Dataset Information

Fabrication and application of indium-tin-oxide nanowire networks by polystyrene-assisted growth.

ABSTRACT: The fabrication and application of polystyrene (PS)-assisted ITO nanowire (NW) networks are reported. The ITO-NW networks are fabricated by means of electron-beam deposition via PS. This method has the advantages of low-temperature (~300?°C), low-cost, facile and efficient operation. The growth mechanism of PS-assisted ITO NWs was analyzed in detail, and the morphology of which could be regulated by the size of PS. X-ray diffraction and high-resolution transmission electron microscope show that the ITO NWs are close to an integral cubic lattice. The transmittance of ITO-NW networks layer is above 90% after 400?nm and the sheet resistance is ~200??/?. When they applied on vertical blue and green LEDs, the light output power all has been improved ~30%. And, the resistive switching behaviors of ITO-NWs were measured and analyzed in Ag/ITO-NW networks/Al capacitor. The application of ITO-NW networks on special morphological devices was discussed. The PS-assisted ITO-NW networks show a strong researching and application value.

SUBMITTER: Li Q

PROVIDER: S-EPMC5431639 | biostudies-literature | 2017 May

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Fabrication and application of indium-tin-oxide nanowire networks by polystyrene-assisted growth.

Li Qiang Q Yun Feng F Li Yufeng Y Ding Wen W Zhang Ye Y

Scientific reports 20170509 1

The fabrication and application of polystyrene (PS)-assisted ITO nanowire (NW) networks are reported. The ITO-NW networks are fabricated by means of electron-beam deposition via PS. This method has the advantages of low-temperature (~300 °C), low-cost, facile and efficient operation. The growth mechanism of PS-assisted ITO NWs was analyzed in detail, and the morphology of which could be regulated by the size of PS. X-ray diffraction and high-resolution transmission electron microscope show that ...[more]

PMID: 28487528

Similar Datasets

Project description:Fabrication and organosilane-functionalization and characterization of nanostructured ITO electrodes are reported. Nanostructured ITO electrodes were obtained by electron beam evaporation, and a subsequent annealing treatment was selectively performed to modify their crystalline state. An increase in geometrical surface area in comparison with thin-film electrodes area was observed by atomic force microscopy, implying higher electroactive surface area for nanostructured ITO electrodes and thus higher detection levels. To investigate the increase in detectability, chemical organosilane-functionalization of nanostructured ITO electrodes was performed. The formation of 3-glycidoxypropyltrimethoxysilane (GOPTS) layers was detected by X-ray photoelectron spectroscopy. As an indirect method to confirm the presence of organosilane molecules on the ITO substrates, cyclic voltammetry and electrochemical impedance spectroscopy (EIS) were also carried out. Cyclic voltammograms of functionalized ITO electrodes presented lower reduction-oxidation peak currents compared with non-functionalized ITO electrodes. These results demonstrate the presence of the epoxysilane coating on the ITO surface. EIS showed that organosilane-functionalized electrodes present higher polarization resistance, acting as an electronic barrier for the electron transfer between the conductive solution and the ITO electrode. The results of these electrochemical measurements, together with the significant difference in the X-ray spectra between bare ITO and organosilane-functionalized ITO substrates, may point to a new exploitable oxide-based nanostructured material for biosensing applications. As a first step towards sensing, rapid functionalization of such substrates and their application to electrochemical analysis is tested in this work. Interestingly, oxide-based materials are highly integrable with the silicon chip technology, which would permit the easy adaptation of such sensors into lab-on-a-chip configurations, providing benefits such as reduced size and weight to facilitate on-chip integration, and leading to low-cost mass production of microanalysis systems.

Dataset Information

Fabrication and application of indium-tin-oxide nanowire networks by polystyrene-assisted growth.

Publications

Fabrication and application of indium-tin-oxide nanowire networks by polystyrene-assisted growth.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets