Giant tuning of ferroelectricity in single crystals by thickness engineering.
Ontology highlight
ABSTRACT:
SUBMITTER: Chen Z
PROVIDER: S-EPMC7556833 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Quantum phase transition achieved by fine tuning the continuous phase transition down to zero kelvin is a challenge for solid state science. Critical phenomena distinct from the effects of thermal fluctuations can materialize when the electronic, structural or magnetic long-range order is perturbed by quantum fluctuations between degenerate ground states. Here we have developed chemically pure tetrahalo-p-benzoquinones of n iodine and 4-n bromine substituents (QBr4-nIn, n=0-4) to search for ferroelectric charge-transfer complexes with tetrathiafulvalene (TTF). Among them, TTF-QBr2I2 exhibits a ferroelectric neutral-ionic phase transition, which is continuously controlled over a wide temperature range from near-zero kelvin to room temperature under hydrostatic pressure. Quantum critical behaviour is accompanied by a much larger permittivity than those of other neutral-ionic transition compounds, such as well-known ferroelectric complex of TTF-QCl4 and quantum antiferroelectric of dimethyl-TTF-QBr4. By contrast, TTF-QBr3I complex, another member of this compound family, shows complete suppression of the ferroelectric spin-Peierls-type phase transition.
| S-EPMC4490386 | biostudies-literature
Project description:Detection and manipulation of spin current lie in the core of spintronics. Here we report an active control of a net spin Hall angle, θSHE(net), in Pt at an interface with a ferroelectric material PZT (PbZr0.2Ti0.8O3), using its ferroelectric polarization. The spin Hall angle in the ultra-thin Pt layer is measured using the inverse spin Hall effect with a pulsed tunneling current from a ferromagnetic La0.67Sr0.33MnO3 electrode. The effect of the ferroelectric polarization on θSHE(net) is enhanced when the thickness of the Pt layer is reduced. When the Pt layer is thinner than 6 nm, switching the ferroelectric polarization even changes the sign of θSHE(net). This is attributed to the reversed polarity of the spin Hall angle in the 1st-layer Pt at the PZT/Pt interface when the ferroelectric polarization is inverted, as supported by the first-principles calculations. These findings suggest a route for designing future energy efficient spin-orbitronic devices using ferroelectric control.
| S-EPMC7250895 | biostudies-literature
Project description:Multicolor tuning of persistent luminescence has been extensively studied by deliberately integrating various luminescent units, known as activators or chromophores, into certain host compounds. However, it remains a formidable challenge to fine-tune the persistent luminescence spectra either in organic materials, such as small molecules, polymers, metal-organic complexes and carbon dots, or in doped inorganic crystals. Herein, we present a strategy to delicately control the persistent luminescence wavelength by engineering sub-bandgap donor-acceptor states in a series of single-phase Ca(Sr)ZnOS crystals. The persistent luminescence emission peak can be quasi-linearly tuned across a broad wavelength range (500-630 nm) as a function of Sr/Ca ratio, achieving a precision down to ~5 nm. Theoretical calculations reveal that the persistent luminescence wavelength fine-tuning stems from constantly lowered donor levels accompanying the modified band structure by Sr alloying. Besides, our experimental results show that these crystals exhibit a high initial luminance of 5.36 cd m-2 at 5 sec after charging and a maximum persistent luminescence duration of 6 h. The superior, color-tunable persistent luminescence enables a rapid, programable patterning technique for high-throughput optical encryption.
