Frequency sweep rate dependence on the dielectrophoretic response of polystyrene beads and red blood cells.
Ontology highlight
ABSTRACT:
SUBMITTER: Adams TN
PROVIDER: S-EPMC3874050 | biostudies-other | 2013
REPOSITORIES: biostudies-other
Similar Datasets
Project description:The high frequency dielectrophoresis (>20 MHz) response of microalgae cells with different lipid content was monitored over time. Chlamydomonas reinhardtii was cultured in regular medium and under nitrogen-depleted conditions in order to produce populations of cells with low and high lipid content, respectively. The electrical conductivity of the culture media was also monitored over the same time. The upper crossover frequency decreased for high-lipid cells over time. The single-shell model predicts that the upper crossover frequency is dictated primarily by the dielectric properties of the cytoplasm. The high frequency DEP response of the high-lipid cells' cytoplasm was changed by lipid accumulation. DEP response of the low-lipid cells also varied with the conductivity of the culture media due to nutrient consumption. Relative lipid content was estimated with BODIPY 505/515 dye by calculating the area-weighted intensity average of fluorescent images. Finally, microalgae cells were successfully separated based on lipid content at 41 MHz and DEP media conductivity 106 ± 1 ?S/cm.
| S-EPMC4526272 | biostudies-literature
Project description:The study of the properties of DNA under high electric fields is of both fundamental and practical interest. We have exploited the high electric fields produced locally in the tip of a nanopipette to probe the motion of double- and single-stranded 40-mer DNA, a 1-kb single-stranded DNA, and a single-nucleotide triphosphate (dCTP) just inside and outside the pipette tip at different frequencies and amplitudes of applied voltages. We used dual laser excitation and dual color detection to simultaneously follow two fluorophore-labeled DNA sequences with millisecond time resolution, significantly faster than studies to date. A strong trapping effect was observed during the negative half cycle for all DNA samples and also the dCTP. This effect was maximum below 1 Hz and decreased with higher frequency. We assign this trapping to strong dielectrophoresis due to the high electric field and electric field gradient in the pipette tip. Dielectrophoresis in electrodeless tapered nanostructures has potential applications for controlled mixing and manipulation of short lengths of DNA and other biomolecules, opening new possibilities in miniaturized biological analysis.
| S-EPMC1303895 | biostudies-literature
Project description:We examine the suitability of metal-containing polystyrene beads for the calibration of a mass cytometer instrument, a single particle analyser based on an inductively coupled plasma ion source and a time of flight mass spectrometer. These metal-containing beads are also verified for their use as internal standards for this instrument. These beads were synthesized by multiple-stage dispersion polymerization with acrylic acid as a comonomer. Acrylic acid acts as a ligand to anchor the metal ions within the interior of the beads. Mass cytometry enabled the bead-by-bead measurement of the metal-content and determination of the metal-content distribution. Beads synthesized by dispersion polymerization that involved three stages were shown to have narrower bead-to-bead variation in their lanthanide content than beads synthesized by 2-stage dispersion polymerization. The beads exhibited insignificant release of their lanthanide content to aqueous solutions of different pHs over a period of six months. When mixed with KG1a or U937 cell lines, metal-containing polymer beads were shown not to affect the mass cytometry response to the metal content of element-tagged antibodies specifically attached to these cells.
| S-EPMC2852877 | biostudies-literature
Project description:We explore the use of dielectrophoresis to discern the electrical properties of single cells by observing them at multiple frequencies. We first simulate experimental conditions to show that as we increase the number of measured frequencies, we are able to better discriminate among different cells. Furthermore, we use the simulation to find the optimal number and value of frequencies to use to best discriminate among different cells in general. We then fabricate a microfluidic device, calibrate it with polystyrene beads, and characterize it with BA/F3 cells. With this device, we test three different activation levels of HL60 cells treated with cytochalasin D using the optimal frequency sequence obtained in simulation to determine the differences in discrimination abilities depending on the number of frequencies used. We quantify the discrimination abilities of the optimal one, two, and three frequencies by minimizing 0-1 loss.
