Molecular, Structural, and Rheological Characterization of Camel Skin Gelatin Extracted Using Different Pretreatment Conditions.
Ontology highlight
ABSTRACT:
SUBMITTER: Fawale OS
PROVIDER: S-EPMC8304296 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:This study explores the molecular structuring of salmon gelatin (SG) with controlled molecular weight produced from salmon skin, and its relationship with its thermal and rheological properties. SG was produced under different pH conditions to produce samples with well-defined high (SGH), medium (SGM), and low (SGL) molecular weight. These samples were characterized in terms of their molecular weight (MW, capillary viscometry), molecular weight distribution (electrophoresis), amino acid profile, and Raman spectroscopy. These results were correlated with thermal (gelation energy) and rheological properties. SGH presented the higher MW (173 kDa) whereas SGL showed shorter gelatin polymer chains (MW < 65 kDa). Raman spectra and gelation energy suggest that amount of helical structures in gelatin is dependent on the molecular weight, which was well reflected by the higher viscosity and G' values for SGH. Interestingly, for all the molecular weight and molecular configuration tested, SG behaved as a strong gel (tan δ < 1), despite its low viscosity and low gelation temperature (3-10 °C). Hence, the molecular structuring of SG reflected directly on the thermal and viscosity properties, but not in terms of the viscoelastic strength of gelatin produced. These results give new insights about the relationship among structural features and macromolecular properties (thermal and rheological), which is relevant to design a low viscosity biomaterial with tailored properties for specific applications.
| S-EPMC7407307 | biostudies-literature
Project description:The aim of this study was to investigate the rheological, physical, and mechanical properties of chicken skin gelatin film forming solutions (FFSs) and films incorporated with potato starch. Chicken skin gelatin-based FFSs with various potato starch concentrations (0, 2, 4, 6, 8, and 10%, w/w) were prepared via casting technique. The dynamic viscoelastic properties of FFS were measured, and film characterization in terms of physical and mechanical properties was conducted. Potato starch incorporation with chicken skin gelatin-based FFS resulted in improvement of viscous behavior (G″ > G'). As potato starch concentration increased, the tensile strength, elongation at break, and elastic modulus values of chicken skin gelatin-based films also increased (p < 0.05). Additionally, increasing the concentration of potato starch caused incremental changes in water vapor permeability and melting temperatures (T m), but a reduction in water solubility (p < 0.05). In addition, the surface smoothness and internal structure of composite films improved via potato starch incorporation. The incorporation of potato starch was also found to provide good barrier properties against ultraviolet and visible light, but did not significantly influence the transparency values of composite films. Overall, chicken skin gelatin film with 6% potato starch concentration incorporation was the most promising composite film, since it was found to exhibit optimal performance in terms of physical properties.
| S-EPMC6892799 | biostudies-literature
Project description:The poultry processing industrial wastes are rich sources of gelatin protein, which can be utilized for various industrial sectors. The present investigation was conducted to evaluate the effect of freeze-drying (FD) and hot air drying (HAD) on the physicochemical, structural, thermal, and functional characteristics of chicken feet gelatin. The yield (%) of extracted FD and HAD gelatin was 14.7 and 14.5%, respectively. The gelatin samples showed lower percent transmittance in the UV region. The FTIR bands were at 3,410-3,448 cm-1, 1,635 cm-1, 1,527-334 cm-1, and 1,242-871 cm-1 representing amide-A, amide-I, amide-II, and amide-III bands, respectively. The water activity of HAD was higher (0.43) than in FD (0.21) samples and pH were 5.23 and 5.14 for HAD and FD samples, respectively. The flow index (n) of 6.67% gelatin solutions was 0.104 and 0.418 with consistency coefficient (k) of 37.94 and 31.68 for HAD and FD samples, respectively. The HAD sample shows higher gel strength (276 g) than the FD samples (251 g). The foaming capacity (FC) and foaming stability (FS) of FD samples were 81 and 79.44% compared to 62 and 71.28% for HAD, respectively. The emulsion capacity and emulsion stability of HAD gelatin were higher at 53.47 and 52.66% than FD gelatin. The water holding capacity (WHC) and oil binding capacity (OBC) of FD were lower, that is, 14.3 and 5.34 mL/g compared to HAD gelatin having 14.54 and 6.2 mL/g WHC and OBC, respectively. Hence, the present study indicated that gelatin samples can be utilized in various food products for enhancing functionality and can be used for developing edible packaging materials.
| S-EPMC9226779 | biostudies-literature
Project description:In this study, microbial transglutaminase (MTGase) and pectin were compared to modify bighead carp (Hypophthalmichthys nobilis) scale gelatin. The functional properties of modified fish scales gelatin (FSG) were largely improved, including melting temperature and rheological behavior. While, modification methods decreased the triple-helix content and destroyed the single left-hand helix chain of modified FSG as investigated by X-ray diffraction. MTGase could induce the denser and finer gels network, but had none significant effect on nanostructural properties of fish gelatin. Pectin inserted itself into the fish gelatin gels network and caused aggregations, forming crystalline peaks and various nanostructures. In particular, compared with pectin modified FSG, MTGase produced FSG with lower storage modulus and apparent viscosity, but higher gel points and melting points.
| S-EPMC5380614 | biostudies-literature
Project description:Background and aimsPectin is a complex macromolecule, the fine structure of which is influenced by many factors. It is used as a gelling, thickening and emulsifying agent in a wide range of applications, from food to pharmaceutical products. Current industrial pectin extraction processes are based on fruit peel, a waste product from the juicing industry, in which thousands of tons of citrus are processed worldwide every year. This study examines how pectin components vary in relation to the plant source (orange, lemon, lime, grapefruit) and considers the influence of extraction conditions on the chemical and macromolecular characteristics of pectin samples.MethodsCitrus peel (orange, lemon, lime and grapefruit) from a commercial supplier was used as raw material. Pectin samples were obtained on a bulk plant scale (kilograms; harsh nitric acid, mild nitric acid and harsh oxalic acid extraction) and on a laboratory scale (grams; mild oxalic acid extraction). Pectin composition (acidic and neutral sugars) and physicochemical properties (molar mass and intrinsic viscosity) were determined.Key resultsOxalic acid extraction allowed the recovery of pectin samples of high molecular weight. Mild oxalic acid-extracted pectins were rich in long homogalacturonan stretches and contained rhamnogalacturonan I stretches with conserved side chains. Nitric acid-extracted pectins exhibited lower molecular weights and contained rhamnogalacturonan I stretches encompassing few and/or short side chains. Grapefruit pectin was found to have short side chains compared with orange, lime and lemon. Orange and grapefruit pectin samples were both particularly rich in rhamnogalacturonan I backbones.ConclusionsStructural, and hence macromolecular, variations within the different citrus pectin samples were mainly related to their rhamnogalacturonan I contents and integrity, and, to a lesser extent, to the length of their homogalacturonan domains.
| S-EPMC4195561 | biostudies-literature
Project description:Polyelectrolyte complexes of sodium alginate and gelatin obtained from cold-blooded fish were studied for potential application as structure-forming agents in food hydrogels. The mass ratio of sodium alginate to gelatin plays a decisive role in the sol-gel transition and rheological behavior of the complexes. Differences in the sol-gel transition temperature were observed upon heating and cooling, as is typical for such materials. We investigated the characteristics of this transition by measuring the isothermal changes in the elastic modulus over time at a constant frequency and the transition temperature at a range of frequencies. The kinetic nature of this transition depends on the composition of the complexes. A characteristic alginate-gelatin mass ratio is the ratio at which maximum transition temperature as well as elastic modulus and viscosity (rheological parameters) values are obtained; the characteristic mass ratio for these complexes was found to be 0.06. Calculation of the ionic group ratios in the biopolymers that form complexes and comparison of these data with the turbidimetric titration results clarified the origin of these maxima. Measuring the viscoelastic properties and the creep-elastic recoil of the samples allowed us to characterize these materials as viscoelastic media with a viscosity in the order of 103-104 Pa·s and an elastic modulus in the order of 102-103 Pa. These values drastically decrease at a certain stress threshold, which can be treated as the gel strength limit. Therefore, the observed rheological behavior of gels formed by fish gelatin modified with sodium alginate characterizes them as typical viscoelastic soft matter.
