Correction: Increased photocorrosion resistance of ZnO foams via transition metal doping.
Ontology highlight
ABSTRACT:
SUBMITTER: Warren Z
PROVIDER: S-EPMC9900717 | biostudies-literature | 2023 Jan
REPOSITORIES: biostudies-literature
Publications
Correction: Increased photocorrosion resistance of ZnO foams <i>via</i> transition metal doping.
Warren Zachary Z Wenk Jannis J Mattia Davide D
RSC advances 20230101 7
[This corrects the article DOI: 10.1039/D2RA06730G.]. ...[more]
Similar Datasets
Project description:ZnO is a widely studied photocatalyst, but practical use is hindered by its low resistance to photocorrosion in water, which leads to metal leaching and loss of performance over time. In this work, highly porous and mechanically stable ZnO foams, called MolFoams, were doped by adding 1% or 2% Co, Ni or Cu salts to the starting Zn salt, followed by air insufflation during a sol-gel rection and sintering. The resulting doped foams showed a major increase in stability, with a 60-85% reduction in Zn2+ leaching after irradiation, albeit with a reduction in photocatalytic activity. A systematic analysis using XRD, Raman, XPS and XANES allowed for the identification of dopant species in the foams revealing the presence of Co3O4, NiO and Cu2O within the ZnO lattice with doping leading to a reduced band gap and significant increases in the resistance to photocorrosion of ZnO while identifying the cause of the reduction in photocatalytic activity to be shifting of the band edge positions. These results provide a pathway to significantly reduce the photocorrosion of ZnO in water, with further work required to maintain the photocatalytic activity of undoped ZnO.
| S-EPMC9844254 | biostudies-literature
Project description:We present a general and in-depth study of the effect of dopants in hybrid inorganic/organic ZnO/PAA (polyacrylic acid) nanocomposites. These dopants vary as much by their ionic size, as by their electronic valence and some of them have been used in ZnO due to their known magnetic and/or optical properties. The chemical nature of the dopants controls their ability to incorporate into ZnO crystal lattice. Three concentrations (0.1%, 1% and 5%) of dopants were studied in order to compare the effect of the concentration with the results obtained previously in the literature. Our results confirm in the first place the trend observed in the literature, that increase in dopant concentration leads to quenching of visible luminescence for ZnO nanocrystals obtained by very different processes. However, the degradation of photoluminescence quantum yield (PL QY) is not inevitable in our nanocomposites. At low doping concentration for some dopants with a small or comparable ionic radius than Zn2+, PL QY can be maintained or even improved, making it possible to tune the visible emission spectrum between 2.17 eV and 2.46 eV. This opens up the prospect of synthesizing phosphors without rare earth for white LEDs, whose spectrum can be tuned to render warm or cold white light, by a chemical synthesis process with a low environmental impact.
| S-EPMC6697676 | biostudies-literature
Project description:Degradation and dissolution of transparent semiconducting oxides is central to various areas, including design of catalysts and catalysis conditions, as well as passivation of metal surfaces. In particular, photocorrosion can be significant and plays a central role during photoelectrochemical activity of transparent semiconducting oxides. Here, we utilize an electrochemical flow cell combined with an inductively coupled plasma mass spectrometer (ICP-MS) to enable the in situ study of the time-resolved release of zinc into solution under simultaneous radiation of UV-light. With this system we study the dissolution of zinc oxide single crystals with (0001) and (101̅0) orientations. At acidic and alkaline pH, we characterized potential dependent dissolution rates into both the oxygen and the hydrogen evolving conditions. A significant influence of the UV radiation and the pH of the electrolyte was observed. The observed dissolution behavior agrees well with the surface chemistry and stabilization mechanism of ZnO surfaces. In particular, polar ZnO(0001) shows ideal stability at low potentials and under hydrogen evolution conditions. Whereas ZnO(101̅0) sustains higher dissolution rates, while it is inactive for water splitting. Our data demonstrates that surface design and fundamental understanding of surface chemistry provides an effective path to rendering electroactive surfaces stable under operating conditions.
| S-EPMC7688208 | biostudies-literature
Project description:Molecular spins have become key enablers for exploring magnetic interactions, quantum information processes and many-body effects in metals. Metal-organic molecules, in particular, let the spin state of the core metal ion to be modified according to its organic environment, allowing localized magnetic moments to emerge as functional entities with radically different properties from its simple atomic counterparts. Here, using and preserving the integrity of transition metal phthalocyanine high-spin complexes, we demonstrate the magnetic doping of gold thin films, effectively creating a new ground state. We demonstrate it by electrical transport measurements that are sensitive to the scattering of itinerant electrons with magnetic impurities, such as Kondo effect and weak antilocalization. Our work expands in a simple and powerful way the classes of materials that can be used as magnetic dopants, opening a new channel to couple the wide range of molecular properties with spin phenomena at a functional scale.
| S-EPMC5159905 | biostudies-literature
Project description:Two-dimensional (2D) Janus transition-metal dichalcogenides (TMDs) (MXY, M = Mo, W; X, Y = S, Se, Te; X ≠ Y) have desirable energy gaps and high stability in ambient conditions, similar to traditional 2D TMDs with potential applications in electronics. But different from traditional 2D TMDs, 2D Janus TMDs possess intrinsic Rashba spin splitting due to out-of-plane mirror symmetry breaking, with promising applications in spintronics. Here we demonstrate a new and effective way to manipulate the Rashba effect in 2D Janus TMDs, that is, charge doping, by using first-principles density functional theory (DFT) calculations. We find that electron doping can effectively strengthen the Rashba spin splitting at the valence band maximum (VBM) and conduction band minimum (CBM) in 2D Janus TMDs without constant energy consumption, superior to traditional techniques (electric fields and strain engineering), but hole doping would weaken the Rashba effect in 2D Janus TMDs. By combining the DFT calculations with the electric-triple-layer model, we also reveal the intrinsic mechanism of tuning the Rashba effect in 2D Janus TMDs by charge doping, and find that the charge transfer plays an important role in tuning the Rashba spin splitting in 2D polar semiconductors. In particular, the Rashba constants are linearly dependent on the charge transfer between X (or Y) and M atoms in 2D Janus TMDs. These results enrich the fundamental understanding of the Rashba effect in 2D semiconductors, which can be promising candidates for spin field-effect transistors (FETs) in experiments.
| S-EPMC9049672 | biostudies-literature
Project description:Exciton dissociation at the zinc oxide/poly(3-hexylthiophene) (ZnO/P3HT) interface as a function of nitrogen doping of the zinc oxide, which decreases the electron concentration from approximately 1019 cm-3 to 1017 cm-3, is reported. Exciton dissociation and device photocurrent are strongly improved with nitrogen doping. This improved dissociation of excitons in the conjugated polymer is found to result from enhanced light-induced de-trapping of electrons from the surface of the nitrogen-doped ZnO. The ability to improve the surface properties of ZnO by introducing a simple nitrogen dopant has general applicability.
| S-EPMC4228972 | biostudies-literature
Project description:Piezoelectricity, a fundamental property of perovskite ferroelectrics, endows the materials at the heart of electromechanical systems spanning from macro to micro/nano scales. Defect engineering strategies, particularly involving heterovalent trace impurities and derived vacancies, hold great potential for adjusting piezoelectric performance. Despite the prevalent use of defect engineering for modification, a comprehensive understanding of the specific features that positively impact material properties is still lacking, this knowledge gap impedes the advancement of a universally applicable defect selection and design strategy. In this work, we select perovskite KTa1-xNbxO3 single crystals with orthorhombic phase as the matrix and introduce Fe and Mn elements, which are commonly used in "hard" ferroelectrics as dopants. We investigate how transition-metal doping modifies piezoelectric properties from the perspective of intrinsic polarization behaviors. Interestingly, despite both being doped into the B-site as an acceptor, Mn doping enhances the local structural heterogeneity, greatly bolstering the piezoelectric coefficient beyond 1000 pC/N, whereas Fe doping tends to stabilize the polarization, leading to a substantial improvement in the mechanical quality factor up to 700. This work deciphers the diverse impacts of transition metal impurities on regulating polarization structures and modifying piezoelectric properties, providing a good paradigm for strategically designing perovskite ferroelectrics.
| S-EPMC11621366 | biostudies-literature
Project description:Ultralight (<10 mg/cm3) cellular materials are desirable for thermal insulation; battery electrodes; catalyst supports; and acoustic, vibration, or shock energy damping. However, most of these ultralight materials, especially ultralight metal foams, are fabricated using either expensive materials or complicated procedures, which greatly limit their large-scale production and practical applications. Here we report a simple and versatile method to obtain ultralight monolithic metal foams. These materials are fabricated with a low-cost polymeric template and the method is based on the traditional silver mirror reaction and electroless plating. We have produced ultralight monolithic metal foams, such as silver, nickel, cobalt, and copper via this method. The resultant ultralight monolithic metal foams have remarkably low densities down to 7.4 mg/cm3 or 99.9% porosity. The metal foams have a long flat stress-train curve in compression tests and the densification strain εD of the Ni/Ag foam with a porosity of 99.8% can reach 82%. The plateau stress σpl was measured and found to be in agreement with the value predicted by the cellular solids theory.
| S-EPMC4562267 | biostudies-literature
Project description:It is highly desirable to develop efficient and low-cost catalysts to minimize the overpotential of the hydrogen evolution reaction (HER) for large-scale hydrogen production from electrochemical water splitting. Doping a foreign element into the host catalysts has been proposed as an effective approach to optimize the electronic characteristics of catalysts and thus improve their electrocatalytic performance. Herein we, for the first time, report vanadium-doped CoP on self-supported conductive carbon cloth (V-CoP/CC) as a robust HER electrocatalyst, which achieves ultra-low overpotentials of 71, 123 and 47 mV to afford a current density of 10 mA cm-2 in 1 M KOH, 1 M PBS and 0.5 M H2SO4 media, respectively. Meanwhile, the V-CoP/CC electrode exhibits a small Tafel slope and superior long-term stability over a wide pH range. Detailed characterizations reveal that the modulation of the electronic structure contributes to the superior HER performance of V-CoP/CC. We believe that doping engineering opens up new opportunities to improve the HER catalytic activity of transition metal phosphides through regulating their physicochemical and electrochemical properties.
| S-EPMC5892309 | biostudies-literature
Project description:Undoped and Fe-doped ZnO nanoparticles (NPs) were synthesized using Amaranthus spinosus leaf extract as a reducing agent. The physicochemical traits, dissolution, cytotoxicity, as well as the antioxidant, photocatalytic and antibacterial activities of synthesized NPs were investigated. The results revealed that ZnO NPs were rod shaped with hexagonal phase structure, and their crystal size, dissolubility and aggregation decreased with Fe doping of NPs. Cytotoxicity of the NPs was studied against MCF-7 cells by MTT assay. IC50 values for undoped and 1 wt% Fe-doped ZnO NPs were found to be 400 and 600 μg mL-1, respectively. Cell viability with Fe-doped ZnO NPs was higher than with undoped ZnO. Among the synthesized NPs, A. spinosus-mediated 1 wt% Fe-doped ZnO shows a better decolourization efficiency of 97% for indigo carmine dye under solar irradiance. The antibacterial activity of NPs was tested against Gram-negative Escherichia coli and Gram-positive Bacillus safensis using disc diffusion, minimum inhibitory concentration and growth curve method. The bactericidal activity of Fe-doped ZnO NPs was more prominent with E. coli than B. safensis bacteria and when compared to undoped ZnO.
| S-EPMC6062353 | biostudies-literature