Concentration and size distribution data of silicon nitride nanoparticles measured using nanoparticle tracking analysis.
Ontology highlight
ABSTRACT:
SUBMITTER: Lal S
PROVIDER: S-EPMC5675993 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The average recovery rate of silicon nitride nanoparticles isolated from serum using the method detailed in previous article "A novel method for isolation and recovery of ceramic nanoparticles and metal wear debris from serum lubricants at ultra-low wear rate" (Lal et al., 2016) [1] was tested gravimetrically by weighing particles doped into serum before and after the isolation process. An average recovery rate of approximately 89.6% (± 7.1?SD) was achieved.
| S-EPMC6141149 | biostudies-other
Project description:Current methods for characterisation of extracellular vesicles (EVs) need further standardisation in order to obtain an acceptable level of data comparability. Size and concentration of EVs can be determined by nanoparticle tracking analysis (NTA). However, both the heterogeneity of EVs and the choice of instrument settings may cause an appreciable analytical variation. Intra-assay (within-day, n = 6) and inter-assay (day-to-day, n = 6) variations (coefficient of variation, % CV) of different preparations of EVs and artificial vesicles or beads were determined using two NanoSight NS500 instruments, located at different laboratories. All analyses were performed by the same operator. The effect of applying identical software settings or instrument-optimised settings for each sample type and instrument was also evaluated. Finally, the impact of different operators and the use of two different software versions were investigated. The intra-assay CVs were 1-12% for both EVs and artificial samples, measured on the same instrument. The overall day-to-day variation was similar for both instruments, ranging from 2% to 25%. However, significantly different results were observed between the two instruments using identical software settings. The effect of applying instrument-optimised settings reduced the mismatch between the instruments, resulting in little to no significant divergences. The impact of using different operators and software versions when analysing silica microspheres and microvesicles from monocytes using instrument-optimised settings on the same instrument did not contribute to significant variation compared to the overall day-to-day variation of one operator. Performance differences between two similar NTA instruments may display significant divergences in size and concentration measurements when analysing EVs, depending on applied instrument settings and technical conditions. The importance of developing a streamlined and standardised execution of analysis, as well as monitoring longitudinal variation parameters on both biological and synthetic samples, should be highlighted.
| S-EPMC5533132 | biostudies-literature
Project description:An increasingly important issue in nanoscience and nanotechnology is the accurate determination of nanoparticle sizing. Wide angle X-ray total scattering (WAXTS) data are frequently used to retrieve the Particle Size Distributions (PSDs) of nanocrystals of highly technological relevance; however, the PSD shape typically relies on an a-priori assumption. Here, we propose a modified version of the classical iterative Lucy-Richardson (LR) algorithm, which is simple, fast and highly reliable against noise, and demonstrate that the inversion of WAXTS data can be profitably used for recovering accurate PSD regardless of its shape. Computer simulations based on the use of the Debye Scattering Equation (DSE) modelling WAXTS data show that the algorithm is capable of recovering accurate PSDs even when the sample is made of a mixture of different polymorphs and/or exhibits microstrain effects. When applied to the inversion of WAXTS data taken on real samples, the method requires accurate modelling of the nanoparticle crystal structure, which includes structural defects, microstrain and surface induced distortions. Provided that this information is correctly fed to the program, the inversion algorithm reconstructs the WAXTS data with high accuracy and recovers highly robust (against noise) PSDs. Two examples reporting the characterization of Magnetite-Maghemite and commercial P25-Titania nanopowders, are discussed. We demonstrate that pre-assumption of wrong PSD shape leads to inaccurate number-based average sizes in highly polydisperse samples.
| S-EPMC7391761 | biostudies-literature
Project description:Specific size, shape and surface chemistry influence the biological activity of nanoparticles. In the case of lipophilic nanoparticles, which are widely used in consumer products, there is evidence that particle size and formulation influences skin permeability and that lipophilic particles smaller than 6 nm can embed in lipid bilayers. Since most nanoparticle synthetic procedures result in mixtures of different particles, post-synthetic purification promises to provide insights into nanostructure-function relationships. Here we used size-selective precipitation to separate lipophilic allyl-benzyl-capped silicon nanoparticles into monodisperse fractions within the range of 1 nm to 5 nm. We measured liposomal encapsulation and cellular uptake of the monodisperse particles and found them to have generally low cytotoxicities in Hela cells. However, specific fractions showed reproducibly higher cytotoxicity than other fractions as well as the unseparated ensemble. Measurements indicate that the cytotoxicity mechanism involves oxidative stress and the differential cytotoxicity is due to enhanced cellular uptake by specific fractions. The results indicate that specific particles, with enhanced suitability for incorporation into lipophilic regions of liposomes and subsequent in vitro delivery to cells, are enriched in certain fractions.
| S-EPMC5341124 | biostudies-literature
Project description:In this work, a complete fitting procedure of UV-Vis spectra of silver nanoparticles in colloidal solutions is reported. The fitting function, based on the Beer-Lambert law, Mie theory, and log-normal probability distribution of nanoparticles' sizes, is developed and confirmed by 33 different independent measurements. In order to validate the accuracy of the function's behavior on different spectra, freely accessible measurements were used, proving that the fitting function works independently of the method of their production-laser or chemical synthesis of nanoparticles. The developed fitting function is, to the best of our knowledge, novel and not based on any conventional spectral analysis approaches like the Mie-Gans procedure. Furthermore, since fitted parameters are all physical, it allows determination of the mode diameter of nanoparticles as well as the standard deviation of the log-normal distribution of sizes. It enables the reconstruction of size distribution of nanoparticles in colloidal solution. Step-by-step derivation of the fitting function is provided with a physical explanation of all parameters. The importance of Lorentzian dependence emerging at the core of Beer-Lambert law is physically discussed and linked to harmonic oscillator behavior of localized surface plasmon resonance of silver nanoparticles in a colloidal solution. Size distribution reconstruction from fitted parameters according to a log-normal distribution function is provided and a concentration calculation is presented.
