Dataset Information

Modeling High-Pressure Methane Adsorption on Shales with a Simplified Local Density Model.

ABSTRACT: Shale gas has attracted increasing attention as a potential alternative gas in recent years. Because a large fraction of gas in shale formation is in an adsorbed state, knowledge of the supercritical methane adsorption behavior on shales is fundamental for gas-in-place predictions and optimum gas recovery. A practical model with rigorous physical significance is necessary to describe the methane adsorption behavior at high pressures and high temperatures on shales. In this study, methane adsorption experiments were carried out on three Lower Silurian Longmaxi shale samples from the Sichuan Basin, South China, at pressures of up to 30 MPa and temperatures of 40, 60, 80, and 100 °C. The simplified local density/Elliott-Suresh-Donohue model was adopted to fit the experimental data in this study and the published methane adsorption data. The results demonstrate that this model is suitable to represent the adsorption data from the experiments and literature for a wide range of temperatures and pressures, and the average absolute deviation is within 10%. The methane adsorption capacity of the Longmaxi shale exhibited a strong linear positive correlation with the total organic carbon content and a linear negative correlation with increasing temperature. The rate of decrease in the methane adsorption capacity with swing temperature increased with the total organic carbon content, indicating that the organic matter is sensitive to temperature.

SUBMITTER: Hu K

PROVIDER: S-EPMC7081435 | biostudies-literature | 2020 Mar

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Modeling High-Pressure Methane Adsorption on Shales with a Simplified Local Density Model.

Hu Ke K Mischo Helmut H

ACS omega 20200302 10

Shale gas has attracted increasing attention as a potential alternative gas in recent years. Because a large fraction of gas in shale formation is in an adsorbed state, knowledge of the supercritical methane adsorption behavior on shales is fundamental for gas-in-place predictions and optimum gas recovery. A practical model with rigorous physical significance is necessary to describe the methane adsorption behavior at high pressures and high temperatures on shales. In this study, methane adsorpt ...[more]

PMID: 32201791

Similar Datasets

Project description:The presence of kerogen in source rocks gives rise to a plethora of potential gas storage mechanisms. Proper estimation of the gas reserve requires knowledge of the quantities of free and adsorbed gas in rock pores and kerogen. Traditional methods of reserve estimation such as the volumetric and material balance approaches are insufficient because they do not consider both the free and adsorbed gas compartments present in kerogens. Modified versions of these equations are based on adding terms to account for hydrocarbons stored in kerogen. None of the existing models considered the effect of kerogen maturing on methane gas adsorption. In this work, a molecular modeling was employed to explore how thermal maturity impacts gas adsorption in kerogen. Four different macromolecules of kerogen were included to mimic kerogens of different maturity levels; these were folded to more closely resemble the nanoporous kerogen structures of source rocks. These structures form the basis of the modeling necessary to assess the adsorption capacity as a function of the structure. The number of double bonds plus the number and type of heteroatoms (O, S, and N) were found to influence the final configuration of the kerogen structures, and hence their capacity to host methane molecules. The degree of aromaticity increased with the maturity level within the same kerogen type. The fraction of aromaticity gives rise to the polarity. We present an empirical mathematical relationship that makes possible the estimation of the adsorption capacity of kerogen based on the degree of polarity. Variations in kerogen adsorption capacity have significant implications on the reservoir scale. The general trend obtained from the molecular modeling was found to be consistent with experimental measurements done on actual kerogen samples. Shale samples with different kerogen content and with different maturity showed that shales with immature kerogen have small methane adsorption capacity compared to shales with mature kerogen. In this study, it is shown for the first time that the key factor to control natural gas adsorption is the kerogen maturity not the kerogen content.

Project description:With the increase in high gas mines in the low coal rank mining area in the northwestern part of China, high gas mines in the low-rank coal mining area have caused many gas emission accidents. Coal is a porous material, containing a large number of micropores (<2 nm), which can absorb large amounts of methane, so it is necessary to explore methane adsorption in micropores of low-rank coal. In this work, FTIR, HRTEM, and 13C-NMR were used to test the macromolecular structural parameters of Buertai coal, which was a kind of low-rank Jurassic coal in northwestern China. The results showed that the aromatic structural units in the Buertai coal structure mainly consist of naphthalene, anthracene, and phenanthrene. The fat structure mainly occurs in the form of aliphatic side chains, cycloalkanes, and other compounds. The oxygen atoms are present in the form of carbonyl groups, ether bonds, and phenol groups with a ratio of about 6:4:9. The nitrogen atoms are present in the form of pyrrole and pyridine compounds. Finally, the macromolecular structure model of Buertai coal was built, and the calculated NMR spectrum from the model was very consistent with the experimental NMR spectrum of Buertai coal. The relationship between the macromolecular density and energy of Buertai coal was explored using the Amorphous Cell module in the simulation software, Materials Studios 8.0 (MS 8.0), and the density value at the lowest energy was determined to be about 1.23 g/cm3. The pore structure parameters of Buertai coal were also calculated. It was found that both pore volume and void fraction decreased evenly as the diameter of the probe molecule increased, but the surface area decreased rapidly when the diameter of the probe molecule was 3.46 Å. All pore sizes were found to be smaller than 10 Å from the pore size distribution (PSD) curve of Buertai coal, which provided a lot of adsorption sites for methane (CH4). The results of the CH4 adsorption simulation from Grand Canonical Monte Carlo (GCMC) showed that CH4 is adsorbed inside the micropores of coal, and the adsorption capacity of CH4 depends on the diameters of micropores when the micropores are less than 8.5 Å. There are many micropores where CH4 did not appear because these micropores are closed and did not provide a channel for CH4 to enter. The results of experimental methane adsorption indicate that the excess adsorption capacity from the GCMC simulation was very close to the experimental results of Buertai coal. This work provides a new perspective to study the methane adsorption behavior in micropores of coal.

Dataset Information

Modeling High-Pressure Methane Adsorption on Shales with a Simplified Local Density Model.

Publications

Modeling High-Pressure Methane Adsorption on Shales with a Simplified Local Density Model.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets