U(VI) adsorption in water by sodium alginate modified Bacillus megaterium.
Ontology highlight
ABSTRACT:
SUBMITTER: Li D
PROVIDER: S-EPMC8074630 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Polyelectrolyte complexes of sodium alginate and gelatin obtained from cold-blooded fish were studied for potential application as structure-forming agents in food hydrogels. The mass ratio of sodium alginate to gelatin plays a decisive role in the sol-gel transition and rheological behavior of the complexes. Differences in the sol-gel transition temperature were observed upon heating and cooling, as is typical for such materials. We investigated the characteristics of this transition by measuring the isothermal changes in the elastic modulus over time at a constant frequency and the transition temperature at a range of frequencies. The kinetic nature of this transition depends on the composition of the complexes. A characteristic alginate-gelatin mass ratio is the ratio at which maximum transition temperature as well as elastic modulus and viscosity (rheological parameters) values are obtained; the characteristic mass ratio for these complexes was found to be 0.06. Calculation of the ionic group ratios in the biopolymers that form complexes and comparison of these data with the turbidimetric titration results clarified the origin of these maxima. Measuring the viscoelastic properties and the creep-elastic recoil of the samples allowed us to characterize these materials as viscoelastic media with a viscosity in the order of 103-104 Pa·s and an elastic modulus in the order of 102-103 Pa. These values drastically decrease at a certain stress threshold, which can be treated as the gel strength limit. Therefore, the observed rheological behavior of gels formed by fish gelatin modified with sodium alginate characterizes them as typical viscoelastic soft matter.
| S-EPMC7957763 | biostudies-literature
Project description:Lanthanun oxide (La2O3) is a lanthanum chemical compound incorporates a sensible anionic complexing ability; however, it lacks stability at a low pH scale. Biochar fibers will give the benefit of their massive space and plethoric uses on the surface to support a metal chemical compound. Herein, wet spinning technology was used to load La3+ onto sodium alginate fiber, and to convert La3+ into La2O3 through carbonization. The La2O3-modified biochar (La-BC) fiber was characterized by SEM, XRD and XPS, etc. An adsorption experiment proved that La-BC showed an excellent adsorption capacity for chromates, and its saturation adsorption capacity was about 104.9 mg/g. The information suggested that the adsorption was in step with both the Langmuir and Freundlich models, following pseudo-second-order surface assimilation mechanics, which showed that the Cr (VI) adsorption was characterized by single-phase and polyphase adsorption, mainly chemical adsorption. The thermodynamic parameters proved that the adsorption process was spontaneous and endothermic. The mechanistic investigation revealed that the mechanism of the adsorption of Cr (VI) by La-BC may include electrostatic interaction, ligand exchange, or complexation. Moreover, the co-existing anions and regeneration experiments proved that the La-BC is recyclable and has good prospects in the field of chrome-containing wastewater removal.
| S-EPMC8123644 | biostudies-literature
Project description:Hydrogels have been widely used in water purification. However, there is not much discussion and comparison about the effects of different nanofillers on the reinforcement and adsorption performances of hydrogels, which can be subjected to rapid water flow and possess strong adsorption ability. In this work, polyacrylamide (PAAM)-sodium alginate (SA) interpenetrating polymer network-structured hydrogels were prepared by in situ polymerization. PAAM formed the first flexible network and SA constructed the second rigid network. Three kinds of inorganic nanoparticles including carbon nanotubes (CNTs), nanoclays (NCs), and nanosilicas (NSs) were incorporated into a PAAM-SA matrix via hydrogen bond. The obtained hydrogels exhibited a macroporous structure with low density (?1.4 g/cm3) and high water content (?83%). Compared with neat PAAM-SA, the hydrogels with inorganic nanoparticles possessed excellent mechanical strengths and elasticities, and the compression strength of PAAM-SA-NS reached up to 1.3 MPa at ? = 60% by adding only 0.036 g NS in a 30 g polymer matrix. However, CNT was the best filler to improve the adsorption capacity owing to its multi-walled hollow nanostructure, and the adsorption capacity of PAAM-SA-CNT was 1.28 times higher than that of PAAM-SA. The prepared hydrogels can be potential candidates for use as absorbents to treat wastewater.
| S-EPMC6722572 | biostudies-literature
Project description:Mesoporous silica nanoparticles (MSN) covered by polymer coatings, cross-linked by weak coordination bonds were expected to present a reversible responsiveness under on-off ultrasound stimuli. Herein, we prepared a sodium alginate (SA) modified MSN with carboxyl-calcium (COO--Ca2+) coordination bonds in the modified layer, which could block the mesopores of MSN and effectively prevent the cargo from pre-releasing before stimulation. The coordination bonds would be destroyed under the stimulation of low intensity ultrasound (20 kHz) or high intensity focused ultrasound (HIFU, 1.1 MHz), leading to a rapid and significant cargo release, and then they could be reformed when ultrasound was turned off, resulting in an instant cargo release stopping. The reversible cleavage and reformation of this coordination bonds under on-off ultrasound stimulus were confirmed by the gel-sol transition behaviors of the SA-CaCl2 gels. An excellent real-time control of rhodamine B (RhB) release performance was obtained under the ultrasound stimuli. Obviously, the cargo release ratio could reach to nearly 40% when HIFU (80 W) was turned on for 5 min, and remained basically constant when ultrasound was turned off, which would finally reach to nearly 100% within 30 min under this on-off pulsatile status. These hybrid MSN based nanoparticles with excellent reversible ultrasound on-off responsiveness were of great interest in on-demand drug delivery applications in the future.
| S-EPMC6378627 | biostudies-literature
Project description:With the commitment to reducing environmental impact, bio-based and biodegradable aerogels may be one approach when looking for greener solutions with similar attributes to current foam-like materials. This study aimed to enhance the mechanical, thermal, and flame-retardant behavior of poly(vinyl alcohol) (PVA) aerogels by adding sodium alginate (SA) and tannic acid (TA). Aerogels were obtained by freeze-drying and post-ion crosslinking through calcium chloride (CaCl2) and boric acid (H3BO3) solutions. The incorporation of TA and SA enhanced the PVA aerogel's mechanical properties, as shown by their high compressive specific moduli, reaching up to a six-fold increase after crosslinking and drying. The PVA/TA/SA aerogels presented a thermal conductivity of 0.043 to 0.046 W/m·K, while crosslinked ones showed higher values (0.049 to 0.060 W/m·K). Under TGA pyrolytic conditions, char layer formation reduced the thermal degradation rate of samples. After crosslinking, a seven-fold decrease in the thermal degradation rate was observed, confirming the high thermal stability of the formed foams. Regarding flammability, aerogels were tested through cone calorimetry. PVA/TA/SA aerogels showed a significant drop in the main parameters, such as the heat release rate (HRR) and the fire growth (FIGRA). The ion crosslinking resulted in a further reduction, confirming the improvement in the fire resistance of the modified compositions.
| S-EPMC9321210 | biostudies-literature
Project description:Water pollution caused by the highly toxic metal hexavalent chromium (Cr(VI)) creates significant human health and ecological risks. In this study, a novel adsorbent was used to treat Cr(VI)-containing wastewater; the adsorbent was prepared using red mud (RM) generated from the alumina production industry and the rare earth element lanthanum. This study explored adsorption performance, kinetics, and mechanisms. Results showed that the adsorption kinetics of the RM modified by lanthanum (La-RM), followed the pseudo-second-order model, with a rapid adsorption rate. Cr(VI) adsorption was positively associated with the absorbent dose, pH, temperature, and initial Cr(VI) concentration; coexisting anions had little impact. The maximum Cr(VI) adsorption capacity was 17.35 mg/g. Cr(VI) adsorption on La-RM was a mono-layer adsorption pattern, following the Langmuir isotherm model. Thermodynamic parameters showed the adsorption was spontaneous and endothermic. The adsorption of Cr(VI) on La-RM occurred as a result of LaOCl formation on the RM surface, which in turn further reacted with Cr(VI) in the wastewater. This study highlighted a method for converting industrial waste into a valuable material for wastewater treatment. The novel absorbent could be used as a potential adsorbent for treating Cr(VI)-contaminating wastewater, due to its cost-effectiveness and high adsorption capability.
| S-EPMC5033449 | biostudies-other
Project description:The intense use of herbicides for weed control in agriculture causes selection pressure on soil microbiota and water ecosystems, possibly resulting in changes to microbial processes, such as biogeochemical cycles. These xenobiotics may increase the production of reactive oxygen species and consequently affect the survival of microorganisms, which need to develop strategies to adapt to these conditions and maintain their ecological functionality. This study analyzed the adaptive responses of bacterial isolates belonging to the same species, originating from two different environments (water and soil), and subjected to selection pressure by herbicides. The effects of herbicide Callisto and its active ingredient, mesotrione, induced different adaptation strategies on the cellular, enzymatic, and structural systems of two Bacillus megaterium isolates obtained from these environments. The lipid saturation patterns observed may have affected membrane permeability in response to this herbicide. Moreover, this may have led to different levels of responses involving superoxide dismutase and catalase activities, and enzyme polymorphisms. Due to these response systems, the strain isolated from water exhibited higher growth rates than did the soil strain, in evaluations made in oligotrophic culture media, which would be more like that found in semi-pristine aquatic environments. The influence of the intracellular oxidizing environments, which changed the mode of degradation of mesotrione in our experimental model and produced different metabolites, can also be observed in soil and water at sites related to agriculture. Since the different metabolites may present different levels of toxicity, we suggest that this fact should be considered in studies on the fate of agrochemicals in different environments.
| S-EPMC5918998 | biostudies-literature
Project description:With the exploitation of rare earth ore, more and more REEs came into groundwater. This was a waste of resources and could be harmful to the organisms. This study aimed to find an efficient adsorption material to mitigate the above issue. Through doping sodium alginate (SA) with poly-γ-glutamate (PGA), an immobilized gel particle material was produced. The composite exhibited excellent capacity for adsorbing rare earth elements (REEs). The amount of La3+ adsorbed on the SA-PGA gel particles reached approximately 163.93 mg/g compared to the 81.97 mg/g adsorbed on SA alone. The factors that potentially affected the adsorption efficiency of the SA-PGA composite, including the initial concentration of REEs, the adsorbent dosage, and the pH of the solution, were investigated. 15 types of REEs in single and mixed aqueous solutions were used to explore the selective adsorption of REEs on gel particles. Scanning electron microscopy (SEM) and Fourier transform infrared (FT-IR) spectroscopy analyses of the SA and SA-PGA gel beads suggested that the carboxyl groups in the composite might play a key role in the adsorption process and the morphology of SA-PGA changed from the compact structure of SA to a porous structure after doping PGA. The kinetics and thermodynamics of the adsorption of REEs were well fit with the pseudo-second-order equation and the Langmuir adsorption isotherm model, respectively. It appears that SA-PGA is useful for recycling REEs from wastewater.
| S-EPMC4440748 | biostudies-literature
Project description:Polycyclic aromatic hydrocarbons (PAHs) have received extensive attention due to being highly toxic, mutagenic, and carcinogenic organic pollutants. As a result, a series of adsorbents have been designed and developed to solve the problem. In this paper, CuZnFeAl-S has been explored as a highly efficient adsorbent for PAHs. First, CuZnFeAl-LDH was prepared using a coprecipitation method and then calcined at 500 °C to obtain CuZnFeAlO. Finally, CuZnFeAl-S was prepared by modifying CuZnFeAlO with sodium dodecyl sulfate (SDS). The physical and chemical properties of the adsorbents were characterized by XRD, N2 adsorption-desorption, SEM, ICP, FT-IR, TG-DSC, and IGC; subsequently their adsorption performance was investigated. The results show that the surface properties of CuZnFeAl-S changed from hydrophilic to hydrophobic after SDS modification, which enhanced the adsorption of PAHs obviously. The removal of naphthalene and phenanthrene on CuZnFeAl-S reached 97.3% and 90.3%, respectively. And the adsorption process of naphthalene and phenanthrene conforms to Langmuir adsorption and Freundlich adsorption, respectively. Besides, the adsorption thermodynamics indicate that the adsorption of PAHs was a spontaneous exothermic reaction. The highly efficient PAH adsorption performance of CuZnFeAl-S is the synergistic result of various molecule interactions, such as hydrogen bonding, π-π interactions, and electrostatic attraction.
| S-EPMC9460979 | biostudies-literature
Project description:The complete annotated genome sequence of Bacillus megaterium bacteriophage Slash is described here. Several key features related to morphogenesis, replication/recombination, DNA metabolism, and lysis are described. Slash also encodes a homolog of SleB, a germination-specific cell wall amidase.
| S-EPMC3861416 | biostudies-literature