Methane emissions from natural gas vehicles in China.
Ontology highlight
ABSTRACT:
SUBMITTER: Da Pan
PROVIDER: S-EPMC7486943 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Eighty percent of US oil and natural gas (O&G) production sites are low production well sites, with average site-level production ≤15 barrels of oil equivalent per day and producing only 6% of the nation's O&G output in 2019. Here, we integrate national site-level O&G production data and previously reported site-level CH4 measurement data (n = 240) and find that low production well sites are a disproportionately large source of US O&G well site CH4 emissions, emitting more than 4 (95% confidence interval: 3-6) teragrams, 50% more than the total CH4 emissions from the Permian Basin, one of the world's largest O&G producing regions. We estimate low production well sites represent roughly half (37-75%) of all O&G well site CH4 emissions, and a production-normalized CH4 loss rate of more than 10%-a factor of 6-12 times higher than the mean CH4 loss rate of 1.5% for all O&G well sites in the US. Our work suggests that achieving significant reductions in O&G CH4 emissions will require mitigation of emissions from low production well sites.
| S-EPMC9019036 | biostudies-literature
Project description:Engineering estimates of methane emissions from natural gas production have led to varied projections of national emissions. This work reports direct measurements of methane emissions at 190 onshore natural gas sites in the United States (150 production sites, 27 well completion flowbacks, 9 well unloadings, and 4 workovers). For well completion flowbacks, which clear fractured wells of liquid to allow gas production, methane emissions ranged from 0.01 Mg to 17 Mg (mean = 1.7 Mg; 95% confidence bounds of 0.67-3.3 Mg), compared with an average of 81 Mg per event in the 2011 EPA national emission inventory from April 2013. Emission factors for pneumatic pumps and controllers as well as equipment leaks were both comparable to and higher than estimates in the national inventory. Overall, if emission factors from this work for completion flowbacks, equipment leaks, and pneumatic pumps and controllers are assumed to be representative of national populations and are used to estimate national emissions, total annual emissions from these source categories are calculated to be 957 Gg of methane (with sampling and measurement uncertainties estimated at ± 200 Gg). The estimate for comparable source categories in the EPA national inventory is ~1,200 Gg. Additional measurements of unloadings and workovers are needed to produce national emission estimates for these source categories. The 957 Gg in emissions for completion flowbacks, pneumatics, and equipment leaks, coupled with EPA national inventory estimates for other categories, leads to an estimated 2,300 Gg of methane emissions from natural gas production (0.42% of gross gas production).
| S-EPMC3816463 | biostudies-literature
Project description:Methane (CH4) emissions from oil and natural gas (O&NG) systems are an important contributor to greenhouse gas emissions. In the United States, recent synthesis studies of field measurements of CH4 emissions at different spatial scales are ~1.5-2× greater compared to official greenhouse gas inventory (GHGI) estimates, with the production-segment as the dominant contributor to this divergence. Based on an updated synthesis of measurements from component-level field studies, we develop a new inventory-based model for CH4 emissions, for the production-segment only, that agrees within error with recent syntheses of site-level field studies and allows for isolation of equipment-level contributions. We find that unintentional emissions from liquid storage tanks and other equipment leaks are the largest contributors to divergence with the GHGI. If our proposed method were adopted in the United States and other jurisdictions, inventory estimates could better guide CH4 mitigation policy priorities.
| S-EPMC8342509 | biostudies-literature
Project description:Increased interest in greenhouse gas (GHG) emissions, including recent legislative action and voluntary programs, has increased attention on quantifying and ultimately reducing methane emissions from the natural gas supply chain. While inventories used for public or corporate GHG policies have traditionally utilized bottom-up (BU) methods to estimate emissions, the validity of such inventories has been questioned. Therefore, there is attention on utilizing full-facility measurements using airborne, satellite, or drone (top-down (TD)) techniques to inform, improve, or validate inventories. This study utilized full-facility estimates from two independent TD methods at 15 midstream natural gas facilities in the U.S.A., which were compared with a contemporaneous daily inventory assembled by the facility operator, employing comprehensive inventory methods. Estimates from the two TD methods statistically agreed in 2 of 28 paired measurements. Operator inventories, which included extensions to capture sources beyond regular inventory requirements and integration of local measurements, estimated significantly lower emissions than the TD estimates for 40 of 43 paired comparisons. Significant disagreement was observed at most facilities, both between the two TD methods and between the TD estimates and operator inventory. These findings have two implications. First, improving inventory estimates will require additional on-site or ground-based diagnostic screening and measurement of all sources. Second, the TD full-facility measurement methods need to undergo further testing, characterization, and potential improvement specifically tailored for complex midstream facilities.
| S-EPMC10552540 | biostudies-literature
Project description:Methane emissions from natural gas delivery and end use must be quantified to evaluate the environmental impacts of natural gas and to develop and assess the efficacy of emission reduction strategies. We report natural gas emission rates for 1 y in the urban region of Boston, using a comprehensive atmospheric measurement and modeling framework. Continuous methane observations from four stations are combined with a high-resolution transport model to quantify the regional average emission flux, 18.5 ± 3.7 (95% confidence interval) g CH4 ? m(-2) ? y(-1). Simultaneous observations of atmospheric ethane, compared with the ethane-to-methane ratio in the pipeline gas delivered to the region, demonstrate that natural gas accounted for ? 60-100% of methane emissions, depending on season. Using government statistics and geospatial data on natural gas use, we find the average fractional loss rate to the atmosphere from all downstream components of the natural gas system, including transmission, distribution, and end use, was 2.7 ± 0.6% in the Boston urban region, with little seasonal variability. This fraction is notably higher than the 1.1% implied by the most closely comparable emission inventory.
