Dataset Information

Surface Chemistry of Electronic Cigarette Electrical Heating Coils: Effects of Metal Type on Propylene Glycol Thermal Decomposition.

ABSTRACT: Introduction:Carbonyls, a class of compounds strongly linked to pulmonary disease in smokers, are probably the most reported non-nicotine toxicants found aerosols. Reported emissions vary from negligible quantities to those far exceeding combustible cigarettes. Observations of high emissions are commonly attributed to "dry puffing", whereby the ECIG heating filament runs dry of liquid and reaches temperatures that induce thermal degradation of the ECIG vapor components at the filament's metal surface. Using a pyrolysis flow reactor, in this study we examined the potential role of surface chemistry in the formation of carbonyl compounds in ECIGs, and whether the different commercially available filament materials could potentially impact their toxicant emissions through catalysis. This information could inform nascent efforts to regulate the design of ECIGs for public health ends. Methods:Nitrogen or air saturated with propylene glycol vapor was drawn through a temperature and residence time controlled tubular quartz pyrolysis flow reactor in which nichrome, Kanthal, or stainless steel ECIG heating filament wires were inserted. A control condition with no inserted wire was also included. Concentrations of carbonyl products at the reactor outlet were measured as a function of temperature, heating filament wire material, and carrier gas composition (N2 vs air). Carbonyls were sampled using DNPH cartridges and analyzed by HPLC. Results:ECIG heating filament wires were found to have a strong catalytic effect. Carbonyl formation initiated at temperatures lower than 250°C in the presence of the metallic wires, compared to 460°C without them. Carbonyl formation was found to be a function of the material of construction, and whether the wire was new or aged. New nichrome wires were the least reactive, but when aged they exhibited the highest reactivity. Carbonyls were formed via dehydration or oxidation reactions of PG. Conclusions:Carbonyl formation chemistry is catalyzed by commonly used ECIG heating filament materials, at temperatures that are well below those expected during "dry puffing". The variability in the distribution and yield of carbonyl compounds across ECIG filament materials suggests that this heretofore unaccounted variable may partially explain the wide ranges reported in the literature to date. More importantly, it suggests that ECIG construction materials may be an important variable for regulations designed to protect public health.

SUBMITTER: Saliba NA

PROVIDER: S-EPMC6428435 | biostudies-literature | 2018 Sep

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Surface Chemistry of Electronic Cigarette Electrical Heating Coils: Effects of Metal Type on Propylene Glycol Thermal Decomposition.

Saliba Najat A NA El Hellani Ahmad A Honein Edward E Salman Rola R Talih Soha S Zeaiter Joseph J Shihadeh Alan A

Journal of analytical and applied pyrolysis 20180726

<h4>Introduction</h4>Carbonyls, a class of compounds strongly linked to pulmonary disease in smokers, are probably the most reported non-nicotine toxicants found aerosols. Reported emissions vary from negligible quantities to those far exceeding combustible cigarettes. Observations of high emissions are commonly attributed to "dry puffing", whereby the ECIG heating filament runs dry of liquid and reaches temperatures that induce thermal degradation of the ECIG vapor components at the filament's ...[more]

