A multi-crystal wavelength dispersive x-ray spectrometer.
Ontology highlight
ABSTRACT:
SUBMITTER: Alonso-Mori R
PROVIDER: S-EPMC3422323 | biostudies-other | 2012 Jul
REPOSITORIES: biostudies-other
Similar Datasets
Project description:X-ray absorption spectroscopy (XAS) beamlines worldwide are steadily increasing their emphasis on full photon-in/photon-out spectroscopies, such as resonant inelastic X-ray scattering (RIXS), resonant X-ray emission spectroscopy (RXES) and high energy resolution fluorescence detection XAS (HERFD-XAS). In such cases, each beamline must match the choice of emission spectrometer to the scientific mission of its users. Previous work has recently reported a miniature tender X-ray spectrometer using a dispersive Rowland refocusing (DRR) geometry that functions with high energy resolution even with a large X-ray spot size on the sample [Holden et al. (2017). Rev. Sci. Instrum. 88, 073904]. This instrument has been used in the laboratory in multiple studies of non-resonant X-ray emission spectroscopy using a conventional X-ray tube, though only for preliminary measurements at a low-intensity microfocus synchrotron beamline. This paper reports an extensive study of the performance of a miniature DRR spectrometer at an unfocused wiggler beamline, where the incident monochromatic flux allows for resonant studies which are impossible in the laboratory. The results support the broader use of the present design and also suggest that the DRR method with an unfocused beam could have important applications for materials with low radiation damage thresholds and that would not survive analysis on focused beamlines.
| S-EPMC7064111 | biostudies-literature
Project description:The synthesis of ionic liquids (ILs) usually involves two steps: (i) quaternization of a precursor followed by (ii) a salt metathesis reaction to introduce the desired anion. A consequence of the second step is that most ILs still contain some amount of the initial anion, often chloride. In this work, wavelength dispersive X-ray fluorescence (WDXRF) spectrometry is presented for the direct measurement of chlorides in ILs. The WDXRF settings were optimized, and the system was calibrated for the detection of chloride in several analogues of the commercially available IL Aliquat 336, [A336][X] (with X = I-, Br-, NO3 -, or SCN-). The Cl Kα intensity showed excellent linearity for samples with a conversion >0.80 (approximately Cl < 8000 ppm). Synthetic quality control samples showed that the instrumental error and deviations induced by the calibration procedure were small with maximum values of 1 and 5%, respectively. Detection and quantification limits depended strongly on the matrix (i.e., anion system and dilution) but were relatively low: 42-191 and 127-578 ppm Cl, respectively. Compared with other analytical techniques used for this purpose, the strengths of WDXRF include its ease of use, rapid measurements, the near absence of sample preparation steps, and versatility in terms of anion systems and chloride concentration range.
| S-EPMC8173560 | biostudies-literature
Project description:BackgroundA pilot study has being carried out at our laboratories, with international collaborators, to develop seven certified reference materials (CRMs), which have matrices of mainly soil and biological tissues. The CRMs will be certified for macro-, micro- and trace elements for environmental, toxicological, agronomic and nutritional purposes. Homogeneity of element concentrations is a critical step in the production process of CRMs. This work employs wavelength dispersive X-ray fluorescence spectrometry (WD-XRF) to test between-bottle homogeneity of the CRMs.ResultsThe relative standard deviation (RSD), relative average deviation, Skewness and Kurtosis of element contents in seven bottles out of 80 bottles of each CRM were considered to assess homogeneity in terms of variability and distribution. More than 50% of the number of quantified elements recorded RSD between 2 and 5%. Hence, based on an in-house classification, the intended CRMs recorded excellent to good between-bottle homogeneity. Nevertheless, the contents of some elements (Ni, Rb, Zn and Br) experienced high RSD values (> 10%). The Skewness and Kurtosis values of most elements are around one indicating symmetric distribution and thus have an absence of tailing relative to the normal distribution.ConclusionsWD-XRF provides fit for purpose data for assessment of initial between-bottle homogeneity in terms of rapidity, ease of use, multi-element quantification and sample non-destruction.
| S-EPMC6662076 | biostudies-literature
Project description:The design and first results of a large-solid-angle X-ray emission spectrometer that is optimized for energies between 1.5 keV and 5.5 keV are presented. The spectrometer is based on an array of 11 cylindrically bent Johansson crystal analyzers arranged in a non-dispersive Rowland circle geometry. The smallest achievable energy bandwidth is smaller than the core hole lifetime broadening of the absorption edges in this energy range. Energy scanning is achieved using an innovative design, maintaining the Rowland circle conditions for all crystals with only four motor motions. The entire spectrometer is encased in a high-vacuum chamber that allocates a liquid helium cryostat and provides sufficient space for in situ cells and operando catalysis reactors.
| S-EPMC7285681 | biostudies-literature
Project description:An open hardware design and implementation for a transient absorption spectrometer are presented that has microsecond time resolution and measures full difference spectra in the visible spectral region from 380 to 750 nm. The instrument has been designed to allow transient absorption spectroscopy measurements of either low or high quantum yield processes by combining intense sub-microsecond excitation flashes using a xenon lamp together with stroboscopic non-actinic white light probing using LED sources driven under high pulsed current from a capacitor bank. The instrument is sensitive to resolve 0.15 mOD flash-induced differences within 1000 measurements at 20 Hz repetition rate using an inexpensive CCD sensor with 200 μm pixel dimension, 40 K electrons full well capacity and a dynamic range of 1800. The excitation flash has 230 ns pulse duration and the 2 mJ flash energy allows spectral filtering while retaining high power density with focussing to generate mOD signals in the 10-4-10-1 ΔOD range. We present the full electronics design and construction of the flash and probe sources, the optics as well as the timing electronics and CCD spectrometer operation and modification for internal signal referencing. The performance characterisation and example measurements are demonstrated using microsecond TAS of Congo red dye, as an example of a low quantum yield photoreaction at 2% with up to 78% of molecules excited. The instrument is fully open hardware and combines inexpensive selection of commercial components, optics and electronics and allows linear response measurements of photoinduced reactions for the purpose of accurate global analysis of chemical dynamics.
