Dataset Information

Quantitative and Semiquantitative Health Risk Assessment of Occupational Exposure to Styrene in a Petrochemical Industry.

ABSTRACT:

Background

Styrene is one of the aromatic compounds used in acetonitrile-butadiene-styrene (ABS) producing petrochemicals, which has an impact on health of workers. Therefore, this study aimed to investigate the health risks of styrene emitted from the petrochemical industry in Iran.

Methods

Air samples were collected based on NIOSH 1501 method. The samples were analyzed by the Varian-cp3800 gas chromatograph. Finally, risk levels of styrene's health effects on employees were assessed by the quantitative method of the U.S. Environmental Protection Agency (U.S. EPA) and the semiquantitative way by the Singapore Occupational Safety and Health Association.

Results

Based on the results, the employees had the highest average exposure to styrene vapors (4.06 ×10-1mg.(kg-day)-1 ) in the polybutadiene latex (PBL) unit. Therefore, the most top predictors of cancer and non-cancer risk were 2.3 ×10-4 and 7.26 ×10-1 , respectively. Given that the lowest average exposure (1.5 ×10-2mg.(kg-day)-1 ) was in the dryer unit, the prediction showed a moderate risk of cancer (0.8 ×10-6 ) and non-cancer (2.3 ×10-3 ) for the employees. The EPA method also predicted that there would be a definite cancer risk in 16% and a probable risk in 76% of exposures. However, according to the semiquantitative approach, the rate of risk was at the "low" level for all staff. The results showed that there was a significant difference (p < 0.05) between the units in exposure and health risk of styrene (p < 0.05).

Conclusion

Given the high risk of styrene's health effects, appropriate control measures are required to reduce the exposure level.

SUBMITTER: Moshiran VA

PROVIDER: S-EPMC8430436 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Similar Datasets

Project description:The awareness of occupational health risk management in the electronics industry is weak in China, and many Chinese occupational health management regulations have not been effectively implemented. China's current occupational hazards classification method and the Environmental Protection Agency (EPA) inhalation risk assessment model recognized internationally were used to perform health risk assessments for a chip manufacturing company in the electronics industry in order to determine the existing problems and put forward the optimization proposals of the occupational hazards classification method in China. The results showed that the detected concentrations of toxic and harmful chemicals in all testing points did not exceed the occupational health exposure limits in China. According to the EPA inhalation risk assessment model, the highest values of non-carcinogenic risks of ammonia, chlorine, fluoride, sulfuric acid, hydrogen chloride, ethylene glycol, phosphine, boron trifluoride, isopropanol, benzene, and xylene were 5.10, 67.12, 1.71, 45.98, 1.83, 1.43, 160.35, 46.56, 2.52, 5.55, and 5.37, respectively, which means workers in electronic chip manufacturing companies exposed to these chemicals have higher occupational health risks. However, on the basis of the occupational hazards classification method, the occupational health risks of exposure to the toxic and hazardous chemicals are relatively harmless operations. The evaluation results of the EPA inhalation risk assessment model are generally higher than those of the occupational hazards classification method. It's recommended to refine the value of occupational exposure limit B, taking more characteristics of the hazard factors into account and fuzzifying the parameters to optimize the occupational hazards classification method. At the same time, it is suggested that the electronic chip manufacturing company should conduct anti-virus risk management covering in three aspects: increasing the awareness of occupational hazards, enhancing system ventilation, and improving personal health management measures.

Project description:BackgroundSchool-aged children living near plastics-producing factories may have higher risk of exposure to phthalates released during the manufacturing processes.ObjectivesWe aimed to investigate the urinary concentrations of phthalate metabolites in school-aged children living near a petrochemical complex and estimate the cumulative risk of phthalate exposure.MethodsWe used a well-established cohort (Taiwan Petrochemical Complex Cohort for Children, TPE3C) of school-aged children (6-13 years old) living near polyvinyl chloride (PVC) and vinyl chloride monomer (VCM) factories in central Taiwan from October 2013 to September 2014. A total of 257 children were included from five elementary schools: Syu-Cuo Branch (n = 58, school A, ~0.9 km), Feng-An (n = 40, school B, ~2.7 km), Ciao-Tou (n = 58, school C, ~5.5 km), Mai-Liao (n = 37, school D, ~6.9 km), and Lung-Feng (n = 57, school E, ~8.6 km). We analyzed 11 metabolites of seven phthalates (including di-2-ethylhexyl phthalate (DEHP) and di-n-butyl phthalate (DnBP)) in urine. Daily intakes (DIs) were compared with acceptable intake levels to calculate the hazard quotient (HQ) for individual phthalates, and the cumulative risk for each child was assessed using a hazard index (HI), which was the sum of the the individual HQs.ResultsThe geometric mean and proportion of participants with HIs exceeding one for hepatic (HIhep) and reproductive (HIrep) effects were 0.33 (13.2%) and 0.24 (7.8%), respectively. The major contributors to phthalate exposure risk were DEHP, di-iso-butyl phthalate (DiBP) and DnBP in all children. Moreover, we observed a U shaped distribution of DEHP exposure by school distance from the PVC and VCM factories (school A: 7.48 μg/kg/day and school E: 80.44 μg/kg/day). This may be due to emissions (closest) and and being located downwind of PVC scrap incineration (farthest).ConclusionsOur findings suggest that children living near a petrochemical complex were at a greater risk of phthalate exposure than normal school-aged children and that phthalate exposure was mainly attributed to DEHP, DiBP and DnBP. In addition, inhalation may have been a risk factor for people living near to PVC and VCM factories.