| S-EPMC11316030 | biostudies-literature
Project description:The photovoltaic (PV) effect in polar materials offers great potential for light-energy conversion that generates a voltage beyond the bandgap limit of present semiconductor-based solar cells. Ferroelectrics have received renewed attention because of the ability to deliver a high voltage in the presence of ferroelastic domain walls (DWs). In recent years, there has been considerable debate over the impact of the DWs on the PV effects, owing to lack of information on the bulk PV tensor of host ferroelectrics. In this article, we provide the first direct evidence of an unusually large PV response induced by ferroelastic DWs-termed 'DW'-PV effect. The precise estimation of the bulk PV tensor in single crystals of barium titanate enables us to quantify the giant PV effect driven by 90° DWs. We show that the DW-PV effect arises from an effective electric field consisting of a potential step and a local PV component in the 90° DW region. This work offers a starting point for further investigation into the DW-PV effect of alternative systems and opens a reliable route for enhancing the PV properties in ferroelectrics based on the engineering of domain structures in either bulk or thin-film form.
| S-EPMC4595799 | biostudies-literature
Project description:Nanometer-scale 3D imaging of materials properties is critical for understanding equilibrium states in electronic materials, as well as for optimization of device performance and reliability, even though such capabilities remain a substantial experimental challenge. Tomographic atomic force microscopy (TAFM) is presented as a subtractive scanning probe technique for high-resolution, 3D ferroelectric property measurements. Volumetric property resolution below 315 nm3, as well as unit-cell-scale vertical material removal, are demonstrated. Specifically, TAFM is applied to investigate the size dependence of ferroelectricity in the room-temperature multiferroic BiFeO3 across two decades of thickness to below 1 nm. TAFM enables volumetric imaging of ferroelectric domains in BiFeO3 with a significant improvement in spatial resolution compared with existing domain tomography techniques. We additionally employ TAFM for direct, thickness-dependent measurements of the local spontaneous polarization and ferroelectric coercive field in BiFeO3 The thickness-resolved ferroelectric properties strongly correlate with cross-sectional transmission electron microscopy (TEM), Landau-Ginzburg-Devonshire phenomenological theory, and the semiempirical Kay-Dunn scaling law for ferroelectric coercive fields. These results provide an unambiguous determination of a stable and switchable polar state in BiFeO3 to thicknesses below 5 nm. The accuracy and utility of these findings on finite size effects in ferroelectric and multiferroic materials more broadly exemplifies the potential for novel insight into nanoscale 3D property measurements via other variations of TAFM.
| S-EPMC6377454 | biostudies-literature
Project description:In recent years, the unique mechanism of sliding ferroelectricity with ultralow switching barriers has been experimentally verified in a series of 2-dimensional (2D) materials. However, its practical applications are hindered by the low polarizations, the challenges in synthesis of ferroelectric phases limited in specific stacking configurations, and the low density for data storage since the switching process involves large-area simultaneous sliding of a whole layer. Herein, through first-principles calculations, we propose a type of semi-sliding ferroelectricity in the single metal porphyrin molecule intercalated in 2D bilayers. An enhanced vertical polarization can be formed independent on stacking configurations and switched via sliding of the molecule accompanied by the vertical displacements of its metal ion anchored from the upper layer to the lower layer. Such semi-sliding ferroelectricity enables each molecule to store 1 bit data independently, and the density for data storage can be greatly enhanced. When the bilayer exhibits intralayer ferromagnetism and interlayer antiferromagnetic coupling, a considerable difference in Curie temperature between 2 layers and a switchable net magnetization can be formed due to the vertical polarization. At a certain range of temperature, the exchange of paramagnetic-ferromagnetic phases between 2 layers is accompanied by ferroelectric switching, leading to a hitherto unreported type of multiferroic coupling that is long-sought for efficient "magnetic reading + electric writing".
| S-EPMC11298321 | biostudies-literature
Project description:Compared with the large variety of solid gold nanostructures, synthetic approaches for their hollow counterparts are limited, largely confined to chemical and irradiation-based etching of preformed nanostructures. In particular, the preparation of through nanopore structures is extremely challenging. Here, a unique strategy for direct synthesis of gold nanopores in solution without the need for sacrificial templates or postsynthesis processing is reported. By controlling the degree of crystal screw dislocation, a single through pore with diameter ranging from sub-nanometer to tens of nanometers, in the center of large gold nanoplates, can be engineered with precision. Ionic current rectification behaviors are observed using the gold nanopore, potentially enabling new capabilities in biosensing, sequencing, and imaging.
| S-EPMC5610653 | biostudies-literature
Project description:A series of high-quality, large-sized (maximum size of 16 × 16 × 32 mm(3)) K1-xNaxTa1-yNbyO3 (x = 0.61, 0.64, and 0.70 and corresponding y = 0.58, 0.60, and 0.63) single crystals were grown using the top-seed solution growth method. The segregation of the crystals, which allowed for precise control of the individual components of the crystals during growth, was investigated. The obtained crystals exhibited excellent properties without being annealed, including a low dielectric loss (0.006), a saturated hysteresis loop, a giant piezoelectric coefficient d33 (d33 = 416 pC/N, determined by the resonance method and d33(*) = 480 pC/N, measured using a piezo-d33 meter), and a large electromechanical coupling factor, k33 (k33 = 83.6%), which was comparable to that of lead zirconate titanate. The reason the piezoelectric coefficient d33 of K0.39Na0.61Ta0.42Nb0.58O3 was larger than those of the other two crystals grown was elucidated through first-principles calculations. The obtained results indicated that K1-xNaxTa1-yNbyO3 crystals can be used as a high-quality, lead-free piezoelectric material.
| S-EPMC4861918 | biostudies-other
Project description:Mg2Sn is a potential thermoelectric (TE) material that can directly convert waste heat into electricity. In this study, Mg2Sn single-crystal ingots are prepared by melting under an Ar atmosphere. The prepared ingots contain Mg vacancies (VMg) as point defects, which results in the formation of two regions: an Mg2Sn single-crystal region without VMg (denoted as the single-crystal region) and a region containing VMg (denoted as the VMg region). The VMg region is embedded in the matrix of the single-crystal region. The interface between the VMg region and the single-crystal region is semi-coherent, which does not prevent electron carrier conduction but does increase phonon scattering. Furthermore, electron carrier concentration depends on the fraction of VMg, reflecting the acceptor characteristics of VMg. The maximum figure of merit zTmax of 1.4(1) × 10-2 is realised for the Mg2Sn single-crystal ingot by introducing VMg. These results demonstrate that the TE properties of Mg2Sn can be optimised via point-defect engineering.
| S-EPMC7005024 | biostudies-literature
Project description:Mineralogical processes taking place close to equilibrium, or with very slow kinetics, are difficult to quantify precisely. The determination of ultraslow dissolution/precipitation rates would reveal characteristic timing associated with these processes that are important at geological scale. We have designed an advanced high-resolution white-beam phase-shift interferometry microscope to measure growth rates of crystals at very low supersaturation values. To test this technique, we have selected the giant gypsum crystals of Naica ore mines in Chihuahua, Mexico, a challenging subject in mineral formation. They are thought to form by a self-feeding mechanism driven by solution-mediated anhydrite-gypsum phase transition, and therefore they must be the result of an extremely slow crystallization process close to equilibrium. To calculate the formation time of these crystals we have measured the growth rates of the {010} face of gypsum growing from current Naica waters at different temperatures. The slowest measurable growth rate was found at 55?°C, 1.4 ± 0.2 × 10(-5) nm/s, the slowest directly measured normal growth rate for any crystal growth process. At higher temperatures, growth rates increase exponentially because of decreasing gypsum solubility and higher kinetic coefficient. At 50?°C neither growth nor dissolution was observed indicating that growth of giant crystals of gypsum occurred at Naica between 58?°C (gypsum/anhydrite transition temperature) and the current temperature of Naica waters, confirming formation temperatures determined from fluid inclusion studies. Our results demonstrate the usefulness of applying advanced optical techniques in laboratory experiments to gain a better understanding of crystal growth processes occurring at a geological timescale.
| S-EPMC3179101 | biostudies-literature