SiOx/C Composite Anode of Lithium-Ion Batteries with Enhanced Performances Using Multicomponent Binders
Ontology highlight
ABSTRACT:
SUBMITTER: Liu H
PROVIDER: S-EPMC8515830 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:A Si-based anode maintaining its high electrochemical performance with cycles was prepared for the nondegradable lithium-ion battery. Nanoscaled Si particles were mechanochemically coupled with approximately 3 nm thick oxide layer and n-carbon (nanoscaled carbon) crystallites to overcome silicon's inherent problems of poor electronic conductivity and severe volume change during lithiation and delithiation cycling. The oxide layer of SiO x was chemically formed via a controlled oxygen environment during the process; meanwhile, the n-carbon crystallites were obtained by mechanical fragmentation from ∼70 μm sized multilayered graphene powders with a low degree of agglomeration. The Si-based composite anode, processed by the above-mentioned mechanochemical coupling, maintained a superior discharge capacity of 1767 mA h/g through 100 cycles with a Coulombic efficiency exceeding 98% at a current density of 100 mA/g. According to our current study, the coupling of the Si particles with oxide layer and n-carbon crystallites was found to be a significantly efficient way to prevent the performance degradation of the Si-based anode.
| S-EPMC6641641 | biostudies-literature
Project description:Commercial polyolefin separators exhibit problems including shrinkage under high temperatures and poor electrolyte wettability and uptake, resulting in low ionic conductivity and safety problems. In this work, core-shell silica-polyphosphazene nanoparticles (SiO2@PZS) with different PZS layer thicknesses were synthesized and coated onto both sides of polyethylene (PE) microporous membranes to prepare composite membranes. Compared to pure silica-coated membranes and PE membranes, the PE-SiO2@PZS composite membrane had higher ionic conductivity. With the increase in the SiO2@PZS shell thickness, the electrolyte uptake, ionic conductivity and discharge capacity gradually increased. The discharge capacity of the PE-SiO2@PZS composite membrane at 8 C rate was 129 mAh/g, which was higher than the values of 107 mAh/g for the PE-SiO2 composite membrane and 104 mAh/g for the PE membrane.
| S-EPMC9322529 | biostudies-literature
Project description:Silicon monoxide (SiO x ), as a promising anode for the next-generation high-power lithium-ion batteries, has some advantages such as higher lithium storage capacity (∼2400 mAh g-1), suitable working potential, and smaller volume variations during cycling compared with pure silicon. However, its disadvantages such as its inherent low conductivity and high cost impede its extensive applications. Herein, we have developed a low-cost and high-capacity SiO x /C@graphite (SCG) composite derived from oat husks by a simple argon/hydrogen reduction method. For further practical application, we also investigated the electrochemical performances of SiO x mixed with different ratios of graphite. As an advanced anode for lithium-ion batteries, the SCG-1 composite exhibits an excellent electrochemical performance in terms of lithium storage capacity (809.5 mAh g-1 at 0.5 A g-1 even after the 250th cycle) and high rate capability (479.7 mAh g-1 at 1 A g-1 after the 200th cycle). This work may pave the way for developing a low-cost silicon-based anode derived from biomass with a large reversible capacity and long cycle life in lithium-ion batteries.
| S-EPMC9089676 | biostudies-literature
Project description:Silicon oxide (SiO x ) has been placed into practical use as an anode active material for next-generation Li-ion batteries because it has a higher theoretical capacity than graphite anodes. However, the synthesis method is typically vapor deposition, which is expensive, and the poor electron conductivity of SiO x restricts high performance. In this study, we prepared M/SiO x active materials consisting of SiO x and a third element (M = Al, B, Sn) using a low-cost mechanical milling (MM) method and investigated their electrode properties as Li-ion battery anodes. Also, the authors added a third element to improve the conductivity of the SiO2 matrix. Al, B, and Sn were selected as elements that do not form a compound with Si, exist as a simple substance, and can be dispersed in SiO2. As a result, we confirmed that SiO x has a nanostructure of nanocrystalline Si dispersed in an amorphous-like SiO2 matrix and that the third element M exists not in the nanocrystalline Si but in the SiO2 matrix. The electron conductivity of SiO x was improved by the addition of B and Sn. However, it was not improved by the addition of Al. This is because Al2O3 was formed in the insulator due to the oxidization of Al. The charge-discharge cycle tests revealed that the cycle life was improved from 170 cycles to 330 or 360 cycles with the addition of B or Sn, respectively. The improvement in electron conductivity is assumed to make it possible for SiO2 to react with Li ions more uniformly and form a structure that can avoid the concentration of stress due to the volume changes of Si, thereby suppressing the electrode disintegration.
| S-EPMC8757335 | biostudies-literature
Project description:We report the interfacial study of a silicon/carbon nanofiber/graphene composite as a potentially high-performance anode for rechargeable lithium-ion batteries (LIBs). Silicon nanoparticle (Si)/carbon nanofiber (CNF)/reduced graphene oxide (rGO) composite films were prepared by simple physical filtration and an environmentally-friendly thermal reduction treatment. The films were used as high-performance anode materials for self-supporting, binder-free LIBs. Reducing graphene oxide improves the electron conductivity and adjusts to the volume change during repeated charge/discharge processes. CNFs can help maintain the structural stability and prevent the peeling off of silicon nanoparticles from the electrodes. When the fabricated Si/CNF/rGO composites were used as anodes of LIBs, the initial specific capacity was measured to be 1894.54 mAh/g at a current density of 0.1 A/g. After 100 cycles, the reversible specific capacity was maintained at 964.68 mAh/g, and the coulombic efficiency could reach 93.8% at the same current density. The Si/CNF/rGO composite electrode exhibited a higher specific capacity and cycle stability than an Si/rGO composite electrode. The Si/CNF/rGO composite films can effectively accommodate and buffer changes in the volume of silicon nanoparticles, form a stable solid-electrolyte interface, improve the conductivity of the electrode, and provide a fast and efficient channel for electron and ion transport.
