Dataset Information

Evaluation of feed efficiency traits for genetic improvement in Japanese Black cattle.

ABSTRACT: We evaluated the genetic relationships (1) among feed efficiency traits with different fattening periods, (2) between feed efficiency traits and growth traits, and (3) between feed efficiency traits and carcass traits, to determine the influence of genetic factors on feed efficiency traits. In total, 4,578 Japanese Black cattle from a progeny testing program were used. Residual feed intake (RFI), residual BW gain (RG), and residual intake and BW gain (RIG) were defined as feed efficiency traits, and were measured for the first half (approximately 9 to 15 months of age), latter half (approximately 15 to 21 months of age), and total period of fattening (approximately 9 to 21 months of age). A single-trait animal model for estimating heritability and a two-trait animal model for estimating genetic and phenotypic correlations were used. The heritability estimates for RFI, RG, and RIG were different in each fattening period, ranging from 0.36 to 0.46, 0.19 to 0.28, and 0.28 to 0.34, respectively, and the heritability estimates for the total fattening period were greater than those for the first and latter halves separately. RIG showed the greatest preferred genetic correlation, with a greater feed conversion ratio than the other feed efficiency traits (ranging from -0.84 to -0.96). RG in the first and latter halves of the fattening period had different genetic correlations with the growth starting point (0.82 and -0.06, respectively) and maturity rate (0.49 and -0.51, respectively) of the Gompertz growth curve parameters, and is strongly dependent on the different fattening periods. Feed efficiency traits in different fattening periods had low genetic correlations with the carcass traits (from -0.05 to 0.19 for RFI; from 0.02 to 0.31 for RG; and from -0.11 to 0.20 for RIG). This study indicated the possibility for genetic improvement through the selection of high-RIG animals to decrease feed intake and increase BW gain without any unfavorable correlated responses affecting mature (asymptotic) weight and carcass grade.

SUBMITTER: Takeda M

PROVIDER: S-EPMC6093584 | biostudies-literature | 2018 Apr

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Evaluation of feed efficiency traits for genetic improvement in Japanese Black cattle.

Takeda Masayuki M Uemoto Yoshinobu Y Inoue Keiichi K Ogino Atsushi A Nozaki Takayoshi T Kurogi Kazuhito K Yasumori Takanori T Satoh Masahiro M

Journal of animal science 20180401 3

We evaluated the genetic relationships (1) among feed efficiency traits with different fattening periods, (2) between feed efficiency traits and growth traits, and (3) between feed efficiency traits and carcass traits, to determine the influence of genetic factors on feed efficiency traits. In total, 4,578 Japanese Black cattle from a progeny testing program were used. Residual feed intake (RFI), residual BW gain (RG), and residual intake and BW gain (RIG) were defined as feed efficiency traits, ...[more]

PMID: 29584931

Similar Datasets

Project description:This study evaluated phenotypic (rph) and genetic correlations (rg) between 8 feed efficiency traits and other traits of economic interest including weight at selection (WS), loin-eye area (LEA), backfat thickness (BF), and rump fat thickness (RF) in Nellore cattle. Feed efficiency traits were gain:feed, residual feed intake (RFI), residual feed intake adjusted for backfat thickness (RFIb) and for backfat and rump fat thickness (RFIsf), residual body weight gain (RG), residual intake and body weight gain (RIG), and residual intake and body weight gain using RFIb (RIGb) and RFIsf (RIGsf). The variance components were estimated by the restricted maximum likelihood method using a two-trait animal model. The heritability estimates (h2) were 0.14, 0.24, 0.20, 0.22, 0.19, 0.15, 0.11 and 0.11 for gain:feed, RFI, RFIb, RFIsf, RG, RIG, RIGb and RIGsf, respectively. All rph values between traits were close to zero, except for the correlation of feed efficiency traits with dry matter intake and average daily gain. High rg values were observed for the correlation of dry matter intake, average daily gain and metabolic weight with WS and hip height (>0.61) and low to medium values (0.15 to 0.48) with the carcass traits (LEA, BF, RF). Among the feed efficiency traits, RG showed the highest rg with WS and hip height (0.34 and 0.25) and the lowest rg with subcutaneous fat thickness (-0.17 to 0.18). The rg values of RFI, RFIb and RFIsf with WS (0.17, 0.23 and 0.22), BF (0.37, 0.33 and 0.33) and RF (0.30, 0.31 and 0.32) were unfavorable. The rg values of gain:feed, RIG, RIGb and RIGsf with WS were low and favorable (0.07 to 0.22), while medium and unfavorable (-0.22 to -0.45) correlations were observed with fat thickness. The inclusion of subcutaneous fat thickness in the models used to calculate RFI did not reduce the rg between these traits. Selecting animals for higher feed efficiency will result in little or no genetic change in growth and will decrease subcutaneous fat thickness in the carcass.

Project description:Enteric methane (CH4) emissions are a natural process in ruminants and can result in up to 12% of energy losses. Hence, decreasing enteric CH4 production constitutes an important step towards improving the feed efficiency of Brazilian cattle herds. The aim of this study was to evaluate the relationship between performance, residual feed intake (RFI), and enteric CH4 emission in growing Nellore cattle (Bos indicus). Performance, RFI and CH4 emission data were obtained from 489 animals participating in selection programs (mid-test age and body weight: 414±159 days and 356±135 kg, respectively) that were evaluated in 12 performance tests carried out in individual pens (n = 95) or collective paddocks (n = 394) equipped with electronic feed bunks. The sulfur hexafluoride tracer gas technique was used to measure daily CH4 emissions. The following variables were estimated: CH4 emission rate (g/day), residual methane emission and emission expressed per mid-test body weight, metabolic body weight, dry matter intake (CH4/DMI), average daily gain, and ingested gross energy (CH4/GE). Animals classified as negative RFI (RFI<0), i.e., more efficient animals, consumed less dry matter (P <0.0001) and emitted less g CH4/day (P = 0.0022) than positive RFI animals (RFI>0). Nonetheless, more efficient animals emitted more CH4/DMI and CH4/GE (P < 0.0001), suggesting that the difference in daily intake between animals is a determinant factor for the difference in daily enteric CH4 emissions. In addition, animals classified as negative RFI emitted less CH4 per kg mid-test weight and metabolic weight (P = 0.0096 and P = 0.0033, respectively), i.e., most efficient animals could emit less CH4 per kg of carcass. In conclusion, more efficient animals produced less methane when expressed as g/day and per kg mid-test weight than less efficient animals, suggesting lower emissions per kg of carcass produced. However, it is not possible to state that feed efficiency has a direct effect on enteric CH4 emissions since emissions per kg of consumed dry matter and the percentage of gross energy lost as CH4 are higher for more efficient animals.

Project description:BackgroundSingle nucleotide polymorphism (SNP) arrays for domestic cattle have catalyzed the identification of genetic markers associated with complex traits for inclusion in modern breeding and selection programs. Using actual and imputed Illumina 778K genotypes for 3887 U.S. beef cattle from 3 populations (Angus, Hereford, SimAngus), we performed genome-wide association analyses for feed efficiency and growth traits including average daily gain (ADG), dry matter intake (DMI), mid-test metabolic weight (MMWT), and residual feed intake (RFI), with marker-based heritability estimates produced for all traits and populations.ResultsModerate and/or large-effect QTL were detected for all traits in all populations, as jointly defined by the estimated proportion of variance explained (PVE) by marker effects (PVE ≥ 1.0%) and a nominal P-value threshold (P ≤ 5e-05). Lead SNPs with PVE ≥ 2.0% were considered putative evidence of large-effect QTL (n = 52), whereas those with PVE ≥ 1.0% but < 2.0% were considered putative evidence for moderate-effect QTL (n = 35). Identical or proximal lead SNPs associated with ADG, DMI, MMWT, and RFI collectively supported the potential for either pleiotropic QTL, or independent but proximal causal mutations for multiple traits within and between the analyzed populations. Marker-based heritability estimates for all investigated traits ranged from 0.18 to 0.60 using 778K genotypes, or from 0.17 to 0.57 using 50K genotypes (reduced from Illumina 778K HD to Illumina Bovine SNP50). An investigation to determine if QTL detected by 778K analysis could also be detected using 50K genotypes produced variable results, suggesting that 50K analyses were generally insufficient for QTL detection in these populations, and that relevant breeding or selection programs should be based on higher density analyses (imputed or directly ascertained).ConclusionsFourteen moderate to large-effect QTL regions which ranged from being physically proximal (lead SNPs ≤ 3Mb) to fully overlapping for RFI, DMI, ADG, and MMWT were detected within and between populations, and included evidence for pleiotropy, proximal but independent causal mutations, and multi-breed QTL. Bovine positional candidate genes for these traits were functionally conserved across vertebrate species.

Project description:The objective of this study was to identify genomic regions and metabolic pathways associated with dry matter intake, average daily gain, feed efficiency and residual feed intake in an experimental Nellore cattle population. The high-density SNP chip (Illumina High-Density Bovine BeadChip, 777k) was used to genotype the animals. The SNP markers effects and their variances were estimated using the single-step genome wide association method. The (co)variance components were estimated by Bayesian inference. The chromosome segments that are responsible for more than 1.0% of additive genetic variance were selected to explore and determine possible quantitative trait loci. The bovine genome Map Viewer was used to identify genes. In total, 51 genomic regions were identified for all analyzed traits. The heritability estimated for feed efficiency was low magnitude (0.13±0.06). For average daily gain, dry matter intake and residual feed intake, heritability was moderate to high (0.43±0.05; 0.47±0.05, 0.18±0.05, respectively). A total of 8, 17, 14 and 12 windows that are responsible for more than 1% of the additive genetic variance for dry matter intake, average daily gain, feed efficiency and residual feed intake, respectively, were identified. Candidate genes GOLIM4, RFX6, CACNG7, CACNG6, CAPN8, CAPN2, AKT2, GPRC6A, and GPR45 were associated with feed efficiency traits. It was expected that the response to selection would be higher for residual feed intake than for feed efficiency. Genomic regions harboring possible QTL for feed efficiency indicator traits were identified. Candidate genes identified are involved in energy use, metabolism protein, ion transport, transmembrane transport, the olfactory system, the immune system, secretion and cellular activity. The identification of these regions and their respective candidate genes should contribute to the formation of a genetic basis in Nellore cattle for feed efficiency indicator traits, and these results would support the selection for these traits.

Dataset Information

Evaluation of feed efficiency traits for genetic improvement in Japanese Black cattle.

Publications

Evaluation of feed efficiency traits for genetic improvement in Japanese Black cattle.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets