Dataset Information

Ion-Exchange Resins for Efficient Removal of Colorants in Bis(hydroxyethyl) Terephthalate.

ABSTRACT: Bis(hydroxyethyl) terephthalate (BHET) obtained from waste poly(ethylene terephthalate) (PET) glycolysis often have undesirable colors, leading to an increased cost in the decoloration of the product and limiting the industrialization of chemical recycling. In this work, eight types of ion-exchange resins were used for BHET decoloration, and resin D201 showed an outstanding performance not only in the decoloration efficiency but also in the retention rate of the product. Under the optimal conditions, the removal rate of the colorant and the retention efficiency of BHET were over 99% and 95%, respectively. D201 showed outstanding reusability with five successive cycles, and the decolored BHET and its r-PET showed good chromaticity. Furthermore, the investigations of adsorption isotherms, kinetics, and thermodynamics have been conducted, which indicated that the decoloration process was a natural endothermic reaction. Adsorption interactions between the colorant and resin were extensively examined by various characterizations, revealing that electrostatic force, π-π interactions, and hydrogen bonding were the dominant adsorption mechanisms.

SUBMITTER: Huang R

PROVIDER: S-EPMC8154176 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:Detecting clandestine, intermittent release of heavy metal pollution into natural and man-made water ways is challenging. Conventional chemical methods are both labor intensive and expensive. A recent approach combining ion-exchange resins with the capabilities of X-ray fluorescence core scanners (XRF-CS) therefore is of great interest. In short, ion-exchange resin is deployed in the water using small sachets, the resin is then collected, dried, filled into sample holders and scanned using XRF-CS. Ion-exchange resins take up heavy metals in proportion to the concentration in the ambient water, with a correlation coefficient (R2) between concentration and XRF-CS counts better than 0.96 for most elements. However, a number of parameters influence the measurements. Different drying methods introduce differences in the XRF counts because of lattice bound water, resin shrinkage, and disaggregation of the resin particles. Furthermore, the newly developed sample carrier, which was constructed using 3D printed polymers, contains trace amounts of elements that may influence the sample measurements through edge effects and secondary fluorescence. In the tested sample carrier materials, substantial levels of Cr, Fe, Co, and Zn were detected, while Ca, Ti, Ni, Cu, Ga showed variable levels. Ba, Tl and Bi show very low levels, and Pb is only of importance in the PLA carrier. It is therefore necessary to streamline the analysis-process to ensure that the variations in sample treatment and drying and filling methods are minimized. It is also recommended that only spectra from the center of the compartments are used for the evaluation to avoid edge effects caused by secondary fluorescence of metals in the compartment walls. Although the technique of using ion-exchange resin sachets and XRF-CS analysis is only semi-quantitative, it is a cost effective and fast way to monitor large areas for environmental pollution, and the new sample carrier greatly contributes to make the process faster and less error prone.

Dataset Information

Ion-Exchange Resins for Efficient Removal of Colorants in Bis(hydroxyethyl) Terephthalate.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets