Kerogen Swelling and Confinement: Its implication on Fluid Thermodynamic Properties in Shales.
Ontology highlight
ABSTRACT:
SUBMITTER: Pathak M
PROVIDER: S-EPMC5624957 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Until now, the oil shale kukersite has been used mainly for energy and oil production. To broaden the possible applications of oil shales, the wet air oxidation of kukersite (an organic-rich sedimentary rock from Estonia) was studied. Kukersite was oxidized with an oxygen-rich gas in water at temperatures up to 200 °C and pressures up to 60 bar. The efficiency of this batch process was evaluated from organic matter conversion, from the amount of solubilized organics obtained, and from the rate of dicarboxylic acid (DCA) formation. The effect of several reaction parameters-pressure, temperature, time, acid/base additives, substrate concentration, the origin of a substrate and its organic matter content, and so forth-was measured. A conversion of 91% in total organic carbon was achieved at 175 °C with 40 bar of the 1:1 oxygen/nitrogen mixture in 3 h without the presence of any additives. Under basic conditions, high yields (up to 50%) of dissolved organic matter were obtained with 8% of DCA; the best results are obtained with K2CO3 and KOH. The highest DCA outcome (12%) within the 3 h reaction time was obtained in the presence of acetic acid. It was found that temperatures higher than 185 °C, pressures over 30 bar of pO2, and long reaction times in the acidic media caused a considerable decrease in the DCA outcome. It was also found that the same process can be applied to shales of different origins, although with lower DCA yields.
| S-EPMC7482093 | biostudies-literature
Project description:Shale gas is a promising energy source offering additional energy security over concerns of fossil fuel depletion. Injecting CO2 into depleted shale gas reservoirs might provide a feasible solution for CO2 storage and enhanced gas recovery. However, shale strain caused by the CO2 injection as well as CO2 sequestration in the reservoir needs to be considered during shale gas production. For this purpose, this paper examines the adsorption capacities, CO2-induced swelling, and He-induced strain of shales at 0-16 MPa and 35-75 °C. The maximum excess adsorption at different temperatures correlated with the bulk phase density: as the CO2 temperature increased, the maximum excess adsorption density decreased. The density of the adsorbed phase, obtained using the Dubinin-Radushkevich model, was used to fit the excess adsorption data. At low pressure, the CO2-induced strain on shale was caused by the gas adsorption, whereas at high pressure, it was caused by gas pressure. The absolute adsorption linearly correlated with the adsorption-induced strain.
| S-EPMC7424733 | biostudies-literature
Project description:Hydraulic fracturing is widely applied for economical gas production from shale reservoirs. Still, the swelling of the clay micro/nano pores due to retained fluid from hydraulic fracturing causes a gradual reduction of gas production. Four different gas-bearing shale samples with different mineralogical characteristics were investigated to study the expected shale swelling and reduction in gas permeability due to hydraulic fracturing. To simulate shale softening, these shale samples were immersed in deionized (DI) water heated to 100 °C temperature and subjected to 8 MPa pressure in a laboratory reactor for 72 hours to simulate shale softening. The low-temperature nitrogen adsorption and density measurements were performed on the original and treated shale to determine the changes in micro and nano pore structure. The micro and nano pore structures changed, and the porosity decreased after shale treatment. The porosity decreased by 4% for clayey shale, while for well-cemented shale the porosity only decreased by 0.52%. The findings showed that the initial mineralogical composition of shale plays a significant role in the change of micro and nano pores and the pore structure alteration due to retained fluid from hydraulic fracturing. A pore network model is used to simulate the permeability of shale used in this study. To define pore structure properties, specific factors such as porosity, pore size, pore throat distribution, and coordination number were used. Furthermore, the anisotropy characteristics of shale were integrated into the model via a coordination number ratio. Finally, the change in permeability due to shale softening was determined and compared with untreated with the progress of shale softening. The simulation showed that the permeability of Longmaxi shale could decrease from 3.82E-16 m2 to 4.71E-17 m2 after treatment.
