Determination of rapid-equilibrium kinetic parameters of ordered and random enzyme-catalyzed reaction A+B=P+Q.
Ontology highlight
ABSTRACT:
SUBMITTER: Alberty RA
PROVIDER: S-EPMC2711645 | biostudies-other | 2009 Jul
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Rapid-equilibrium rate equations are derived for the five different mechanisms for the enzymatic catalysis of A + B + C --> products using a computer. These rate equations are used to determine the minimum number of velocities required to estimate the values of the kinetic parameters. The rate equation for the completely ordered mechanism involves four kinetic parameters, and the rate equation for the completely random mechanism involves eight kinetic parameters. Therefore, the four to eight kinetic parameters can be estimated by determining four to eight velocities and solving four to eight simultaneous equations. General recommendations are made as to the choices of triplets of substrate concentrations {[A], [B], [C]} to be used to determine the velocities. The effects of 5% errors in the measured velocities, one at a time, are calculated and are summarized in tables. Calculations of effects of experimental errors are useful in choosing the triplets of substrate concentrations to be used to obtain the most accurate values of the kinetic parameters. When the kinetic parameters for A + B + C --> products are to be determined for the first time, it is recommended that the program for the completely random mechanism be used because it can identify the mechanism and determine the kinetic parameters in one operation.
| S-EPMC2654092 | biostudies-literature
Project description:Based on experimental data of both batch and continuous enzyme-catalyzed kinetic resolutions of (±)-trans-1,2-cyclohexanediol in supercritical carbon dioxide, kinetic models of increasing complexity were developed to explore the strengths and drawbacks of various modeling approaches. The simplest, first-order model proved to be a good fit for the batch experimental data in regions of high reagent concentrations but failed elsewhere. A more complex system that closely follows the true mechanism was able to fit the full range of experimental data, find constant reaction rate coefficients, and was successfully used to predict the results of the same reaction run continuously in a packed bed reactor. Care must be taken when working with such models, however, to avoid problems of overfitting; a more complex model is not always more accurate. This work may serve as an example for more rigorous reaction modeling and reactor design in the future.
| S-EPMC7581243 | biostudies-literature
Project description:A popular approach to analyze the dynamics of high-dimensional many-body systems, such as macromolecules, is to project the trajectories onto a space of slowly varying collective variables, where subsequent analyses are made, such as clustering or estimation of free energy profiles or Markov state models. However, existing "dynamical" dimension reduction methods, such as the time-lagged independent component analysis (TICA), are only valid if the dynamics obeys detailed balance (microscopic reversibility) and typically require long, equilibrated simulation trajectories. Here, we develop a dimension reduction method for non-equilibrium dynamics based on the recently developed Variational Approach for Markov Processes (VAMP) by Wu and Noé. VAMP is illustrated by obtaining a low-dimensional description of a single file ion diffusion model and by identifying long-lived states from molecular dynamics simulations of the KcsA channel protein in an external electrochemical potential. This analysis provides detailed insights into the coupling of conformational dynamics, the configuration of the selectivity filter, and the conductance of the channel. We recommend VAMP as a replacement for the less general TICA method.
| S-EPMC6486394 | biostudies-literature
Project description:Understanding and quantification of cosolvent influences on enzyme-catalyzed reactions are driven by a twofold interest. On the one hand, cosolvents can simulate the cellular environment for deeper understanding of in cellulo reaction conditions. On the other hand, cosolvents are applied in biotechnology to tune yield and kinetics of reactions. Further, cosolvents are even present inherently, for example, for reactions with cofactor regeneration or for enzymes that need cosolvents in a function of a stabilizer. As the experimental determination of yield and kinetics is costly and time consuming, this work aims at providing a thermodynamic predictive approach that might allow screening cosolvent influences on yield and Michaelis constants. Reactions investigated in this work are the reduction of butanone and 2-pentanone under the influence of 17 wt % of the cosolvent polyethylene glycol 6000, which is also often used as a crowder to simulate cellular environments. The considered reactions were catalyzed by a genetically modified alcohol dehydrogenase (ADH 270). Predictions of cosolvent influences are based on accounting for a cosolvent-induced change of molecular interactions among the reacting agents as well as between the reacting agents and the solvent. Such interactions were characterized by activity coefficients of the reacting agents that were predicted by means of electrolyte perturbed-chain statistical associating fluid theory. This allowed simultaneously predicting the cosolvent effects on yield and Michaelis constants for two-substrate reactions for the first time.
| S-EPMC6648939 | biostudies-literature
Project description:Nucleoside analogues are among the most common medications given for the treatment of viral infections and cancers. The therapeutic effectiveness of nucleoside analogues can be dramatically improved by phosphorylation. The ProTide approach was developed using a phosphorylated nucleoside that is masked by esterification with an amino acid and phenol forming a chiral phosphorus center. The biological activity of the ProTides depends, in part, on the stereochemistry at phosphorus, and thus, it is imperative that efficient methods be developed for the chemical synthesis and isolation of diastereomerically pure ProTides. Chiral ProTides are often synthesized by direct displacement of a labile phenol (p-nitrophenol or pentafluorophenol) from a chiral phosphoramidate precursor with the appropriate nucleoside analogue. The ability to produce these chiral products is dictated by the synthesis of the chiral phosphoramidate precursors. The enzyme phosphotriesterase (PTE) from Pseudomonas diminuta is well-known for its high stereoselectivity and broad substrate profile. Screening PTE variants from enzyme evolution libraries enabled the identification of variants of PTE that can stereoselectively hydrolyze the chiral phosphoramidate precursors. The variant G60A-PTE exhibits a 165-fold preference for hydrolysis of the RP isomer, while the variant In1W-PTE has a 1400-fold preference for hydrolysis of the SP isomer. Using these mutants of PTE, the SP and RP isomers were isolated on a preparative scale with no detectable contamination of the opposite isomer. Combining the simplicity of the enzymatic resolution of the precursor with the latest synthetic strategy will facilitate the production of diastereometrically pure nucleotide phosphoramidate prodrugs.
| S-EPMC6822272 | biostudies-literature
Project description:BACKGROUND: Numerous models for use in interpreting quantitative PCR (qPCR) data are present in recent literature. The most commonly used models assume the amplification in qPCR is exponential and fit an exponential model with a constant rate of increase to a select part of the curve. Kinetic theory may be used to model the annealing phase and does not assume constant efficiency of amplification. Mechanistic models describing the annealing phase with kinetic theory offer the most potential for accurate interpretation of qPCR data. Even so, they have not been thoroughly investigated and are rarely used for interpretation of qPCR data. New results for kinetic modeling of qPCR are presented. RESULTS: Two models are presented in which the efficiency of amplification is based on equilibrium solutions for the annealing phase of the qPCR process. Model 1 assumes annealing of complementary targets strands and annealing of target and primers are both reversible reactions and reach a dynamic equilibrium. Model 2 assumes all annealing reactions are nonreversible and equilibrium is static. Both models include the effect of primer concentration during the annealing phase. Analytic formulae are given for the equilibrium values of all single and double stranded molecules at the end of the annealing step. The equilibrium values are then used in a stepwise method to describe the whole qPCR process. Rate constants of kinetic models are the same for solutions that are identical except for possibly having different initial target concentrations. Analysis of qPCR curves from such solutions are thus analyzed by simultaneous non-linear curve fitting with the same rate constant values applying to all curves and each curve having a unique value for initial target concentration. The models were fit to two data sets for which the true initial target concentrations are known. Both models give better fit to observed qPCR data than other kinetic models present in the literature. They also give better estimates of initial target concentration. Model 1 was found to be slightly more robust than model 2 giving better estimates of initial target concentration when estimation of parameters was done for qPCR curves with very different initial target concentration. Both models may be used to estimate the initial absolute concentration of target sequence when a standard curve is not available. CONCLUSIONS: It is argued that the kinetic approach to modeling and interpreting quantitative PCR data has the potential to give more precise estimates of the true initial target concentrations than other methods currently used for analysis of qPCR data. The two models presented here give a unified model of the qPCR process in that they explain the shape of the qPCR curve for a wide variety of initial target concentrations.
