The TSIS-1 Hybrid Solar Reference Spectrum.
Ontology highlight
ABSTRACT:
SUBMITTER: Coddington OM
PROVIDER: S-EPMC8244077 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Perovskite solar cells have shown a meteoric rise of power conversion efficiency and a steady pace of improvements in their stability of operation. Such rapid progress has triggered research into approaches that can boost efficiencies beyond the Shockley-Queisser limit stipulated for a single-junction cell under normal solar illumination conditions. The tandem solar cell architecture is one concept here that has recently been successfully implemented. However, the approach of solar concentration has not been sufficiently explored so far for perovskite photovoltaics, despite its frequent use in the area of inorganic semiconductor solar cells. Here, the prospects of hybrid perovskites are assessed for use in concentrator solar cells. Solar cell performance parameters are theoretically predicted as a function of solar concentration levels, based on representative assumptions of charge-carrier recombination and extraction rates in the device. It is demonstrated that perovskite solar cells can fundamentally exhibit appreciably higher energy-conversion efficiencies under solar concentration, where they are able to exceed the Shockley-Queisser limit and exhibit strongly elevated open-circuit voltages. It is therefore concluded that sufficient material and device stability under increased illumination levels will be the only significant challenge to perovskite concentrator solar cell applications.
| S-EPMC5908368 | biostudies-literature
Project description:Silicon nanoarray hybrid solar cells benefit from the ease of fabrication and the cost-effectiveness of the hybrid structure, and represent a new research focus towards the utilization of solar energy. However, hybrid solar cells composed of both inorganic and organic components suffer from the notorious stability issue, which has to be tackled before the hybrid solar cells could become a viable alternative for harvesting solar energy. Here we show that Si nanoarray/PEDOT:PSS hybrid solar cells with improved stability can be fabricated via eliminating the water inclusion in the initial formation of the heterojunction between Si nanoarray and PEDOT:PSS. The Si nanoarray hybrid solar cells are stable against rapid degradation in the atmosphere environment for several months without encapsulation. This finding paves the way towards the real-world applications of Si nanoarray hybrid solar cells.
| S-EPMC3893641 | biostudies-literature
Project description:The Atacama Desert has been pointed out as one of the places on earth where the highest surface irradiance may occur. This area is characterized by its high altitude, prevalent cloudless conditions and relatively low columns of ozone and water vapor. Aimed at the characterization of the solar spectrum in the Atacama Desert, we carried out in February-March 2015 ground-based measurements of the spectral irradiance (from the ultraviolet to the near infrared) at seven locations that ranged from the city of Antofagasta (on the southern pacific coastline) to the Chajnantor Plateau (5,100 m altitude). Our spectral measurements allowed us to retrieve the total ozone column, the precipitable water, and the aerosol properties at each location. We found that changes in these parameters, as well as the shorter optical path length at high-altitude locations, lead to significant increases in the surface irradiance with the altitude. Our measurements show that, in the range 0-5100 m altitude, surface irradiance increases with the altitude by about 27% in the infrared range, 6% in the visible range, and 20% in the ultraviolet range. Spectral measurements carried out at the Izaña Observatory (Tenerife, Spain), in Hannover (Germany) and in Santiago (Chile), were used for further comparisons.
| S-EPMC4773812 | biostudies-other
Project description:Over the last few years, a growing interest has surfaced about the possibility of enhancing solar harvester efficiency by coupling photovoltaic (PV) cells with thermoelectric generators (TEGs). To be effective solutions, hybrid thermoelectric-photovoltaic (HTEPV) solar harvesters must not only increase the solar conversion efficiency but should also be economically competitive. The aim of this paper is to estimate the profitability of HTEPV solar harvesters with no reference to specific materials, relating it instead to their physical properties only and thus providing a tool to address research effort toward classes of HTEPV systems able to compete with current PV technologies. An economic convenience index is defined and used to assess the economic sustainability of hybridization. It is found that, although hybridization often leads to enhanced solar power conversion, power costs (USD/W) may not always justify HTEPV deployment at the current stage of technology. An analysis of the cost structure shows that profitability requires largely enhanced thermoelectric stages, concentrated solar cells, or PV materials with favorable temperature efficiency coefficients, such as perovskite solar cells.
| S-EPMC8159161 | biostudies-literature
Project description:Recently, inorganic/organic hybrid solar cells have been considered as a viable alternative for low-cost photovoltaic devices because the Schottky junction between inorganic and organic materials can be formed employing low temperature processing methods. We present an efficient hybrid solar cell based on highly ordered silicon nanopillars (SiNPs) and poly(3,4-ethylene-dioxythiophene):polystyrenesulfonate (PEDOT:PSS). The proposed device is formed by spin coating the organic polymer PEDOT:PSS on a SiNP array fabricated using metal assisted electroless chemical etching process. The characteristics of the hybrid solar cells are investigated as a function of SiNP height. A maximum power conversion efficiency (PCE) of 9.65% has been achieved for an optimized SiNP array hybrid solar cell with nanopillar height of 400 nm, despite the absence of a back surface field enhancement. The effect of an ultrathin atomic layer deposition (ALD), grown aluminum oxide (Al2O3), as a passivation layer (recombination barrier) has also been studied for the enhanced electrical performance of the device. With the inclusion of the ultrathin ALD deposited Al2O3 between the SiNP array textured surface and the PEDOT:PSS layer, the PCE of the fabricated device was observed to increase to 10.56%, which is ∼10% greater than the corresponding device without the Al2O3 layer. The device described herein is considered to be promising toward the realization of a low-cost, high-efficiency inorganic/organic hybrid solar cell.
| S-EPMC4142496 | biostudies-literature
Project description:The challenge in solar energy today is not the cost of photovoltaic (PV) electricity generation, already competing with fossil fuel prices, but rather utility-scale energy storage and flexibility in supply. Low-cost thermal energy storage (TES) exists but relies on expensive heat engines. Here, we introduce the concept of luminescent solar power (LSP), where sunlight is absorbed in a photoluminescent (PL) absorber, followed by red-shifted PL emission matched to an adjacent PV cell's band edge. This way the PV cell operates nearly as efficiently as under direct illumination but with minimal excessive heat. The PL absorber temperature rises because of thermalization, allowing it to store the excessive heat, which can later be converted into electricity. Tailored luminescent materials that support an additional 1.5 kW h PV electricity for every 1 kW h of (virtual) heat engine electricity with a dynamic shift between the two sources are experimentally demonstrated. Such an ideal hybrid system may lead to a potential reduction in the cost of electricity for a base-load solution.
| S-EPMC7526987 | biostudies-literature
Project description:Smart windows can selectively regulate excess solar radiation to reduce heating and cooling energy consumption in the built environment. However, the inevitable dissipation of ultraviolet and near-infrared into waste heat results in inefficient solar utilization. Herein, a dual-band selective solar harvesting (SSH) window is developed to realize full-spectrum utilization. A transparent photovoltaic, converting ultraviolet into electricity, and a transparent solar absorber, converting near-infrared into thermal energy, are integrated and coupled with a ventilation system to extract heat for indoor use. Compared with common transparent photovoltaics, the SSH window increases solar harvesting efficiency up to threefold while maintaining a considerable visible transmittance. Simulations suggest that the SSH window, besides generating electricity, delivers energy savings by over 30% higher than common smart windows. This is the first integration of transparent photovoltaic and transparent solar absorber into a window, which may open up a new avenue for the development of energy-efficient buildings.
| S-EPMC9313496 | biostudies-literature
Project description:Present environmental issues force the research to explore radically new concepts in sustainable and renewable energy production. In the present work, a functional fluid consisting of a stable colloidal suspension of maghemite magnetic nanoparticles in water was characterized from the points of view of thermoelectrical and optical properties, to evaluate its potential for direct electricity generation from thermoelectric effect enabled by the absorption of sunlight. These nanoparticles were found to be an excellent solar radiation absorber and simultaneously a thermoelectric power-output enhancer with only a very small volume fraction when the fluid was heated from the top. These findings demonstrate the investigated nanofluid's high promise as a heat transfer fluid for co-generating heat and power in brand new hybrid flat-plate solar thermal collectors where top-heating geometry is imposed.
| S-EPMC8074063 | biostudies-literature
Project description:A retrospective study was carried out where histopathology records of Department of Pathology, Armed Forces Medical College, Pune were scrutinised covering a period of 10 years. We came across 325 cases of nephropathies. The sample comprised of 92.6% adults and 7.4% children. 79.7% were males and 20.3% were females. The patient population comprised of 35.1% serving soldiers, 37.8% their family members and 27.1% not related to Armed Forces. The study is based on only light microscopy findings. It was observed that primary glomerular disease was the commonest entity and comprised of 61.5% of all the nephropathies. Acute diffuse proliferative glomerulonephritis was not only the commonest primary glomerulopathy (23.5%) but the commonest nephropathy as well. The other primary glomerulopathies in descending order of frequency were, membranoproliferative glomerulonephritis (22.5%), mesangioproliferative glomerulonephritis (21.5%), chronic glomerulonephritis (9%), minimal change disease (7.5%), membranous glomerulopathy (7%), focal segmental glomerulosclerosis (5%) and crescentic glomerulonephritis (4%). We had only 14 cases (4.3% of all nephropathies) of secondary glomerulopathies, amongst which amyloidosis was the commonest cause. We came across 2 cases (0.6% of all nephropathies) of Alport's syndrome. In the other nephropathies, 22.2% were tubulointerstitial diseases and 5.5% were malignant kidney tumors. In 5.8% renal biopsies, no significant pathology was seen on light microscopy.
| S-EPMC5532003 | biostudies-other
Project description:Natural photosynthesis harnesses solar energy to convert CO2 and water to value-added chemical products for sustaining life. We present a hybrid bioinorganic approach to solar-to-chemical conversion in which sustainable electrical and/or solar input drives production of hydrogen from water splitting using biocompatible inorganic catalysts. The hydrogen is then used by living cells as a source of reducing equivalents for conversion of CO2 to the value-added chemical product methane. Using platinum or an earth-abundant substitute, α-NiS, as biocompatible hydrogen evolution reaction (HER) electrocatalysts and Methanosarcina barkeri as a biocatalyst for CO2 fixation, we demonstrate robust and efficient electrochemical CO2 to CH4 conversion at up to 86% overall Faradaic efficiency for ≥ 7 d. Introduction of indium phosphide photocathodes and titanium dioxide photoanodes affords a fully solar-driven system for methane generation from water and CO2, establishing that compatible inorganic and biological components can synergistically couple light-harvesting and catalytic functions for solar-to-chemical conversion.
| S-EPMC4577177 | biostudies-other