PMID: 30906089

Similar Datasets

Project description:Introduction"Vaping" electronic cigarettes (e-cigarettes) is increasingly popular with youth, driven by the wide range of available flavors, often created using flavor aldehydes. The objective of this study was to examine whether flavor aldehydes remain stable in e-cigarette liquids or whether they undergo chemical reactions, forming novel chemical species that may cause harm to the user.MethodsGas chromatography was used to determine concentrations of flavor aldehydes and reaction products in e-liquids and vapor generated from a commercial e-cigarette. Stability of the detected reaction products in aqueous media was monitored by ultraviolet spectroscopy and nuclear magnetic resonance spectroscopy, and their effects on irritant receptors determined by fluorescent calcium imaging in HEK-293T cells.ResultsFlavor aldehydes including benzaldehyde, cinnamaldehyde, citral, ethylvanillin, and vanillin rapidly reacted with the e-liquid solvent propylene glycol (PG) after mixing, and upward of 40% of flavor aldehyde content was converted to flavor aldehyde PG acetals, which were also detected in commercial e-liquids. Vaping experiments showed carryover rates of 50%-80% of acetals to e-cigarette vapor. Acetals remained stable in physiological aqueous solution, with half-lives above 36 hours, suggesting they persist when inhaled by the user. Acetals activated aldehyde-sensitive TRPA1 irritant receptors and aldehyde-insensitive TRPV1 irritant receptors.ConclusionsE-liquids are potentially reactive chemical systems in which new compounds can form after mixing of constituents and during storage, as demonstrated here for flavor aldehyde PG acetals, with unexpected toxicological effects. For regulatory purposes, a rigorous process is advised to monitor the potentially changing composition of e-liquids and e-vapors over time, to identify possible health hazards.ImplicationsThis study demonstrates that e-cigarette liquids can be chemically unstable, with reactions occurring between flavorant and solvent components immediately after mixing at room temperature. The resulting compounds have toxicological properties that differ from either the flavorants or solvent components. These findings suggest that the reporting of manufacturing ingredients of e-liquids is insufficient for a safety assessment. The establishment of an analytical workflow to detect newly formed compounds in e-liquids and their potential toxicological effects is imperative for regulatory risk analysis.

Project description:The terpolymerization of carbon dioxide (CO?), propylene oxide (PO), and cyclohexene oxide (CHO) were performed by both random polymerization and block polymerization to synthesize the random poly (propylene cyclohexene carbonate) (PPCHC), di-block polymers of poly (propylene carbonate?cyclohexyl carbonate) (PPC-PCHC), and tri-block polymers of poly (cyclohexyl carbonate?propylene carbonate?cyclohexyl carbonate) (PCHC-PPC-PCHC). The kinetics of the thermal degradation of the terpolymers was investigated by the multiple heating rate method (Kissinger-Akahira-Sunose (KAS) method), the single heating rate method (Coats-Redfern method), and the Isoconversional kinetic analysis method proposed by Vyazovkin with the data from thermogravimetric analysis under dynamic conditions. The values of ln k vs. T-1 for the thermal decomposition of four polymers demonstrate the thermal stability of PPC and PPC-PCHC are poorer than PPCHC and PCHC-PPC-PCHC. In addition, for PPCHC and PCHC-PPC-PCHC, there is an intersection between the two rate constant lines, which means that, for thermal stability of PPCHC, it is more stable than PCHC-PPC-PCHC at the temperature less than 309 °C and less stable when the decomposed temperature is more than 309 °C. Pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS) and thermogravimetric analysis/infrared spectrometry (TG/FTIR) techniques were applied to investigate the thermal degradation behavior of the polymers. The results showed that unzipping was the main degradation mechanism of all polymers so the final pyrolysates were cyclic propylene carbonate and cyclic cyclohexene carbonate. For the block copolymers, the main chain scission reaction first occurs at PC-PC linkages initiating an unzipping reaction of PPC chain and then, at CHC?CHC linkages, initiating an unzipping reaction of the PCHC chain. That is why the T-5% of di-block and tri-block polymers were not much higher than that of PPC while two maximum decomposition temperatures were observed for both the block copolymer and the second one were much higher than that of PPC. For PPCHC, the random arranged bulky cyclohexane groups in the polymer chain can effectively suppress the backbiting process and retard the unzipping reaction. Thus, it exhibited much higher T-5% than that of PPC and block copolymers.

Project description:The main constituents of electronic cigarette liquids are nicotine, propylene glycol (PG), and vegetable glycerin (VG), together with distilled water and flavors. To assess the toxicity of PG/VG mixtures with and without nicotine as basic components of liquids used in e-cigarettes, a 90-day rat inhalation study according to the Organization for Economic Co-operation and Development test guideline 413 was conducted. Sprague-Dawley (SD) rats were nose-only exposed, 6?h/day, 5 days/week to filtered air, or nebulized vehicle (saline), or three concentrations of PG/VG (0.174 mg PG/l + 0.210 mg VG/l; 0.520 mg PG/l + 0.630 mg VG/l; 1.520 mg PG/l + 1.890 mg VG/l) ï¿½ with (test item) and without (reference item) 23 ï¿½g nicotine/L. Standard toxicological endpoints were complemented by molecular analyses using transcriptomics, proteomics, and lipidomics. Compared to vehicle exposure, the tested PG/VG aerosols showed only very limited biological effects with no signs of toxicity, both for the standard toxicological endpoints (e.g., histopathology, clinical chemistry) and the systems toxicological analyses (transcriptomics, proteomics, and lipidomics). The addition of nicotine to the PG/VG aerosols (23 ï¿½g/l) resulted in effects in line with nicotine effects in previous studies. These included up-regulation of xenobiotic enzymes (Cyp1a1 and Fmo3) in the lung and metabolic effects, e.g., reduction in serum lipid concentrations and changes in the expression of metabolic enzymes in the liver. Signs of a generalized stress response to nicotine exposure such as decreased thymus weights were observed; and likely, a subset of the observed metabolic alterations was interlinked with this generalized stress response. Under the conditions of this 90-day SD rat inhalation study, no toxicologically relevant effects of PG/VG aerosols (up to 1.520 mg PG/l + 1.890 mg VG/l) were observed, and the no observed adverse effect level (NOAEL) for PG/VG/nicotine was determined to be 438/544/6.7 mg/kg/day. Further the study demonstrated how complementary systems toxicology analyses can reveal, also in the absence of observable adverse effects, subtoxic and adaptive responses to pharmacologically active compounds such as nicotine.

Project description:The main constituents of electronic cigarette liquids are nicotine, propylene glycol (PG), and vegetable glycerin (VG), together with distilled water and flavors. To assess the toxicity of PG/VG mixtures with and without nicotine as basic components of liquids used in e-cigarettes, a 90-day rat inhalation study according to the Organization for Economic Co-operation and Development test guideline 413 was conducted. Sprague-Dawley (SD) rats were nose-only exposed, 6â€‰h/day, 5 days/week to filtered air, or nebulized vehicle (saline), or three concentrations of PG/VG (0.174 mg PG/l + 0.210 mg VG/l; 0.520 mg PG/l + 0.630 mg VG/l; 1.520 mg PG/l + 1.890 mg VG/l) with (test item) and without (reference item) 23 µg nicotine/L. Standard toxicological endpoints were complemented by molecular analyses using transcriptomics, proteomics, and lipidomics. Compared to vehicle exposure, the tested PG/VG aerosols showed only very limited biological effects with no signs of toxicity, both for the standard toxicological endpoints (e.g., histopathology, clinical chemistry) and the systems toxicological analyses (transcriptomics, proteomics, and lipidomics). The addition of nicotine to the PG/VG aerosols (23 Âµg/l) resulted in effects in line with nicotine effects in previous studies. These included up-regulation of xenobiotic enzymes (Cyp1a1 and Fmo3) in the lung and metabolic effects, e.g., reduction in serum lipid concentrations and changes in the expression of metabolic enzymes in the liver. Signs of a generalized stress response to nicotine exposure such as decreased thymus weights were observed; and likely, a subset of the observed metabolic alterations was interlinked with this generalized stress response. Under the conditions of this 90-day SD rat inhalation study, no toxicologically relevant effects of PG/VG aerosols (up to 1.520 mg PG/l + 1.890 mg VG/l) were observed, and the no observed adverse effect level (NOAEL) for PG/VG/nicotine was determined to be 438/544/6.7 mg/kg/day. Further the study demonstrated how complementary systems toxicology analyses can reveal, also in the absence of observable adverse effects, subtoxic and adaptive responses to pharmacologically active compounds such as nicotine.

Dataset Information

Surface Chemistry of Electronic Cigarette Electrical Heating Coils: Effects of Metal Type on Propylene Glycol Thermal Decomposition.

Publications

Surface Chemistry of Electronic Cigarette Electrical Heating Coils: Effects of Metal Type on Propylene Glycol Thermal Decomposition.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets