential to act as multimodal contrast agents for tracking live cells.
| S-EPMC3947824 | biostudies-literature
Project description:A highly efficient novel photocatalyst consisting of nitrogen-carbon dots (N-CDs) and three-dimensional (3D) hierarchical BiOBr was synthesized via a simple ultrasonic-assisted method and used for the degradation of hazardous dyes. Deposition of N-CDs onto the surface of BiOBr was confirmed through structure and composition characterizations. The N-CDs/BiOBr composites exhibited superior activity for organic contaminant degradation under visible light and the 1 wt% N-CDs/BiOBr composite showed the highest degradation rate, indicating that N-CDs/BiOBr composites have great potential for application in mitigating hazardous contaminants. The N-CDs played an important role in improving the photocatalytic performance, owing to the enhancement of up-converted photoluminescence behavior as well as the efficient separation of photogenerated charge carriers originating from the intimately contacted interface. A possible photocatalytic mechanism was proposed based on the experimental results.
| S-EPMC5361154 | biostudies-literature
Project description:The efficient detection of Fe3+ and MnO4 - in a water environment is very important and challenging due to their harmful effects on the health of humanity and environmental systems. Good biocompatibility, sensitivity, selectivity, and superior photophysical properties were important attributes of carbon dot-based CDs sensors for sensing applications. In this work, we synthesized N, P-co-doped carbon dots (N/P CDs) with guanosine 5'-monophosphate (GMP) as a green carbon source, with high fluorescence quantum yield in water (QY, 53.72%). First, the luminescent N/P CDs showed a three-state "on-off-on" fluorescence response upon the sequential addition of Fe3+ and F-, with a low detection limit of 12 nM for Fe3+ and 8.5 nM for F-, respectively. Second, the N/P CDs also exhibited desirable selectivity and sensitivity for toxic MnO4 - detection with the limit of detection of 18.2 nM, through a turn-off mechanism. Moreover, the luminescent N/P CDs successfully monitored the aforementioned ions in environmental water samples and in Escherichia coli.
| S-EPMC9210210 | biostudies-literature
Project description:Nitrogen-doped carbon dots (NCD) with high fluorescence retention and good stability were successfully fabricated using citric acid and urea via a facile and eco-friendly one-step microwave method, which exhibited superior specificity for detection of nitrofurantoin (NFT). Upon the addition of NFT, the fluorescence intensity of NCD at 450 nm was significantly decreased. Besides, a satisfactory linear relationship between the fluorescence quenching efficiency and concentrations of NFT was obtained. Especially, NCD was qualitatively and quantitatively applied for detection NFT in milk and meat extract samples with a high recovery rate. Consequently, it was suggested that the detection method had potential application in the specific detection of NFT, offering a novel approach for veterinary drug residue detection.
| S-EPMC10955566 | biostudies-literature
Project description:The tunable photoluminescence (PL) of nitrogen-doped carbon dots (NCDs) has attracted much attention in recent years while the specific mechanism is still in dispute. Herein, NCDs with yellow emission were successfully synthesized via a facile hydrothermal approach. Three kinds of post-treatment routes were investigated to verify the influence of surface states on the PL emission of NCDs including solvent-dependent, reduced-reaction and metal-enhanced effect. The interaction mechanism was studied by absorption spectrum, structural characterizations, steady-state and time-resolved spectroscopy. When dispersed in different solvents, the as-prepared NCDs show tunable emission and PL enhancement attributed to hydrogen bonding between solvents and NCDs. Besides, the addition of NaBH4 can induce the reduction of the C=O bonds existing in original NCDs to C-O bonds and thus result in the enhancement of the intrinsic (n-π*) emission. Moreover, metal-enhanced fluorescence of NCDs can also be observed when adding Ag+ into initial NCD solution, which might be ascribed to aggregation-induced emission enhancement. These results for post-treated NCDs demonstrate that surface functional groups are responsible for PL emission and provide new possibilities like multi-image sensing and lighting application.
| S-EPMC6534678 | biostudies-literature