Pristine and Modified Porous Membranes for Zinc Slurry-Air Flow Battery.

ABSTRACT: The membrane is a crucial component of Zn slurry-air flow battery since it provides ionic conductivity between the electrodes while avoiding the mixing of the two compartments. Herein, six commercial membranes (Cellophane™ 350PØØ, Zirfon^®, Fumatech^® PBI, Celgard^® 3501, 3401 and 5550) were first characterized in terms of electrolyte uptake, ion conductivity and zincate ion crossover, and tested in Zn slurry-air flow battery. The peak power density of the battery employing the membranes was found to depend on the in-situ cell resistance. Among them, the cell using Celgard^® 3501 membrane, with in-situ area resistance of 2 Ω cm² at room temperature displayed the highest peak power density (90 mW cm^-2). However, due to the porous nature of most of these membranes, a significant crossover of zincate ions was observed. To address this issue, an ion-selective ionomer containing modified poly(phenylene oxide) (PPO) and N-spirocyclic quaternary ammonium monomer was coated on a Celgard^® 3501 membrane and crosslinked via UV irradiation (PPO-3.45 + 3501). Moreover, commercial FAA-3 solutions (FAA, Fumatech) were coated for comparison purpose. The successful impregnation of the membrane with the anion-exchange polymers was confirmed by SEM, FTIR and Hg porosimetry. The PPO-3.45 + 3501 membrane exhibited 18 times lower zincate ions crossover compared to that of the pristine membrane (5.2 × 10^-13 vs. 9.2 × 10^-12 m² s^-1). With low zincate ions crossover and a peak power density of 66 mW cm^-2, the prepared membrane is a suitable candidate for rechargeable Zn slurry-air flow batteries.

SUBMITTER: Tsehaye MT 

PROVIDER: S-EPMC8272061 | biostudies-literature |

REPOSITORIES: biostudies-literature