Minimizing thermal stress for data center servers through thermal-aware relocation.
Ontology highlight
ABSTRACT:
SUBMITTER: Chaudhry MT
PROVIDER: S-EPMC3988751 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:We report on experimental investigation of thermal contact resistance, RC, of the noncuring graphene thermal interface materials with the surfaces characterized by different degree of roughness, Sq. It is found that the thermal contact resistance depends on the graphene loading, ξ, non-monotonically, achieving its minimum at the loading fraction of ξ ~15 wt %. Decreasing the surface roughness by Sq~1 μm results in approximately the factor of ×2 decrease in the thermal contact resistance for this graphene loading. The obtained dependences of the thermal conductivity, KTIM, thermal contact resistance, RC, and the total thermal resistance of the thermal interface material layer on ξ and Sq can be utilized for optimization of the loading fraction of graphene for specific materials and roughness of the connecting surfaces. Our results are important for the thermal management of high-power-density electronics implemented with diamond and other wide-band-gap semiconductors.
| S-EPMC8306163 | biostudies-literature
Project description:BackgroundSpatial transcriptomics (ST) combines stained tissue images with spatially resolved high-throughput RNA sequencing. The spatial transcriptomic analysis includes challenging tasks like clustering, where a partition among data points (spots) is defined by means of a similarity measure. Improving clustering results is a key factor as clustering affects subsequent downstream analysis. State-of-the-art approaches group data by taking into account transcriptional similarity and some by exploiting spatial information as well. However, it is not yet clear how much the spatial information combined with transcriptomics improves the clustering result.ResultsWe propose a new clustering method, Stardust, that easily exploits the combination of space and transcriptomic information in the clustering procedure through a manual or fully automatic tuning of algorithm parameters. Moreover, a parameter-free version of the method is also provided where the spatial contribution depends dynamically on the expression distances distribution in the space. We evaluated the proposed methods results by analyzing ST data sets available on the 10x Genomics website and comparing clustering performances with state-of-the-art approaches by measuring the spots' stability in the clusters and their biological coherence. Stability is defined by the tendency of each point to remain clustered with the same neighbors when perturbations are applied.ConclusionsStardust is an easy-to-use methodology allowing to define how much spatial information should influence clustering on different tissues and achieving more stable results than state-of-the-art approaches.
| S-EPMC9364686 | biostudies-literature
Project description:Cytometry by Time-Of-Flight (CyTOF) uses antibodies conjugated to isotopically pure metals to identify and quantify a large number of cellular features with single-cell resolution. A barcoding approach allows for 20 unique samples to be pooled and processed together in one tube, reducing the intra-barcode technical variability. However, with only 20 samples per barcode, multiple barcode sets (batches) are required to address questions in robustly powered study designs. A batch adjustment procedure is required to reduce variability across batches and to facilitate direct comparison of runs performed across multiple barcodes run over weeks, months, or years. We describe a method using technical replicates that are included in each run to determine and apply an appropriate adjustment per batch without manual intervention. The use of technical replicate samples (i.e., anchors or reference samples) avoids assumptions of sample homogeneity among batches, and allows direct estimation of batch effects and appropriate adjustment parameters applicable to all samples within a batch. Quantification of cell subpopulations and mean signal intensity pre- and post-adjustment using both manual gating and unsupervised clustering demonstrate substantial mitigation of batch effects in the anchor samples used for this adjustment calculation, and in a second validation set of technical replicates.
| S-EPMC6803429 | biostudies-literature
Project description:Enzymatic degradation is a major concern in peptide analysis. Postmortem metabolism in biological samples entails considerable risk for measurements misrepresentative of true in vivo concentrations. It is therefore vital to find reliable, reproducible, and easy-to-use procedures to inhibit enzymatic activity in fresh tissues before subjecting them to qualitative and quantitative analyses. The aim of this study was to test a benchtop thermal stabilization method to optimize measurement of endogenous opioids in brain tissue. Endogenous opioid peptides are generated from precursor proteins through multiple enzymatic steps that include conversion of one bioactive peptide to another, often with a different function. Ex vivo metabolism may, therefore, lead to erroneous functional interpretations. The efficacy of heat stabilization was systematically evaluated in a number of postmortem handling procedures. Dynorphin B (DYNB), Leu-enkephalin-Arg(6) (LARG), and Met-enkephalin-Arg(6)-Phe(7) (MEAP) were measured by radioimmunoassay in rat hypothalamus, striatum (STR), and cingulate cortex (CCX). Also, simplified extraction protocols for stabilized tissue were tested. Stabilization affected all peptide levels to varying degrees compared to those prepared by standard dissection and tissue handling procedures. Stabilization increased DYNB in hypothalamus, but not STR or CCX, whereas LARG generally decreased. MEAP increased in hypothalamus after all stabilization procedures, whereas for STR and CCX, the effect was dependent on the time point for stabilization. The efficacy of stabilization allowed samples to be left for 2 hours in room temperature (20°C) without changes in peptide levels. This study shows that conductive heat transfer is an easy-to-use and efficient procedure for the preservation of the molecular composition in biological samples. Region- and peptide-specific critical steps were identified and stabilization enabled the optimization of tissue handling and opioid peptide analysis. The result is improved diagnostic and research value of the samples with great benefits for basic research and clinical work.
| S-EPMC4834486 | biostudies-literature
Project description:BackgroundA smartphone is a promising tool for daily cardiovascular measurement and mental stress monitoring. A smartphone camera-based photoplethysmography (PPG) and a low-cost thermal camera can be used to create cheap, convenient, and mobile monitoring systems. However, to ensure reliable monitoring results, a person must remain still for several minutes while a measurement is being taken. This is cumbersome and makes its use in real-life situations impractical.ObjectiveWe proposed a system that combines PPG and thermography with the aim of improving cardiovascular signal quality and detecting stress responses quickly.MethodsUsing a smartphone camera with a low-cost thermal camera added on, we built a novel system that continuously and reliably measures 2 different types of cardiovascular events: (1) blood volume pulse and (2) vasoconstriction/dilation-induced temperature changes of the nose tip. 17 participants, involved in stress-inducing mental workload tasks, measured their physiological responses to stressors over a short time period (20 seconds) immediately after each task. Participants reported their perceived stress levels on a 10-cm visual analog scale. For the instant stress inference task, we built novel low-level feature sets representing cardiovascular variability. We then used the automatic feature learning capability of artificial neural networks to improve the mapping between the extracted features and the self-reported ratings. We compared our proposed method with existing hand-engineered features-based machine learning methods.ResultsFirst, we found that the measured PPG signals presented high quality cardiac cyclic information (mean pSQI: 0.755; SD 0.068). We also found that the measured thermal changes of the nose tip presented high-quality breathing cyclic information and filtering helped extract vasoconstriction/dilation-induced patterns with fewer respiratory effects (mean pSQI: from 0.714 to 0.157). Second, we found low correlations between the self-reported stress scores and the existing metrics of the cardiovascular signals (ie, heart rate variability and thermal directionality) from short measurements, suggesting they were not very dependent upon one another. Third, we tested the performance of the instant perceived stress inference method. The proposed method achieved significantly higher accuracies than existing precrafted features-based methods. In addition, the 17-fold leave-one-subject-out cross-validation results showed that combining both modalities produced higher accuracy than using PPG or thermal imaging only (PPG+Thermal: 78.33%; PPG: 68.53%; Thermal: 58.82%). The multimodal results are comparable to the state-of-the-art stress recognition methods that require long-term measurements. Finally, we explored effects of different data labeling strategies on the sensitivity of our inference methods. Our results showed the need for separation of and normalization between individual data.ConclusionsThe results demonstrate the feasibility of using smartphone-based imaging for instant stress detection. Given that this approach does not need long-term measurements requiring attention and reduced mobility, we believe it is more suitable for mobile mental health care solutions in the wild.
| S-EPMC6477570 | biostudies-literature
Project description:Fuzzing has become an important method for finding vulnerabilities in software. For fuzzing programs expecting structural inputs, syntactic- and semantic-aware fuzzing approaches have been particularly proposed. However, they still cannot fuzz in-memory data stores sufficiently, since some code paths are only executed when the required data are available. In this article, we propose a data-aware fuzzing method, DAFuzz, which is designed by considering the data used during fuzzing. Specifically, to ensure different data-sensitive code paths are exercised, DAFuzz first loads different kinds of data into the stores before feeding fuzzing inputs. Then, when generating inputs, DAFuzz ensures the generated inputs are not only syntactically and semantically valid but also use the data correctly. We implement a prototype of DAFuzz based on Superion and use it to fuzz Redis and Memcached. Experiments show that DAFuzz covers 13~95% more edges than AFL, Superion, AFL++, and AFLNet, and discovers vulnerabilities over 2.7× faster. In total, we discovered four new vulnerabilities in Redis and Memcached. All the vulnerabilities were reported to developers and have been acknowledged and fixed.
| S-EPMC10557509 | biostudies-literature
Project description:Overcoming envelope metastability is crucial to trimer-based HIV-1 vaccine design. Here, we present a coherent vaccine strategy by minimizing metastability. For 10 strains across five clades, we demonstrate that the gp41 ectodomain (gp41ECTO) is the main source of envelope metastability by replacing wild-type gp41ECTO with BG505 gp41ECTO of the uncleaved prefusion-optimized (UFO) design. These gp41ECTO-swapped trimers can be produced in CHO cells with high yield and high purity. The crystal structure of a gp41ECTO-swapped trimer elucidates how a neutralization-resistant tier 3 virus evades antibody recognition of the V2 apex. UFO trimers of transmitted/founder viruses and UFO trimers containing a consensus-based ancestral gp41ECTO suggest an evolutionary root of metastability. The gp41ECTO-stabilized trimers can be readily displayed on 24- and 60-meric nanoparticles, with incorporation of additional T cell help illustrated for a hyperstable 60-mer, I3-01. In mice and rabbits, these gp140 nanoparticles induced tier 2 neutralizing antibody responses more effectively than soluble trimers.
| S-EPMC6248932 | biostudies-literature
Project description:Memristors based on two-dimensional (2D) materials are a rapidly growing research area due to their potential in energy-efficient in-memory processing and neuromorphic computing. However, the data retention of these emerging memristors remains sparsely investigated, despite its crucial importance to device performance and reliability. In this study, we employ kinetic Monte-Carlo simulations to investigate the data retention of a 2D planar memristor. The operation of the memristor depends on field-driven on defect migration, while thermal diffusion gradually evens the defect distribution, leading to the degradation of the high resistance state (HRS) and diminishing the ON/OFF ratio. Notably, we examine the resilience of devices based on single crystals of transition metal dichalcogenides (TMDs) in harsh environments. Specifically, our simulations show that MoS2-based devices have negligible degradation after 10 years of thermal annealing at 400 K. Furthermore, the variability in data retention lifetime across different temperatures is less than 22%, indicating a relatively consistent performance over a range of thermal conditions. We also demonstrate that device miniaturization does not compromise data retention lifetime. Moreover, employing materials with higher activation energy for defect migration can significantly enhance data retention at the cost of increased switching voltage. These findings shed light on the behavior of 2D memristors and pave the way for their optimization in practical applications.
| S-EPMC10398860 | biostudies-literature
Project description:Thermal history plays a role in the response of corals to subsequent heat stress. Prior heat stress can have a profound impact on later thermal tolerance, but the mechanism for this plasticity is not clear. The understanding of gene expression changes behind physiological acclimatization is critical in forecasts of coral health in impending climate change scenarios. Acropora millepora fragments were preconditioned to sublethal bleaching threshold stress for a period of 10 days; this prestress conferred bleaching resistance in subsequent thermal challenge, in which non-preconditioned coral bleached. Using microarrays, we analyze the transcriptomes of the coral host, comparing the bleaching-resistant preconditioned treatment to non-preconditioned and control treatments.
2012-11-29 | GSE41435 | GEO
Project description:Wireless Body Area Networks (WBANs) are in the spotlight of researchers and engineering industries due to many applications. Remote health monitoring for general as well as military purposes where tiny sensors are attached or implanted inside the skin of the body to sense the required attribute is particularly prominent. To seamlessly accomplish this procedure, there are various challenges, out of which temperature control to reduce thermal effects and optimum power consumption to reduce energy wastage are placed at the highest priority. Regular and consistent operation of a sensor node for a long-time result in a rising of the temperature of respective tissues, where it is attached or implanted. This temperature rise has harmful effects on human tissues, which may lead to the tissue damage. In this paper, a Temperate Aware and Energy Optimized (TAEO) routing protocol is proposed that not only deals with the thermal aspects and hot spot problem, but also extends the stability and lifetime of a network. Analytical simulations are conducted, and the results depict better performance in terms of the network lifetime, throughput, energy preservation, and temperature control with respect to state of the art WBAN protocols.
| S-EPMC6696412 | biostudies-literature