| S-EPMC9565506 | biostudies-literature
Project description:The urgent challenges posed by the energy crisis, alongside the heat dissipation of advanced electronics, have embarked on a rising demand for the development of highly thermally conductive polymer composites. Electrospun composite mats, known for their flexibility, permeability, high concentration and orientational degree of conductive fillers, stand out as one of the prime candidates for addressing this need. This study explores the efficacy of boron nitride (BN) and its potential alternative, silicon nitride (SiN) nanoparticles, in enhancing the thermal performance of the electrospun composite thermoplastic polyurethane (TPU) fibers and mats. The 3D reconstructed models obtained from FIB-SEM imaging provided valuable insights into the morphology of the composite fibers, aiding the interpretation of the measured thermal performance through scanning thermal microscopy for the individual composite fibers and infrared thermography for the composite mats. Notably, we found that TPU-SiN fibers exhibit superior heat conduction compared to TPU-BN fibers, with up to a 6 °C higher surface temperature observed in mats coated on copper pipes. Our results underscore the crucial role of arrangement of nanoparticles and fiber morphology in improving heat conduction in the electrospun composites. Moreover, SiN nanoparticles are introduced as a more suitable filler for heat conduction enhancement of electrospun TPU fibers and mats, suggesting immense potential for smart textiles and thermal management applications.
| S-EPMC11310906 | biostudies-literature
Project description:Glasses and single crystals have traditionally been used as optical windows. Recently, there has been a high demand for harder and tougher optical windows that are able to endure severe conditions. Transparent polycrystalline ceramics can fulfill this demand because of their superior mechanical properties. It is known that polycrystalline ceramics with a spinel structure in compositions of MgAl2O4 and aluminum oxynitride (γ-AlON) show high optical transparency. Here we report the synthesis of the hardest transparent spinel ceramic, i.e. polycrystalline cubic silicon nitride (c-Si3N4). This material shows an intrinsic optical transparency over a wide range of wavelengths below its band-gap energy (258 nm) and is categorized as one of the third hardest materials next to diamond and cubic boron nitride (cBN). Since the high temperature metastability of c-Si3N4 in air is superior to those of diamond and cBN, the transparent c-Si3N4 ceramic can potentially be used as a window under extremely severe conditions.
| S-EPMC5355983 | biostudies-literature
Project description:Which sizes of nanoparticles embedded in a crystalline solid yield the lowest thermal conductivity? Nanoparticles have long been demonstrated to reduce the thermal conductivity of crystals by scattering phonons, but most previous works assumed the nanoparticles to have a single size. Here, we use optimization methods to show that the best nanoparticle size distribution to scatter the broad thermal phonon spectrum is not a similarly broad distribution but rather several discrete peaks at well-chosen nanoparticle radii. For SiGe, the best size distribution yields a thermal conductivity below that of amorphous silicon. Further, we demonstrate that a simplified distribution yields nearly the same low thermal conductivity and can be readily fabricated. Our work provides important insights into how to manipulate the full spectrum of phonons and will guide the design of more efficient thermoelectric materials.
| S-EPMC4355732 | biostudies-other
Project description:The physiological and pathophysiological roles of extracellular vesicles (EVs) have become increasingly recognized, making the EV field a quickly evolving area of research. There are many different methods for EV isolation, each with distinct advantages and disadvantages that affect the downstream yield and purity of EVs. Thus, characterizing the EV prep isolated from a given source by a chosen method is important for interpretation of downstream results and comparison of results across laboratories. Various methods exist for determining the size and quantity of EVs, which can be altered by disease states or in response to external conditions. Nanoparticle tracking analysis (NTA) is one of the prominent technologies used for high-throughput analysis of individual EVs. Here, we present a detailed protocol for quantification and size determination of EVs isolated from mouse perigonadal adipose tissue and human plasma using a breakthrough technology for NTA representing major advances in the field. The results demonstrate that this method can deliver reproducible and valid total particle concentration and size distribution data for EVs isolated from different sources using different methods, as confirmed by transmission electron microscopy. The adaptation of this instrument for NTA will address the need for standardization in NTA methods to increase rigor and reproducibility in EV research.
| S-EPMC8243380 | biostudies-literature
Project description:As the physicochemical properties of drug delivery systems are governed not only by the material properties which they are compose of but by their size that they conform, it is crucial to determine the size and distribution of such systems with nanometer-scale precision. The standard technique used to measure the size distribution of nanometer-sized particles in suspension is dynamic light scattering (DLS). Recently, nanoparticle tracking analysis (NTA) has been introduced to measure the diffusion coefficient of particles in a sample to determine their size distribution in relation to DLS results. Because DLS and NTA use identical physical characteristics to determine particle size but differ in the weighting of the distribution, NTA can be a good verification tool for DLS and vice versa. In this study, we evaluated two NTA data analysis methods based on maximum-likelihood estimation, namely finite track length adjustment (FTLA) and an iterative method, on monodisperse polystyrene beads and polydisperse vesicles by comparing the results with DLS. The NTA results from both methods agreed well with the mean size and relative variance values from DLS for monodisperse polystyrene standards. However, for the lipid vesicles prepared in various polydispersity conditions, the iterative method resulted in a better match with DLS than the FTLA method. Further, it was found that it is better to compare the native number-weighted NTA distribution with DLS, rather than its converted distribution weighted by intensity, as the variance of the converted NTA distribution deviates significantly from the DLS results.
| S-EPMC6389903 | biostudies-literature