Browse
Submit Data
Databases
API
Help

Dataset Information

26 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Flame Synthesis of Cu/ZnO-CeO₂ Catalysts: Synergistic Metal-Support Interactions Promote CH₃OH Selectivity in CO₂ Hydrogenation.

ABSTRACT: The hydrogenation of CO₂ to CH₃OH is an important reaction for future renewable energy scenarios. Herein, we compare Cu/ZnO, Cu/CeO₂, and Cu/ZnO-CeO₂ catalysts prepared by flame spray pyrolysis. The Cu loading and support composition were varied to understand the role of Cu-ZnO and Cu-CeO₂ interactions. CeO₂ addition improves Cu dispersion with respect to ZnO, owing to stronger Cu-CeO₂ interactions. The ternary Cu/ZnO-CeO₂ catalysts displayed a substantially higher CH₃OH selectivity than binary Cu/CeO₂ and Cu/ZnO catalysts. The high CH₃OH selectivity in comparison with a commercial Cu-ZnO catalyst is also confirmed for Cu/ZnO-CeO₂ catalyst prepared with high Cu loading (∼40 wt %). In situ IR spectroscopy was used to probe metal-support interactions in the reduced catalysts and to gain insight into CO₂ hydrogenation over the Cu-Zn-Ce oxide catalysts. The higher CH₃OH selectivity can be explained by synergistic Cu-CeO₂ and Cu-ZnO interactions. Cu-ZnO interactions promote CO₂ hydrogenation to CH₃OH by Zn-decorated Cu active sites. Cu-CeO₂ interactions inhibit the reverse water-gas shift reaction due to a high formate coverage of Cu and a high rate of hydrogenation of the CO intermediate to CH₃OH. These insights emphasize the potential of fine-tuning metal-support interactions to develop improved Cu-based catalysts for CO₂ hydrogenation to CH₃OH.

SUBMITTER: Zhu J

PROVIDER: S-EPMC8057230 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Enhanced CH3OH selectivity in CO2 hydrogenation using Cu-based catalysts generated via SOMC from GaIII single-sites.

Project description:Small and narrowly distributed nanoparticles of copper alloyed with gallium supported on silica containing residual GaIII sites can be obtained via surface organometallic chemistry in a two-step process: (i) formation of isolated GaIII surface sites on SiO2 and (ii) subsequent grafting of a CuI precursor, [Cu(O t Bu)]4, followed by a treatment under H2 to generate CuGa x alloys. This material is highly active and selective for CO2 hydrogenation to CH3OH. In situ X-ray absorption spectroscopy shows that gallium is oxidized under reaction conditions while copper remains as Cu0. This CuGa material only stabilizes methoxy surface species while no formate is detected according to ex situ infrared and solid-state nuclear magnetic resonance spectroscopy.

| S-EPMC8159433 | biostudies-literature

Copper-Based Catalysts for Selective Hydrogenation of Acetylene Derived from Cu(OH)2.

Project description:Replacing precious metals with cheap metals in catalysts is a topic of interest in both industry and academia but challenging. Here, a selective hydrogenation catalyst was prepared by thermal treatment of Cu(OH)2 nanowires with acetylene-containing gas at 120 °C followed by hydrogen reduction at 150 °C. The characterization by means of transmission electron microscopy observation, X-ray diffraction, and X-ray photoelectron spectroscopy revealed that two crystallites were present in the resultant catalyst. One of the crystal phases was metal Cu, whereas the other crystal phase was ascribed to an interstitial copper carbide (Cu x C) phase. The reduction of freshly prepared copper (II) acetylide (CuC2) at 150 °C also afforded the formation of Cu and Cu x C crystallites, indicating that CuC2 was the precursor or an intermediate in the formation of Cu x C. The prepared catalysts consisting of Cu and Cu x C exhibited a considerably high hydrogenation activity at low temperatures in the selective hydrogenation of acetylene in the ethylene stream. In the presence of a large excess of ethylene, acetylene was completely converted at 110 °C and atmospheric pressure with an ethane selectivity of <15%, and the conversion and selectivity were constant in a 260 h run.

| S-EPMC7860242 | biostudies-literature

Exploring the ternary interactions in Cu-ZnO-ZrO2 catalysts for efficient CO2 hydrogenation to methanol.

Project description:The synergistic interaction among different components in complex catalysts is one of the crucial factors in determining catalytic performance. Here we report the interactions among the three components in controlling the catalytic performance of Cu-ZnO-ZrO2 (CZZ) catalyst for CO2 hydrogenation to methanol. The in situ diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) measurements under the activity test pressure (3 MPa) reveal that the CO2 hydrogenation to methanol on the CZZ catalysts follows the formate pathway. Density functional theory (DFT) calculations agree with the in situ DRIFTS measurements, showing that the ZnO-ZrO2 interfaces are the active sites for CO2 adsorption and conversion, while the presence of metallic Cu is also necessary to facilitate H2 dissociation and to provide hydrogen resource. The combined experiment and DFT results reveal that tuning the interaction between ZnO and ZrO2 can be considered as another important factor for designing high performance catalysts for methanol generation from CO2.

| S-EPMC6411953 | biostudies-literature

Enhanced Methanol Synthesis from CO2 Hydrogenation Achieved by Tuning the Cu-ZnO Interaction in ZnO/Cu2O Nanocube Catalysts Supported on ZrO2 and SiO2.

Project description:The nature of the Cu-Zn interaction and especially the role of Zn in Cu/ZnO catalysts used for methanol synthesis from CO2 hydrogenation are still debated. Migration of Zn onto the Cu surface during reaction results in a Cu-ZnO interface, which is crucial for the catalytic activity. However, whether a Cu-Zn alloy or a Cu-ZnO structure is formed and the transformation of this interface under working conditions demand further investigation. Here, ZnO/Cu2O core-shell cubic nanoparticles with various ZnO shell thicknesses, supported on SiO2 or ZrO2 were prepared to create an intimate contact between Cu and ZnO. The evolution of the catalyst's structure and composition during and after the CO2 hydrogenation reaction were investigated by means of operando spectroscopy, diffraction, and ex situ microscopy methods. The Zn loading has a direct effect on the oxidation state of Zn, which, in turn, affects the catalytic performance. High Zn loadings, resulting in a stable ZnO catalyst shell, lead to increased methanol production when compared to Zn-free particles. Low Zn loadings, in contrast, leading to the presence of metallic Zn species during reaction, showed no significant improvement over the bare Cu particles. Therefore, our work highlights that there is a minimum content of Zn (or optimum ZnO shell thickness) needed to activate the Cu catalyst. Furthermore, in order to minimize catalyst deactivation, the Zn species must be present as ZnOx and not metallic Zn or Cu-Zn alloy, which is undesirably formed during the reaction when the precatalyst ZnO overlayer is too thin.

| S-EPMC10979448 | biostudies-literature

Differences in Deterioration Behaviors of Cu/ZnO/Al2O3 Catalysts with Different Cu Contents toward Hydrogenation of CO and CO2.

Project description:The deterioration behaviors of Cu/ZnO/Al2O3 (CZA) catalysts upon different Cu contents were elucidated. The fresh and spent catalysts after being used in CO and CO2 hydrogenation at 250 °C under atmospheric pressure were properly characterized using various techniques including X-ray powder diffraction, X-ray photoelectron spectroscopy, and temperature-programmed reduction for the changes of metal sites, while the textural and chemical properties and carbon deposition on spent CZA catalysts were analyzed by N2 physisorption, energy-dispersive X-ray spectroscopy, and temperature-programmed oxidation. During the hydrogenation reaction for both CO and CO2, the unstable Cu0 site on the spent CZA catalyst having a low Cu loading (sCZA-L) was oxidized to CuO and the aggregation of metal crystallite sites (Cu-ZnO and ZnO) was observed. Moreover, the amount of carbon deposition on sCZA-L (ca. >2%) is higher than the spent CZA catalyst having a high Cu loading (sCZA-H, ca. <0.5%). These phenomena led to a decrease in the surface area and the blockage of active sites. These findings can be determined on the catalytic deactivation and the obvious decrease in the catalytic activity of the CZA catalyst having a low Cu content (CZA-L, Cu:Zn = 0.8).

| S-EPMC9330176 | biostudies-literature

Coordination environment dependent selectivity of single-site-Cu enriched crystalline porous catalysts in CO2 reduction to CH4.

Project description:The electrochemical CO2 reduction to high-value-added chemicals is one of the most promising and challenging research in the energy conversion field. An efficient ECR catalyst based on a Cu-based conductive metal-organic framework (Cu-DBC) is dedicated to producing CH4 with superior activity and selectivity, showing a Faradaic efficiency of CH4 as high as ~80% and a large current density of -203 mA cm-2 at -0.9 V vs. RHE. The further investigation based on theoretical calculations and experimental results indicates the Cu-DBC with oxygen-coordinated Cu sites exhibits higher selectivity and activity over the other two crystalline ECR catalysts with nitrogen-coordinated Cu sites due to the lower energy barriers of Cu-O4 sites during ECR process. This work unravels the strong dependence of ECR selectivity on the Cu site coordination environment in crystalline porous catalysts, and provides a platform for constructing highly selective ECR catalysts.

| S-EPMC8568903 | biostudies-literature

CeO2 Frustrated Lewis Pairs Improving CO2 and CH3OH Conversion to Monomethylcarbonate.

Project description:Frustrated Lewis pairs (FLPs), discovered in the last few decades for homogeneous catalysts and in the last few years also for heterogeneous catalysts, are stimulating the scientific community's interest for their potential in small-molecule activation. Nevertheless, how an FLP activates stable molecules such as CO2 is still undefined. Through a careful spectroscopic study, we here report the formation of FLPs over a highly defective CeO2 sample prepared by microwave-assisted synthesis. Carbon dioxide activation over FLP is shown to occur through a bidentate carbonate bridging the FLP and implying a Ce3+-to-CO2 charge transfer, thus enhancing its activation. Carbon dioxide reaction with methanol to form monomethylcarbonate is here employed to demonstrate active roles of FLP and, eventually, to propose a reaction mechanism clarifying the role of Ce3+ and oxygen vacancies.

| S-EPMC10064321 | biostudies-literature

The active sites of Cu-ZnO catalysts for water gas shift and CO hydrogenation reactions.

Project description:Cu-ZnO-Al2O3 catalysts are used as the industrial catalysts for water gas shift (WGS) and CO hydrogenation to methanol reactions. Herein, via a comprehensive experimental and theoretical calculation study of a series of ZnO/Cu nanocrystals inverse catalysts with well-defined Cu structures, we report that the ZnO-Cu catalysts undergo Cu structure-dependent and reaction-sensitive in situ restructuring during WGS and CO hydrogenation reactions under typical reaction conditions, forming the active sites of CuCu(100)-hydroxylated ZnO ensemble and CuCu(611)Zn alloy, respectively. These results provide insights into the active sites of Cu-ZnO catalysts for the WGS and CO hydrogenation reactions and reveal the Cu structural effects, and offer the feasible guideline for optimizing the structures of Cu-ZnO-Al2O3 catalysts.

| S-EPMC8282834 | biostudies-literature

Hydrogen Production from Methanol Steam Reforming over Fe-Modified Cu/CeO2 Catalysts.

Project description:Fe-modified Cu catalysts with CeO2 support, prepared by the impregnation method, were subjected to physicochemical analysis and catalytic tests in the steam reforming of methanol (SRM). Physicochemical studies of the catalysts were carried out using the XRF, TEM, STEM-EDS, XRD, TPR and nitrogen adsorption/desorption methods. XRD, TEM studies and catalytic tests of the catalysts were carried out at two reduction temperatures, 260 °C and 400 °C, to determine the relationship between the form and oxidation state of the active phase of the catalysts and the catalytic properties of these systems in the SRM. Additionally, the catalysts after the reaction were analysed for the changes in the structure and morphology using TEM methods. The presented results show that the composition of the catalysts, morphology, structure, form and oxidation state of the Cu and Fe active metals in the catalysts and the reaction temperature significantly impact their activity, selectivity and stability in the SRM process. The gradual deactivation of the studied catalysts under SRM conditions could result from the forming of carbon deposits and/or the gradual oxidation of the copper and iron phases under the reaction conditions.

| S-EPMC11357062 | biostudies-literature

Electronic Metal-Support Interactions Between CuxO and ZnO for CuxO/ZnO Catalysts With Enhanced CO Oxidation Activity.

Project description:Metal-support interaction has been one of the main topics of research on supported catalysts all the time. However, many other factors including the particle size, shape and chemical composition can have significant influences on the catalytic performance when considering the role of metal-support interaction. Herein, we have designed a series of CuxO/ZnO catalysts as examples to quantitatively investigate how the metal-support interaction influences the catalytic performance. The electronic metal-support interactions between CuxO and ZnO were regulated successfully without altering the structure of CuxO/ZnO catalyst. Due to the lower work function of ZnO, electrons would transfer from ZnO to CuO, which is favorable for the formation of higher active Cu species. Combined experimental and theoretical calculations revealed that electron-rich interface result from interaction was favorable for the adsorption of oxygen and CO oxidation reaction. Such strategy represents a new direction to boost the catalytic activity of supported catalysts in various applications.

| S-EPMC9136224 | biostudies-literature