Dataset Information

Selective Recovery of Palladium (II) from Metallurgical Wastewater Using Thiadiazole-Based Chloromethyl Polystyrene-Modified Adsorbent.

ABSTRACT: Selective adsorption of palladium from metallurgical wastewater containing Pt (IV), Rh (III), Ca²⁺, Cu²⁺, Fe³⁺, Ni²⁺, Pb²⁺, V³⁺, and Ti⁴⁺ has tremendous economic and environmental benefits. In this paper, a novel thiadiazole-based chloromethyl polystyrene-modified adsorbent, viz. 2, 5-bis-polystyrene-1,3,4-thiadiazole (PS-DMTD), was synthesized using chloromethyl polystyrene as the backbone. The experimental results show that PS-DMTD can selectively separate Pd (II) from metallurgical wastewater in a one-step adsorption process. The calculated saturation adsorption capacity of PS-DMTD for Pd (II) was 176.3 mg/g at 25 °C. The separation factors of β_{Pd (II)/M}ⁿ⁺ (Mⁿ⁺: Pt (IV), Rh (III), Ca²⁺, Cu²⁺, Fe³⁺, Ni²⁺, Pb²⁺, V³⁺, and Ti⁴⁺) were all higher than 1 × 10⁴. FT-IR, XPS, and single-crystal X-ray diffraction showed that the adsorption of Pd (II) to PS-DMTD was primarily through a coordination mechanism. Density functional theory (DFT) calculations revealed that the other base metal ions could not coordinate with the PS-DMTD. Pt (IV) could not be adsorbed to PS-DMTD due to its strong chlorophilicity. Furthermore, Rh (III) existed as a polyhydrate, which inhibited Rh (III) diffusion toward the positively charged absorption sites on the PS-DMTD. These results highlight that PS-DMTD has broad application prospects in the recovery of Pd (II) from metallurgical wastewater.

SUBMITTER: Zhang X

PROVIDER: S-EPMC9603776 | biostudies-literature | 2022 Oct

REPOSITORIES: biostudies-literature

ACCESS DATA

Publications

Selective Recovery of Palladium (II) from Metallurgical Wastewater Using Thiadiazole-Based Chloromethyl Polystyrene-Modified Adsorbent.

Zhang Xiaoguo X Chen Zhihong Z Wan Zhaoneng Z Liu Chali C He Renze R Xie Xiaoguang X Huang Zhangjie Z

International journal of molecular sciences 20221012 20

Selective adsorption of palladium from metallurgical wastewater containing Pt (IV), Rh (III), Ca2+, Cu2+, Fe3+, Ni2+, Pb2+, V3+, and Ti4+ has tremendous economic and environmental benefits. In this paper, a novel thiadiazole-based chloromethyl polystyrene-modified adsorbent, viz. 2, 5-bis-polystyrene-1,3,4-thiadiazole (PS-DMTD), was synthesized using chloromethyl polystyrene as the backbone. The experimental results sho ...[more]

PMID: 36293033

Similar Datasets

Project description:Competition for the migration of interfering cations limits the scale-up and implementation of the Donnan dialysis process for the recovery of ammonia nitrogen (NH4+-N) from wastewater in practice. Highly efficient selective permeation of NH4+ through a cation exchange membrane (CEM) is expected to be modulated via tuning the surface charge and structure of CEM. In this work, a novel CEM was designed to form a graphene oxide (GO)-polyethyleneimine (PEI) cross-linked layer by introducing self-assembling layers of GO and PEI on the surface of a commercial CEM, which rationally regulates the surface charge and structure of the membrane. The resulting positively charged membrane surface exhibits stronger repulsion for divalent cations compared to monovalent cations according to Coulomb's law, while, simultaneously, GO forms π-metal cation conjugates between metal cations (e.g., Mg2+ and Ca2+), thus limiting metal cation transport across the membrane. During the DD process, higher NH4+ concentrations resulted in a longer time to reach Donnan equilibrium and higher NH4+ flux, while increased Mg2+ concentrations resulted in lower NH4+ flux (from 0.414 to 0.213 mol·m-2·h-1). Using the synergistic effect of electrostatic interaction and non-covalent cross-linking, the designed membrane, referred to as GO-PEI (20) and prepared by a 20 min impregnation in the GO-PEI mixture, exhibited an NH4+ transport rate of 0.429 mol·m-2·h-1 and a Mg2+ transport rate of 0.003 mol·m-2·h-1 in single-salt solution tests and an NH4+/Mg2+ selectivity of 15.46, outperforming those of the unmodified and PEI membranes (1.30 and 5.74, respectively). In mixed salt solution tests, the GO-PEI (20) membrane showed a selectivity of 15.46 (~1.36, the unmodified membrane) for NH4+/Mg2+ and a good structural stability after 72 h of continuous operation. Therefore, this facile surface charge modulation approach provides a promising avenue for achieving efficient NH4+-selective separation by modified CEMs.

Project description:Wastewater rich in phosphates and nitrates causes eutrophication and leads to the impairment of freshwater resources. Out of various methods used, adsorption is the immaculate and economical for removing and recovering phosphates and nitrates from wastewater streams in a single-step process. This study explores the potential of bio-based adsorbent, functionalized organosolv lignin [OL], chemically modified by grafting with 3-aminopropyltriethoxysilane [APTES], as an effective bio-based adsorbent [OL-APTES-H+] for phosphate recovery from aqueous solutions and industrial wastewater. The characterization of OL-APTES-H+ was performed using multiple analytical techniques, providing comprehensive information on the material morphology, elemental composition, functional groups, thermal stability, surface charge, and electrokinetic behavior. The adsorption efficiency of OL-APTES-H+ was assessed under varying experimental conditions, including pH, contact time, and initial phosphate concentration. The adsorption capacity of OL-APTES-H+ depended on pH, with different forms of phosphate species being preferentially adsorbed at different pH values. A maximum adsorption capacity of 21.12 mg/g was achieved at pH 5. Kinetic studies indicated that the adsorption process followed a combination of electrostatic interactions, chemisorption and surface interaction, as evidenced by SEM and EDS analyses. XPS results confirm phosphorus incorporation on the adsorbent surface, reinforcing chemisorption. Adsorption isotherm analysis revealed that the data fitted well to the Langmuir isotherm model, suggesting a monolayer adsorption mechanism. The adsorption performance of OL-APTES-H+ was enhanced in the presence of monovalent ions, while a slight reduction in efficiency was observed in the presence of divalent anions. When applied to industrial dairy wastewater, OL-APTES-H+ exhibited phosphate removal efficiencies ranging from 30 % to 58 %. Overall, OL-APTES-H+ demonstrates considerable potential as a bio-based adsorbent for phosphate recovery, effectively mitigating environmental pollution in wastewater bodies and providing an eco-friendly source of phosphates for sustainable agricultural practices.

Dataset Information

Selective Recovery of Palladium (II) from Metallurgical Wastewater Using Thiadiazole-Based Chloromethyl Polystyrene-Modified Adsorbent.

Publications

Selective Recovery of Palladium (II) from Metallurgical Wastewater Using Thiadiazole-Based Chloromethyl Polystyrene-Modified Adsorbent.

Similar Datasets

OmicsDI is part of the ELIXIR infrastructure

Tweets