Thermodynamic Modeling of Solvent-Assisted Lipid Bilayer Formation Process.
Ontology highlight
ABSTRACT:
SUBMITTER: Xu H
PROVIDER: S-EPMC8777629 | biostudies-literature |
REPOSITORIES: biostudies-literature
Similar Datasets
Project description:Supported lipid bilayers (SLB) are important for the study of membrane-based phenomena and as coatings for biosensors. Nevertheless, there is a fundamental lack of understanding of the process by which they form from vesicles in solution. We report insights into the mechanism of SLB formation by vesicle adsorption using temperature-controlled time-resolved fluorescence microscopy at low vesicle concentrations. First, lipid accumulates on the surface at a constant rate up to approximately 0.8 of SLB coverage. Then, as patches of SLB nucleate and spread, the rate of accumulation increases. At a coverage of approximately 1.5 x SLB, excess vesicles desorb as SLB patches rapidly coalesce into a continuous SLB. Variable surface fluorescence immediately before SLB patch formation argues against the existence of a critical vesicle density necessary for rupture. The accelerating rate of accumulation and the widespread, abrupt loss of vesicles coincide with the emergence and disappearance of patch edges. We conclude that SLB edges enhance vesicle adhesion to the surface and induce vesicle rupture, thus playing a key role in the formation of continuous SLB.
| S-EPMC2800963 | biostudies-literature
Project description:Molecular dynamics (MD) simulations are used to study the pathway for the insertion of the cationic antimicrobial peptide protegrin-1 (PG1) into mixed anionic lipid bilayers composed of palmitoyl-oleoyl-phosphatidylglycerol (POPG) and palmitoyl-oleoyl-phosphatidylethanolamine (POPE) in a 1:3 ratio (POPG/POPE). We calculate the potential of mean force (PMF) during the transfer of the peptide from the bulk aqueous phase to the transmembrane (TM) configuration using the adaptive biasing force (ABF) method. We find that the PMF has two energy minima separated by an energy barrier. One minimum corresponds to the fully transmembrane inserted state, with a free energy of -20.1 kcal/mol. The second PMF minimum, which corresponds to adsorption to the membrane surface, has a value of -2.5 kcal/mol. The PMF also shows the existence of a free energy barrier of +6.3 kcal/mol for the insertion process. Using the Kramers theory Langevin equation and the Grote-Hynes theory generalized Langevin equation, we calculated the transmission coefficient for PG1 diffusion through the potential barrier. We focus on the use of the PMF and the time correlation function of the fluctuation of the instantaneous force to calculate the rate constants for insertion/deinsertion of PG1 from the mixed POPG/POPE membrane. The influence of the activation free energy barrier on the dynamics of the insertion and permeation of peptides through the membrane are discussed.
| S-EPMC3461958 | biostudies-literature
Project description:Self-assembly is a ubiquitous approach to the design and fabrication of novel supermolecular architectures. Here we report a strategy termed 'lipid-bilayer-assisted self-assembly' that is used to assemble DNA origami nanostructures into two-dimensional lattices. DNA origami structures are electrostatically adsorbed onto a mica-supported zwitterionic lipid bilayer in the presence of divalent cations. We demonstrate that the bilayer-adsorbed origami units are mobile on the surface and self-assembled into large micrometre-sized lattices in their lateral dimensions. Using high-speed atomic force microscopy imaging, a variety of dynamic processes involved in the formation of the lattice, such as fusion, reorganization and defect filling, are successfully visualized. The surface modifiability of the assembled lattice is also demonstrated by in situ decoration with streptavidin molecules. Our approach provides a new strategy for preparing versatile scaffolds for nanofabrication and paves the way for organizing functional nanodevices in a micrometer space.
| S-EPMC4560778 | biostudies-literature
Project description:We present a micro-device in which more than 10,000 asymmetric lipid bilayer membranes are formed at a time on micro-chamber arrays. The arrayed asymmetric lipid bilayers, where lipid compositions are different between the inner and outer leaflets, are formed with high efficiency of over 97% by injecting several types of liquids into a micro-device that has hydrophilic-in-hydrophobic surfaces. The lipid compositional asymmetry is an intrinsic property of bio-membranes, and therefore, this micro-device extends the versatility of artificial lipid-bilayer systems, which were previously limited to symmetric bilayer formation, and could contribute to the understanding of the role of lipid compositional asymmetry in cell physiology and also to further analytical and pharmacological applications.
| S-EPMC4233334 | biostudies-literature
Project description:The lipid bilayer environment around membrane proteins strongly affects their structure and functions. Here, we aimed to study the fusion of proteoliposomes (PLs) derived from cultured cells with an artificial lipid bilayer membrane and the distribution of the PL components after the fusion. PLs, which were extracted as a crude membrane fraction from Chinese hamster ovary (CHO) cells, formed isolated domains in a supported lipid bilayer (SLB), comprising phosphatidylcholine (PC), phosphatidylethanolamine (PE), and cholesterol (Chol), after the fusion. Observation with a fluorescence microscope and an atomic force microscope showed that the membrane fusion occurred selectively at microdomains in the PC?+?PE?+?Chol-SLB, and that almost all the components of the PL were retained in the domain. PLs derived from human embryonic kidney 293 (HEK) cells also formed isolated domains in the PC?+?PE?+?Chol-SLB, but their fusion kinetics was different from that of the CHO-PLs. We attempted to explain the mechanism of the PL-SLB fusion and the difference between CHO- and HEK-PLs, based on a kinetic model. The domains that contained the whole cell membrane components provided environments similar to that of natural cell membranes, and were thus effective for studying membrane proteins using artificial lipid bilayer membranes.
| S-EPMC5738377 | biostudies-literature
Project description:Herein, we describe a new analytical platform utilizing advances in heterogeneous supported lipid bilayer (SLB) electrophoresis and matrix-assisted laser desorption/ionization-mass spectrometry (MALDI-MS) imaging. This platform allowed for the separation and visualization of both charged and neutral lipid membrane components without the need for extrinsic labels. A heterogeneous SLB was created using vesicles containing monosialoganglioside GM1, disialoganglioside GD1b, POPC, as well as the ortho and para isomers of Texas Red-DHPE. These components were then separated electrophoretically into five resolved bands. This represents the most complex separation by SLB electrophoresis performed to date. The SLB samples were flash frozen in liquid ethane and dried under vacuum before imaging with MALDI-MS. Fluorescence microscopy was employed to confirm the position of the Texas Red labeled lipids, which agreed well with the MALDI-MS imaging results. These results clearly demonstrate this platform's ability to isolate and identify nonlabeled membrane components within an SLB.
| S-EPMC3717335 | biostudies-literature
Project description:This work focuses on the process development of membrane-assisted solvent extraction of hydrophobic compounds such as monoterpenes. Beginning with the choice of suitable solvents, quantum chemical calculations with the simulation tool COSMO-RS were carried out to predict the partition coefficient (logP) of (S)-(+)-carvone and terpinen-4-ol in various solvent-water systems and validated afterwards with experimental data. COSMO-RS results show good prediction accuracy for non-polar solvents such as n-hexane, ethyl acetate and n-heptane even in the presence of salts and glycerol in an aqueous medium. Based on the high logP value, n-heptane was chosen for the extraction of (S)-(+)-carvone in a lab-scale hollow-fibre membrane contactor. Two operation modes are investigated where experimental and theoretical mass transfer values, based on their related partition coefficients, were compared. In addition, the process is evaluated in terms of extraction efficiency and overall product recovery, and its biotechnological application potential is discussed. Our work demonstrates that the combination of in silico prediction by COSMO-RS with membrane-assisted extraction is a promising approach for the recovery of hydrophobic compounds from aqueous solutions.
| S-EPMC5936919 | biostudies-literature
Project description:In the immersion precipitation process for membrane formation, a polymer casting film is placed in contact with a nonsolvent in a coagulation bath; an essential feature of the membrane formation process is the foray into the metastable region of the ternary phase diagram for the nonsolvent/solvent/polymer system. The primary objective of this article is to trace the origins of such forays. The Maxwell-Stefan diffusion formulation is combined with the Flory-Huggins description of phase equilibrium thermodynamics to set up a model for describing the transient equilibration trajectory that is followed in the polymer casting film. Four different systems are analyzed: water/acetone/CA, water/DMF/PVDF, water/NMP/PSF, and water/NMP/PEI (CA = cellulose acetate; PVDF = poly(vinylidene fluoride); PSF = polysulfone; PEI = polyetherimide, DMF = dimethyl formamide; NMP = N-methyl-2-pyrrolidone). The analysis shows that diffusional forays are mainly engendered due to thermodynamic coupling effects; such effects are quantified by the set of thermodynamic factors , where a i , the activity of species i, is dependent on the volume fractions, ϕ i and ϕ j , of both nonsolvent (i) and solvent (j). In regions close to phase transitions, the off-diagonal elements Γ ij (i ≠ j) are often negative and may attain large magnitudes in relation to the diagonal elements Γ ii . Strong thermodynamic coupling effects cause the transient equilibration trajectories to be strongly curvilinear, causing ingress into the metastable region. If thermodynamic coupling effects are ignored, no such ingress occurs. It is also shown that analogous diffusional forays may lead to emulsion formation in partially miscible liquid mixtures.
| S-EPMC7045869 | biostudies-literature
Project description:A new implicit solvation model was developed for calculating free energies of transfer of molecules from water to any solvent with defined bulk properties. The transfer energy was calculated as a sum of the first solvation shell energy and the long-range electrostatic contribution. The first term was proportional to solvent accessible surface area and solvation parameters (?(i)) for different atom types. The electrostatic term was computed as a product of group dipole moments and dipolar solvation parameter (?) for neutral molecules or using a modified Born equation for ions. The regression coefficients in linear dependencies of solvation parameters ?(i) and ? on dielectric constant, solvatochromic polarizability parameter ?*, and hydrogen-bonding donor and acceptor capacities of solvents were optimized using 1269 experimental transfer energies from 19 organic solvents to water. The root-mean-square errors for neutral compounds and ions were 0.82 and 1.61 kcal/mol, respectively. Quantification of energy components demonstrates the dominant roles of hydrophobic effect for nonpolar atoms and of hydrogen-bonding for polar atoms. The estimated first solvation shell energy outweighs the long-range electrostatics for most compounds including ions. The simplicity and computational efficiency of the model allows its application for modeling of macromolecules in anisotropic environments, such as biological membranes.
| S-EPMC3089899 | biostudies-literature
Project description:We present a chip design allowing rapid and robust lipid bilayer (LBL) membrane formation using a Parylene coated thin silicon nitride aperture. After bilayer formation, single membrane channels can be reconstituted and characterized by electrophysiology. The ability for robust reconstitution will allow parallelization and enhanced screening of small molecule drugs acting on or permeating across the membrane channel. The aperture was realized on a microfabricated silicon nitride membrane by using standard clean-room fabrication processes. To ensure the lipid bilayer formation, the nitride membrane was coated with a hydrophobic and biocompatible Parylene layer. We tested both Parylene-C and Parylene-AF4. The contact angle measurements on both Parylene types showed very good hydrophobic properties and affinity to lipids. No precoating of the Parylene with an organic solvent is needed to make the aperture lipophilic, in contradiction to Teflon membranes. The chips can be easily placed in an array utilizing a 3D printed platform. Experiments show repetitive LBL formation and destruction (more than 6 times) within a very short time (few seconds). Through measurements we have established that the LBL layers are very thin. This allows the investigation of the fusion process of membrane proteins i.e. outer membrane protein (OmpF) in the LBL within a few minutes.
| S-EPMC7192868 | biostudies-literature