CO2 Mineralization and Utilization using Steel Slag for Establishing a Waste-to-Resource Supply Chain.
Ontology highlight
ABSTRACT:
SUBMITTER: Pan SY
PROVIDER: S-EPMC5722910 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:The volume of slags generated from the steel industry is a source of possible resources which is constantly increasing. Specifically, in the production of stainless steel, specific and singular slags with unique characteristics are obtained, which allows considering an approach aimed at their use in new recycling ways. This work shows the feasibility of using stainless steel slag as a substitute for limestone filler in the manufacture of self-compacting concrete. The influence of different treatments applied to slags on physical and chemical properties was studied. On the other hand, the mechanical behaviour, as well as the durability acquired in self-compacting concrete, has been analysed. Very encouraging results were obtained, since this research demonstrates the possible application of this stainless steel slag as a construction material, improving sustainability and promoting circular economy processes, which are achieved through the minimisation of the waste disposal and accumulation.
| S-EPMC7254312 | biostudies-literature
Project description:High-temperature molten steel slag is a large amount of industrial solid waste containing available heat energy and resources. This paper introduces an efficient and comprehensive utilization process of high-temperature molten steel slag. The waste heat energy in the high-temperature molten steel slag can be fully recovered through the three-stage heat exchange. Through mass balance and energy balance, the theoretical heat recovery rate can reach 81.42 pct when the waste heat stored in steel slag is converted into usable heat energy, and the exergy efficiency of the overall system is 27.93 pct. When the waste heat stored in the steel slag is converted for electric energy, the theoretical heat recovery rate can reach 24.49 pct, and the exergy efficiency of the overall system is 33.83 pct. When the waste heat stored in steel slag is used for cogeneration, the theoretical heat recovery rate can reach 83.98 pct, and the exergy efficiency of the overall system is 38 pct. The normal-temperature solid steel slag produced by the process is easy for iron selection and subsequent high value-added utilization. The solidification of steel slag in this process consumes a large amount of CO2 so that the free calcium oxide (f-CaO) in the steel slag is fixed, which is more conducive to subsequent utilization, thereby achieving the purpose of energy saving and emission reduction. Compared with the utilization of traditional steel slag, this process can better utilize the energy and resources contained in steel slag and provides a new method for fully utilizing the waste heat energy and resource attributes of high-temperature molten steel slag. Supplementary Information The online version of this article (10.1007/s11663-021-02213-7).
| S-EPMC8202223 | biostudies-literature
Project description:In this work, steel slag slurry was used in combination with O3 oxidation for the simultaneous removal of SO2 and NO x in a laboratory-scale wet flue gas desulfurization process. The effects of the oxidation temperature, steel slag concentration, initial SO2 concentration, and pH value on the desulfurization and denitrification efficiencies were studied. The results showed that the highest NO x removal efficiency occurred at an oxidation temperature of 90 °C. With an increase of the oxidation temperature above 90 °C, the denitrification efficiency decreased due to the decomposition of N2O5. The effect of the SO2 concentration on denitrification was complicated. When the concentration of SO2 was 500 ppm, generation of SO3 2- promoted the absorption of NO2. However, higher SO2 concentrations strengthened the competitive absorption of SO2 and NO x . In the pH range of 8.5-4.5, the denitrification efficiency was maintained at about 96%. The component analyses of the aqueous solution and the solid residue were conducted to investigate the compositions of the absorption products. The results showed that NO3 - and SO4 2- were the major anions in the aqueous solution. The nitrogen balance was analyzed to be 95.8%, clearly illustrating the migration and transformation path of nitrogen. In the solid residue, most alkaline substances were consumed, and the final products were mainly CaSO4 and FeO. Accordingly, the reaction mechanism of simultaneous desulfurization and denitrification using steel slag combined with ozone oxidation was proposed.
| S-EPMC8567348 | biostudies-literature
Project description:Carbon dioxide sequestration via carbonation of steel slags is a promising way of combining two waste products to create value. Understanding the dissolution kinetics of steel slags, which are alkaline and rich in calcium, in acidic media is essential to configure such a process. In this study, we seek to analyse the dissolution mechanism from experimental studies and develop a mathematical model considering the heterogeneous characteristics of slag. We found that the reduction in calcium extraction efficiency with an increase in particle size, which is normally associated with surface passivation or non-uniformity of samples, can be explained by considering the morphological features associated with the distribution of MgO-FeO (RO) phase in the calcium silicate matrix. We present a population balance model and show that the reduction in calcium extraction efficiency in coarse particle fractions is due to increased sporulation of the RO phase. The findings in the study suggest that the leaching of metal ions from slag is controlled by proton-promoted surface dissolution reaction, where the dependence of acid concentration follows the Langmuir-Hinshelwood adsorption isotherm. The model shows good agreement with a large set of parametric studies and demonstrates the importance of considering morphological features, as we progress towards development of a priori dissolution models for multi-mineral oxides and silicates.
| S-EPMC6501660 | biostudies-literature
Project description:Photoreduction of CO2 with sunlight to produce solar fuels, also named artificial photosynthesis, is considered one of the most attractive strategies to face the challenge of reducing greenhouse gases and achieving climate neutrality. Following an approach in line with the principles of the circular economy, the low-cost catalytic system (1) based on an industrial by-product such as steel slag was assessed, which was properly modified with nanostructured palladium on its surface in order to make it capable of promoting the conversion of CO2 into methanol and hydrogen through a two-stage process of photoreduction and thermal conversion having formic acid as the intermediate. Notably, for the first time in the literature steel slag is used as photoreduction catalyst.
| S-EPMC9256681 | biostudies-literature
Project description:The disposal of slag generated by the steel industry can have negative consequences upon the surrounding aquatic environment by the generation of high pH waters, leaching of potentially problematic trace metals, and rapid rates of calcite precipitation which smother benthic habitats. A 36-year dataset was collated from the long-term ambient monitoring of physicochemical parameters and elemental concentrations of samples from two steel slag leachate-affected watercourses in northern England. Waters were typified by elevated pH (>10), high alkalinity, and were rich in dissolved metals (e.g. calcium (Ca), aluminium (Al), and zinc (Zn)). Long-term trend analysis was performed upon pH, alkalinity, and Ca concentration which, in addition to Ca flux calculations, were used to highlight the longevity of pollution arising as a result of the dumping and subsequent leaching of steel slags. Declines in calcium and alkalinity have been modest over the monitoring period and not accompanied by significant declines in water pH. If the monotonic trends of decline in alkalinity and calcium continue in the largest of the receiving streams, it will be in the region of 50-80 years before calcite precipitation would be expected to be close to baseline levels, where ecological impacts would be negligible.
| S-EPMC4483270 | biostudies-literature
Project description:Reducing food loss and waste (FLW) is widely recognized as an important lever for lowering the environmental impacts of food systems. The United Nations Sustainable Development Agenda includes a goal to reduce FLW by 50% by 2030. Given differences in resource inputs along the food supply chain (FSC), the environmental benefits of FLW reduction will vary by stage of the FSC. Here, we identify the points along the supply chain where a 50% FLW reduction could yield the largest potential environmental benefits, assuming that decreases in consumption propagate back up the supply chain to reduce production. We use an environmentally extended input-output (EEIO) model combined with data on rates of FLW to calculate the scale of the total environmental impacts of the U.S. food system resulting from lost or wasted food. We evaluate the maximum potential environmental benefit resulting from 50% FLW reduction at all possible combinations of six supply chain stages (agricultural production, food processing, distribution/retail, restaurant foodservice, institutional foodservice, and households). We find that FLW reduction efforts should target the foodservice (restaurant) sector, food processing sector, and household consumption. Halving FLW in the foodservice sector has the highest potential to reduce greenhouse gas output and energy use. Halving FLW in the food processing sector could reduce the most land use and eutrophication potential, and reducing household consumption waste could avert the most water consumption. In contrast, FLW reduction at the retail, institutional foodservice, and farm level averts less environmental impact. Our findings may help determine optimal investment in FLW reduction strategies.