| S-EPMC7809343 | biostudies-literature
Project description:Bagasse-derived carbon electrodes were developed by doping with nitrogen functional groups and compositing with high-capacity MnO2 nanoparticles (MnO2/NBGC). The bagasse-derived biochar was N-doped by refluxing in urea, followed by the deposition of MnO2 nanoparticles onto its porous surface via the hydrothermal reduction of KMnO4. Different initial KMnO4 loading concentrations (i.e. 5, 10, 40, and 100 mM) were applied to optimize the composite morphology and the corresponding electrochemical performance. Material characterization confirmed that the carbon composite has a mesoporous structure along with the dispersion of MnO2 nano-particles on the N-containing carbon surface. It was found that the 5-MnO2/NBGC sample exhibited the highest electrochemical performance with a reversible capacity of 760 mA h g-1 at a current density of 186 mA g-1. It delivered reversible capacities of 488 and 390 mA h g-1 in cycle tests at 372 and 744 mA g-1, respectively, for 150 cycles and presented good reversibility with nearly 100% coulombic efficiency. In addition, it could exert high capacities up to 388 and 301 mA h g-1 even under high current densities of 1860 and 3720 mA g-1, respectively. Moreover, most of the prepared composite products showed high rate capability with great reversibility up to more than 90% after testing at a high current density of 3720 mA g-1. The great electrochemical performance of the MnO2/NBGC nanocomposite electrode can be attributed to the synergistic impact of the hierarchical architecture of the MnO2 nanocrystals deposited on porous carbon and the capacitive effect of the N-containing defects within the carbon material. The nanostructure of the MnO2 particles deposited on porous carbon limits its large volume change during cycling and promotes good adhesion of MnO2 nanoparticles with the substrate. Meanwhile, the capacitive effect of the exposed N-functional groups enables fast ionic conduction and reduces interfacial resistance at the electrode interface.
| S-EPMC10782432 | biostudies-literature
Project description:A simple and effective carbon-free strategy is carried out to prepare mixed molybdenum oxides as an advanced anode material for lithium-ion batteries. The new material shows a high specific capacity up to 930.6 mAh·g-1, long cycle-life (>200 cycles) and high rate capability. 1D and 2D solid-state NMR, as well as XRD data on lithiated sample (after discharge) show that the material is associated with both insertion/extraction and conversion reaction mechanisms for lithium storage. The well mixed molybdenum oxides at the microscale and the involvement of both mechanisms are considered as the key to the better electrochemical properties. The strategy can be applied to other transition metal oxides to enhance their performance as electrode materials.
| S-EPMC5353649 | biostudies-literature
Project description:Heterogeneous TiO2@Nb2O5 composites, in which TiO2 nanoparticles were evenly embedded on ultrathin Nb2O5 nanosheets, were used as anode materials for LIBs and demonstrated high capacities and excellent rate capability. For instance, this material displayed large capacities of 166.3 and 129.1 mA h g-1 at current densities of 1 A g-1 after 100 cycles and 5 A g-1 after 300 cycles, respectively.
| S-EPMC5543047 | biostudies-literature
Project description:The copper oxide (CuO) nanowires/functionalized graphene (f-graphene) composite material was successfully composed by a one-pot synthesis method. The f-graphene synthesized through the Birch reduction chemistry method was modified with functional group "-(CH?)?COOH", and the CuO nanowires (NWs) were well dispersed in the f-graphene sheets. When used as anode materials in lithium-ion batteries, the composite exhibited good cyclic stability and decent specific capacity of 677 mA·h·g-1 after 50 cycles. CuO NWs can enhance the lithium-ion storage of the composites while the f-graphene effectively resists the volume expansion of the CuO NWs during the galvanostatic charge/discharge cyclic process, and provide a conductive paths for charge transportation. The good electrochemical performance of the synthesized CuO/f-graphene composite suggests great potential of the composite materials for lithium-ion batteries anodes.
| S-EPMC5344618 | biostudies-literature
Project description:Silicon (Si) is under consideration as a potential next-generation anode material for the lithium ion battery (LIB). Experimental reports of up to 40% increase in energy density of Si anode based LIBs (Si-LIBs) have been reported in literature. However, this increase in energy density is achieved when the Si-LIB is allowed to swell (volumetrically expand) more than graphite based LIB (graphite-LIB) and beyond practical limits. The volume expansion of LIB electrodes should be negligible for applications such as automotive or mobile devices. We determine the theoretical bounds of Si composition in a Si-carbon composite (SCC) based anode to maximize the volumetric energy density of a LIB by constraining the external dimensions of the anode during charging. The porosity of the SCC anode is adjusted to accommodate the volume expansion during lithiation. The calculated threshold value of Si was then used to determine the possible volumetric energy densities of LIBs with SCC anode (SCC-LIBs) and the potential improvement over graphite-LIBs. The level of improvement in volumetric and gravimetric energy density of SCC-LIBs with constrained volume is predicted to be less than 10% to ensure the battery has similar power characteristics of graphite-LIBs.
| S-EPMC4911546 | biostudies-literature