| S-EPMC8799588 | biostudies-literature
Project description:Accurate analysis using a simple and rapid procedure is always the most important pursuit of analytical chemists. In this study, a new sample preparation procedure, namely the shaker cup (SH) method, was designed and compared with two sample preparation procedures, commonly used in the laboratory, from three aspects: homogeneity of the sample-flux mixture, potential for sample contamination, and sample preparation time. For the three methods, a set of 54 certified reference materials (CRMs) was used to establish the calibration curves, while another set of 19 CRMs was measured to validate the results. In the calibration procedures, the matrix effects were corrected using the theoretical alpha coefficient method combined with the experimental coefficient method. The data of the major oxides (SiO2, TiO2, Al2O3, TFe2O3, MnO, MgO, CaO, Na2O, K2O, and P2O5) and minor elements (Cr, Cu, Ba, Ni, Sr, V, Zr, and Zn) obtained by wavelength dispersive X-ray fluorescence spectroscopy (WD-XRF) were compared using two derivative equations based on the findings by Laurence Whitty-Léveillé. The results revealed that the WD-XRF measured values using the SH method best agreed with the values recommended in the literature.
| S-EPMC7570679 | biostudies-literature
Project description:Continued improvement of the energy resolution of resonant inelastic x-ray scattering (RIXS) spectrometers is crucial for fulfilling the potential of this technique in the study of electron dynamics in materials of fundamental and technological importance. In particular, RIXS is the only alternative tool to inelastic neutron scattering capable of providing fully momentum resolved information on dynamic spin structures of magnetic materials, but is limited to systems whose magnetic excitation energy scales are comparable to the energy resolution. The state-of-the-art spherical diced crystal analyzer optics provides energy resolution as good as 25 meV but has already reached its theoretical limit. Here, we demonstrate a novel sub-10 meV RIXS spectrometer based on flat-crystal optics at the Ir-L3 absorption edge (11.215 keV) that achieves an analyzer energy resolution of 3.9 meV, very close to the theoretical value of 3.7 meV. In addition, the new spectrometer allows efficient polarization analysis without loss of energy resolution. The performance of the instrument is demonstrated using longitudinal acoustical and optical phonons in diamond, and magnon in Sr3Ir2O7. The novel sub-10 meV RIXS spectrometer thus provides a window into magnetic materials with small energy scales.
| S-EPMC5792644 | biostudies-literature
Project description:Circular dichroism spectroscopy is one of the most important tools in nanoscopic chiroptics. However, there is lack of simple, fast and reliable method for measuring the circular dichroism responses of single nanostructures. To tackle this issue, we report a polarization-dispersive imaging spectrometer which is capable of measuring the scattering circular dichroism response of a single chiral nanostructure with a single shot. Using this technique, we studied the scattering circular dichroism spectra of a model system, the vertically coupled plasmonic nanorod pair. Both experimental and theoretical results indicate that the polarization-dispersive spectrometer measures the imaginary part of nonlocal susceptibility of the structure. We further applied the technique to 3-dimensional Au nanorod structures assembled on DNA origami templates together with correlated scanning electron microscopic measurements. Rich chiroptical phenomena were unveiled at the single nanostructure level.
| S-EPMC8933428 | biostudies-literature
Project description:A lightweight and portable spectrometer is desirable for miniaturization and integration. The unprecedented capability of optical metasurfaces has shown much promise to perform such a task. We propose and experimentally demonstrate a compact high-resolution spectrometer with a multi-foci metalens. The novel metalens is designed based on wavelength and phase multiplexing, which can accurately map the wavelength information into its focal points located on the same plane. The measured wavelengths in the light spectra agree with simulation results upon the illumination of various incident light spectra. The uniqueness of this technique lies in the novel metalens that can simultaneously realize wavelength splitting and light focusing. The compactness and ultrathin nature of the metalens spectrometer render this technology have potential applications in on-chip integrated photonics where spectral analysis and information processing can be performed in a compact platform.
| S-EPMC10160045 | biostudies-literature
Project description:We report recent advances in absolute x-ray wavelength metrology in the context of producing modern standard reference data. Primary x-ray wavelength standards are produced today using diffraction spectrometers using crystal optics arranged to be operated in dispersive and non-dispersive geometries, giving natural-line-width limited profiles with high resolution and accuracy. With current developments, measurement results can be made traceable to the Système internationale definition of the meter by using diffraction crystals that have absolute lattice-spacing provenance through x-ray-optical interferometry. Recent advances in goniometry, innovation of electronic x-ray area detectors, and new in situ alignment and measurement methods now permit robust measurement and quantification of previously-elusive systematic uncertainties. This capability supports infrastructures like the NIST Standard Reference Data programs and the International Initiative on X-ray Fundamental Parameters and their contributions to science and industry. Such data projects are further served by employing complementary wavelength-and energy-dispersive spectroscopic techniques. This combination can provide, among other things, new tabulations of less-intense x-ray lines that need to be identified in x-ray fluorescence investigation of uncharacterized analytes. After delineating the traceability chain for primary x-ray wavelength standards, and NIST efforts to produce standard reference data and materials in particular, this paper posits the new opportunities for x-ray reference data tabulation that modern methods now afford.
| S-EPMC7266105 | biostudies-literature