| S-EPMC7295203 | biostudies-literature
Project description:The COVID-19 crisis has notably impacted global supply chains as it has disrupted manufacturing operations. To recover from the aforementioned disruptions, supply chain digitalization [SCD] is increasingly being acknowledged to help the recovery process. Based on this, scholars have called for additional research on how SCD can enhance supply chain visibility [SCV] and boost supply chain performance [SCP] in turbulent environments. Based on 399 valid responses collected through cross-sectional method from Turkish manufacturing firms and using a non-probabilistic sampling method [i.e., purposive sampling], this research explores the effect of SCD on SCP. The mediating role of SCV and the moderating role of supply chain survivability [SCS] on the SCD-SCP relationship were also explored. The findings showed that SCD has a positive effect on SCP. SCD has a positive effect on SCV. SCV has a positive effect on SCP. The link between SCD and SCP is mediated by SCP. The results also revealed that SCS moderated the SCD-SCV link such that SCD has a stronger, positive relationship with SCV when SCS is high than when it's low. SCS moderates the SCD-SCP link, such that at low levels of SCS, the positive effect of SCD on SCP is weakened. The indirect positive effect of SCD on SCP via SCV is strongest when supply chain survivability is high. The findings suggest that SCD can improve cost-effectiveness, promote communication and information efficiency, and enhance supply chain resilience to improve performance after disruptions. This study provides insightful new implications for both supply chain literature and practitioners.
| S-EPMC10881317 | biostudies-literature
Project description:ABSTRACT Building up a lunar settlement is the ultimate aim of lunar exploitation. Yet, limited fuel and oxygen supplies restrict human survival on the Moon. Herein, we demonstrate the in situ resource utilization of lunar soil for extraterrestrial fuel and oxygen production, which may power up our solely natural satellite and supply respiratory gas. Specifically, the lunar soil is loaded with Cu species and employed for electrocatalytic CO2 conversion, demonstrating significant production of methane. In addition, the selected component in lunar soil (i.e. MgSiO3) loaded with Cu can reach a CH4 Faradaic efficiency of 72.05% with a CH4 production rate of 0.8 mL/min at 600 mA/cm2. Simultaneously, an O2 production rate of 2.3 mL/min can be achieved. Furthermore, we demonstrate that our developed process starting from catalyst preparation to electrocatalytic CO2 conversion is so accessible that it can be operated in an unmmaned manner via a robotic system. Such a highly efficient extraterrestrial fuel and oxygen production system is expected to push forward the development of mankind's civilization toward an extraterrestrial settlement. This work demonstrates the in situ resource utilization of Chang’E-5 lunar soil for electrocatalytic CO2 conversion toward fuel and oxygen production in an unmanned operation manner via the robotic system.
| S-EPMC9935986 | biostudies-literature
Project description:Metal promotion is the most widely adopted strategy for enhancing the hydrogenation functionality of an oxide catalyst. Typically, metal nanoparticles or dopants are located directly on the catalyst surface to create interfacial synergy with active sites on the oxide, but the enhancement effect may be compromised by insufficient hydrogen delivery to these sites. Here, we introduce a strategy to promote a ZnZrOx methanol synthesis catalyst by incorporating hydrogen activation and delivery functions through optimized integration of ZnZrOx and Pd supported on carbon nanotube (Pd/CNT). The CNT in the Pd/CNT + ZnZrOx system delivers hydrogen activated on Pd to a broad area on the ZnZrOx surface, with an enhancement factor of 10 compared to the conventional Pd-promoted ZnZrOx catalyst, which only transfers hydrogen to Pd-adjacent sites. In CO2 hydrogenation to methanol, Pd/CNT + ZnZrOx exhibits drastically boosted activity-the highest among reported ZnZrOx-based catalysts-and excellent stability over 600 h on stream test, showing potential for practical implementation.
| S-EPMC9925737 | biostudies-literature