| S-EPMC4343086 | biostudies-literature
Project description:Understanding methane emissions from the natural gas supply chain continues to be of interest. Previous studies identified that measurements are skewed due to "super-emitters", and recently, researchers identified temporal variability as another contributor to discrepancies among studies. We focused on the latter by performing 17 methane audits at a single production site over 4 years, from 2016 to 2020. Source detection was similar to Method 21 but augmented with accurate methane mass rate quantification. Audit results varied from ∼78 g/h to over 43 kg/h with a mean emissions rate of 4.2 kg/h and a geometric mean of 821 g/h. Such high variability sheds light that even quarterly measurement programs will likely yield highly variable results. Total emissions were typically dominated by those from the produced water storage tank. Of 213 sources quantified, a single tank measurement represented 60% of the cumulative emission rate. Measurements were separated into four categories: wellheads (n = 78), tank (n = 17), enclosed gas process units (n = 31), and others (n = 97). Each subgroup of measurements was skewed and fat-tailed, with the skewness ranging from 2.4 to 5.7 and kurtosis values ranging from 6.5 to 33.7. Analyses found no significant correlations between methane emissions and temperature, whole gas production, or water production. Since measurement results were highly variable and daily production values were known, we completed a Monte Carlo analysis to estimate average throughput-normalized methane emissions which yielded an estimate of 0.093 ± 0.013%.
| S-EPMC8190792 | biostudies-literature
Project description:Published estimates of methane emissions from atmospheric data (top-down approaches) exceed those from source-based inventories (bottom-up approaches), leading to conflicting claims about the climate implications of fuel switching from coal or petroleum to natural gas. Based on data from a coordinated campaign in the Barnett Shale oil and gas-producing region of Texas, we find that top-down and bottom-up estimates of both total and fossil methane emissions agree within statistical confidence intervals (relative differences are 10% for fossil methane and 0.1% for total methane). We reduced uncertainty in top-down estimates by using repeated mass balance measurements, as well as ethane as a fingerprint for source attribution. Similarly, our bottom-up estimate incorporates a more complete count of facilities than past inventories, which omitted a significant number of major sources, and more effectively accounts for the influence of large emission sources using a statistical estimator that integrates observations from multiple ground-based measurement datasets. Two percent of oil and gas facilities in the Barnett accounts for half of methane emissions at any given time, and high-emitting facilities appear to be spatiotemporally variable. Measured oil and gas methane emissions are 90% larger than estimates based on the US Environmental Protection Agency's Greenhouse Gas Inventory and correspond to 1.5% of natural gas production. This rate of methane loss increases the 20-y climate impacts of natural gas consumed in the region by roughly 50%.
| S-EPMC4697433 | biostudies-literature
Project description:Mitigating methane emissions is vital in meeting global climate targets, but there is a lack of understanding of emissions and abatement opportunities to enable this. The natural gas supply chain is a key emission source, where methane emissions from liquefied natural gas (LNG) shipping have until now not been directly measured. This study provides the first measurement and modeling of total methane and CO2 emissions from an LNG carrier on a round trip voyage from the USA to Belgium and back, including loading, laden voyage, unloading, and ballast voyage, measuring emissions from exhaust stacks, vents, and fugitives. Venting and fugitive emissions were extremely low, contributing less than 0.1% of total greenhouse gas emissions. CO2 emissions from fuel usage were also lower than previous estimates due to improved efficiencies in modern engines and ship design. However, methane slip through the engines were higher than those in prior studies, averaging 3.8% across all engines: equating to 0.1% of delivered LNG. Generator engines are not typically included in emissions analyses but were the key cause of methane emissions. Engines exhibited higher methane slip rates at low loads, and optimized operation could reduce slip rates by half. More measurement studies are now needed to better understand fleet emissions and enable cost-effective mitigation strategies.
| S-EPMC9261184 | biostudies-literature
Project description:From wellhead to burner tip, each component of the natural gas process chain has come under increased scrutiny for the presence and magnitude of methane leaks, because of the large global warming potential of methane. Top-down measures of methane emissions in urban areas are significantly greater than bottom-up estimates. Recent research suggests this disparity might in part be explained by gas leaks from one of the least understood parts of the process chain: behind the gas meter in homes and buildings. However, little research has been performed in this area and few methods and data sets exist to measure or estimate them. We develop and test a simple and widely deployable closed chamber method that can be used for quantifying indoor methane emissions with an order-of-magnitude precision which allows for screening of indoor large volume ("super-emitting") leaks. We also perform test applications of the method finding indoor leaks in 90% of the 20 Greater Boston buildings studied and indoor methane emissions between 0.02-0.51 ft3 CH4 day-1 (0.4-10.3 g CH4 day-1) with a mean of 0.14 ft3 CH4 day-1 (2.8 g CH4 day-1). Our method provides a relatively simple way to scale up indoor methane emissions data collection. Increased data may reduce uncertainty in bottom-up inventories, and can be used to find super-emitting indoor emissions which may better explain the disparity between top-down and bottom-up post-meter emissions estimates.
| S-EPMC10688665 | biostudies-literature
Project description:Methane emissions were measured at 6650 sites across six major oil and gas producing regions in Canada to examine regional emission trends, and to derive an inventory estimate for Canada's upstream oil and gas sector. Emissions varied by fluid type and geographic region, with the heavy oil region of Lloydminster ranking highest on both absolute and intensity-based scales. Emission intensities varied widely for natural gas production, where older, low-producing developments such as Medicine Hat, Alberta showed high emission intensities, and newer developments in Montney, British Columbia showed emission intensities that are amongst the lowest in North America. Overall, we estimate that the Canadian upstream oil and gas methane inventory is underestimated by a factor of 1.5, which is consistent with previous studies of individual regions.
| S-EPMC8044210 | biostudies-literature