Electrical conduction mechanism in La3Ta0.5Ga5.3Al0.2O14 single crystals.
Ontology highlight
ABSTRACT:
SUBMITTER: Yaokawa R
PROVIDER: S-EPMC3874063 | biostudies-other | 2013 Dec
REPOSITORIES: biostudies-other
Similar Datasets
Project description:In this work, the thermal and electrical transport in an individual silver nanowire is characterized down to 35 K for in-depth understanding of the strong structural defect induced electron scattering. The results indicate that, at room temperature, the electrical resistivity increases by around 4 folds from that of bulk silver. The Debye temperature (151 K) of the silver nanowire is found 36% lower than that (235 K) of bulk silver, confirming strong phonon softening. At room temperature, the thermal conductivity is reduced by 55% from that of bulk silver. This reduction becomes larger as the temperature goes down. To explain the opposite trends of thermal conductivity (?) ~ temperature (T) of silver nanowire and bulk silver, a unified thermal resistivity (? ~ T/k ) is used to elucidate the electron scattering mechanism. A large residual ? is observed for silver nanowire while that of the bulk silver is almost zero. The same ? ~ T trend proposes that the silver nanowire and bulk silver share the similar phonon-electron scattering mechanism for thermal transport. Due to phonon-assisted electron energy transfer across grain boundaries, the Lorenz number of the silver nanowire is found much larger than that of bulk silver and decreases with decreasing temperature.
| S-EPMC4451791 | biostudies-other
Project description:Single-crystal Bi2Te3 nanowires (NWs) and nanoribbons (NRs) were synthesized by a vapor-liquid-solid (VLS) method from Bi2Te3 powder. To investigate the thermal properties of the Bi2Te3 nanostructure, a nondestructive technique based on temperature dependent Raman mapping was carried out. The Raman peaks were red shifted with increasing temperature. In addition, the fraction of the laser power absorbed inside the Bi2Te3 nanostructures was estimated by optical simulation and used to calculate the thermal conductivity value (κ). The thermal conductivity value obtained for the Bi2Te3 NW and NR was 1.47 Wm(-1)K(-1) and 1.81 Wm(-1)K(-1) at 300 K, respectively. The electrical conductivity of the Bi2Te3 nanostructure was also measured. In particular, an excellent electrical conductivity value of 1.22 * 10(3 )Ω(-1) cm(-1) was obtained for the Bi2Te3 NW at 300 K. This result can be attributed to topological insulator surface states. As a result of our study, the figure of merit (ZT) for the Bi2Te3 NW and NR can be significantly improved.
| S-EPMC4707524 | biostudies-literature
Project description:Organ-specific functions of tissue-resident macrophages in the steady-state heart are unknown. Here, we show that cardiac macrophages facilitate electrical conduction through the distal atrioventricular node, where conducting cells densely intersperse with elongated macrophages expressing connexin 43. When coupled to spontaneously beating cardiomyocytes via connexin-43-containing gap junctions, cardiac macrophages have a negative resting membrane potential and depolarize in synchrony with cardiomyocytes. Conversely, macrophages render the resting membrane potential of cardiomyocytes more positive and, according to computational modeling, accelerate their repolarization. Photostimulation of channelrhodopsin-2-expressing macrophages improves atrioventricular conduction, whereas conditional deletion of connexin 43 in macrophages and congenital lack of macrophages delay atrioventricular conduction. In the Cd11bDTR mouse, macrophage ablation induces progressive atrioventricular block. These observations implicate macrophages in normal and aberrant cardiac conduction.
| S-EPMC5474950 | biostudies-literature
Project description:Li-doped high-entropy oxides (Li-HEO) are promising electrode materials for Li-ion batteries. However, their electrical conduction in a wide range of temperatures and/or at high pressure is unknown, hindering their applications under extreme conditions. Especially, a clear understanding of the conduction mechanism is needed. In this work, we determined the carrier type of several Li-doped (MgCoNiCuZn)O semiconductor compounds and measured their electrical conduction at temperatures 79-773 K and/or at pressures up to 50 GPa. Three optical band gaps were uncovered from the UV-vis-NIR absorption measurements, unveiling the existence of defect energy levels near the valence band of p-type semiconductors. The Arrhenius-like plot of the electrical conductivity data revealed the electronic conduction in three temperature regions, i.e., the ionization region from 79 to 170 K, the extrinsic region from ∼170 to 300 K, and the intrinsic region at ≥300 K. The closeness of the determined electronic band gap and the second optical band gap suggests that the conduction electrons in the intrinsic region originate from a thermal excitation from the defect energy levels to the conduction band, which determines the electronic conductivity. It was also found that at or above room temperature, ionic conduction coexists with electronic conduction with a comparable magnitude at ambient pressure and that the intrinsic conduction mechanism also operates at high pressures. These findings provide us a fundamental understanding of the band structure and conduction mechanism of Li-HEO, which would be indispensable to their applications in new technical areas.
| S-EPMC10900490 | biostudies-literature
Project description:Crystalline, electrically conductive, and intrinsically porous materials are rare. Layered two-dimensional (2D) metal-organic frameworks (MOFs) break this trend. They are porous crystals that exhibit high electrical conductivity and are novel platforms for studying fundamentals of electricity and magnetism in two dimensions. Despite demonstrated applications, electrical transport in these remains poorly understood because of a lack of single crystal studies. Here, studies of single crystals of two 2D MOFs, Ni3(HITP)2 and Cu3(HHTP)2, uncover critical insights into their structure and transport. Conductivity measurements down to 0.3 K suggest metallicity for mesoscopic single crystals of Ni3(HITP)2, which contrasts with apparent activated conductivity for polycrystalline films. Microscopy studies further reveal that these MOFs are not isostructural as previously reported. Notably, single rods exhibit conductivities up to 150 S/cm, which persist even after prolonged exposure to ambient conditions. These single crystal studies confirm that 2D MOFs hold promise as molecularly tunable platforms for fundamental science and applications where porosity and conductivity are critical.
| S-EPMC6936098 | biostudies-literature
Project description:Single crystals of Pb1-3x▯xNd2x(MoO4)1-3x(WO4)3x (PNMWO) with scheelite-type structure, where ▯ denotes cationic vacancies, have been successfully grown by the Czochralski method in air and under 1 MPa. This paper presents the results of structural, optical, magnetic and electrical, as well as the broadband dielectric spectroscopy measurements of PNMWO single crystals. Research has shown that replacing diamagnetic Pb2+ ions with paramagnetic Nd3+ ones, with a content not exceeding 0.01 and possessing a screened 4f-shell, revealed a significant effect of orbital diamagnetism and Van Vleck's paramagnetism, n-type electrical conductivity with an activation energy of 0.7 eV in the intrinsic area, a strong increase of the power factor above room temperature for a crystal with x = 0.005, constant dielectric value (~30) and loss tangent (~0.01) up to room temperature. The Fermi energy (~0.04 eV) and the Fermi temperature (~500 K) determined from the diffusion component of thermopower showed shallow donor levels.
| S-EPMC9866789 | biostudies-literature
Project description:Semiconductor materials based on metal high crosslinked-vinyl polymer composites were prepared through loading of Pd(OAc)2 on both Poly(ethylene-1,2-diyl dimethacrylate) (poly(EDMA)) and poly(ethylene-1,2-diyl dimethacrylate-co-methyl methacrylate) (Poly(EDMA-co-MMA)). The thermochemical properties for both poly(EDMA) and poly(EDMA-co-MMA) were investigated by thermal gravimetric analysis TGA technique. The dielectric permittivity, AC electrical conductivity and conduction mechanism for all the prepared polymers and their Pd(OAc)2 composites were studied. The results showed that the loading of polymers with Pd(OAc)2 led to an increase in the magnitudes of both the dielectric permittivity and AC electrical conductivity (σac). The value of σac increased from 1.38 × 10-5 to 5.84 × 10-5 S m-1 and from 6.40 × 10-6 to 2.48 × 10-5 S m-1 for poly(EDMA) and poly(EDMA-co-MMA), respectively, at 1 MHz and 340 K after loading with Pd(OAc)2. Additionally, all the prepared polymers and composites were considered as semiconductors at all the test frequencies and in the temperature range of 300-340 K. Furthermore, it seems that a conduction mechanism for all the samples could be Quantum Mechanical Tunneling (QMT).
| S-EPMC8434503 | biostudies-literature
Project description:Heart failure (HF) is associated with an increased propensity for atrial fibrillation (AF), causing higher mortality than AF or HF alone. It is hypothesized that HF-induced remodelling of atrial cellular and tissue properties promotes the genesis of atrial action potential (AP) alternans and conduction alternans that perpetuate AF. However, the mechanism underlying the increased susceptibility to atrial alternans in HF remains incompletely elucidated. In this study, we investigated the effects of how HF-induced atrial cellular electrophysiological (with prolonged AP duration) and tissue structural (reduced cell-to-cell coupling caused by atrial fibrosis) remodelling can have an effect on the generation of atrial AP alternans and their conduction at the cellular and one-dimensional (1D) tissue levels. Simulation results showed that HF-induced atrial electrical remodelling prolonged AP duration, which was accompanied by an increased sarcoplasmic reticulum (SR) Ca2+ content and Ca2+ transient amplitude. Further analysis demonstrated that HF-induced atrial electrical remodelling increased susceptibility to atrial alternans mainly due to the increased sarcoplasmic reticulum Ca2+-ATPase (SERCA) Ca2+ reuptake, modulated by increased phospholamban (PLB) phosphorylation, and the decreased transient outward K+ current (Ito). The underlying mechanism has been suggested that the increased SR Ca2+ content and prolonged AP did not fully recover to their previous levels at the end of diastole, resulting in a smaller SR Ca2+ release and AP in the next beat. These produced Ca2+ transient alternans and AP alternans, and further caused AP alternans and Ca2+ transient alternans through Ca2+?AP coupling and AP?Ca2+ coupling, respectively. Simulation of a 1D tissue model showed that the combined action of HF-induced ion channel remodelling and a decrease in cell-to-cell coupling due to fibrosis increased the heart tissue's susceptibility to the formation of spatially discordant alternans, resulting in an increased functional AP propagation dispersion, which is pro-arrhythmic. These findings provide insights into how HF promotes atrial arrhythmia in association with atrial alternans.
| S-EPMC7402519 | biostudies-literature
Project description:BackgroundMethods for the electrical inhibition of cardiac excitation have long been sought to control excitability and conduction, but to date remain largely impractical. High-amplitude alternating current (AC) stimulation has been known to extend cardiac action potentials (APs), and has been recently exploited to terminate reentrant arrhythmias by producing reversible conduction blocks. Yet, low-amplitude currents at similar frequencies have been shown to entrain cardiac tissues by generation of repetitive APs, leading in some cases to ventricular fibrillation and hemodynamic collapse in vivo. Therefore, an inhibition method that does not lead to entrainment - irrespective of the stimulation amplitude (bound to fluctuate in an in vivo setting) - is highly desirable.Methodology/principal findingsWe investigated the effects of broader amplitude and frequency ranges on the inhibitory effects of extracellular AC stimulation on HL-1 cardiomyocytes cultured on microelectrode arrays, using both sinusoidal and square waveforms. Our results indicate that, at sufficiently high frequencies, cardiac tissue exhibits a binary response to stimulus amplitude with either prolonged APs or no effect, thereby effectively avoiding the risks of entrainment by repetitive firing observed at lower frequencies. We further demonstrate the ability to precisely define reversible local conduction blocks in beating cultures without influencing the propagation activity in non-blocked areas. The conduction blocks were spatiotemporally controlled by electrode geometry and stimuli duration, respectively, and sustainable for long durations (300 s).Conclusion/significanceInhibition of cardiac excitation induced by high-frequency AC stimulation exhibits a binary response to amplitude above a threshold frequency, enabling the generation of reversible conduction blocks without the risks of entrainment. This inhibition method could yield novel approaches for arrhythmia modeling in vitro, as well as safer and more efficacious tools for in vivo cardiac mapping and radio-frequency ablation guidance applications.
| S-EPMC3340354 | biostudies-literature
Project description:ClC chloride channels are voltage-gated transmembrane proteins that have been associated with a wide range of regulatory roles in vertebrates. To accomplish their function, they allow small inorganic anions to efficiently pass through, while blocking the passage of all other particles. Understanding the conduction mechanism of ClC has been the subject of many experimental investigations, but until now, the detailed dynamic mechanism was not known despite the availability of crystallographic structures. We investigate Cl(-) conduction by means of an all-atom molecular dynamics simulation of the ClC channel in a membrane environment. Based on our simulation results, we propose a king-of-the-hill mechanism for permeation, in which a lone ion bound to the center of the ClC pore is pushed out by a second ion that enters the pore and takes its place. Although the energy required to extract the single central ion from the pore is enormous, by resorting to this two-ion process, the largest free energy barrier for conduction is reduced to 4 kcal/mol. At the narrowest part of the pore, residues Tyr-445 and Ser-107 stabilize the central ion. There, the bound ion blocks the pore, disrupting the formation of a continuous water file that could leak protons, possibly preventing the passage of uncharged solutes.
| S-EPMC1303931 | biostudies-literature