| S-EPMC3519511 | biostudies-other
Project description:A model is presented that accounts for all types of reversible inhibition by a single inhibitor molecule in bimolecular rapid-equilibrium random-order enzyme systems. The characterization of inhibition mechanisms by graphical methods is examined, and a system of nomenclature is suggested.
| S-EPMC1179061 | biostudies-other
Project description:Cocombustion of bituminous coal (HC) and Pinus sawdust (PS) was investigated in this paper with the aim of determining the kinetic parameters relevant to cocombustion reactions of their fuel blends. PS was used because it is a waste biomass product capable of generating energy. Motivated by the need to partly substitute HC used in existing boilers with PS, the optimum kinetic parameters at different blending ratios were thus investigated with the ultimate goal of diversifying the energy portfolio for these boilers. Blended samples were prepared with a PS substitution by mass ranging from 0 to 30%, thus producing five samples, namely:100HC, 90HC10PS, 80HC20PS, 70HC30PS, and 100PS. A simultaneous thermogravimetric analyzer was used to investigate the degradation of the fuel samples under a synthetic air atmosphere using 5, 12.5, and 20 °C/min heating rates. The kinetic parameters were evaluated using the distributed activation energy model (DAEM) due to its ability to evaluate complex parallel chemical mechanisms. The influential homogenous volatile combustion and heterogenous combustion stages produced an increasing trend for activation energy (E a) with increased PS (100HC to 70HC30PS) from an average of 61.80-104.34 kJ/mol while the pre-exponential factor increased from 1.31 × 105 to 6.52 × 108. Generally, blending of HC with PS did not produce a linear variation of the kinetic parameters; thus, by using various plots, an optimum blending ratio of 80HC20PS was deduced.
| S-EPMC9476186 | biostudies-literature
Project description:We report the application of recently developed microscopic models to estimate the apparent kinetic and thermodynamic parameters in a single molecule force spectroscopy study of the carbonic anhydrase enzyme and a complementary sulfonamide inhibitor. The most probable rupture force for the enzyme-inhibitor interaction shows a nonlinear dependency on the log-loading rate. Estimates for the kinetic and thermodynamic parameters were obtained by fitting the nonlinear dependency to linear cubic potential and cusp potential models and compared to the standard Bell-Evans model. The reliability of the estimated parameters was verified by modeling the experimental rupture force distributions by the theoretically predicted distributions at rupture. We also report that linkers that are attached to the enzyme and inhibitor show appreciable effects on the apparent kinetic and thermodynamic parameters.
| S-EPMC2586077 | biostudies-literature
Project description:Stability and biological activity of proteins is highly dependent on their physicochemical environment. The development of realistic models of biological systems necessitates quantitative information on the response to changes of external conditions like pH, salinity and concentrations of substrates and allosteric modulators. Changes in just a few variable parameters rapidly lead to large numbers of experimental conditions, which go beyond the experimental capacity of most research groups. We implemented a computer-aided experimenting framework ("robot lab assistant") that allows us to parameterize abstract, human-readable descriptions of micro-plate based experiments with variable parameters and execute them on a conventional 8 channel liquid handling robot fitted with a sensitive plate reader. A set of newly developed R-packages translates the instructions into machine commands, executes them, collects the data and processes it without user-interaction. By combining script-driven experimental planning, execution and data-analysis, our system can react to experimental outcomes autonomously, allowing outcome-based iterative experimental strategies. The framework was applied in a response-surface model based iterative optimization of buffer conditions and investigation of substrate, allosteric effector, pH and salt dependent activity profiles of pyruvate kinase (PYK). A diprotic model of enzyme kinetics was used to model the combined effects of changing pH and substrate concentrations. The 8 parameters of the model could be estimated from a single two-hour experiment using nonlinear least-squares regression. The model with the estimated parameters successfully predicted pH and PEP dependence of initial reaction rates, while the PEP concentration dependent shift of optimal pH could only be reproduced with a set of manually tweaked parameters. Differences between model-predictions and experimental observations at low pH suggest additional protonation-sites at the enzyme or substrates critical for enzymatic activity. The developed framework is a powerful tool to investigate enzyme reaction specifics and explore biological system behaviour in a wide range of experimental conditions.
| S-EPMC2873295 | biostudies-literature