| S-EPMC6220158 | biostudies-literature
Project description:The study of electrical activity in single cells and local circuits of excitable cells, such as neurons, requires an easy-to-use, high-throughput methodology that allows for the measurement of membrane potential. Investigating the electrical properties in specific subcompartments of neurons, or in a specific type of neurons, introduces additional complexity. An optical voltage-imaging technique that allows high spatial and temporal resolution could be an ideal solution. However, most valid voltage-imaging techniques are nonspecific. Those that are more site-directed require a lot of preliminary work and specific adaptations, among other drawbacks. Here, we explore a new method for membrane voltage imaging, based on Förster resonance energy transfer between fluorescent polystyrene (FPS) beads and dipicrylamine. Not only has it been shown that fluorescence intensity correlates with membrane potential, but more importantly, the membrane potential from individual particles can be detected. Among other advantages, FPS beads can be synthesized with surface functional groups and can be targeted to specific proteins by conjugation of recognition molecules. Therefore, in the presence of dipicrylamine, FPS beads represent single-particle detectors of membrane potential that can be localized to specific membrane compartments. This new and easily accessible platform for targeted optical voltage imaging can further elucidate the mechanisms of neuronal electrical activity.
| S-EPMC8651512 | biostudies-literature
Project description:Inverted colloidal crystal (ICC) hydrogel scaffolds have emerged as a new class of three-dimensional cell culture matrix that represents a unique opportunity to reproduce lymphoid tissue microenvironments. ICC geometry promotes the formation of stromal cell networks and their interaction with hematopoietic cells, a core cellular process in lymphoid tissues. When subdermally implanted, ICC hydrogel scaffolds direct unique foreign body responses to form a vascularized stromal tissue with prolonged attraction of hematopoietic cells, which together resemble lymphoid tissue microenvironments. While conceptually simple, fabrication of ICC hydrogel scaffold requires multiple steps and laborious handling of delicate materials. Here, we introduce a facile route for ICC hydrogel scaffold fabrication using expanded polystyrene (EPS) beads. EPS beads shrink and fuse in a tunable manner under pressurized thermal conditions, which serves as colloidal crystal templates for ICC scaffold fabrication. Inclusion of collagen in the precursor solution greatly simplified preparation of bioactive hydrogel scaffolds. The resultant EPS-templated bioactive ICC hydrogel scaffolds demonstrate characteristic features required for lymphoid tissue modeling in both in vitro and in vivo settings. We envision that the presented method will facilitate widespread implementation of ICC hydrogel scaffolds for lymphoid tissue engineering and other emerging applications. Impact statement Inverted colloidal crystal (ICC) hydrogel scaffolds have emerged as a new class of three-dimensional cell culture matrix that represents a unique opportunity for lymphoid tissue modeling and other emerging novel bioengineering applications. While conceptually simple, fabrication of the ICC hydrogel scaffold requires multiple steps and laborious handling of delicate materials with highly toxic chemicals. The presented method for ICC hydrogel scaffold fabrication using expanded polystyrene (EPS) beads is simple, cost-effective, and involves less toxic chemicals than conventional methods, while retaining comparable biological significance. We envision that EPS bead-based hydrogel scaffold fabrication will greatly facilitate the widespread implementation of ICC hydrogel scaffolds and their practical applications.
| S-EPMC7099427 | biostudies-literature
Project description:A method that can rapidly quantify variations in the morphology of single red blood cells (RBCs) using light and sound is presented. When irradiated with a laser pulse, an RBC absorbs the optical energy and emits an ultrasonic pressure wave called a photoacoustic wave. The power spectrum of the resulting photoacoustic wave contains distinctive features that can be used to identify the RBC size and morphology. When particles 5-10 μm in diameter (such as RBCs) are probed with high-frequency photoacoustics, unique periodically varying minima and maxima occur throughout the photoacoustic signal power spectrum at frequencies >100 MHz. The location and distance between spectral minima scale with the size and morphology of the RBC; these shifts can be used to quantify small changes in the morphology of RBCs. Morphological deviations from the normal biconcave RBC shape are commonly associated with disease or infection. Using a single wide-bandwidth transducer sensitive to frequencies between 100 and 500 MHz, we were able to differentiate healthy RBCs from irregularly shaped RBCs (such as echinocytes, spherocytes, and swollen RBCs) with high confidence using a sample size of just 21 RBCs. As each measurement takes only seconds, these methods could eventually be translated to an automated device for rapid characterization of RBC morphology and deployed in a clinical setting to help diagnose RBC pathology.
| S-EPMC3699781 | biostudies-literature
Project description:Accurate comparison of flow cytometric data requires an understanding of how the cytometric fingerprint of a sample may vary from instrument to instrument. Key sources of variability include the number, wavelengths, and power of excitation lasers; the number and types of emission detectors; sample-handling systems and options; and whether fixed or dynamic detector voltages are used. To explore this variability, suspensions of three sizes (0.2, 0.5, and 0.8 μm-diameter) of solid, fluorescent, polystyrene beads were prepared. The suspensions were then run on four flow cytometers, keeping instrument settings as consistent as possible. The results are displayed graphically in Figure 3 of the article "Flow cytometry applications in water treatment, distribution, and reuse: A review" (DOI: 10.1016/j.watres.2018.12.016) [1]. This dataset contains the complete FCS files generated from the experimental comparison. In the development and application of flow cytometry to water quality assessment, we recommend data sharing in this manner to enable comprehensive reporting, meaningful comparison of results obtained using different cytometer models, enhanced exploration of data along multiple parameters, and use of acquired data for computational advancements in the field.
| S-EPMC6451693 | biostudies-literature
Project description:Red cells suspended in solutions much more viscous than blood plasma assume an almost steady-state orientation when sheared above a threshold value of shear rate. This orientation is a consequence of the motion of the membrane around the red cell called tank-treading. Observed along the undisturbed vorticity of the shear flow, tank-treading red cells appear as slender bodies. Their orientation can be quantified as an angle of inclination (?) of the major axis with respect to the undisturbed flow direction. We measured ? using solution viscosities (?0) and shear rates (??) covering one and three orders of magnitude, respectively. At the lower values of ?0, ? was almost independent of ??. At the higher values of ?0, ? displayed a maximum at intermediate shear rates. The respective maximal values of ? increased by ?10° from 10.7 to 104 mPas. After accounting for the absent membrane viscosity in models by using an increased cytoplasmic viscosity, their predictions of ? agree qualitatively with our data. Comparison of the observed variation of ? at constant ?? with model results suggests a change in the reference configuration of the shear stiffness of the membrane.
| S-EPMC4375532 | biostudies-literature
Project description:Metabolic rate is a key ecological variable that quantifies the energy expenditure needed to fuel almost all biological processes in an organism. Metabolic rates are typically measured at the whole-organism level (woMR) with protocols that can elicit stress responses due to handling and confinement, potentially biasing resulting data. Improved, non-stressful methodology would be especially valuable for measures of field metabolic rate, which quantifies the energy expenditure of free-living individuals. Recently, techniques to measure cellular metabolic rate (cMR) in mitochondria of blood cells have become available, suggesting that blood-based cMR can be a proxy of organismal aerobic performance. Aerobic metabolism actually takes place in the mitochondria. Quantifying cMR from blood samples offers several advantages such as direct estimates of metabolism and minimized disturbance of individuals. To our knowledge, the hypothesis that blood-based cMR correlates with woMR has not yet been directly tested. We measured cMR in red blood cells of captive great tits (Parus major), first during their morning activity period and second after subjecting them to a 2.5 h day-time respirometry protocol to quantify woMR. We predicted cMR to decrease as individuals transitioned from an active to a resting state. In the two blood samples we also assessed circulating corticosterone concentrations to determine the perceived disturbance of individuals. From respirometry traces we extracted initial and final woMR measures to test for a predicted positive correlation with cMR measures, while accounting for corticosterone concentrations. Indeed, cMR declined from the first to the second measurement. Furthermore, woMR and cMR were positively related in individuals that had relatively low corticosterone concentrations and displayed little locomotor activity throughout respirometry. By contrast, woMR and cMR covaried negatively in birds that increased corticosterone concentrations and activity levels substantially. Our results show that red blood cell cMR represents a proxy for woMR when birds do not display signs of stress, i.e., either before increases in hormonal or behavioral parameters have occurred or after they have abated. This method represents a valuable tool for obtaining metabolic data repeatedly and in free-living individuals. Our findings also highlight the importance of accounting for individual stress responses when measuring metabolic rate at any level.
| S-EPMC8322697 | biostudies-literature