Pentiptycene Polymer/Single-Walled Carbon Nanotube Complexes: Applications in Benzene, Toluene, and o-Xylene Detection.
Ontology highlight
ABSTRACT:
SUBMITTER: Luo SL
PROVIDER: S-EPMC7370303 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:UnlabelledAlthough organic-based direct conversion X-ray detectors have been developed, their photocurrent generation efficiency has been limited by recombination of excitons due to the intrinsically poor electrical properties of organic materials. In this report, we fabricated a polymer-based flexible X-ray detector and enhanced the X-ray detection sensitivity using a single-walled carbon nanotube (SWNT) enriched polymer composite. When this SWNT enriched polymer composite was used as the active layer of an X-ray detector, it efficiently separated charges at the interface between the SWNTs and polymer, preventing recombination of X-ray-induced excitons. This increased the photocurrent generation efficiency, as measured from current-voltage characteristics. Therefore, X-ray-induced photocurrent and X-ray detection sensitivity were enhanced as the concentration of SWNTs in the composite was increased. However, this benefit was counterbalanced by the slow and unstable time-dependent response at high SWNT concentrations, arising from reduced Schottky barrier heights between the active layer and electrodes. At high SWNT concentration, the dark current also increased due to the reduced Schottky barrier height, leading to decrease the signal-to-noise ratio (SNR) of the device. Experimental results indicated that 0.005 wt.% SWNT in the composite was the optimum composition for practical X-ray detector operation because it showed enhanced performance in both sensitivity and SNR. In mechanical flexibility tests, the device exhibited a stable response up to a bending radius of 0.5 cm, and the device had no noticeable change in diode current after 1,000 bending cycles.Pacs code8.67.Sc.
| S-EPMC4493992 | biostudies-literature
Project description:This study utilized the Community Multiscale Air Quality model to simulate the spatial distribution of benzene, toluene, and xylene (BTX) concentrations from large national industrial complexes (IC) located in the Ulsan metropolitan region (UMR). Through controlling pollutant emissions from major IC, this study performed a quantitative analysis of the influence of pollutant emissions on BTX concentrations in surrounding urban areas. The results showed that approximately 40% of the annual average BTX concentrations in nearby urban grids were directly influenced by pollutant emissions from the IC. Seasonal modeling results indicated that average BTX concentrations were high around petrochemical complexes, with higher concentrations in the surrounding urban areas during the summer (July). All three of the BTX pollutants showed similar seasonal differences. Daily contributions differed significantly throughout the modeling period, with some values reaching a maximum of 80% during July. Overall, when urban areas were located downwind of the IC, contributions rose. Moreover, this study compared the differences in BTX contributions at each measurement point within the IC and urban areas, which showed that the influence of the IC emissions decreased significantly with distance. The spatial distribution and direct influence of the IC on BTX concentrations in the UMR identified through this study could be used to provide input data in environmental epidemiological studies.
| S-EPMC5825684 | biostudies-literature
Project description:The petrochemical industry can reduce its environmental impacts by moving from fossil resources to alternative carbon feedstocks. Biomass and plastic waste-based production pathways have recently been developed for benzene, toluene, and xylene (BTX). This study evaluates the environmental impacts of these novel BTX pathways at a commercial and future (2050) scale, combining traditional life cycle assessment with absolute environmental sustainability assessment using the planetary boundary concept. We show that plastic waste-based BTX has lower environmental impacts than fossil BTX, including a 12% decrease in greenhouse gas (GHG) emissions. Biomass-based BTX shows greater GHG emission reductions (42%), but it causes increased freshwater consumption and eutrophication. Toward 2050, GHG emission reductions become 75 and 107% for plastic waste and biobased production, respectively, compared to current fossil-BTX production. When comparing alternative uses of plastic waste, BTX production has larger climate benefits than waste incineration with energy recovery with a GHG benefit of 1.1 kg CO2-equiv/kg plastic waste. For biomass (glycerol)-based BTX production, other uses of glycerol are favorable over BTX production. While alternative BTX production pathways can decrease environmental impacts, they still transgress multiple planetary boundaries. Further impact reduction efforts are thus required, such as using other types of (waste) biomass, increasing carbon recycling, and abatement of end-of-life emissions.
| S-EPMC10988839 | biostudies-literature
Project description:There is a current interest in reducing the in vivo toxicity testing of nanomaterials in animals by increasing toxicity testing using in vitro cellular assays; however, toxicological results are seldom concordant between in vivo and in vitro models. This study compared global multi-walled carbon nanotube (MWCNT)-induced gene expression from human lung epithelial and microvascular endothelial cells in monoculture and coculture with gene expression from mouse lungs exposed to MWCNT. Using a cutoff of 10% false discovery rate and 1.5 fold change, we determined that there were more concordant genes (gene expression both up- or downregulated in vivo and in vitro) expressed in both cell types in coculture than in monoculture. When reduced to only those genes involved in inflammation and fibrosis, known outcomes of in vivo MWCNT exposure, there were more disease-related concordant genes expressed in coculture than monoculture. Additionally, different cellular signaling pathways are activated in response to MWCNT dependent upon culturing conditions. As coculture gene expression better correlated with in vivo gene expression, we suggest that cellular cocultures may offer enhanced in vitro models for nanoparticle risk assessment and the reduction of in vivo toxicological testing.
2019-04-12 | GSE129640 | GEO
Project description:The current delivery size of transcatheter aortic valves, limited by the thickness of their pericardial leaflets, correlates with a high prevalence of major vascular complications. Polyurethane valves can be developed to a fraction of the thickness of pericardial valves through the addition of carbon nanotubes to reinforce their leaflets. This study investigates the suitability of a novel carbon nanotube reinforced leaflet to reduce the delivery profile of transcatheter aortic valves. Carbon nanotube polyurethane composites were developed with thicknesses of 50 μm and their mechanical properties were determined in relation to various environmental effects. The composites demonstrated improvements to the material stiffness, particularly at increasing strain rates compared to the neat polymer. However, increasing nanotube concentrations significantly decreased the fatigue life of the composites. Key findings highlighted a potential for carbon nanotube reinforcement in valve replacement which experience very high strain rates during the cardiac cycle. Further testing is needed to achieve a strong nanotube-matrix interface which will prolong the cyclic fatigue life and further strengthen tensile properties. Testing on the durability and haemocompatibility of these composite heart valves are ongoing.
| S-EPMC5573758 | biostudies-literature
Project description:Carbon nanotubes were among the earliest products of nanotechnology and have many potential applications in medicine, electronics, and manufacturing. The low density, small size, and biological persistence of carbon nanotubes create challenges for exposure control and monitoring and make respiratory exposures to workers likely. We have previously shown mitotic spindle aberrations in cultured primary and immortalized human airway epithelial cells exposed to 24, 48 and 96 ?g/cm(2) single-walled carbon nanotubes (SWCNT). To investigate mitotic spindle aberrations at concentrations anticipated in exposed workers, primary and immortalized human airway epithelial cells were exposed to SWCNT for 24-72 h at doses equivalent to 20 weeks of exposure at the Permissible Exposure Limit for particulates not otherwise regulated. We have now demonstrated fragmented centrosomes, disrupted mitotic spindles and aneuploid chromosome number at those doses. The data further demonstrated multipolar mitotic spindles comprised 95% of the disrupted mitoses. The increased multipolar mitotic spindles were associated with an increased number of cells in the G2 phase of mitosis, indicating a mitotic checkpoint response. Nanotubes were observed in association with mitotic spindle microtubules, the centrosomes and condensed chromatin in cells exposed to 0.024, 0.24, 2.4 and 24 ?g/cm(2) SWCNT. Three-dimensional reconstructions showed carbon nanotubes within the centrosome structure. The lower doses did not cause cytotoxicity or reduction in colony formation after 24h; however, after three days, significant cytotoxicity was observed in the SWCNT-exposed cells. Colony formation assays showed an increased proliferation seven days after exposure. Our results show significant disruption of the mitotic spindle by SWCNT at occupationally relevant doses. The increased proliferation that was observed in carbon nanotube-exposed cells indicates a greater potential to pass the genetic damage to daughter cells. Disruption of the centrosome is common in many solid tumors including lung cancer. The resulting aneuploidy is an early event in the progression of many cancers, suggesting that it may play a role in both tumorigenesis and tumor progression. These results suggest caution should be used in the handling and processing of carbon nanotubes.
| S-EPMC4696046 | biostudies-literature
Project description:In this work, a comprehensive methodology for the fitting of single-walled carbon nanotube absorption spectra is presented. Different approaches to background subtraction, choice of line profile, and calculation of full width at half-maximum are discussed both in the context of previous literature and the contemporary understanding of carbon nanotube photophysics. The fitting is improved by the inclusion of exciton-phonon sidebands, and new techniques to improve the individualization of overlapped nanotube spectra by exploiting correlations between the first- and second-order optical transitions and the exciton-phonon sidebands are presented. Consideration of metallic nanotubes allows an analysis of the metallic/semiconducting content, and a process of constraining the fit of highly congested spectra of carbon nanotube solid films according to the spectral weights of each (n, m) species in solution is also presented, allowing for more reliable resolution of overlapping peaks into single (n, m) species contributions.
