High density GaN/AlN quantum dots for deep UV LED with high quantum efficiency and temperature stability.
Ontology highlight
ABSTRACT:
SUBMITTER: Yang W
PROVIDER: S-EPMC4046137 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:III-nitride quantum dots (QDs) are a promising system actively studied for their ability to maintain single photon emission up to room temperature. Here, we report on the evolution of the emission properties of self-assembled GaN/AlN QDs for temperatures ranging from 5 to 300 K. We carefully track the photoluminescence of a single QD and measure an optimum single photon purity of g(2)(0) = 0.05 ± 0.02 at 5 K and 0.17 ± 0.08 at 300 K. We complement this study with temperature dependent time-resolved photoluminescence measurements (TRPL) performed on a QD ensemble to further investigate the exciton recombination dynamics of such polar zero-dimensional nanostructures. By comparing our results to past reports, we emphasize the complexity of recombination processes in this system. Instead of the more conventional mono-exponential decay typical of exciton recombination, TRPL transients display a bi-exponential feature with short- and long-lived components that persist in the low excitation regime. From the temperature insensitivity of the long-lived excitonic component, we first discard the interplay of dark-to-bright state refilling in the exciton recombination process. Besides, this temperature-invariance also highlights the absence of nonradiative exciton recombinations, a likely direct consequence of the strong carrier confinement observed in GaN/AlN QDs up to 300 K. Overall, our results support the viability of these dots as a potential single-photon source for quantum applications at room temperature.
| S-EPMC9046275 | biostudies-literature
Project description:This article describes GaN/AlN heterostructures for ultraviolet-C (UVC) emitters with multiple (up to 400 periods) two-dimensional (2D)-quantum disk/quantum well structures with the same GaN nominal thicknesses of 1.5 and 16 ML-thick AlN barrier layers, which were grown by plasma-assisted molecular-beam epitaxy in a wide range of gallium and activated nitrogen flux ratios (Ga/N2*) on c-sapphire substrates. An increase in the Ga/N2* ratio from 1.1 to 2.2 made it possible to change the 2D-topography of the structures due to a transition from the mixed spiral and 2D-nucleation growth to a purely spiral growth. As a result, the emission energy (wavelength) could be varied from 5.21 eV (238 nm) to 4.68 eV (265 nm) owing to the correspondingly increased carrier localization energy. Using electron-beam pumping with a maximum pulse current of 2 A at an electron energy of 12.5 keV, a maximum output optical power of 50 W was achieved for the 265 nm structure, while the structure emitting at 238 nm demonstrated a power of 10 W.
| S-EPMC10059987 | biostudies-literature
Project description:Cross-gap light emission is reported in n-type unipolar GaN/AlN double-barrier heterostructure diodes at room temperature. Three different designs were grown on semi-insulating bulk GaN substrates using molecular beam epitaxy (MBE). All samples displayed a single electroluminescent spectral peak at 360 nm with full-width at half-maximum (FWHM) values no greater than 16 nm and an external quantum efficiency (EQE) of ≈0.0074% at 18.8 mA. In contrast to traditional GaN light emitters, p-type doping and p-contacts are completely avoided, and instead, holes are created in the GaN on the emitter side of the tunneling structure by direct interband (that is, Zener) tunneling from the valence band to the conduction band on the collector side. The Zener tunneling is enhanced by the high electric fields (~5 × 106 V cm-1) created by the notably large polarization-induced sheet charge at the interfaces between the AlN and GaN.
| S-EPMC6060061 | biostudies-literature
Project description:Phosphors with high quantum efficiency and thermal stability are greatly desired for lighting industries. Based on the design strategy of solid solution, a series of deep-blue-emitting phosphors (Sr0.99-xBax)2P2O7:0.02Eu2+ (SBxPE x = 0-0.5) are developed. Upon excitation at 350 nm, the optimized SB0.3PE phosphor shows a relatively narrow full width at half maximum (FWHM = 32.7 nm) peaking at 420 nm, which matches well with the plant absorption in blue region. Moreover, this phosphor exhibits obvious enhancement of internal quantum efficiency (IQE) (from 74% to 100%) and thermal stability (from 88% to 108% of peak intensity and from 99% to 124% of integrated area intensity at 150°C) compared with the pristine one. The white LED devices using SB0.3PE as deep-blue-emitting component show good electronic properties, indicating that SB0.3PE is promising to be used in plant growth lighting, white LEDs, and other photoelectric applications.
| S-EPMC7049664 | biostudies-literature
Project description:GaN-based UV light-emitting devices suffer from low efficiency. To mitigate this issue, we hybridized GaN nanowires (NWs) grown on Si substrates by plasma-assisted molecular beam epitaxy with solution-processed p-type MnO quantum dots (QDs) characterized by a wider band gap (∼5 eV) than that of GaN. Further investigations reveal that the photoluminescence intensity of the GaN NWs increases up to ∼3.9-fold (∼290%) after functionalizing them with p-MnO QDs, while the internal quantum efficiency is improved by ∼1.7-fold. Electron energy loss spectroscopy (EELS) incorporated into transmission electron microscopy reveals an increase in the density of states in QD-decorated NWs compared to the bare ones. The advanced optical and EELS analyses indicate that the energy transfer from the wider band gap p-MnO QDs to n-GaN NW can lead to substantial emission enhancement and greater radiative recombination contribution because of the good band alignment between MnO QDs and GaN NWs. This work provides valuable insights into an environmentally friendly strategy for improving UV device performance.
