Dataset Information

Validation of a Device to Measure Knee Joint Angles for a Dynamic Movement.

ABSTRACT: Participation in sports has risen in the United States over the last few years, increasing the risk of injuries such as tears to the anterior cruciate ligament (ACL) in the knee. Previous studies have shown a correlation between knee kinematics when landing from a jump and this injury. The purpose of this study was to validate the ability of a commercially available inertial measurement units (IMUs) to accurately measure knee joint angles during a dynamic movement. Eight healthy subjects participated in the study. Validation was performed by comparing the angles measured by the wearable device to those obtained through the gold standard motion capture system when landing from a jump. Root mean square, linear regression analysis, and Bland-Altman plots were performed/constructed. The mean difference between the wearable device and the motion capture data was 8.4° (flexion/extension), 4.9° (ab/adduction), and 3.9° (rotation). In addition, the device was more accurate at smaller knee angles. In our study, a commercially available wearable IMU was able to perform fairly well under certain conditions and was less accurate in other conditions.

SUBMITTER: Ajdaroski M

PROVIDER: S-EPMC7147162 | biostudies-literature | 2020 Mar

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Validation of a Device to Measure Knee Joint Angles for a Dynamic Movement.

Ajdaroski Mirel M Tadakala Ruchika R Nichols Lorraine L Esquivel Amanda A

Sensors (Basel, Switzerland) 20200321 6

Participation in sports has risen in the United States over the last few years, increasing the risk of injuries such as tears to the anterior cruciate ligament (ACL) in the knee. Previous studies have shown a correlation between knee kinematics when landing from a jump and this injury. The purpose of this study was to validate the ability of a commercially available inertial measurement units (IMUs) to accurately measure knee joint angles during a dynamic movement. Eight healthy subjects partici ...[more]

PMID: 32245187

Similar Datasets

Project description:Neuromuscular electrical stimulation (NMES) has been used to increase muscle strength and physical function. However, NMES induces rapid fatigue, limiting its application. To date, the effect of quadriceps femoris (QF) muscle length by knee and hip joint manipulation on NMES-induced contraction fatigability is not clear. We aimed to quantify the effects of different muscle lengths on NMES-induced contraction fatigability, fatigue index, and electromyographic (EMG) activity for QF muscle. QF maximum evoked contraction (QMEC) was applied in a 26 min protocol (10 s on; 120 s off; 12 contractions) in 20 healthy participants (24.0 ± 4.6 years old), over 4 sessions on different days to test different conditions. The tested conditions were as follows: supine with knee flexion of 60° (SUP60), seated with knee flexion of 60° (SIT60), supine with knee flexion of 20° (SUP20), and seated with knee flexion of 20° (SIT20). Contraction fatigability (torque decline assessed by maximal voluntary contraction [MVC] and during NMES), fatigue index (percentage reduction in MVC), and EMG activity (root mean square [RMS] and median frequency) of the superficial QF' constituents were assessed. After NMES, all positions except SUP20 had an absolute reduction in MVC (p < .001). Fatigue index was greater in SIT20 than in SIT60 (p < .001) and SUP20 (p = .01). There was significant torque reduction across the 12 QMEC in SUP60 and SIT60, up to 10.5% (p < .001-.005) and 9.49% (p < .001-.033), respectively. There was no torque reduction during NMES in SUP20 and SIT20. Fatigue was accompanied by an increase in RMS (p = .032) and a decrease in median frequency for SUP60 (p < .001). Median frequency increased only in the SUP20 condition (p = .021). We concluded that QF NMES-induced contraction fatigability is greater when the knee is flexed at 60° compared to 20°. In addition, a supine position promotes earlier fatigue for a 60° knee flexion, but it delays fatigue onset for a 20° knee flexion compared to the seated position. These results provide a rationale for lower limb positioning during NMES, which depends on training objectives, e.g., strengthening or task-specific functionality training.

Dataset Information

Validation of a Device to Measure Knee Joint Angles for a Dynamic Movement.

Publications

Validation of a Device to Measure Knee Joint Angles for a Dynamic Movement.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets