Closing the Loop with Keratin-Rich Fibrous Materials.
Ontology highlight
ABSTRACT:
SUBMITTER: Perta-Crisan S
PROVIDER: S-EPMC8201023 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Keratins are structural proteins that are abundant in human skin, nails, and hair, where they provide mechanical strength. In the present study, we investigate the molecular mobilities and structures of three keratin-rich materials with clearly different mechanical properties: nails, stratum corneum (upper layer of epidermis), and keratinocytes (from lower layer of epidermis). We use solid-state NMR on natural-abundance 13C to characterize small changes in molecular dynamics in these biological materials with close to atomistic resolution. One strong advantage of this method is that it detects small fractions of mobile components in a molecularly complex material while it simultaneously gives information on the rigid components in the very same sample. The molecular mobility can be linked to mechanical material properties in different conditions, including hydration or exposure to osmolytes or organic solvents. Importantly, the study revealed that the response to both hydration and addition of urea is clearly different for the nail keratin compared to the stratum corneum keratin. The comparative examination of these materials may provide a better understanding of skin diseases originating from keratin malfunction and contributes to the design and development of new materials.
| S-EPMC10265668 | biostudies-literature
Project description:The ability of various commercial fibrous carbon materials to withstand stress and conduct heat has been evaluated through experimental and analytical studies. The combined effects of different micro/macro-structural characteristics were discussed and compared. Large differences in mechanical behavior were observed between the different groups or subgroups of fibrous materials, due to the different types of fibers and the mechanical and/or chemical bonds between them. The application of the Mooney-Rivlin model made it possible to determine the elastic modulus of soft felts, with a few exceptions, which were studied in-depth. The possible use of two different mechanical test methods allowed a comparison of the results in terms of elastic modulus obtained under different deformation regimes. The effective thermal conductivity of the same fibrous materials was also studied and found to be much lower than that of a single carbon fiber due to the high porosity, and varied with the bulk density and the fiber organization involving more or less thermal contact resistances. The thermal conductivity of most materials is highly anisotropic, with higher values in the direction of preferential fiber orientation. Finally, the combination of compression and transient thermal conductivity measurement techniques allowed the heat conduction properties of the commercial fibrous carbons to be investigated experimentally when compressed. It was observed that thermal conductivity is strongly affected under compression, especially perpendicular to the main fiber orientation.
| S-EPMC8038575 | biostudies-literature
Project description:Frontotemporal lobar degeneration comprises a group of disorders characterized by behavioural, executive, language impairment and sometimes features of parkinsonism and motor neuron disease. In 1994 we described an Irish-American family with frontotemporal dementia linked to chromosome 17 associated with extensive tau pathology. We named this disinhibition-dementia-parkinsonism-amyotrophy complex. We subsequently identified mutations in the MAPT gene. Eleven MAPT gene splice site stem loop mutations were identified over time except for 5' splice site of exon 10. We recently identified another Irish family with autosomal dominant early amnesia and behavioural change or parkinsonism associated with the 'missing' +15 mutation at the intronic boundary of exon 10. We performed a clinical, neuropsychological and neuroimaging study on the proband and four siblings, including two affected siblings. We sequenced MAPT and performed segregation analysis. We looked for a biological effect of the tau variant by performing real-time polymerase chain reaction analysis of RNA extracted from human embryonic kidney cells transfected with exon trapping constructs. We found a c.915+15A>C exon 10/intron 10 stem loop mutation in all affected subjects but not in the unaffected. The c.915+15A>C variant caused a shift in tau splicing pattern to a predominantly exon 10+ pattern presumably resulting in predominant 4 repeat tau and little 3 repeat tau. This strongly suggests that the c.915+15A>C variant is a mutation and that it causes frontotemporal dementia linked to chromosome 17 in this pedigree by shifting tau transcription and translation to +4 repeat tau. Tau (MAPT) screening should be considered in families where amnesia or atypical parkinsonism coexists with behavioural disturbance early in the disease process. We describe the final missing stem loop tau mutation predicted 15 years ago. Mutations have now been identified at all predicted sites within the 'stem' when the stem-loop model was first proposed and no mutations have been found within the 'loop' region as expected. Therefore we 'close the tau loop' having 'opened the loop' 21 years ago.
| S-EPMC5006396 | biostudies-literature
Project description:A method was developed in which cellulose (CEL) and/or chitosan (CS) were added to keratin (KER) to enable [CEL/CS+KER] composites to have better mechanical strength and wider utilization. Butylmethylimmidazolium chloride ([BMIm(+)Cl(-)]), an ionic liquid, was used as the sole solvent, and because the [BMIm(+)Cl(-)] used was recovered, the method is green and recyclable. Fourier transform infrared spectroscopy results confirm that KER, CS, and CEL remain chemically intact in the composites. Tensile strength results expectedly show that adding CEL or CS into KER substantially increases the mechanical strength of the composites. We found that CEL, CS, and KER can encapsulate drugs such as ciprofloxacin (CPX) and then release the drug either as a single or as two- or three-component composites. Interestingly, release rates of CPX by CEL and CS either as a single or as [CEL+CS] composite are faster and independent of concentration of CS and CEL. Conversely, the release rate by KER is much slower, and when incorporated into CEL, CS, or CEL+CS, it substantially slows the rate as well. Furthermore, the reducing rate was found to correlate with the concentration of KER in the composites. KER, a protein, is known to have secondary structure, whereas CEL and CS exist only in random form. This makes KER structurally denser than CEL and CS; hence, KER releases the drug slower than CEL and CS. The results clearly indicate that drug release can be controlled and adjusted at any rate by judiciously selecting the concentration of KER in the composites. Furthermore, the fact that the [CEL+CS+KER] composite has combined properties of its components, namely, superior mechanical strength (CEL), hemostasis and bactericide (CS), and controlled drug release (KER), indicates that this novel composite can be used in ways which hitherto were not possible, e.g., as a high-performance bandage to treat chronic and ulcerous wounds.
| S-EPMC4318626 | biostudies-literature
Project description: Not available
| S-EPMC8845068 | biostudies-literature
Project description:The RNA polymerase (RNAP) trigger loop (TL) is a mobile structural element of the RNAP active center that, based on crystal structures, has been proposed to cycle between an "unfolded"/"open" state that allows an NTP substrate to enter the active center and a "folded"/"closed" state that holds the NTP substrate in the active center. Here, by quantifying single-molecule fluorescence resonance energy transfer between a first fluorescent probe in the TL and a second fluorescent probe elsewhere in RNAP or in DNA, we detect and characterize TL closing and opening in solution. We show that the TL closes and opens on the millisecond timescale; we show that TL closing and opening provides a checkpoint for NTP complementarity, NTP ribo/deoxyribo identity, and NTP tri/di/monophosphate identity, and serves as a target for inhibitors; and we show that one cycle of TL closing and opening typically occurs in each nucleotide addition cycle in transcription elongation.
| S-EPMC7355006 | biostudies-literature
Project description:Protein loop dynamics have recently been recognized as central to enzymatic activity, specificity and stability. However, the factors controlling loop opening and closing kinetics have remained elusive. Here, we combine molecular dynamics simulations with string-method determination of complex reaction coordinates to elucidate the molecular mechanism and rate-limiting step for WPD-loop dynamics in the PTP1B enzyme. While protein conformational dynamics is often represented as diffusive motion hindered by solvent viscosity and internal friction, we demonstrate that loop opening and closing is activated. It is governed by torsional rearrangement around a single loop peptide group and by significant friction caused by backbone adjustments, which can dynamically trap the loop. Considering both torsional barrier and time-dependent friction, our calculated rate constants exhibit very good agreement with experimental measurements, reproducing the change in loop opening kinetics between proteins. Furthermore, we demonstrate the applicability of our results to other enzymatic loops, including the M20 DHFR loop, thereby offering prospects for loop engineering potentially leading to enhanced designs.
| S-EPMC10955111 | biostudies-literature
Project description:The first ribozymes are thought to have emerged at a time when RNA replication proceeded via nonenzymatic template copying processes. However, functional RNAs have stable folded structures, and such structures are much more difficult to copy than short unstructured RNAs. How can these conflicting requirements be reconciled? Also, how can the inhibition of ribozyme function by complementary template strands be avoided or minimized? Here, we show that short RNA duplexes with single-stranded overhangs can be converted into RNA stem loops by nonenzymatic cross-strand ligation. We then show that loop-closing ligation reactions enable the assembly of full-length functional ribozymes without any external template. Thus, one can envisage a potential pathway whereby structurally complex functional RNAs could have formed at an early stage of evolution when protocell genomes might have consisted only of collections of short replicating oligonucleotides.
| S-EPMC9354263 | biostudies-literature
Project description:Description Synthetic fibrous materials were engineered to contract under cellular forces similar to natural extracellular matrix. The natural extracellular matrix (ECM) within tissues is physically contracted and remodeled by cells, allowing the collective shaping of functional tissue architectures. Synthetic materials that facilitate self-assembly similar to natural ECM are needed for cell culture, tissue engineering, and in vitro models of development and disease. To address this need, we develop fibrous hydrogel assemblies that are stabilized with photocrosslinking and display fiber density–dependent strain-responsive properties (strain stiffening and alignment). Encapsulated mesenchymal stromal cells locally contract low fiber density assemblies, resulting in macroscopic volumetric changes with increased cell densities and moduli. Because of properties such as shear-thinning and self-healing, assemblies can be processed into microtissues with aligned ECM deposition or through extrusion bioprinting and photopatterning to fabricate constructs with programmed shape changes due to cell contraction. These materials provide a synthetic approach to mimic features of natural ECM, which can now be processed for applications in biofabrication and tissue engineering.
| S-EPMC8580309 | biostudies-literature
Project description:Asbestos has been banned in many countries but many countries, including developing countries, are still using asbestos or materials containing asbestos. Substitute materials have been studied and developed over a long period of time because of the hazards of asbestos, and many people have recently shown interest in the hazards of substitute materials. However, comprehensive information about the types of asbestos substitutes, their use and health hazards, and references for the protection for the health of workers is limited. The purpose of this study is to provide people in the related industries with information on the types and health hazards of fibrous materials that can be used as asbestos substitutes. According to the patent resources from the United States and Europe, fibrous materials have been used to develop asbestos-free products since before 1980. Recently, the health hazards of asbestos substitutes have been assessed and many additional researches are required. However, only some of the substitute materials have been assessed for health hazards, and health hazard data has not been sufficient in many cases. Therefore, efforts should be made to minimize workers' exposure to substitute materials that do not contain asbestos.
| S-EPMC6129992 | biostudies-literature