Dataset Information

Evaluation of Pollutants Along the National Road N2 in Togo using the AERMOD Dispersion Model.

ABSTRACT: Background:Air pollution has become a major problem around the world and is increasingly an issue in Togo due to increased vehicular traffic. Gaseous pollutants are released by engines and are very harmful to human health and the environment. The fuels used on the major road in Togo, the N2, are adulterated with unknown contents and are of poor quality. Many of the vehicles come from neighboring countries, such as Benin, Ghana and Nigeria. Objectives:The present study aims to evaluate the pollution rate in Togo through the estimation of the concentrations of sulfur dioxide (SO2), nitrogen oxides (NOx), and particular matter (PM) on the international road, the National Road N2, in Lomé, compared to the World Health Organization's (WHO) standard limit. Methods:The simulations of pollutant concentration were performed using the Industrial Source Complex Short Term Version 3 model, which is included in the United States Environmental Protection Agency Regulatory Model (USEPA) AERMOD View software. The meteorological averages data were obtained from the local station near the National Road N2 in Togo in 2018. Hourly averages were calculated according to the European Monitoring Evaluation Programme/European Environmental Agency air pollutant emission inventory guidebook 2016 and were processed using AERMET View and a terrain pre-processor, AERMAP. For the model, the sources of pollution were the vehicles traveling on the road segment. The source was a line volume with 20 m of width and 2 m of height. The estimation methodology covered exhaust emissions of NOx, SO2 and PM contained in the fuel. Results:The simulations provided average hourly, daily and annual concentrations of the different pollutants: 71.91 ?g/m3, 42.41 ?g/m3,11.23 ?g/m3 for SO2; 16.78 ?g/m3, 9.89 ?g/m3, 2.46 ?g/m3 for NOx and below the detection limit, 0.62 ?g/m3, 0.15 ?g/m3 for PM, respectively. These results indicate that on the National Road N2 in Togo, the concentrations of SO2 were high compared to those of NOx and PM. The daily average concentration of SO2 was twice the permissible limits set by the WHO. Conclusions:Emissions obtained from the AERMOD for NOx and PM were less than the permissible limits set by the WHO, while the rate of SO2 was twice the permissible limit. The fuels used on this road were very rich in sulfur. The sulfur level in fuels must be monitored by stakeholders in Togo. Competing Interests:The authors declare no competing financial interests.

SUBMITTER: Amouzouvi YM

PROVIDER: S-EPMC7453808 | biostudies-literature | 2020 Sep

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Evaluation of Pollutants Along the National Road N2 in Togo using the AERMOD Dispersion Model.

Amouzouvi Yawovi Mignanou YM Dzagli Milohum Mikesokpo MM Sagna Koffi K Török Zoltán Z Roba Carmen Andreea CA Mereuţă Alexandru A Ozunu Alexandru A Edjame Kodjovi Sidéra KS

Journal of health & pollution 20200825 27

<h4>Background</h4>Air pollution has become a major problem around the world and is increasingly an issue in Togo due to increased vehicular traffic. Gaseous pollutants are released by engines and are very harmful to human health and the environment. The fuels used on the major road in Togo, the N2, are adulterated with unknown contents and are of poor quality. Many of the vehicles come from neighboring countries, such as Benin, Ghana and Nigeria.<h4>Objectives</h4>The present study aims to eval ...[more]

PMID: 32874764

Similar Datasets

Project description:The development of accurate and appropriate exposure metrics for health effect studies of traffic-related air pollutants (TRAPs) remains challenging and important given that traffic has become the dominant urban exposure source and that exposure estimates can affect estimates of associated health risk. Exposure estimates obtained using dispersion models can overcome many of the limitations of monitoring data, and such estimates have been used in several recent health studies. This study examines the sensitivity of exposure estimates produced by dispersion models to meteorological, emission and traffic allocation inputs, focusing on applications to health studies examining near-road exposures to TRAP. Daily average concentrations of CO and NOx predicted using the Research Line source model (RLINE) and a spatially and temporally resolved mobile source emissions inventory are compared to ambient measurements at near-road monitoring sites in Detroit, MI, and are used to assess the potential for exposure measurement error in cohort and population-based studies. Sensitivity of exposure estimates is assessed by comparing nominal and alternative model inputs using statistical performance evaluation metrics and three sets of receptors. The analysis shows considerable sensitivity to meteorological inputs; generally the best performance was obtained using data specific to each monitoring site. An updated emission factor database provided some improvement, particularly at near-road sites, while the use of site-specific diurnal traffic allocations did not improve performance compared to simpler default profiles. Overall, this study highlights the need for appropriate inputs, especially meteorological inputs, to dispersion models aimed at estimating near-road concentrations of TRAPs. It also highlights the potential for systematic biases that might affect analyses that use concentration predictions as exposure measures in health studies, e.g., to estimate health impacts.

Project description:BackgroundNear-road exposures of traffic-related air pollutants have been receiving increased attention due to evidence linking emissions from high-traffic roadways to adverse health outcomes. To date, most epidemiological and risk analyses have utilized simple but crude exposure indicators, most typically proximity measures, such as the distance between freeways and residences, to represent air quality impacts from traffic. This paper derives and analyzes a simplified microscale simulation model designed to predict short- (hourly) to long-term (annual average) pollutant concentrations near roads. Sensitivity analyses and case studies are used to highlight issues in predicting near-road exposures.MethodsProcess-based simulation models using a computationally efficient reduced-form response surface structure and a minimum number of inputs integrate the major determinants of air pollution exposures: traffic volume and vehicle emissions, meteorology, and receptor location. We identify the most influential variables and then derive a set of multiplicative submodels that match predictions from "parent" models MOBILE6.2 and CALINE4. The assembled model is applied to two case studies in the Detroit, Michigan area. The first predicts carbon monoxide (CO) concentrations at a monitoring site near a freeway. The second predicts CO and PM2.5 concentrations in a dense receptor grid over a 1 km2 area around the intersection of two major roads. We analyze the spatial and temporal patterns of pollutant concentration predictions.ResultsPredicted CO concentrations showed reasonable agreement with annual average and 24-hour measurements, e.g., 59% of the 24-hr predictions were within a factor of two of observations in the warmer months when CO emissions are more consistent. The highest concentrations of both CO and PM(2.5) were predicted to occur near intersections and downwind of major roads during periods of unfavorable meteorology (e.g., low wind speeds) and high emissions (e.g., weekday rush hour). The spatial and temporal variation among predicted concentrations was significant, and resulted in unusual distributional and correlation characteristics, including strong negative correlation for receptors on opposite sides of a road and the highest short-term concentrations on the "upwind" side of the road.ConclusionsThe case study findings can likely be generalized to many other locations, and they have important implications for epidemiological and other studies. The reduced-form model is intended for exposure assessment, risk assessment, epidemiological, geographical information systems, and other applications.

Project description:The industrial complexes built during the course of economic development in South Korea played a pivotal role in the country's rapid economic growth. However, this growth was accompanied by health problems due to the pollutants released from the industrial complexes inevitably located near residential areas, given the limited land area available in South Korea. This study was conducted to evaluate the exposure to each pollutant emanating from industrial complexes for residents living in nearby areas, and to determine the substances requiring priority attention in future surveys. Pollutants were comprehensively categorized according to their emission and exposure levels based on data previously collected from the study areas. The emission, ambient concentration, and biomarker concentration levels of major pollutants emitted from eight national industrial complexes (Ulsan, Pohang, Gwangyang, Yeosu, Chungju, Daesan, Sihwa, and Banwol) were determined and tabulated. Each of the values was compared with the national/local average values, reference values, or control area concentrations depending on availability. Substances with completed exposure pathways and with high values for emissions, ambient concentrations, and biomarker concentrations were considered the substances posing exposure risks to the residents living near the corresponding industrial complex. The substances requiring continuous monitoring or supplementary exposure investigation were also categorized and presented. Lead and benzene had higher values for emissions, ambient concentrations, and biomarker concentrations in the Ulsan Industrial Complex area; thus, they were most likely to pose exposure risks to residents living in the area's neighborhoods. In other areas, styrene, xylene, cadmium, nitrogen oxide, trichloroethylene, nickel, manganese, and chromium required continuous monitoring, and arsenic, nickel, manganese, and chromium required biomarker measurements. In conclusion, the substances identified and categorized in this study need to be given appropriate attention in future surveys on exposure risks and health effects related to industrial complexes.

Project description:BackgroundIn a previous study PCR analysis of clinical samples from suspected cases of Buruli ulcer disease (BUD) from Togo and external quality assurance (EQA) for local microscopy were conducted at an external reference laboratory in Germany. The relatively poor performance of local microscopy as well as effort and time associated with shipment of PCR samples necessitated the implementation of stringent EQA measures and availability of local laboratory capacity. This study describes the approach to implementation of a national BUD reference laboratory in Togo.MethodologyLarge scale outreach activities accompanied by regular training programs for health care professionals were conducted in the regions "Maritime" and "Central," standard operating procedures defined all processes in participating laboratories (regional, national and external reference laboratories) as well as the interaction between laboratories and partners in the field. Microscopy was conducted at regional level and slides were subjected to EQA at national and external reference laboratories. For PCR analysis, sample pairs were collected and subjected to a dry-reagent-based IS2404-PCR (DRB-PCR) at national level and standard IS2404 PCR followed by IS2404 qPCR analysis of negative samples at the external reference laboratory.Principal findingsThe inter-laboratory concordance rates for microscopy ranged from 89% to 94%; overall, microscopy confirmed 50% of all suspected BUD cases. The inter-laboratory concordance rate for PCR was 96% with an overall PCR case confirmation rate of 78%. Compared to a previous study, the rate of BUD patients with non-ulcerative lesions increased from 37% to 50%, the mean duration of disease before clinical diagnosis decreased significantly from 182.6 to 82.1 days among patients with ulcerative lesions, and the percentage of category III lesions decreased from 30.3% to 19.2%.ConclusionsHigh inter-laboratory concordance rates as well as case confirmation rates of 50% (microscopy), 71% (PCR at national level), and 78% (including qPCR confirmation at external reference laboratory) suggest high standards of BUD diagnostics. The increase of non-ulcerative lesions, as well as the decrease in diagnostic delay and category III lesions, prove the effect of comprehensive EQA and training measures involving also procedures outside the laboratory.

Dataset Information

Evaluation of Pollutants Along the National Road N2 in Togo using the AERMOD Dispersion Model.

Publications

Evaluation of Pollutants Along the National Road N2 in Togo using the AERMOD Dispersion Model.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets