Browse
Submit Data
Databases
API
Help

Dataset Information

22 Views

0 Connections

0 Citations

0 Reanalyses

0 Downloads

Omics score: 0

Investigation of electrocatalytic and photocatalytic ability of Cu/Ni/TiO₂/MWCNTs Nanocomposites for detection and degradation of antibiotic drug Furaltadone.

ABSTRACT: In this manuscript, "Get two mangoes with one stone" strategy was used to study the electrochemical detection and photocatalytic mineralization of furaltadone (FLT) drug using Cu/Ni/TiO₂/MWCNTs nanocomposites for the first time. The bi-functional nanocomposites were synthesized through a hydrothermal synthesis technique. The successfully synthesized nanocomposites were analyzed by various analytical techniques. The Cu/Ni/TiO₂/MWCNTs nanocomposites decorated screen-printed carbon electrode (SPCE) exhibit a good electrocatalytic ability towards detection of FLT. Moreover, the electrocatalytic detection of FLT based on the nanocomposites decorated SPCE have high stability, lower detection limit, and excellent sensitivity of 0.0949 μM and 1.9288 μA μM^-1 cm^-2, respectively. In addition, the nanocomposites decorated SPCE electrodes performed in real samples, such as river water and tap water, the satisfactory results were observed. As UV-Visible spectroscopy revealed that the Cu/Ni/TiO₂/MWCNTs nanocomposites had an excellent photocatalytic ability for degradation of FLT drug. The higher degradation efficiency of 75% was achieved within 45 min under irradiation of visible light. In addition, after the degradation process various intermediates are produced which is confirmed by GC-MS analysis. The excellent photocatalytic ability was improved to the dopant ions and restrictions of electron-hole pair.

SUBMITTER: Vasu D

PROVIDER: S-EPMC8766570 | biostudies-literature |

REPOSITORIES: biostudies-literature

ACCESS DATA

Json Xml

Similar Datasets

Enhanced Photocatalytic and Antibacterial Ability of Cu-Doped Anatase TiO2 Thin Films: Theory and Experiment.

Project description:Multifunctional thin films which can display both photocatalytic and antibacterial activity are of great interest industrially. Here, for the first time, we have used aerosol-assisted chemical vapor deposition to deposit highly photoactive thin films of Cu-doped anatase TiO2 on glass substrates. The films displayed much enhanced photocatalytic activity relative to pure anatase and showed excellent antibacterial (vs Staphylococcus aureus and Escherichia coli) ability. Using a combination of transient absorption spectroscopy, photoluminescence measurements, and hybrid density functional theory calculations, we have gained nanoscopic insights into the improved properties of the Cu-doped TiO2 films. Our analysis has highlighted that the interactions between substitutional and interstitial Cu in the anatase lattice can explain the extended exciton lifetimes observed in the doped samples and the enhanced UV photoactivities observed.

| S-EPMC7146757 | biostudies-literature

TiO?@PEI-Grafted-MWCNTs Hybrids Nanocomposites Catalysts for CO? Photoreduction.

Project description:Anatase (TiO?) and multiwalled carbon nanotubes bearing polyethylenimine (PEI) anchored on their surface were hybridized in different proportions according to a sol-gel method. The resulting nanocomposites (TiO?@PEI-MWCNTs), characterized by BET, XRD, XPS, SEM, and UV techniques, were found efficient catalysts for CO? photoreduction into formic and acetic acids in water suspension and under visible light irradiation. PEI-grafted nanotubes co-catalysts are believed to act as CO? activators by forming a carbamate intermediate allowing to accomplish the first example in the literature of polyamines/nanotubes/TiO? mediated CO? photoreduction to carboxylic acids.

| S-EPMC5849004 | biostudies-literature

In Vitro Toxicity of TiO2:SiO2 Nanocomposites with Different Photocatalytic Properties.

