Dataset Information

Polyvinyl Alcohol-Few Layer Graphene Composite Films Prepared from Aqueous Colloids. Investigations of Mechanical, Conductive and Gas Barrier Properties.

ABSTRACT: Quasi all water soluble composites use graphene oxide (GO) or reduced graphene oxide (rGO) as graphene based additives despite the long and harsh conditions required for their preparation. Herein, polyvinyl alcohol (PVA) films containing few layer graphene (FLG) are prepared by the co-mixing of aqueous colloids and casting, where the FLG colloid is first obtained via an efficient, rapid, simple, and bio-compatible exfoliation method providing access to relatively large FLG flakes. The enhanced mechanical, electrical conductivity, and O2 barrier properties of the films are investigated and discussed together with the structure of the films. In four different series of the composites, the best Young's modulus is measured for the films containing around 1% of FLG. The most significant enhancement is obtained for the series with the largest FLG sheets contrary to the elongation at break which is well improved for the series with the lowest FLG sheets. Relatively high one-side electrical conductivity and low percolation threshold are achieved when compared to GO/rGO composites (almost 10-3 S/cm for 3% of FLG and transport at 0.5% FLG), while the conductivity is affected by the formation of a macroscopic branched FLG network. The composites demonstrate a reduction of O2 transmission rate up to 60%.

SUBMITTER: Van der Schueren B

PROVIDER: S-EPMC7711457 | biostudies-literature | 2020 Apr

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Polyvinyl Alcohol-Few Layer Graphene Composite Films Prepared from Aqueous Colloids. Investigations of Mechanical, Conductive and Gas Barrier Properties.

Van der Schueren Benoit B Marouazi Hamza El HE Mohanty Anurag A Lévêque Patrick P Sutter Christophe C Romero Thierry T Janowska Izabela I

Nanomaterials (Basel, Switzerland) 20200429 5

Quasi all water soluble composites use graphene oxide (GO) or reduced graphene oxide (rGO) as graphene based additives despite the long and harsh conditions required for their preparation. Herein, polyvinyl alcohol (PVA) films containing few layer graphene (FLG) are prepared by the co-mixing of aqueous colloids and casting, where the FLG colloid is first obtained via an efficient, rapid, simple, and bio-compatible exfoliation method providing access to relatively large FLG flakes. The enhanced m ...[more]

PMID: 32365565

Similar Datasets

Project description:Graphene oxide (GO) oligo-layered laminates were self-assembled on porous ceramic substrates via their simple dip-coating into aqueous GO dispersions. To augment the stability of the developed composite GO/ceramic membranes and control the morphology and stacking quality of the formed laminate, short-((3-glycidoxypropyl)trimethoxy silane-GLYMO, (3-aminopropyl)triethoxy silane-APTES), and long-chain (polydopamine-PDA) molecules were involved and examined as interfacial linkers. A comparative study was performed regarding the linker's capacity to enhance the interfacial adhesion between the ceramic surface and the GO deposit and affect the orientation and assemblage characteristics of the adjacent GO nanosheets that composed the formed oligo-layered laminates. Subsequently, by post-filtrating a GO/H2O suspension through the oligo-layered laminate membranes, the respective multi-layered ones have been developed, whereas ethylenediamine (EDA) was used in the suspension as an efficient molecular linker that strongly bonds and interlocks the GO nanosheets. The definition of the best linker and approach was conducted on macroporous α-alumina disks, due to the use of inexpensive raw materials and the ability to fabricate them in the lab with high reproducibility. To validate the concept at a larger scale, while investigating the effect of the porous substrate as regards its micrometer-scale roughness and surface chemistry, specific chemical modifications that yielded membranes with the best gas permeability/selectivity performance were replicated on a commercial single-channel monolith with a ZrO2 microfiltration layer. XRD, Raman, ATR, FESEM, and XPS analyses were conducted to study the structural, physicochemical, surface, and morphological properties of the GO/ceramic composite membranes, whereas permeance results of several gases at various temperatures and trans-membrane pressures were interpreted to shed light on the pore structural features. Concerning the short-chain linkers, the obtained results ascertain that GLYMO causes denser and more uniform assembly of GO nanosheets within the oligo-layered laminate. PDA had the same beneficial effect, as it is a macromolecule. Overall, this study shows that the development of gas-separating membranes, by just dipping the linker-modified substrate into the GO suspension, is not straightforward. The application of post-filtration contributed significantly to this target and the quality of the superficially deposited, thick GO laminate depended on this of the chemically attached oligo-layered one.

Dataset Information

Polyvinyl Alcohol-Few Layer Graphene Composite Films Prepared from Aqueous Colloids. Investigations of Mechanical, Conductive and Gas Barrier Properties.

Publications

Polyvinyl Alcohol-Few Layer Graphene Composite Films Prepared from Aqueous Colloids. Investigations of Mechanical, Conductive and Gas Barrier Properties.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets