Perovskite versus ZnCuInS/ZnS Luminescent Nanoparticles in Wavelength-Shifting Layers for Sensor Applications.
Ontology highlight
ABSTRACT:
SUBMITTER: Sosna-Glebska A
PROVIDER: S-EPMC8124472 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Lead halide perovskites have recently emerged as promising X/γ-ray scintillators. However, the small Stokes shift of exciton luminescence in perovskite scintillators creates problems for the light extraction efficiency and severely impedes their applications in hard X/γ-ray detection. Dopants have been used to shift the emission wavelength, but the radioluminescence lifetime has also been unwantedly extended. Herein, we demonstrate the intrinsic strain in 2D perovskite crystals as a general phenomenon, which could be utilized as self-wavelength shifting to reduce the self-absorption effect without sacrificing the radiation response speed. Furthermore, we successfully demonstrated the first imaging reconstruction by perovskites for application of positron emission tomography. The coincidence time resolution for the optimized perovskite single crystals (4 × 4 × 0.8 mm3) reached 119 ± 3 ps. This work provides a new paradigm for suppressing the self-absorption effect in scintillators and may facilitate the application of perovskite scintillators in practical hard X/γ-ray detections.
| S-EPMC10192432 | biostudies-literature
Project description:Nanomaterials that can circulate in the body hold great potential to diagnose and treat disease. For such applications, it is important that the nanomaterials be harmlessly eliminated from the body in a reasonable period of time after they carry out their diagnostic or therapeutic function. Despite efforts to improve their targeting efficiency, significant quantities of systemically administered nanomaterials are cleared by the mononuclear phagocytic system before finding their targets, increasing the likelihood of unintended acute or chronic toxicity. However, there has been little effort to engineer the self-destruction of errant nanoparticles into non-toxic, systemically eliminated products. Here, we present luminescent porous silicon nanoparticles (LPSiNPs) that can carry a drug payload and of which the intrinsic near-infrared photoluminescence enables monitoring of both accumulation and degradation in vivo. Furthermore, in contrast to most optically active nanomaterials (carbon nanotubes, gold nanoparticles and quantum dots), LPSiNPs self-destruct in a mouse model into renally cleared components in a relatively short period of time with no evidence of toxicity. As a preliminary in vivo application, we demonstrate tumour imaging using dextran-coated LPSiNPs (D-LPSiNPs). These results demonstrate a new type of multifunctional nanostructure with a low-toxicity degradation pathway for in vivo applications.
| S-EPMC3058936 | biostudies-other
Project description:Novel strategies in the field of nanotechnology for the development of suitable multifunctional drug delivery vehicles have been pursued with promising upshots. Luminescent copper nanocluster-doped hydroxyapatite nanoparticles (HAP NPs) were synthesized and applied for the delivery of antibacterial drug kanamycin. The negatively charged doped HAP NPs could electrostatically interact with the positively charged kanamycin. The kanamycin-loaded doped HAP NPs showed pronounced activity in the case of Gram-negative bacteria compared to that in Gram-positive bacteria. Upon interaction with the bacteria, kanamycin could probably generate harmful agents such as hydroxyl radical that leads to bacterial cell damage. After being incorporated with copper nanoclusters (Cu NCs), the doped HAP NPs were applied for the bioimaging of bacterial cells. The biocompatibility of doped HAP NPs was also studied in HeLa cells. As compared to copper nanoclusters, the doped HAP NPs showed excellent biocompatibility even at higher concentrations of copper. The kanamycin-loaded doped HAP NPs were further applied toward Pseudomonas aeruginosa biofilm eradication. Thus, the as-synthesized copper nanocluster-doped HAP NPs were applied as nanocarriers for antibiotic drug delivery, bioimaging, and antibiofilm applications.
| S-EPMC6648608 | biostudies-literature
Project description:One source of instability in perovskite solar cells (PSCs) is interfacial defects, particularly those that exist between the perovskite and the hole transport layer (HTL). We demonstrate that thermally evaporated dopant-free tetracene (120 nm) on top of the perovskite layer, capped with a lithium-doped Spiro-OMeTAD layer (200 nm) and top gold electrode, offers an excellent hole-extracting stack with minimal interfacial defect levels. For a perovskite layer interfaced between these graded HTLs and a mesoporous TiO2 electron-extracting layer, its photoluminescence yield reaches 15% compared to 5% for the perovskite layer interfaced between TiO2 and Spiro-OMeTAD alone. For PSCs with graded HTL structure, we demonstrate efficiency of up to 21.6% and an extended power output of over 550 hours of continuous illumination at AM1.5G, retaining more than 90% of the initial performance and thus validating our approach. Our findings represent a breakthrough in the construction of stable PSCs with minimized nonradiative losses.
| S-EPMC6377269 | biostudies-literature
Project description:In this study, we present a promising and facile approach toward the fabrication of non-toxic, water-stable, and eco-friendly luminescent fiber paper composed of polycaprolactone (PCL) polymer and CsPbBr3@SiO2 core-shell perovskite nanocrystals. PCL-perovskite fiber paper was fabricated using a conventional electrospinning process. Transmission electron microscopy (TEM) clearly revealed incorporation of CsPbBr3@SiO2 nanocrystals in the fibers, while scanning electron microscopy (SEM) demonstrated that incorporation of CsPbBr3@SiO2 nanocrystals did not affect the surface and diameter of the PCL-perovskite fibers. In addition, thermogravimetric analysis (TGA) and contact angle measurements have demonstrated that the PCL-perovskite fibers exhibit excellent thermal and water stability. The fabricated PCL-perovskite fiber paper exhibited a bright green emission centered at 520 nm upon excitation by ultra-violet (UV) light (374 nm). We have demonstrated that fluorescent PCL-perovskite fiber paper is a promising candidate for anti-counterfeiting applications because various patterns can be printed on the paper, which only become visible after exposure to UV light at 365 nm. Cell proliferation tests revealed that the PCL-perovskite fibers are cytocompatibility. Consequently, they may be suitable for biocompatible anti-counterfeiting. The present study reveals that PCL-perovskite fibers may pave way toward next generation biomedical probe and anti-counterfeiting applications.
| S-EPMC10156878 | biostudies-literature
Project description:Dye-protein fluoromodules consist of fluorogenic dyes and single chain antibody fragments that form brightly fluorescent noncovalent complexes. This report describes two new bichromophoric dyes that extend the range of wavelengths of excitation or emission of existing fluoromodules. In one case, a fluorogenic thiazole orange (TO) was attached to an energy acceptor dye, Cy5. Upon binding to a protein that recognizes TO, red emission due to efficient energy transfer from TO to Cy5 replaces the green emission observed for monochromophoric TO bound to the same protein. Separately, TO was attached to a coumarin that serves as an energy donor. The same green emission is observed for coumarin-TO and TO bound to a protein, but efficient energy transfer allows violet excitation of coumarin-TO, versus longer wavelength, blue excitation of monochromophoric TO. Both bichromophores exhibit low nanomolar KD values for their respective proteins, >95% energy transfer efficiency and high fluorescence quantum yields.
| S-EPMC4520264 | biostudies-literature
Project description:Pure and Eu3+-doped zinc sulfide (ZnS) crystallites were synthesized through a hydrothermal method using water and ethanol (W/E) as the solvent. The powder samples have been characterized systematically using a number of characterization techniques such as X-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, photoluminescence spectroscopy, and UV-vis absorption spectroscopy. The band gap of ZnS and ZnS/xEu3+ was calculated according to absorption spectroscopy, and an obvious red shift with the increasing molar fraction of Eu3+-doped ions was found. The luminescent mechanism of ZnS was explored by measuring the emission spectra of ZnS with different ratios of Zn and S. The emission spectra of ZnS/xEu3+ included the characteristic emission peak of ZnS and Eu3+ ions. The CIE chromaticity coordinates of the ZnS/xEu3+ sample varied with the molar fraction of Eu3+ ions. The emission intensity and morphology changed with the ratio of W/E in the process of hydrothermal reaction. The results indicate that the luminescence of the ZnS crystallite can be modulated by doping a certain amount of Eu3+ ions, changing the ratio of Zn and S, or adding moderate ethanol as the reaction medium.
| S-EPMC6641465 | biostudies-literature
Project description:Graphene quantum dots (GQDs) possess excellent optical and electrical properties that can be used in a wide variety of application. Synthesis of hybrid nanoparticles with GQDs have been known to improve the properties further. Therefore, in this method, graphene quantum dots -gold (GQD-Au) hybrid nanoparticles were synthesized using GQDs which reduces HAuCl4.3H2O to Au nanoparticles on its surface at room temperature. The GQDs with self-passivated layers were synthesized by microwave assisted hydrothermal method using glucose as a single precursor. The synthesis process does not involve the use of harmful chemicals. The whole synthesis process of GQD and GQD-Au hybrid nanoparticles takes only five minutes. The synthesized GQDs have been extracted using citrate in order to increase the stability of the hybrid nanoparticles for up to four weeks. The size of the synthesized GQD-Au hybrid nanoparticles is in the range of 5-100 nm and were found to be luminescent under UV-A illumination. The merit of the following method over other synthesis techniques include its rapidity, ease of preparation, and no requirement of elaborate synthesis procedures and/or harmful chemicals. The GQD-Au hybrid nanoparticles can be used in several applications such as luminescent coatings for glass and windowpanes for automobiles, etc. The reducing property of GQDs can further be utilized for the reduction of various metal salts (AgNO3) and organic dyes (methylene blue and methyl orange). . It presents a method/protocol-development of the luminescent GQD-Au hybrid particles of size ~ 5-100 nm. . The GQD-Au hybrid particles find potential applications in luminescent coating applications.
| S-EPMC7327850 | biostudies-literature
Project description:Doping metal ions into lead halide perovskite nanocrystals (NCs) has attracted great attention over the past few years due to the emergence of novel properties relevant to optoelectronic applications. Here, the synthesis of Mn2+/Yb3+ codoped CsPbCl3 NCs through a hot-injection technique is reported. The resulting NCs show a unique triple-wavelength emission covering ultraviolet/blue, visible, and near-infrared regions. By optimizing the dopant concentrations, the total photoluminescence quantum yield (PL QY) of the codoped NCs can reach ≈125.3% due to quantum cutting effects. Mechanism studies reveal the efficient energy transfer processes from host NCs to Mn2+ and Yb3+ dopant ions, as well as a possible inter-dopant energy transfer from Mn2+ to Yb3+ ion centers. Owing to the high PL QYs and minimal reabsorption loss, the codoped perovskite NCs are demonstrated to be used as efficient emitters in luminescent solar concentrators, with greatly enhanced external optical efficiency compared to that of using solely Mn2+ doped CsPbCl3 NCs. This study presents a new model system for enriching doping chemistry studies and future applications of perovskite NCs.
| S-EPMC7509694 | biostudies-literature
Project description:Nanocrystalline cesium lead halide perovskites (CsPbX3, X?=?Cl, Br, and I) form an exciting new class of semiconductor materials showing quantum confinement. The emission color can be tuned over the full visible spectral region making them promising for light?emitting applications. Further control over the optical and magnetic properties of quantum dots (QDs) can be achieved through doping of transition metal (TM) ions such as Mn2+ or Co2+. Here we demonstrate how, following QD synthesis in the presence of a Mn?precursor, dropwise addition of silicon tetrachloride (SiCl4) to the QDs in toluene results in the formation of Mn?doped CsPbCl3 QDs showing bright orange Mn2+ emission around 600?nm. Evidence for successful doping is provided by excitation spectra of the Mn2+ emission, with all features of the CsPbCl3 QD absorption spectrum and a decrease of the 410?nm excitonic emission life time with increasing Mn?concentration, giving evidence for enhanced exciton to Mn2+ energy transfer. As a doping mechanism we propose a combination of surface etching and reconstruction and diffusion doping. The presently reported approach provides a promising avenue for doping TM ions into perovskites QDs enabling a wider control over optical and magnetic properties for this new class of QDs.
| S-EPMC5388844 | biostudies-other