Dataset Information

Treatment of distal clavicle fractures using a Scorpion plate and influence of timing on surgical outcomes: a retrospective cohort study of 105 cases.

ABSTRACT:

Background

Plate fixation is an established method for treating unstable distal clavicle fractures. However, the appropriate timing of surgery for acute distal clavicle fractures remains unclear. The present study aimed to evaluate the clinical outcomes of osteosynthesis using a Scorpion plate and to assess the influence of surgery timing on the surgical outcomes for acute unstable distal clavicle fractures.

Methods

We retrospectively reviewed 105 patients who underwent fixation for acute unstable distal clavicle fractures (Neer type II and V) using the Scorpion plate between 2008 and 2018. Patients were divided into early (45 patients) and delayed (60 patients) treatment groups based on the timing of the surgical intervention (within or after 7 days). The outcomes were postoperative complications (nonunion, peri-implant fracture, plate loosening, plate-related pain, and stiffness). We evaluated the outcomes from X-ray radiographs and clinical notes.

Results

Among the 105 patients, nonunion, plate loosening, plate-related pain, and stiffness were observed in six patients (5.7%), four patients (3.8%), seven patients (6.7%), and one patient (1.0%), respectively. The nonunion rate was significantly higher in the delayed treatment group than that in the early treatment group (P?=?0.036). Although the difference was not significant, plate loosening and stiffness were only observed in the delayed treatment group.

Conclusion

Our results demonstrated that osteosynthesis using Scorpion plates achieved satisfactory surgical outcomes for unstable distal clavicle fractures. In addition, this study suggested that performing surgery within 6 days after injury is recommended to reduce postoperative complications.

SUBMITTER: Furuhata R

PROVIDER: S-EPMC7057610 | biostudies-literature | 2020 Mar

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Treatment of distal clavicle fractures using a Scorpion plate and influence of timing on surgical outcomes: a retrospective cohort study of 105 cases.

Furuhata Ryogo R Takahashi Masaaki M Hayashi Teppei T Inagawa Miyu M Kono Aki A Matsumura Noboru N Kamata Yusaku Y Arino Hiroshi H Morioka Hideo H

BMC musculoskeletal disorders 20200304 1

<h4>Background</h4>Plate fixation is an established method for treating unstable distal clavicle fractures. However, the appropriate timing of surgery for acute distal clavicle fractures remains unclear. The present study aimed to evaluate the clinical outcomes of osteosynthesis using a Scorpion plate and to assess the influence of surgery timing on the surgical outcomes for acute unstable distal clavicle fractures.<h4>Methods</h4>We retrospectively reviewed 105 patients who underwent fixation f ...[more]

PMID: 32131803

Similar Datasets

Project description:To assess the clinical and anatomical causes of cutaneous paresthesia after internal fixation of clavicle fractures.This study included 135 patients who underwent internal fixation of clavicle fractures from May 2013 to June 2016 at the First and Second Affiliated Hospital of Guangxi Medical University. The incidence of postoperative supraclavicular nerve injury, the duration of numbness, and improvements after plate removal were retrospectively analyzed. Seven human cadaver specimens were subsequently dissected to analyze the supraclavicular nerve and its relationship to numbness.Of the 135 patients who underwent internal fixation of clavicle fractures, 26 (19.3%) experienced postoperative cutaneous paresthesia, with 22 (16.3%) and 4 (2.8%) experiencing numbness and pain, respectively. The most intense numbness occurred during the first operative month. Of the 22 patients with numbness, 1 (4.5%), 1 (4.5%), and 20 (90.1%) patients reported mild, moderate, and severe numbness, respectively. Two patients described increased awareness of numbness when in contact with clothes, 2 were psychologically affected by numbness, and 20 (90.1%) reported reduced severity of numbness over time. At the last follow-up, numbness was found to persist in 2 (1.5%) patients. None of the patients was bothered by numbness. Cadaver dissection showed that the supraclavicular nerve emerged from the 1/2 posterior edge of the cervical sternocleidomastoid muscle and subsequently divided into 3 branches, with the lateral branch 2.26 ± 1.17 cm from the lateral margin of the acromion, the middle branch near the mid-clavicle, and the medial branch 2.03 ± 0.85 cm from the sternal lateral margin.Cutaneous paresthesia is common following internal fixation of the clavicle. Anatomic analysis showed that the nerve could be easily injured during clavicle operation. Numbness improved in most patients, but persisted for up to 2 years and was even permanent in a few. Most patients considered numbness as an insignificant factor in their daily lives.

Project description:BackgroundMany surgical treatment methods exist for clavicle shaft fractures. A locking compression plate (LCP) fixation with three screws per fracture side is commonly used. For certain fractures a stabilization with 2 screws per side is potentially suitable, offering the advantage of reduced soft tissue approach, while avoiding the disadvantages of minimally-invasive nailing at the same time. This hypothesis was evaluated biomechanically and clinically.MethodsFour treatment procedures were investigated biomechanically using composite human clavicle specimens. A load-to-failure test was performed using a three-point cantilever test. In group 1, a simple shaft fracture was simulated and stabilized with 2 screws per fracture side (5-hole LCP). In the second group 3 screws per side (7-hole LCP) were used. In group 3, a non-reduced fracture zone was simulated and treated with 3 screws per side (7-hole LCP). In group 4, an anatomically reduced fracture zone was simulated and treated with 3 screws per side (7-hole LCP). Furthermore 27 patients treated with a short plate and 2 screws per side (similar to group 1) were assessed after a minimum follow-up of 12 months (Constant and DASH Score).ResultsThe maximum load-to-failure of group 1 was 367N. We observed the highest load-to-failure in group 2 with 497N and the lowest in group 3 with 90N. In group 4 a maximum load-to-failure of 298N could be evaluated. There was no significant difference in load-to-failure between the treatment of a simple clavicle fracture using 5- or 7-hole LCP (p = 0.121). However, we found a significant difference of load-to-failure between the simple and anatomically reduced fracture using a 7-hole plate (p = 0.014). The mean constant score of the surgically treated patients was 95 and the DASH score 3.0. Fracture consolidation was observed in 96.3%.ConclusionsFor certain non-fragmented and well interlocking 2-part fractures, a plate osteosynthesis fixed with only 2 screws per fracture side might offer sufficient biomechanical stability, better soft tissue preservation and comparable fusion rates compared to the operative treatment with 3 screws per side. However, the maximum load-to-failure of the 7-hole LCP was higher than of the 5-hole LCP, but this difference was not statistically significant.Trial registrationApproval from the ethics committee of the Technical University of Dresden was retrospectively obtained (EK 588122019).

Dataset Information

Treatment of distal clavicle fractures using a Scorpion plate and influence of timing on surgical outcomes: a retrospective cohort study of 105 cases.

Background

Methods

Results

Conclusion

Publications

Treatment of distal clavicle fractures using a Scorpion plate and influence of timing on surgical outcomes: a retrospective cohort study of 105 cases.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets