Determination of SLES in Personal Care Products by Colloid Titration with Light Reflection Measurements.
Ontology highlight
ABSTRACT:
SUBMITTER: Ziolkowska D
PROVIDER: S-EPMC8124727 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Nanoplastics with small particle size and high surface area/volume ratio make them easy to absorb environmental pollutants and affect their bioavailability. In this study, polystyrene nanoplastic beads (PS-NPBs) with a particle size of 100nm and sunscreen butyl methoxydibenzoylmethane (BMDBM) contained in personal care products were chosen as target pollutants to study their developmental toxicity and interactive effects on zebrafish embryo. The exposure period was 2-12 hours post fertilization (hpf). The BMDBM and PS-NPBs significantly upregulated the genes related to antioxidant enzymes and downregulated the gene expression of aromatase and DNA methyltransferases, but the influenced genes were not exactly the same, and the combined exposure reduced the adverse effects on the expression of all genes. With the help of single-cell RNA sequencing technology, the neural mid cells were identified as the target cells of both pollutants, and brain development, head development and notch signaling pathway were the functions they commonly altered. The key genes and functions that are specifically affected by BMDBM and/or PS-NPBs were identified. The BMDBM mainly affect the differentiation and fate of neurons in central nervous system through the regulation of her5, her6, her11, lfng, pax2a and fgfr4. The PS-NPBs regulated the expression of olig2, foxg1a, fzd8b, six3a, rx1, lhx2b, nkx2.1a and sfrp5 to alter nervous system development, retinal development, and stem cell differentiation. The phenotypic responses of zebrafish larvae at 120 hpf were tested, and significant inhibition of locomotor activity was found, indicating that early disrupting effect on central nervous system would have a sustained impact on the behavior of zebrafish.
2020-09-12 | GSE157816 | GEO
Project description:Bacterial diversity in home and personal care products
| PRJEB19391 | ENA
Project description:Titanium dioxide is a common additive in many food, personal care, and other consumer products used by people, which after use can enter the sewage system and, subsequently, enter the environment as treated effluent discharged to surface waters or biosolids applied to agricultural land, incinerated wastes, or landfill solids. This study quantifies the amount of titanium in common food products, derives estimates of human exposure to dietary (nano-) TiO(2), and discusses the impact of the nanoscale fraction of TiO(2) entering the environment. The foods with the highest content of TiO(2) included candies, sweets, and chewing gums. Among personal care products, toothpastes and select sunscreens contained 1% to >10% titanium by weight. While some other crèmes contained titanium, despite being colored white, most shampoos, deodorants, and shaving creams contained the lowest levels of titanium (<0.01 ?g/mg). For several high-consumption pharmaceuticals, the titanium content ranged from below the instrument detection limit (0.0001 ?g Ti/mg) to a high of 0.014 ?g Ti/mg. Electron microscopy and stability testing of food-grade TiO(2) (E171) suggests that approximately 36% of the particles are less than 100 nm in at least one dimension and that it readily disperses in water as fairly stable colloids. However, filtration of water solubilized consumer products and personal care products indicated that less than 5% of the titanium was able to pass through 0.45 or 0.7 ?m pores. Two white paints contained 110 ?g Ti/mg while three sealants (i.e., prime coat paint) contained less titanium (25 to 40 ?g Ti/mg). This research showed that, while many white-colored products contained titanium, it was not a prerequisite. Although several of these product classes contained low amounts of titanium, their widespread use and disposal down the drain and eventually to wastewater treatment plants (WWTPs) deserves attention. A Monte Carlo human exposure analysis to TiO(2) through foods identified children as having the highest exposures because TiO(2) content of sweets is higher than other food products and that a typical exposure for a US adult may be on the order of 1 mg Ti per kilogram body weight per day. Thus, because of the millions of tons of titanium-based white pigment used annually, testing should focus on food-grade TiO(2) (E171) rather than that adopted in many environmental health and safety tests (i.e., P25), which is used in much lower amounts in products less likely to enter the environment (e.g., catalyst supports, photocatalytic coatings).
| S-EPMC3288463 | biostudies-literature
Project description:The impact of pharmaceutical and personal care products (PPCPs) on the performance of biological wastewater treatment plants (WWTPs) has been widely studied using whole-community approaches. These contaminants affect the capacity of microbial communities to transform nutrients; however, most have neither honed their examination on the nitrifying communities directly nor considered the impact on individual populations. In this study, six PPCPs commonly found in WWTPs, including a stimulant (caffeine), an antimicrobial agent (triclosan), an insect repellent ingredient (N,N-diethyl-m-toluamide (DEET)) and antibiotics (ampicillin, colistin and ofloxacin), were selected to assess their short-term toxic effect on enriched nitrifying cultures: Nitrosomonas sp. and Nitrobacter sp. The results showed that triclosan exhibited the greatest inhibition on nitrification with EC50 of 89.1 μg L-1. From the selected antibiotics, colistin significantly affected the overall nitrification with the lowest EC50 of 1 mg L-1, and a more pronounced inhibitory effect on ammonia-oxidizing bacteria (AOB) compared to nitrite-oxidizing bacteria (NOB). The EC50 of ampicillin and ofloxacin was 23.7 and 12.7 mg L-1, respectively. Additionally, experimental data suggested that nitrifying bacteria were insensitive to the presence of caffeine. In the case of DEET, moderate inhibition of nitrification (<40%) was observed at 10 mg L-1. These findings contribute to the understanding of the response of nitrifying communities in presence of PPCPs, which play an essential role in biological nitrification in WWTPs. Knowing specific community responses helps develop mitigation measures to improve system resilience.
| S-EPMC8580922 | biostudies-literature
Project description:Background and objectivesColloid osmotic pressure (COP) is a principal determinant of intravascular fluid homeostasis and a pillar of fluid therapy and transfusion. Transfusion-associated circulatory overload (TACO) is a leading complication of transfusion, and COP could be responsible for recruiting additional fluid. Study objective was to measure COP of blood products as well as investigate the effects of product concentration and storage lesion on COP.Materials and methodsThree units of each product were sampled longitudinally. COP was measured directly as well as the determinants thereof albumin and total protein. Conventional blood products, that is red blood cell (RBC), fresh-frozen plasma (FFP) and platelet concentrates (PLTs), were compared with their concentrated counterparts: volume-reduced RBCs, hyperconcentrated PLTs, and fully and partially reconstituted lyophilized plasma (prLP). Fresh and maximally stored products were measured to determine changes in protein and COP. We calculated potential volume load (PVL) to estimate volume recruited using albumin's water binding per product.ResultsColloid osmotic pressure varies widely between conventional products (RBCs, 1·9; PLTs, 7·5; and FFP, 20·1 mmHg); however, all are hypooncotic compared with human plasma COP (25·4 mmHg). Storage lesion did not increase COP. Concentrating RBCs and PLTs did not increase COP; only prLP showed a supraphysiological COP of 47·3 mm Hg. The PVL of concentrated products was lower than conventional products.ConclusionColloid osmotic pressure of conventional products was low. Therefore, third-space fluid recruitment is an unlikely mechanism in TACO. Concentrated products had a lower calculated fluid load and may prevent TACO. Finally, storage did not significantly increase oncotic pressure of blood products.
| S-EPMC7754447 | biostudies-literature
Project description:The dataset provides information on Pharmaceutical and Personal Care Products (PPCPs) detected in the Albufera Natural Park (Valencia, Spain), a typical Mediterranean coastal wetland. These PPCPs constitute an important group of organic pollutants highly representative of the human impact. The concentrations values measured in soil, sediment and water and the statistical relationship of contaminants between them and with the environmental parameters could help to understand their fate in different compartments. The data also reported the occurrence and removal efficiency (%) for each contaminant in ten wastewater treatment plants (WWTPs), located in the surrounding area. This dataset could provide an idea on the effectiveness of WWTP treatments and the capacity of released PPCPs to affect the ecosystem. The extraction of analytes was based on solid-phase extraction (SPE) for water and solvent extraction followed by the previous SPE as clean-up for soil and sediment. Determination was carried out by high performance liquid chromatography tandem mass spectrometry (HPLC-MS/MS) with a triple-quadrupole. The present dataset was analyzed within the article entitled: "Pharmaceuticals and personal care products in a Mediterranean coastal wetland: Impact of anthropogenic and spatial factors and environmental risk assessment"[1].
| S-EPMC8027530 | biostudies-literature
Project description:Titanium dioxide (TiO2) is a common component in personal care products (PCP), which through use enters the wastewater treatment plant (WWTP) and ultimately the environment. A citizen science approach is utilized here to inform the prevalence and usage of TiO2 containing PCP on a household scale, which generates information as to the quantity of TiO2 entering the WWTP, and the portion ultimately discharged to the environment. Meanwhile, citizen science sourced inventories were generated to estimate the quantity of TiO2, and potentially nanoscale TiO2 entering the WWTP from consumer products and to determine which products had the greatest contribution. The estimated values were compared with water samples from the WWTP which quantified the amount of total titanium present using ICP-AES. These values were at a similar level with other top-down estimation approaches and suggest that a citizen science approach is valid to estimate the loading of TiO2, and potentially other emerging contaminants, while at the same time engaging with community stakeholders.
| S-EPMC7390335 | biostudies-literature
Project description:One of the many ways by which bacteria control gene expression is through cis-acting regulatory mRNA elements called riboswitches. By specifically binding to small molecules or metabolites and pairing the binding event to an RNA structure change, riboswitches link a metabolic input to a transcriptional or translational output. For over a decade, isothermal titration calorimetry (ITC) has been used to investigate how riboswitches interact with small molecules. We present methods for assaying RNA-ligand interactions using ITC and analyzing resulting data to estimate thermodynamic parameters associated with binding.
| S-EPMC7324066 | biostudies-literature
Project description:We demonstrate the application of a high-throughput modeling framework to estimate exposure to chemicals used in personal care products (PCPs). As a basis for estimating exposure, we use the product intake fraction (PiF), defined as the mass of chemical taken by an individual or population per mass of a given chemical used in a product. We calculated use- and disposal- stage PiFs for 518 chemicals for five PCP archetypes. Across all product archetypes the use- and disposal- stage PiFs ranged from 10(-5) to 1 and 0 to 10(-3), respectively. There is a distinction between the use-stage PiF for leave-on and wash-off products which had median PiFs of 0.5 and 0.02 across the 518 chemicals, respectively. The PiF is a function of product characteristics and physico-chemical properties and is maximized when skin permeability is high and volatility is low such that there is no competition between skin and air losses from the applied product. PCP chemical contents (i.e. concentrations) were available for 325 chemicals and were combined with PCP usage characteristics and PiF yielding intakes summed across a demonstrative set of products ranging from 10(-8)-30 mg/kg/d, with a median of 0.1 mg/kg/d. The highest intakes were associated with body lotion. Bioactive doses derived from high-throughput in vitro toxicity data were combined with the estimated PiFs to demonstrate an approach to estimate bioactive equivalent chemical content and to screen chemicals for risk.
| S-EPMC7359637 | biostudies-literature
Project description:BACKGROUND: Over the past 10-15 years, a substantial amount of work has been done by the scientific, regulatory, and business communities to elucidate the effects and risks of pharmaceuticals and personal care products (PPCPs) in the environment. OBJECTIVE: This review was undertaken to identify key outstanding issues regarding the effects of PPCPs on human and ecological health in order to ensure that future resources will be focused on the most important areas. DATA SOURCES: To better understand and manage the risks of PPCPs in the environment, we used the "key question" approach to identify the principle issues that need to be addressed. Initially, questions were solicited from academic, government, and business communities around the world. A list of 101 questions was then discussed at an international expert workshop, and a top-20 list was developed. Following the workshop, workshop attendees ranked the 20 questions by importance. DATA SYNTHESIS: The top 20 priority questions fell into seven categories: a) prioritization of substances for assessment, b) pathways of exposure, c) bioavailability and uptake, d) effects characterization, e) risk and relative risk, f?) antibiotic resistance, and g) risk management. CONCLUSIONS: A large body of information is now available on PPCPs in the environment. This exercise prioritized the most critical questions to aid in development of future research programs on the topic.
| S-EPMC3440110 | biostudies-literature