| S-EPMC7957763 | biostudies-literature
Project description:In recent years, there has been increased interest in the production of gelatin from alternative sources, such as raw fish materials. Traditionally, gelatin is obtained using an acidic or alkaline treatment. However, these methods have some disadvantages, such as the long times for processing raw materials and the use of large amounts of water and chemicals. Furthermore, milder processing regimes are required for producing fish gelatin. Enzymes could be the solution for improving the technology of fish gelatin production, due to their specificity and ability to increase the rate of collagen digestion. In this work, samples of gelatin from cod skin were obtained using enzymes of bacterial (protosubtilin) and animal (pancreatin) origins. The use of enzymes reduced the duration of extraction by 40%, and the yield of the final product was increased from 51% to 58-60%. The dependence of the contents of the main components of the secondary structure of gelatin and its rheological and thermal properties on molecular weight was also established. In this study, the gelatins obtained without enzymes and with protosubtilin were shown to have the most desirable characteristics, namely of the highest molecular weights and the highest proportion of ordered structures.
| S-EPMC8879374 | biostudies-literature
Project description:Barley cultivar Amulet was used to study the quantitative proteome changes through different drought conditions utilizing two-dimensional difference gel electrophoresis (2D-DIGE). Plants were cultivated for 10 days under different drought conditions. To obtain control and differentially drought-treated plants, the soil water content was kept at 65, 35, and 30% of soil water capacity (SWC), respectively. Osmotic potential, water saturation deficit, (13)C discrimination, and dehydrin accumulation were monitored during sampling of the crowns for proteome analysis. Analysis of the 2D-DIGE gels revealed 105 differentially abundant spots; most were differentially abundant between the controls and drought-treated plants, and 25 spots displayed changes between both drought conditions. Seventy-six protein spots were successfully identified by tandem mass spectrometry. The most frequent functional categories of the identified proteins can be put into the groups of: stress-associated proteins, amino acid metabolism, carbohydrate metabolism, as well as DNA and RNA regulation and processing. Their possible role in the response of barley to drought stress is discussed. Our study has shown that under drought conditions barley cv. Amulet decreased its growth and developmental rates, displayed a shift from aerobic to anaerobic metabolism, and exhibited increased levels of several protective proteins. Comparison of the two drought treatments revealed plant acclimation to milder drought (35% SWC); but plant damage under more severe drought treatment (30% SWC). The results obtained revealed that cv. Amulet is sensitive to drought stress. Additionally, four spots revealing a continuous and significant increase with decreasing SWC (UDP-glucose 6-dehydrogenase, glutathione peroxidase, and two non-identified) could be good candidates for testing of their protein phenotyping capacity together with proteins that were significantly distinguished in both drought treatments.
| S-EPMC4485253 | biostudies-literature
Project description:3D bioprinting is an emerging technology that enables the fabrication of three-dimensional organised cellular constructs. One of the major challenges in 3D bioprinting is to develop a material to meet the harsh requirements (cell-compatibility, printability, structural stability post-printing and bio-functionality to regulate cell behaviours) suitable for printing. Gelatin methacryloyl (GelMA) has recently emerged as an attractive biomaterial in tissue engineering because it satisfies the requirements of bio-functionality and mechanical tunability. However, poor rheological property such as low viscosity at body temperature inhibits its application in 3D bioprinting. In this work, an enzymatic crosslinking method triggered by Ca2+-independent microbial transglutaminase (MTGase) was introduced to catalyse isopeptide bonds formation between chains of GelMA, which could improve its rheological behaviours, specifically its viscosity. By combining enzymatic crosslinking and photo crosslinking, it is possible to tune the solution viscosity and quickly stabilize the gelatin macromolecules at the same time. The results showed that the enzymatic crosslinking can increase the solution viscosity. Subsequent photo crosslinking could aid in fast stabilization of the structure and make handling easy.
| S-EPMC7575630 | biostudies-literature
Project description:Pectin, a kind of natural polysaccharide, shows the attractive potential as a natural stabilizer for protein emulsion. The aim of this study is to investigate the effect of pectin on the physical stability, rheology, interface, and interaction properties of the fish gelatin (FG) emulsion, as pectin was utilized to improve the stability of FG, fish oil emulsion. During the study, when pH < 6, the FG-pectin emulsion displayed better storage stability and salinity tolerance. Analyzing the result, pectin could avoid phase separation at the freeze-thaw process and prevent the liquid-gel transition of FG emulsions during storage. On the other hand, when pH ≥ 6, the emulsion displayed high viscosity due to the complex flocculation and stratified during long-term storage. Electrostatic interactions, hydrophobic interactions, and hydrogen bonding of the FG-pectin complexes in the emulsion were all reduced. Overall, pectin improved the stability of FG emulsions through electrostatic repulsion, hydrophobic interactions, and steric hindrance.
| S-EPMC9326445 | biostudies-literature