| S-EPMC8501039 | biostudies-literature
Project description:The adsorption behavior and the mechanism of a CO2/CH4 mixture in shale organic matter play significant roles to predict the carbon dioxide sequestration with enhanced gas recovery (CS-EGR) in shale reservoirs. In the present work, the adsorption performance and the mechanism of a CO2/CH4 binary mixture in realistic shale kerogen were explored by employing grand canonical Monte Carlo (GCMC) and molecular dynamics (MD) simulations. Specifically, the effects of shale organic type and maturity, temperature, pressure, and moisture content on pure CH4 and the competitive adsorption performance of a CO2/CH4 mixture were investigated. It was found that pressure and temperature have a significant influence on both the adsorption capacity and the selectivity of CO2/CH4. The simulated results also show that the adsorption capacities of CO2/CH4 increase with the maturity level of kerogen. Type II-D kerogen exhibits an obvious superiority in the adsorption capacity of CH4 and CO2 compared with other type II kerogen. In addition, the adsorption capacities of CO2 and CH4 are significantly suppressed in moist kerogen due to the strong adsorption strength of H2O molecules on the kerogen surface. Furthermore, to characterize realistic kerogen pore structure, a slit-like kerogen nanopore was constructed. It was observed that the kerogen nanopore plays an important role in determining the potential of CO2 subsurface sequestration in shale reservoirs. With the increase in nanopore size, a transition of the dominated gas adsorption mechanism from micropore filling to monolayer adsorption on the surface due to confinement effects was found. The results obtained in this study could be helpful to estimate original gas-in-place and evaluate carbon dioxide sequestration capacity in a shale matrix.
| S-EPMC6956192 | biostudies-literature
Project description:Stroke affects millions each year. Poststroke brain edema predicts the severity of eventual stroke damage, yet our concept of how edema develops is incomplete and treatment options remain limited. In early stages, fluid accumulation occurs owing to a net gain of ions, widely thought to enter from the vascular compartment. Here, we used magnetic resonance imaging, radiolabeled tracers, and multiphoton imaging in rodents to show instead that cerebrospinal fluid surrounding the brain enters the tissue within minutes of an ischemic insult along perivascular flow channels. This process was initiated by ischemic spreading depolarizations along with subsequent vasoconstriction, which in turn enlarged the perivascular spaces and doubled glymphatic inflow speeds. Thus, our understanding of poststroke edema needs to be revised, and these findings could provide a conceptual basis for development of alternative treatment strategies.
| S-EPMC7375109 | biostudies-literature
Project description:The need for more accessible energy resources makes shale formations increasingly important. Characterization of such low-permeability formations is complicated, due to the presence of multiscale features, and defies conventional methods. High-quality 3D imaging may be an ultimate solution for revealing the complexities of such porous media, but acquiring them is costly and time consuming. High-quality 2D images, on the other hand, are widely available. A novel three-step, multiscale, multiresolution reconstruction method is presented that directly uses 2D images in order to develop 3D models of shales. It uses a high-resolution 2D image representing the small-scale features to reproduce the nanopores and their network, a large scale, low-resolution 2D image to create the larger-scale characteristics, and generates stochastic realizations of the porous formation. The method is used to develop a model for a shale system for which the full 3D image is available and its properties can be computed. The predictions of the reconstructed models are in excellent agreement with the data. The method is, however, quite general and can be used for reconstructing models of other important heterogeneous materials and media. Two biological examples and from materials science are also reconstructed to demonstrate the generality of the method.
| S-EPMC4642334 | biostudies-literature
Project description:The effects of CO?-water-rock interactions on the mechanical properties of shale are essential for estimating the possibility of sequestrating CO? in shale reservoirs. In this study, uniaxial compressive strength (UCS) tests together with an acoustic emission (AE) system and SEM and EDS analysis were performed to investigate the mechanical properties and microstructural changes of black shales with different saturation times (10 days, 20 days and 30 days) in water dissoluted with gaseous/super-critical CO?. According to the experimental results, the values of UCS, Young's modulus and brittleness index decrease gradually with increasing saturation time in water with gaseous/super-critical CO?. Compared to samples without saturation, 30-day saturation causes reductions of 56.43% in UCS and 54.21% in Young's modulus for gaseous saturated samples, and 66.05% in UCS and 56.32% in Young's modulus for super-critical saturated samples, respectively. The brittleness index also decreases drastically from 84.3% for samples without saturation to 50.9% for samples saturated in water with gaseous CO?, to 47.9% for samples saturated in water with super-critical carbon dioxide (SC-CO?). SC-CO? causes a greater reduction of shale's mechanical properties. The crack propagation results obtained from the AE system show that longer saturation time produces higher peak cumulative AE energy. SEM images show that many pores occur when shale samples are saturated in water with gaseous/super-critical CO?. The EDS results show that CO?-water-rock interactions increase the percentages of C and Fe and decrease the percentages of Al and K on the surface of saturated samples when compared to samples without saturation.
| S-EPMC5509274 | biostudies-literature
Project description:Water is the universal solvent and plays a critical role in all known geological and biological processes. Confining water in nano-scale domains, as encountered in sedimentary rocks, in biological, and in engineered systems, leads to the deviations in water's physicochemical properties relative to those measured for the non-confined phase. In our comprehensive analysis, we demonstrate that nano-scale confinement leads to the decrease in the melting/freezing point temperature, density, and surface tension of confined water. With increasing degree of spatial confinement the population of networked water, as evidenced by alterations in the O-H stretching modes, increases. These analyses were performed on two groups of mesoporous silica materials, which allows to separate pore size effects from surface chemistry effects. The observed systematic effects of nano-scale confinement on the physical properties of water are driven by alterations to water's hydrogen-bonding network-influenced by water interactions with the silica surface - and has implications for how we understand the chemical and physical properties of liquids confined in porous materials.
| S-EPMC6546746 | biostudies-literature
Project description:High precision control of micro- and nanoscale objects in aqueous media is an essential technology for nanoscience and engineering. Existing methods for particle trapping primarily depend on optical, magnetic, electrokinetic, and acoustic fields. In this work, we report a new hydrodynamic flow based approach that allows for fine-scale manipulation and positioning of single micro- and nanoscale particles using automated fluid flow. As a proof-of-concept, we demonstrate trapping and two-dimensional (2D) manipulation of 500 nm and 2.2 ?m diameter particles with a positioning precision as small as 180 nm during confinement. By adjusting a single flow parameter, we further show that the shape of the effective trap potential can be efficiently controlled. Finally, we demonstrate two distinct features of the flow-based trapping method, including isolation of a single particle from a crowded particle solution and active control over the surrounding medium of a trapped object. The 2D flow-based trapping method described here further expands the micro/nanomanipulation toolbox for small particles and holds strong promise for applications in biology, chemistry, and materials research.
| S-EPMC3689313 | biostudies-literature
Project description:Successful implementation of carbon molecular sieve (CMS) membranes in large scale chemical processes inevitably relies on fabrication of high performance integrally skinned asymmetric or thin-film composite membranes. In principle, to maximize separation efficiency the selective CMS layer should be as thin as possible which requires its lateral confinement to a supporting structure. In this work, we studied pyrolysis-induced structural development as well as ethanol vapor-induced swelling of ultrathin CMS films made from a highly aromatic polyimide of an intrinsic microporosity (PIM-PI) precursor. Utilization of a light polarization-sensitive technique, spectroscopic ellipsometry, allowed for the identification of an internal orientation within the turbostratic amorphous CMS structure driven by the laterally constraining support. Our results indicated a significant thickness dependence both in the extent of pyrolytic collapse and response to organic vapor penetrant. Thinner, substrate-confined films (∼30 nm) collapsed more extensively leading to a reduction of microporosity in comparison to their thicker (∼300 nm) as well as self-supported (∼70 μm) counterparts. The reduced microporosity in the thinner films induced changes in the balance between penetrant-induced dilation (swelling) and filling of micropores. In comparison to thicker films, the initial lower microporosity of the thinner films was accompanied by slightly enhanced organic vapor-induced swelling. The presented results are anticipated to generate the fundamental knowledge necessary to design optimized ultrathin CMS membranes. In particular, our results reinforce previous findings that excessive reduction of the selective layer thickness in amorphous microporous materials (such as PIMs or CMS) beyond several hundred nanometers may not be optimal for maximizing their fluid transport performance.
| S-EPMC8289180 | biostudies-literature