| S-EPMC5377271 | biostudies-literature
Project description:The projected increase in the production and use of nanomaterials is expected to result in a corresponding increase in human exposure, potentially resulting in significant morbidity and mortality. Currently, the lung toxicity of multi-walled carbon nanotubes (MWCNT), a prototype nanomaterial, was investigated in a rat model. The rats were exposed by whole-body inhalation to air (controls) or MWCNT (6 hours/day, 3 days) to result in cumulative doses of 180, 90, 45, 22.5, or 11.25 mg/m3. Lung toxicity and gene expression profiles were determined in the lungs of the control and MWCNT exposed rats one day following termination of the exposures. Moderate lung histological changes, indicative of toxicity, were detected in rats exposed to MWCNT at doses > 45 mg/m3. Changes in toxicity parameters including, lactate dehydrogenase (LDH) activity, oxidant production, cell counts of phagocytes, and cytokine levels were detected in the bronchoalveolar lavage of rats exposed to > 22.5 mg/m3 MWCNT, compared with the air controls. Lung gene expression profiling detected differences in transcript levels (fold change >1.5 and FDR p<0.05) of several genes in the rats exposed to >22.5 mg/m3 MWCNT, compared with the controls. The changes in lung toxicity and gene expression profiles exhibited a dose-response to the MWCNT administered in the rats.
2022-12-31 | GSE148869 | GEO
Project description:Single-walled carbon nanotubes (SWNTs) have been identified as an efficient drug carrier. Here a controlled drug-delivery system based on SWNTs coated with doxorubicin (DOX) through hydrazone bonds was developed, because the hydrazone bond is more sensitive to tumor microenvironments than other covalent linkers. The SWNTs were firstly stabilized with polyethylene glycol (H(2)N-PEG-NH(2)). Hydrazinobenzoic acid (HBA) was then covalently attached on SWNTs via carbodiimide-activated coupling reaction to form hydrazine-modified SWNTs. The anticancer drug DOX was conjugated to the HBA segments of SWNT using hydrazine as the linker. The resulting hydrazone bonds formed between the DOX molecules and the HBA segments of SWNTs are acid cleavable, thereby providing a strong pH-responsive drug release, which may facilitate effective DOX release near the acidic tumor microenvironment and thus reduce its overall systemic toxicity. The DOX-loaded SWNTs were efficiently taken up by HepG2 tumor cells, and DOX was released intracellularly, as revealed by MTT assay and confocal microscope observations. Compared with SWNT-DOX conjugate formed by supramolecular interaction, the SWNT-HBA-DOX featured high weight loading and prolonged release of DOX, and thus improved its cytotoxicity against cancer cells. This study suggests that while SWNTs have great potential as a drug carrier, the efficient formulation strategy requires further study.
| S-EPMC3224716 | biostudies-literature
Project description:Biotrickling filters (BTFs) are becoming very potential means to purify waste gases containing multiple VOC components, but the removal of the waste gases by BTF has been a major challenge due to the extremely complicated interactions among the components. Four biotrickling filters packed with polyurethane foam were employed to identify the interactions among four aromatic compounds (benzene, toluene, xylene and styrene). The elimination capacities obtained at 90% of removal efficiency for individual toluene, styrene and xylene were 297.02, 225.27 and 180.75 g/m3h, respectively. No obvious removal for benzene was observed at the inlet loading rates ranging from 20 to 450 g/m3h. The total elimination capacities for binary gases significantly decreased in all biotrickling filters. However, the removal of benzene was enhanced in the presence of other gases. The removal capacities of ternary and quaternary gases were further largely lowered. High-throughput sequencing results revealed that microbial communities changed greatly with the composition of gases, from which we found that: all samples were dominated either by the genus Achromobacter or the Burkholderia. Different gaseous combination enriched or inhibited some microbial species. Group I includes samples of BTFs treating single and binary gases and was dominated by the genus Achromobacter, with little Burkholderia inside. Group II includes the rest of the samples taken from BTFs domesticated with ternary and quaternary gases, and was dominated by the genus Burkholderia, with little Achromobacter detected. These genera were highly associated with the biodegradation of benzene series in BTFs.
| S-EPMC5749713 | biostudies-literature