Project description:The enormous technological relevance of titanium dioxide (TiO2) nanoparticles (NPs) and the consequent concerns regarding potentially hazardous effects that exposure during production, use, and disposal can generate, encourage material scientists to develop and validate intrinsically safe design solution (safe-by-design). Under this perspective, the encapsulation in a silica dioxide (SiO2) matrix could be an effective strategy to improve TiO2 NPs safety, preserving photocatalytic and antibacterial properties. In this work, A549 cells were used to investigate the toxic effects of silica-encapsulated TiO2 having different ratios of TiO2 and SiO2 (1:1, 1:3, and 3:1). NPs were characterized by electron microscopy and dynamic light scattering, and cell viability, oxidative stress, morphological changes, and cell cycle alteration were evaluated. Resulting data demonstrated that NPs with lower content of SiO2 are able to induce cytotoxic effects, triggered by oxidative stress and resulting in cell necrosis and cell cycle alteration. The physicochemical properties of NPs are responsible for their toxicity. Particles with small size and high stability interact with pulmonary cells more effectively, and the different ratio among silica and titania plays a crucial role in the induced cytotoxicity. These results strengthen the need to take into account a safe(r)-by-design approach in the development of new nanomaterials for research and manufacturing.

| S-EPMC6669742 | biostudies-literature

Electrocatalytic activity of lithium polysulfides adsorbed into porous TiO2 coated MWCNTs hybrid structure for lithium-sulfur batteries.

Project description:Lithium-sulfur batteries have attracted great attention because of their high energy density, environmental friendliness, natural abundance and intrinsically low cost of sulfur. However, their commercial applications are greatly hindered by rapid capacity decay due to poor conductivity of electrode, fast dissolution of the intermediate polysulfides into the electrolyte, and the volume expansion of sulfur. Herein, we report a novel composite MWCNTs@TiO2-S nanostructure by grafting TiO2 onto the surface of MWCNTs, followed by incorporating sulfur into the composite. The inner MWCNTs improved the mechanical strength and conductivity of the electrode and the outer TiO2 provided the adsorption sites to immobilize polysulfides due to bonding interaction between TiO2 and polysulfides. The MWCNTs@TiO2-S composite with a mass ratio of 50% (MWCNTs in MWCNTs@TiO2) exhibited the highest electrochemistry performance among all compositing ratios of MWCNTs/TiO2. The performance improvement might be attributed to the downward shift of the apparent Fermi level to a more positive potential and electron rich space region at the interface of MWCNTs-TiO2 that facilitates the reduction of lithium polysulfide at a higher potential. Such a novel hybrid structure can be applicable for electrode design in other energy storage applications.

| S-EPMC5241630 | biostudies-literature

Photoreduction route for Cu2O/TiO2 nanotubes junction for enhanced photocatalytic activity.

Project description:Here, we synthesized copper(i) oxide and titanium dioxide nanotubes (TNTs) heterojunctions (HJs) by a photoreduction method using a low-power UV lamp without involving any additional steps, such as chemical reduction, surfactant, or protection agents. Transmission electron microscopy, X-ray diffraction, Raman scattering, X-ray photoelectron spectroscopy, diffuse reflectance spectra, and photoluminescence spectroscopy were carried out to verify the formation of a HJ between the Cu2O nanoparticles (Cu2O NPs) and TNTs. The efficiency and the rate of methylene blue photo-degradation over the Cu2O/TNTs HJ were found to be nearly double and triple compared to the isolated TNTs. The enhanced efficiency is attributed to the narrow band gap and defect states caused by the oxygen vacancies in the vicinity of HJs. Moreover, the type II band alignment of Cu2O NPs and TNTs naturally separates the photo-generated carriers and constrains the recombination process owing to the internal electric field across the Cu2O/TNTs interface.

| S-EPMC9079757 | biostudies-literature

Facile Fabrication of C-TiO2 Nanocomposites with Enhanced Photocatalytic Activity for Degradation of Tetracycline.

Project description:Visible-lightdriven C-TiO2 nanocomposites were prepared via a simple calcination and acid etching process. The C-TiO2 nanocomposites were characterized by X-ray photoelectron spectroscopy, Raman spectroscopy, X-ray diffraction, transmission electron microscopy, and high-resolution TEM. The results showed that TiO2 nanoparticles were combined with a porous carbon layer through surface C-O groups, which facilitates the strong interface interaction. The interface combination of nano-TiO2 and carbon material increases the specific surface area of nano-TiO2, widens the range of light response, and improves the efficiency of light-induced electron migration. The visible-light photocatalytic activity of the prepared photocatalyst was evaluated by the decomposition of tetracycline aqueous solution. Compared with that of pure TiO2, the photocatalytic activity of C-TiO2 nanocomposites was significantly improved. Furthermore, a possible photocatalytic mechanism was also tentatively proposed. This work can promote the development of active photocatalysts under solar light for the photodegradation of environmental pollutants.

| S-EPMC6921265 | biostudies-literature

Photocatalytic performance of Cu2O-loaded TiO2/rGO nanoheterojunctions obtained by UV reduction.

