Quantum dot-embedded microspheres for remote refractive index sensing.
Ontology highlight
ABSTRACT:
SUBMITTER: Pang S
PROVIDER: S-EPMC2682744 | biostudies-other | 2008 Jun
REPOSITORIES: biostudies-other
Similar Datasets
Project description:We report the synthesis of Ag nanocubes by using a sodium sulfide assisted solvothermal method. Small edge-length nanocubes (32 and 44 nm) were obtained at 145 and 155 °C reaction temperature in the synthesis process. The refractive index sensitivity of synthesized nanocubes was investigated with an aqueous solution of glucose. The refractive index sensitivity of 161 nm per RIU was found in the colloidal dispersion of nanocubes. On the LSPR chip made by immobilization of nanocubes on the (3-aminopropyl)trimethoxysilane modified glass coverslip, the obtained sensitivity was 116 nm per RIU. Detection of formaldehyde in water and milk samples was also performed with nanocubes of edge-length of 44 nm. Formaldehyde detection was performed by utilizing the interaction of the aryl amine of 4-aminothiophenol immobilized on the nanocubes and electrophilic carbon atom of the formaldehyde. In water and in diluted milk, the formaldehyde sensitivity of 0.62 and 0.29 nm μM-1 was obtained, respectively.
| S-EPMC8695105 | biostudies-literature
Project description:Strong coupling between a cavity and transition dipole moments in emitters leads to vacuum Rabi splitting. Researchers have not reported strong coupling between a single emitter and a dielectric cavity at room temperature until now. In this study, we investigated the photoluminescence (PL) spectra of colloidal quantum dots on the surface of a SiO2/Si material at various collection angles at room temperature. We measured the corresponding reflection spectra for the SiO2/Si material and compared them with the PL spectra. We observed PL spectral splitting and regarded it as strong coupling between colloidal quantum dots and the SiO2/Si material. Upper polaritons and lower polaritons exhibited anticrossing behavior. We observed Rabi splitting from single-photon emission in the dielectric cavity at room temperature. Through analysis, we attributed the Rabi splitting to strong coupling between quantum dots and bound states in the continuum in the low-refractive-index/high-refractive-index hybrid material.
| S-EPMC7679155 | biostudies-literature
Project description:In this work, quantum dots (QDs) of various heterostructured compositions and shell thicknesses are used as Förster or fluorescence resonance energy transfer (FRET) donors and acceptors to optimize QD-QD FRET sensing through materials design. While several reports have highlighted the advantages of using QD-dye, rather than dye-dye, FRET in sensing applications, QD-QD FRET has lagged behind in development as a result of high background signal from direct acceptor excitation. However, in designing sensors for longitudinal studies, QD-dye sensors are limited by the photostability of the fluorescent dye. While fluorescence generally affords higher sensitivity than absorbance-based readouts, the instrumentation needed for detecting fluorescence can be expensive, motivating the development of sensors bright enough to be seen by eye or imaged with cheap consumer electronics. Harnessing the exceptional brightness of QDs, our study focuses on the development of QD-QD FRET pairs where color change is achieved for visual readout and instrument-free sensing. We demonstrate that bulk semiconductor material characteristics can be used to a priori predict and tailor the behavior of QD-QD FRET systems, and our findings show that it is possible to create QD donors that are brighter than their acceptors through concerted compositional and morphological choices in heterostructured QDs. This is significant for developing visual sensors, as we show that the most profound color change occurs when the direct acceptor emission is lower than that of the donor. Finally, the use of an optimal cadmium-free QD-QD FRET pair is presented in a pH sensor that shows a large range of pH-dependent color change with bright, instrument-free readout.
| S-EPMC8275315 | biostudies-literature
Project description:Quantum dots are ideally suited for color conversion in light emitting diodes owing to their spectral tunability, high conversion efficiency and narrow emission bands. These properties are particularly important for display backlights; the highly saturated colors generated by quantum dots justify their higher production cost. Here, we demonstrate the benefits of a hybrid remote phosphor approach that combines a green-emitting europium-doped phosphor with red-emitting CdSe/CdS core/shell quantum dots. Different stacking geometries, including mixed and separate layers of both materials, are studied at the macroscopic and microscopic levels to identify the configuration that achieves maximum device efficiency while minimizing material usage. The influence of reabsorption, optical outcoupling and refractive index-matching between the layers is evaluated in detail with respect to device efficiency and cost. From the findings of this study, general guidelines are derived to optimize both the cost and efficiency of CdSe/CdS and other (potentially cadmium-free) quantum dot systems. When reabsorption of the green and/or red emission is significant compared to the absorption strength for the blue emission of the pumping light emitting diode, the hybrid remote phosphor approach becomes beneficial.
