Analysis of progress curves by simulations generated by numerical integration.
Ontology highlight
ABSTRACT:
SUBMITTER: Zimmerle CT
PROVIDER: S-EPMC1138373 | biostudies-other | 1989 Mar
REPOSITORIES: biostudies-other
Similar Datasets
Project description:A difficulty associated with high throughput screening for enzyme inhibitors is to establish reaction conditions that maximize the sensitivity and resolution of the assay. Deduction of information from end-point assays at single concentrations requires a detailed understanding of the time progress of the enzymatic reaction, an essential but often difficult process to model. A tool to simulate the time progress of enzyme catalyzed reactions and allows adjustment of reactant concentrations and parameters (initial concentrations, K(m), k(cat), K(i) values, enzyme half-life, product•enzyme dissociation constant, and the rate constant for the reversed reaction) has been developed. This tool provides comparison of the progress of uninhibited versus inhibited reactions for common inhibitory mechanisms, and guides the tuning of reaction conditions. Possible applications include: analysis of substrate turnover, identification of the point of maximum difference in product concentration (?(max)[P]) between inhibited and uninhibited reactions, determination of an optimal observation window unbiased for inhibitor mechanisms or potency, and interpretation of observed inhibition in terms of true inhibition. An important observation that can be utilized to improve assay signal strength and resolution is that ?(max)[P] occurs at a high degree of substrate consumption (commonly >75%) and that observation close to this point does not adversely affect observed inhibition or IC(50) values.
| S-EPMC3468632 | biostudies-literature
Project description:We summarize the present form of the instability theory for drumlin formation, which describes the coupled subglacial flow of ice, water and sediment. This model has evolved over the last 20 years, and is now at the point where it can predict instabilities corresponding to ribbed moraine, drumlins and mega-scale glacial lineations, but efforts to provide numerical solutions of the model have been limited. The present summary adds some slight nuances to previously published versions of the theory, notably concerning the constitutive description of the subglacial water film and its flow. A new numerical method is devised to solve the model, and we show that it can be solved for realistic values of most of the parameters, with the exception of that corresponding to the water film thickness. We show that evolved bedforms can be three-dimensional and of the correct sizes, and we explore to some extent the variation of the solutions with the model's parameters.
| S-EPMC5582181 | biostudies-literature
Project description:A method is described for fitting the velocities obtained from progress curves to a steady-state rate equation. It is based on the method of Markus & Plesser [(1981) in Kinetic Data Analysis: Design and Analysis of Enzyme and Kinetic Data (Edrenyi, ed.), pp. 317-339, Plenum Press, New York]. The obstacle of needing good initial estimates of kinetic parameters is removed by using the parameters provided graphically by a minor modification of the method of Yun & Suelter [(1977) Biochim, Biophys. Acta 480, 1-13]. This progress-curved-based method allows the same discrimination among rival models as do the initial-velocity-based methods, with a great saving of experimental time. The BASIC and FORTRAN 77 programs are deposited as Supplementary Publication SUP 50132 (17 pages) at the British Library (Lending Division), Boston Spa, Wetherby, West Yorkshire LS23 7BQ, U.K., from whom copies can be obtained on the terms indicated in Biochem. J. (1986) 233, 5-6.
| S-EPMC1153069 | biostudies-other
Project description:Piezoelectric materials characterization is a challenging problem involving physical concepts, electrical and mechanical measurements and numerical optimization techniques. Piezoelectric ceramics such as Lead Zirconate Titanate (PZT) belong to the 6 mm symmetry class, which requires five elastic, three piezoelectric and two dielectric constants to fully represent the material properties. If losses are considered, the material properties can be represented by complex numbers. In this case, 20 independent material constants are required to obtain the full model. Several numerical methods have been used to adjust the theoretical models to the experimental results. The continuous improvement of the computer processing ability has allowed the use of a specific numerical method, the Finite Element Method (FEM), to iteratively solve the problem of finding the piezoelectric constants. This review presents the recent advances in the numerical characterization of 6 mm piezoelectric materials from experimental electrical impedance curves. The basic strategy consists in measuring the electrical impedance curve of a piezoelectric disk, and then combining the Finite Element Method with an iterative algorithm to find a set of material properties that minimizes the difference between the numerical impedance curve and the experimental one. Different methods to validate the results are also discussed. Examples of characterization of some common piezoelectric ceramics are presented to show the practical application of the described methods.
| S-EPMC5456513 | biostudies-other
Project description:Progress curves of enzyme-catalysed reactions are described by equations of a type that precludes direct calculation of the extent of reaction at any time. Previously, such equations have been solved by the Newton-Raphson method, but this procedure may fail when based upon the usual formulae. An alternative formulation is proposed that is both quicker and more robust.
| S-EPMC1146728 | biostudies-other
Project description:Aeolian sand beds exhibit regular patterns of ripples resulting from the interaction between topography and sediment transport. Their characteristics have been so far related to reptation transport caused by the impacts on the ground of grains entrained by the wind into saltation. By means of direct numerical simulations of grains interacting with a wind flow, we show that the instability turns out to be driven by resonant grain trajectories, whose length is close to a ripple wavelength and whose splash leads to a mass displacement toward the ripple crests. The pattern selection results from a compromise between this destabilizing mechanism and a diffusive downslope transport which stabilizes small wavelengths. The initial wavelength is set by the ratio of the sediment flux and the erosion/deposition rate, a ratio which increases linearly with the wind velocity. We show that this scaling law, in agreement with experiments, originates from an interfacial layer separating the saltation zone from the static sand bed, where momentum transfers are dominated by midair collisions. Finally, we provide quantitative support for the use of the propagation of these ripples as a proxy for remote measurements of sediment transport.
| S-EPMC4226103 | biostudies-literature
Project description:Progress curves of the reaction catalysed by pyruvate kinase from Escherichia coli K12, designed to cover the four-dimensional concentration space of phosphoenolpyruvate, ADP, Mg2+ and ATP in the regulatory region, were recorded with the pH-stat method (pH 7.0 and 25 degrees C). Additional initial-rate measurement were performed to assess specific points. Two methods for the evaluation of progress curves were used: fitting the rate law to the rates obtained from the tangents of the progress curves and fitting the integrated rate law directly to the curves. Two models, both extensions of the concerted model given by Monod, Wyman & Changeux [(1965) J. Mol. Biol. 12, 88--118] with four protomers, could be fitted to the data within the experimental error. Model discrimination in favour of one of these models was possible by proper experimental design. In the selected model one conformational state of the enzyme forms the active complex. The active site of a second conformational state forms abortive complexes with Mg2+, causing strong inhibition at high Mg2+ concentrations. In the absence of ligands, most of the enzyme is in a third state that binds ATP at an allosteric site.
| S-EPMC1162020 | biostudies-other
Project description:The effects of errors in Km and Vmax. on the determination of the kinetic constants for the irreversible inhibition of acetylcholinesterase were determined. The results show that small errors in the values of Km and Vmax. give rise to large errors in the fitted parameters k2 and Kd. The problem may be minimized for multiple progress curves by selecting an appropriate number and distribution of inhibitor concentrations.
| S-EPMC1149936 | biostudies-other
Project description:Meta-analysis is a method for enhancing statistical power through the integration of information from multiple studies. Various methods for integrating p-values (i.e., statistical significance), including Fisher's method under an independence assumption, the permutation method, and the decorrelation method, have been broadly used in bioinformatics and computational biotechnology studies. However, these methods have limitations related to statistical assumption, computing efficiency, and accuracy of statistical significance estimation. In this study, we proposed a numerical integration method and examined its theoretical properties. Simulation studies were conducted to evaluate its Type I error, statistical power, computational efficiency, and estimation accuracy, and the results were compared with those of other methods. The results demonstrate that our proposed method performs well in terms of Type I error, statistical power, computing efficiency (regardless of sample size), and statistical significance estimation accuracy. P-value data from multiple large-scale genome-wide association studies (GWASs) and transcriptome-wise association studies (TWASs) were analyzed. The results demonstrate that our proposed method can be used to identify critical genomic regions associated with rheumatoid arthritis and asthma, increase statistical significance in individual GWASs and TWASs, and control for false-positives more effectively than can Fisher's method under an independence assumption. We created the software package Pbine, available at GitHub (https://github.com/Yinchun-Lin/Pbine).
| S-EPMC9283883 | biostudies-literature
Project description:UV radiation can inactivate viruses such as SARS-CoV-2. However, designing effective UV germicidal irradiation (UVGI) systems can be difficult because the effects of dried respiratory droplets and other fomites on UV light intensities are poorly understood. Numerical modeling of UV intensities inside virus-containing particles on surfaces can increase understanding of these possible reductions in UV intensity. We model UV intensities within spherical approximations of virions randomly positioned within spherical particles. The model virions and dried particles have sizes and optical properties to approximate SARS-CoV-2 and dried particles formed from respiratory droplets, respectively. In 1-, 5- and 9-µm diameter particles on a surface, illuminated by 260-nm UV light from a direction perpendicular to the surface, 0%, 10% and 18% (respectively) of simulated virions are exposed to intensities less than 1/100th of intensities in individually exposed virions (i.e., they are partially shielded). Even for 302-nm light (simulating sunlight), where absorption is small, 0% and 11% of virions in 1- and 9-µm particles have exposures 1/100th those of individually exposed virions. Shielding is small to negligible in sub-micron particles. Results show that shielding of virions in a particle can be reduced by illuminating a particle either from multiple widely separated incident directions, or by illuminating a particle rotating in air for a time sufficient to rotate through enough orientations. Because highly UV-reflective paints and surfaces can increase the angular ranges of illumination and the intensities within particles, they appear likely to be useful for reducing shielding of virions embedded within particles.
| S-EPMC7836904 | biostudies-literature