Project description:A novel dot-like Cu2O-loaded TiO2/reduced graphene oxide (rGO) nanoheterojunction was synthesized via UV light reduction for the first time. Cu2O with size of ca. 5 nm was deposited on rGO sheet and TiO2 nanosheets. The products were characterized by infrared spectroscopy, Raman spectrum, UV-Vis diffuse reflectance spectra, XPS techniques, photoluminescence spectra. The results demonstrated that Cu2O and rGO enhanced the absorption for solar light, separation efficiency of electron-hole pairs, charge shuttle and transfer, and eventually improved photoelectrochemical and photocatalytic performance for contaminants degradation. The reaction time and anion precursor could affect the final copper-containing phase. As extending UV irradiation time, Cu2+ was be first reduced to Cu2O and then transformed to metal Cu. In comparison with CH3COO- (copper acetate), NO3- (copper nitrate) and Cl- (copper chloride), SO42- (copper sulfate) was the optimum for synthesizing pure Cu2O phase.

| S-EPMC5348572 | biostudies-literature

Enthalpies of Formation of (Cu,Ni)3Sn, (Cu,Ni)6Sn5-HT and (Ni,Cu)3Sn2-HT.

Project description:Standard enthalpies of formation of ternary phases in the Cu-Ni-Sn system were determined along sections at 25, 41 and 45.5 at.% Sn applying tin solution drop calorimetry. Generally, the interaction of Ni with Sn is much stronger than that of Cu with Sn. Along all sections the enthalpy of formation changes almost linearly with the mutual substitution of Cu and Ni within the respective homogeneity ranges. Thus no additional ternary interaction promoting the formation of further Cu-Ni-Sn phases can be assumed. The results are discussed and compared with literature values relevant to this system.

| S-EPMC4894260 | biostudies-literature

Synthesizing and Evaluating the Photocatalytic and Antibacterial Ability of TiO2/SiO2 Nanocomposite for Silicate Coating.

Project description:The TiO2/SiO2 nanocomposite has been synthesized by a sol-gel method and investigated the effect of the SiO2 content (0, 5, 10, 15, 20, and 50%) on the rutile-to-anatase phase transition of TiO2 NPs. In order to increase the photocatalytic efficiency of the nanocomposite and decrease the price of material, the TiO2/SiO2 Nc with content SiO2 of 15% sample is chosen for preparing silicate coating. The efficiency of photocatalytic MB and antibacterial ability in the air of W silicate coating (adding TiO2/SiO2 Nc (15%)) achieve almost 100% for 60 h and 94.35% for 3 h, respectively. While the efficiency of photocatalytic MB and antibacterial ability of WO silicate coating (adding commercial TiO2/SiO2) is about 25-30% for 60 h and 6.02% for 3 h, respectively. The presence of TiO2/SiO2 Nc (15%) with a larger surface area in W silicate coating can provide increased centers for absorption, photocatalytic reaction, and the contact between sample and bacteria lead to enhance the photocatalytic and antibacterial ability of W silicate coating.

| S-EPMC8485069 | biostudies-literature

High photocatalytic activity of Fe2O3/TiO2 nanocomposites prepared by photodeposition for degradation of 2,4-dichlorophenoxyacetic acid.

Project description:Two series of Fe2O3/TiO2 samples were prepared via impregnation and photodeposition methods. The effect of preparation method on the properties and performance of Fe2O3/TiO2 for photocatalytic degradation of 2,4-dichlorophenoxyacetic acid (2,4-D) under UV light irradiation was examined. The Fe2O3/TiO2 nanocomposites prepared by impregnation showed lower activity than the unmodified TiO2, mainly due to lower specific surface area caused by heat treatment. On the other hand, the Fe2O3/TiO2 nanocomposites prepared by photodeposition showed higher photocatalytic activity than the unmodified TiO2. Three times higher photocatalytic activity was obtained on the best photocatalyst, Fe2O3(0.5)/TiO2. The improved activity of TiO2 after photodeposition of Fe2O3 was contributed to the formation of a heterojunction between the Fe2O3 and TiO2 nanoparticles that improved charge transfer and suppressed electron-hole recombination. A further investigation on the role of the active species on Fe2O3/TiO2 confirmed that the crucial active species were both holes and superoxide radicals. The Fe2O3(0.5)/TiO2 sample also showed good stability and reusability, suggesting its potential for water purification applications.

| S-EPMC5433238 | biostudies-literature