| S-EPMC7497627 | biostudies-literature
Project description:GaN and the heterostructures are attractive in condensed matter science and applications for electronic devices. We measure the electron transport in GaN/AlGaN field-effect transistors (FETs) at cryogenic temperature. We observe formation of quantum dots in the conduction channel near the depletion of the 2-dimensional electron gas (2DEG). Multiple quantum dots are formed in the disordered potential induced by impurities in the FET conduction channel. We also measure the gate insulator dependence of the transport properties. These results can be utilized for the development of quantum dot devices utilizing GaN/AlGaN heterostructures and evaluation of the impurities in GaN/AlGaN FET channels.
| S-EPMC7508848 | biostudies-literature
Project description:We report deep ultraviolet (UVC) emitting core-shell-type AlGaN/AlN multiple quantum wells (MQWs) on the AlN nanorods which are prepared by catalyst/lithography free process. The MQWs are grown on AlN nanorods on a sapphire substrate by polarity-selective epitaxy and etching (PSEE) using high-temperature metal organic chemical vapor deposition. The AlN nanorods prepared through PSEE have a low dislocation density because edge dislocations are bent toward neighboring N-polar AlN domains. The core-shell-type MQWs grown on AlN nanorods have three crystallographic orientations, and the final shape of the grown structure is explained by a ball-and-stick model. The photoluminescence (PL) intensity of MQWs grown on AlN nanorods is approximately 40 times higher than that of MQWs simultaneously grown on a planar structure. This result can be explained by increased internal quantum efficiency, large active volume, and increase in light extraction efficiency based on the examination in this study. Among those effects, the increase of active volume on AlN nanorods is considered to be the main reason for the enhancement of the PL intensity.
| S-EPMC5772499 | biostudies-literature
Project description:GaN-based ultraviolet (UV) LEDs are widely used in numerous applications, including white light pump sources and high-density optical data storage. However, one notorious issue is low hole injection rate in p-type transport layer due to poorly activated holes and spontaneous polarization, giving rise to insufficient light emission efficiency. Therefore, improving hole injection rate is a key step towards high performance UV-LEDs. Here, we report a new method of suppressing spontaneous polarization in p-type region to augment light output of UV-LEDs. This was achieved by simply passivating graphene oxide (GO) on top of the fully fabricated LED. The dipole layer formed by the passivated GO enhanced hole injection rate by suppressing spontaneous polarization in p-type region. The homogeneity of electroluminescence intensity in active layers was improved due to band filling effect. As a consequence, the light output was enhanced by 60% in linear current region. Our simple approach of suppressing spontaneous polarization of p-GaN using GO passivation disrupts the current state of the art technology and will be useful for high-efficiency UV-LED technology.
| S-EPMC4293595 | biostudies-literature
Project description:Quantum Dots (QDs) are being investigated in a hybrid white light LED structure which inculcates phosphor in the package with a blue LED chip as the light source recently. In this work, Zn doped CdS QD with ZnS shell together with green light emission phosphor is used. Upon prolonged operation, degradation of the LEDs due to the degradation of QDs is observed, which can limit its practical applications. The degradation includes intensity reduction as well as blue shift of the emitted wavelength from the white light. Three stages of degradation are observed, namely an enhancement state where light intensity is found to increase, followed by a rapid degradation stage where light intensity decreases rapidly, and finally a slower degradation stage where the degradation rate of light intensity slows down and continues till the end of the test. Through various detail material analysis, with confirmation from the density functional theory (DFT) calculations, we find that the degradation of the LEDs is due to the time evolving degradation of CdS core structure, beginning from the oxidation of sulfur vacancy of CdS QDs by the nearby oxygen atoms as a result of imperfection of the ZnS protective coating around the QDs in the presence of blue light. This oxidation renders a transformation of CdS into CdO at the initial stage. The final stage is the formation of CdSO4 via some intermediate processes.
| S-EPMC8683471 | biostudies-literature
Project description:Ultraviolet emission characteristics of cubic (c-) GaN enabled through hexagonal-to-cubic phase transition are reported. Substrate patterning and material growth are shown to affect phase purity and emission characteristics of c-GaN as studied by electron backscatter diffraction, and photo- and cathodoluminescence, respectively. Raman study shows a tensile strain in the c-GaN. Time-resolved photoluminescence reveals c-GaN band edge emission decay time of 11 ps. The ultraviolet emissions from both phases of GaN are linearly polarized in the same direction, which is along the ?112?0? and ?110? directions of hexagonal GaN and c-GaN, respectively. Temperature-dependent (5.7 to 280 K) cathodoluminescence studies reveal an internal quantum efficiency of ~29% at room temperature along with intrinsic and extrinsic defect energy levels of ~124 and ~344 meV, respectively, of the phase-transition c-GaN. Using the IQE value and carrier decay lifetime, a radiative lifetime of 38 ps is extracted. Overall, photonic properties of phase-transition c-GaN and their dependence on substrate patterning and material growth are reported.
| S-EPMC6376204 | biostudies-literature