Hybrid Metal-Dielectric Nano-Aperture Antenna for Surface Enhanced Fluorescence.
Ontology highlight
ABSTRACT:
SUBMITTER: Lu G
PROVIDER: S-EPMC6119926 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:In this work, we designed and prepared a hierarchically assembled 3D plasmonic metal-dielectric-metal (PMDM) hybrid nano-architecture for high-performance surface-enhanced Raman scattering (SERS) sensing. The fabrication of the PMDM hybrid nanostructure was achieved by the thermal evaporation of Au film followed by thermal dewetting and the atomic layer deposition (ALD) of the Al2O3 dielectric layer, which is crucial for creating numerous nanogaps between the core Au and the out-layered Au nanoparticles (NPs). The PMDM hybrid nanostructures exhibited strong SERS signals originating from highly enhanced electromagnetic (EM) hot spots at the 3 nm Al2O3 layer serving as the nanogap spacer, as confirmed by the finite-difference time-domain (FDTD) simulation. The PMDM SERS substrate achieved an outstanding SERS performance, including a high sensitivity (enhancement factor, EF of 1.3 × 108 and low detection limit 10-11 M) and excellent reproducibility (relative standard deviation (RSD) < 7.5%) for rhodamine 6G (R6G). This study opens a promising route for constructing multilayered plasmonic structures with abundant EM hotspots for the highly sensitive, rapid, and reproducible detection of biomolecules.
| S-EPMC8838151 | biostudies-literature
Project description:We describe a hybrid metal-dielectric waveguide structures (MDWs) with numerous potential applications in the biosciences. These structures consist of a thin metal film coated with a dielectric layer. Depending on the thickness of the dielectric layer, the modes can be localized near the metal, within the dielectric, or at the top surface of the dielectric. The optical modes in a metal-dielectric waveguide can have either S (TE) or P (TM) polarization. The dielectric spacer avoids the quenching, which usually occurs for fluorophores within about 5 nm from the metal. Additionally, the resonances display a sharp angular dependence and can exhibit several hundred-fold increases in intensity (E2) at the silica-air interface relative to the incident intensity. Fluorophores placed on top of the silica layer couple efficiently with the metal, resulting in a sharp angular distribution of emission through the metal and down from the bottom of the structure. This coupling occurs over large distances to several hundred nm away from the metal and was found to be consistent with simulations of the reflectivity of the metal-dielectric waveguides. Remarkably, for some silica thicknesses, the emission is almost completely coupled through the structure with little free-space emission away from the metal-dielectric waveguide. The efficiency of fluorophore coupling is related to the quality of the resonant modes sustained by the metal-dielectric waveguide, resulting in coupling of most of the emission through the metal into the underlying glass substrates. Metal-dielectric waveguides also provide a method to resolve the emission from surface-bound fluorophores from the bulk-phase fluorophores. Metal-dielectric waveguides are simple to fabricate for large surface areas, the resonance wavelength can be adjusted by the dielectric thickness, and the silica surface is suitable for coupling to biomolecules. Metal-dielectric waveguides can have numerous applications in diagnostics and high-throughput proteomics or DNA analysis.
| S-EPMC4626214 | biostudies-literature
Project description:The development of efficient plasmonic nanostructures with controlled and reproducible surface-enhanced Raman spectroscopy (SERS) signals is an important task for the evolution of ultrasensitive sensor-related methods. One of the methods to improving the characteristics of nanostructures is the development of hybrid structures that include several types of materials. Here, we experimentally investigate ultrathin gold films (3-9 nm) near the percolation threshold on Si/Au/SiO2 and Si/Au/SiO2/graphene multilayer structures. The occurring field enhanced (FE) effects were characterized by a recording of SERS signal from Crystal Violet dye. In this geometry, the overall FE principally benefits from the combination of two mechanisms. The first one is associated with plasmon excitation in Au clusters located closest to each other. The second is due to the gap plasmons' excitation in a thin dielectric layer between the mirror and corrugated gold layers. Experimentally obtained SERS signals from sandwiched structures fabricated with Au film of 100 nm as a reflector, dielectric SiO2 spacer of 50 nm and ultrathin gold atop could reach SERS enhancements of up to around seven times relative to gold films near the percolation threshold deposited on a standard glass substrate. The close contiguity of the analyte to graphene and nanostructured Au efficiently quenches the fluorescent background of the model compound. The obtained result shows that the strategy of combining ultrathin nano-island gold films near the percolation threshold with gap plasmon resonances is promising for the design of highly efficient SERS substrates for potential applications in ultrasensitive Raman detection.
| S-EPMC8708964 | biostudies-literature
Project description:Controlling the emission properties of fluorophores is essential for improving the performance of fluorescence-based techniques in modern biochemical research, medical diagnosis, and sensing. Fluorescence emission is isotropic in nature, which makes it difficult to capture more than a small fraction of the total emission. Metal- dielectric-metal (MDM) substrates, discussed in this Letter, convert isotropic fluorescence into beaming emission normal to the substrate. This improves fluorescence collection efficiency and also opens up new avenues for a wide range of fluorescence-based applications. We suggest that MDM substrates can be readily adapted for multiple uses, such as in microarray formats, for directional fluorescence studies of multiple probes or for molecule-specific sensing with a high degree of spatial control over the fluorescence emission.SectionPhysical Processes in Nanomaterials and Nanostructures.
| S-EPMC3762509 | biostudies-literature
Project description:Metal-enhanced fluorescence of conjugated polyelectrolytes (CPs) is realized using a simple, green hybrid Ag nanocomposite film. Ag nanoparticles (Ag NPs) are pre-prepared by sodium citrate reduction and incorporated into agarose by mixing to form an Ag-containing agarose film (Ag@agarose). Through variation of the amount of Ag NPs in the Ag@agarose film as well as the thickness of the interlayer between CPs and the Ag@agarose film prepared of layer-by-layer assembly of chitosan and sodium alginate, a maximum 8.5-fold increase in the fluorescence of CPs is obtained. After introducing tyrosinase, this system also can be used to detect phenolic compounds with high sensitivity and good visualization under ultraviolet light.
| S-EPMC3957278 | biostudies-literature
Project description:We observed over 400-fold enhanced fluorescence from single Cy5 molecules assembled on multilayer silver nanoparticle-dielectric-metal (PDM) substrate. This substantial enhancement is due to the near-field enhanced excitation, emission, and interaction of Cy5 with plasmonic nanostructures. Experimental observation is supported by finite-element method calculations.
| S-EPMC4893342 | biostudies-literature
Project description:We study resonant photonic-plasmonic coupling between a gold dipole nanoantenna and a silicon nanodisc supporting electric and magnetic dipolar Mie-type resonances. Specifically, we consider two different cases for the mode structure of the silicon nanodisc, namely spectrally separate and spectrally matching electric and magnetic dipolar Mie-type resonances. In the latter case, the dielectric nanoparticle scatters the far fields of a unidirectional Huygens' source. Our results reveal an anticrossing of the plasmonic dipole resonance and the magnetic Mie-type dipole resonance of the silicon nanodisc, accompanied by a clear signature of photonic-plasmonic mode hybridization in the corresponding mode profiles. These characteristics show that strong coupling is established between the two different resonant systems in the hybrid nanostructure. Furthermore, our results demonstrate that in comparison with purely metallic or dielectric nanostructures, hybrid metal-dielectric nanoresonators offer higher flexibility in tailoring the fractions of light which are transmitted, absorbed and reflected by the nanostructure over a broad range of parameters without changing its material composition. As a special case, highly asymmetric reflection and absorption properties can be achieved.This article is part of the themed issue 'New horizons for nanophotonics'.
| S-EPMC5321834 | biostudies-literature
Project description:In this paper, a dielectric resonator antenna (DRA) with high gain and wide impedance bandwidth for fifth-generation (5G) wireless communication applications is proposed. The dielectric resonator antenna is designed to operate at higher-order TE?15x mode to achieve high antenna gain, while a hollow cylinder at the center of the DRA is introduced to improve bandwidth by reducing the quality factor. The DRA is excited by a 50? microstrip line with a narrow aperture slot. The reflection coefficient, antenna gain, and radiation pattern of the proposed DRAs are analyzed using the commercially available full-wave electromagnetic simulation tool CST Microwave Studio (CST MWS). In order to verify the simulation results, the proposed antenna structures were fabricated and experimentally validated. Measured results of the fabricated prototypes show a 10-dB return loss impedance bandwidth of 10.7% (14.3-15.9GHz) and 16.1% (14.1-16.5 GHz) for DRA1 and DRA2, respectively, at the operating frequency of 15 GHz. The results show that the designed antenna structure can be used in the Internet of things (IoT) for device-to-device (D2D) communication in 5G systems.
| S-EPMC7038332 | biostudies-literature
Project description:Dielectric nano-antennas are promising elements in nanophotonics due to their low material loss and strong leaky-mode optical resonances. In particular, light scattering can be easily manipulated using dielectric nano-antennas. To take full advantage of dielectric nano-antennas and explore their new optical applications, it is necessary to fabricate three-dimensional nano-structures under arbitrary conditions such as in non-planar substrates. Here, we demonstrate full-visible-range resonant light scattering from a single dielectric optical nano-rod antenna. The nano-rod antenna was formed by electron beam-induced deposition (EBID), a promising three-dimensional nanofabrication technique with a high spatial resolution. The nano-rods consist of amorphous alloys of C and O, with a width of 180?nm on average and a length of 4.5??m. Polarization-resolved dark-field scattering measurements show that both transverse-electric and transverse-magnetic mode resonances cover the full visible range as the height of the nano-rod antenna varies from 90 to 280?nm. Numerical simulations successfully reproduce the measured scattering features and characterize the modal properties, using the critical points dispersive dielectric constant of the EBID carbonaceous material. Our deep understanding of resonant light scattering in the EBID dielectric nano-antenna will be useful for near-field measurement or for the implementation of three-dimensional nanophotonic devices.
| S-EPMC4437380 | biostudies-literature
Project description:In this paper, a circular hybrid plasmonic waveguide-fed nano-antenna (CHPWFNA) has been introduced for operating at the standard telecommunication wavelength of 1,550 nm. For the first time, the dispersion relation of a circular hybrid plasmonic waveguide as the feed line of the proposed nano-antenna has been derived, analytically. To verify the accuracy of the analytical solution, two numerical techniques of finite element method (FEM) and finite-difference time-domain (FDTD) method have been used. Numerical results are well-matched with the theoretical ones. The characteristics of the CHPWFNA have been studied by two mentioned methods. The obtained realized gains (directivities) by the FDTD and FEM simulations are 9.03 dB (9.38 dBi) and 10.00 dB (10.32 dBi), respectively, at 1,550 nm wavelength. For on-chip point-to-point wireless link performance, the obtained quality factor by the FDTD method (FEM) is 63.97 (100). The obtained radiation characteristics and link performance reveal that at 1,550 nm, the proposed antenna has the best performance. Besides, the frequency bandwidth of the antenna (185-200 THz) covers the low-loss optical frequency range. Also, paying attention to the laser eye safety is so important. Consequently, the wavelength of 1,550 nm has been chosen as the target wavelength. Moreover, the array configuration has been studied and the directivity and realized gain have been obtained based on the array factor theory and numerical methods, which are agree with each other. The attained realized gain by the FDTD method (FEM) for the considered single row array, at 1,550 nm, is 11.20 dB (11.30 dB). There is a little difference between the numerical results due to the total mesh size, the grid size refinement and the relative error of the numerical methods convergence. Finally, as one of the most important challenges in fabrication is the gold surface quality, we have studied the effect of gold surface roughness and its pentagonal cross section on the antenna performance.
| S-EPMC7493997 | biostudies-literature