| S-EPMC6062237 | biostudies-literature
Project description:Supramolecular assemblies of a quantum dot (QD) associated to palladium(II) porphyrins have been developed to detect oxygen (pO2) in organic solvents. Palladium porphyrins are sensitive in the 0-160 Torr range, making them ideal phosphors for in vivo biological oxygen quantification. Porphyrins with meso pyridyl substituents bind to the surface of the QD to produce self-assembled nanosensors. Appreciable overlap between QD emission and porphyrin absorption features results in efficient Förster resonance energy transfer (FRET) for signal transduction in these sensors. The QD serves as a photon antenna, enhancing porphyrin emission under both one- and two-photon excitation, demonstrating that QD-palladium porphyrin conjugates may be used for oxygen sensing over physiological oxygen ranges.
| S-EPMC3881537 | biostudies-literature
Project description:In this work, we present a highly-sensitive refractive index sensor based on metatronic nanocircuits operating at near-infrared spectral range. The structure is designed based on simple nanorod geometry and fabricated by nanopatterning of transparent conducting oxides. The functionality of these polarization dependent metatronic nanocircuits is enhanced by applying tunable response. This feature is investigated by depositing NH2 (Amine) groups via plasma polymerization technique on top of indium-tin-oxide nanorods. The dielectric constant of Amine groups is a function of their thickness, which can be controlled by the RF power and the time duration of the applied plasma polymerization process. The resonance wavelengths of nanocircuits shift to higher wavelength, as the dielectric constant of the deposited material increases. An excellent agreement between the design and experimental results are obtained. Our metatronic based nanosensor offers a high-sensitive performance of 1587?nm/RIU with a satisfactory figure of merit for this class of sensors.
| S-EPMC6065432 | biostudies-literature
Project description:We demonstrate the use of a hybrid fluorescent protein semiconductor quantum dot (QD) sensor capable of specifically monitoring caspase 3 proteolytic activity. mCherry monomeric red fluorescent protein engineered to express an N-terminal caspase 3 cleavage site was ratiometrically self-assembled to the surface of QDs using metal-affinity coordination. The proximity of the fluorescent protein to the QD allows it to function as an efficient fluorescence resonance energy transfer acceptor. Addition of caspase 3 enzyme to the QD-mCherry conjugates specifically cleaved the engineered mCherry linker sequence, altering the energy transfer with the QD and allowing quantitative monitoring of proteolytic activity. Inherent advantages of this sensing approach include bacterial expression of the protease substrate in a fluorescently appended form, facile self-assembly to QDs, and the ability to recombinantly modify the substrate to target other proteases of interest.
| S-EPMC2679970 | biostudies-literature
Project description:Intracellular pH (pH(i)) plays a critical role in the physiological and pathophysiological processes of cells, and fluorescence imaging using pH-sensitive indicators provides a powerful tool to assess the pH(i) of intact cells and subcellular compartments. Here we describe a nanoparticle-based ratiometric pH sensor, comprising a bright and photostable semiconductor quantum dot (QD) and pH-sensitive fluorescent proteins (FPs), exhibiting dramatically improved sensitivity and photostability compared to BCECF, the most widely used fluorescent dye for pH imaging. We found that Förster resonance energy transfer between the QD and multiple FPs modulates the FP/QD emission ratio, exhibiting a >12-fold change between pH 6 and 8. The modularity of the probe enables customization to specific biological applications through genetic engineering of the FPs, as illustrated by the altered pH range of the probe through mutagenesis of the fluorescent protein. The QD-FP probes facilitate visualization of the acidification of endosomes in living cells following polyarginine-mediated uptake. These probes have the potential to enjoy a wide range of intracellular pH imaging applications that may not be feasible with fluorescent proteins or organic fluorophores alone.
| S-EPMC3758920 | biostudies-literature
Project description:As a noncentrosymmetric crystal with spin-polarized band structure, MoS2 nanomaterials have attracts increasing attention in many areas such as lithium ion batteries, flexible electronic devices, photoluminescence and valleytronics. The investigation of MoS2 is mainly focused on the electronics and spintronics instead of optics, which restrict its applications as key elements of photonics. In this work, we demonstrate the first observation of the polarization-dependent optical absorption of the MoS2 thin film, which is integrated onto an optical waveguide device. With this feature, a novel optical sensor combining MoS2 thin-film and a microfluidic structure has been constituted to achieve the sensitive monitoring of refractive index. Our work indicates the MoS2 thin film as a complementary material to graphene for the optical polarizer in the visible light range, and explores a new application direction of MoS2 nanomaterials for the construction of photonic circuits.
| S-EPMC4268638 | biostudies-other
Project description:An ultrasensitive magnetic field sensor is proposed and investigated experimentally. The no-core fiber is fusion-spliced between two pieces of single-mode fibers and then immersed in magnetic fluid with an appropriate value of refractive index. Under the refractive-index-matched coupling condition, the guided mode becomes leaky and a coupling wavelength dip in the transmission spectrum of the structure is observed. The coupling wavelength dip is extremely sensitive to the ambient environment. The excellent sensitivity to the refractive index is measured to be 116.681 μm/RIU (refractive index unit) in the refractive index range of 1.45691-1.45926. For the as-fabricated sensors, the highest magnetic field sensing sensitivities of 6.33 and 1.83 nm/mT are achieved at low and high fields, respectively. The sensitivity is considerably enhanced compared with those of previously designed, similar structures.
| S-EPMC5539600 | biostudies-other