A secure RFID authentication protocol adopting error correction code.
Ontology highlight
ABSTRACT:
SUBMITTER: Chen CM
PROVIDER: S-EPMC4052535 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Numerous systems are being employed in daily life where two entities authenticate each other over a range of distance. The distance involved is relatively small, but still attacks were documented. The distance bounding (DB) protocol was introduced to cater to security requirements. The schemes, however, are still prone to several threats; mainly the Relay Attack (Terrorist and Mafia Fraud). In Mafia Fraud, an attempts are made to get accepted as the prover either by replaying of messages or by the help a malicious key. In Terrorist fraud, an attempt is made to extract the secret from the verifying entity, either by extracting the key from the message captured or by physically tempering the verifying/proving entity. Therefore the mitigation of these attacks needs to be done; as to not put computational overhead on the scheme. The paper presents a comprehensive and comparative performance analysis of twelve DB protocols based on defined metrics. It also proposes a protocol which incorporates the design elements needed for added security, is computationally easy to implement and resistant to most of the threats mentioned. Analysis of the protocol is carried out against the security requirements.
| S-EPMC8114813 | biostudies-literature
Project description:Passive radio-frequency identification (RFID) tag has been used in many applications. While the RFID market is expected to grow, concerns about security and privacy of the RFID tag should be overcome for the future use. To overcome these issues, privacy-preserving authentication protocols based on cryptographic algorithms have been designed. However, to the best of our knowledge, evaluation of the whole tag, which includes an antenna, an analog front end, and a digital processing block, that runs authentication protocols has not been studied. In this paper, we present an implementation and evaluation of a fully integrated passive UHF RFID tag that runs a privacy-preserving mutual authentication protocol based on a hash function. We design a single chip including the analog front end and the digital processing block. We select a lightweight hash function supporting 80-bit security strength and a standard hash function supporting 128-bit security strength. We show that when the lightweight hash function is used, the tag completes the protocol with a reader-tag distance of 10 cm. Similarly, when the standard hash function is used, the tag completes the protocol with the distance of 8.5 cm. We discuss the impact of the peak power consumption of the tag on the distance of the tag due to the hash function.
| S-EPMC4603319 | biostudies-other
Project description:[This corrects the article DOI: 10.1371/journal.pcbi.1005148.].
| S-EPMC5695272 | biostudies-literature
Project description:The constituent parts of a quantum computer are inherently vulnerable to errors. To this end, we have developed quantum error-correcting codes to protect quantum information from noise. However, discovering codes that are capable of a universal set of computational operations with the minimal cost in quantum resources remains an important and ongoing challenge. One proposal of significant recent interest is the gauge color code. Notably, this code may offer a reduced resource cost over other well-studied fault-tolerant architectures by using a new method, known as gauge fixing, for performing the non-Clifford operations that are essential for universal quantum computation. Here we examine the gauge color code when it is subject to noise. Specifically, we make use of single-shot error correction to develop a simple decoding algorithm for the gauge color code, and we numerically analyse its performance. Remarkably, we find threshold error rates comparable to those of other leading proposals. Our results thus provide the first steps of a comparative study between the gauge color code and other promising computational architectures.
| S-EPMC4974574 | biostudies-literature
Project description:The Internet of Things (IoT) has been integrated into legacy healthcare systems for the purpose of improving healthcare processes. As one of the key technologies of IoT, radio frequency identification (RFID) technology has been applied to offer services like patient monitoring, drug administration, and medical asset tracking. However, people have concerns about the security and privacy of RFID-based healthcare systems, which require a proper solution. To solve the problem, recently in 2019, Fan et al. proposed a lightweight RFID authentication scheme in the IEEE Network. They claimed that their scheme can resist various attacks in RFID systems with low implementation cost, and thus is suitable for RFID-based healthcare systems. In this article, our contributions mainly consist of two parts. First, we analyze the security of Fan et al.'s scheme and find out its security vulnerabilities. Second, we propose a novel lightweight authentication scheme to overcome these security weaknesses. The security analysis shows that our scheme can satisfy the necessary security requirements. Besides, the performance evaluation demonstrates that our scheme is of low cost. Thus, our scheme is well-suited for practical RFID-based healthcare systems.
| S-EPMC7506697 | biostudies-literature
Project description:An error-correction code (ECC) sequencing approach has recently been reported to effectively reduce sequencing errors by interrogating a DNA fragment with three orthogonal degenerate sequencing-by-synthesis (SBS) reactions. However, similar to other non-single-molecule SBS methods, the reaction will gradually lose its synchronization within a molecular colony in ECC sequencing. This phenomenon, called dephasing, causes sequencing error, and in ECC sequencing, induces distinctive dephasing patterns. To understand the characteristic dephasing patterns of the dual-base flowgram in ECC sequencing and to generate a correction algorithm, we built a virtual sequencer in silico. Starting from first principles and based on sequencing chemical reactions, we simulated ECC sequencing results, identified the key factors of dephasing in ECC sequencing chemistry and designed an effective dephasing algorithm. The results show that our dephasing algorithm is applicable to sequencing signals with at least 500 cycles, or 1000-bp average read length, with acceptably low error rate for further parity checks and ECC deduction. Our virtual sequencer with our dephasing algorithm can further be extended to a dichromatic form of ECC sequencing, allowing for a potentially much more accurate sequencing approach.
| S-EPMC8288425 | biostudies-literature
Project description:The development of a superconducting analog to the transistor with extremely low power dissipation will accelerate the proliferation of low-temperature circuitry operating in the milliKelvin regime. The thin-film, magnetically actuated cryotron switch is a candidate building block for more complicated and flexible milliKelvin circuitry. We demonstrate its utility for implementing reconfigurable circuitry by integrating a cryotron switch into flux-summed code-division SQUID multiplexed readout for large arrays of transition-edge-sensor (TES) microcalorimeters. Code-division multiplexing eliminates the noise penalty of time-division multiplexing while being drop-in compatible with the latter's control electronics. However, code-division multiplexing is susceptible to single-point failure mechanisms which can result in an unconstrained demodulation matrix and the loss of information from many sensing elements. In the event of a failure, the integrated cryotron switch provides a zero-signal output from a single TES, enabling the demodulation matrix used to compute TES signals from SQUID signals to be constrained and data recovered from the remaining sensors. This demonstration of configurable error correction provides both a realworld application of the cryotron switch and a foundation for more complex circuitry at milliKelvin temperatures.
| S-EPMC10938549 | biostudies-literature
Project description:Radio frequency identification (RFID) is a technology that has grown in popularity and in the applications of use. However, there are major issues regarding security and privacy with respect to RFID technology which have caught the interest of many researchers. There are significant challenges which must be overcome to resolve RFID security and privacy issues. One reason is the constraints attached to the provision of security and privacy in RFID systems. Along with meeting the security and privacy needs of RFID technology, solutions must be inexpensive, practical, reliable, scalable, flexible, inter-organizational, and long-lasting. To make RFID identifiers effective and efficient they must identify the item(s) while resisting attacks aimed at obtaining the tag's information and compromising the system or making it possible to bypass the protection RFID tags are supposed to provide. Different authentication methods have been proposed, researched, and evaluated in the literature. In this work, we proposed our methodology in evaluating RFID authentication, and a few of the most promising authentication methods are reviewed, compared, and ranked in order to arrive at a possible best choice of protocol to use.
| S-EPMC6164036 | biostudies-other
Project description:In information security, it is widely accepted that the more authentication factors are used, the higher the security level. However, more factors cannot guarantee usability in real usage because human and other non-technical factors are involved. This paper proposes the use of all possible authentication factors, called comprehensive-factor authentication, which can maintain the required security level and usability in real-world implementation. A case study of an implementation of a secure time attendance system that applies this approach is presented. The contribution of this paper is therefore to provide a security scheme seamlessly integrating all classical authentication factors plus a location factor into one single system in a real environment with a security and usability focus. Usability factors emerging from the study are related to a seamless process including the least number of actions required, the lowest amount of time taken, health safety during the pandemic, and data privacy compliance.
| S-EPMC8384039 | biostudies-literature
Project description:Intelligent Transport System (ITS) offers inter-vehicle communication, safe driving, road condition updates, and intelligent traffic management. This research intends to propose a novel decentralized "BlockAuth" architecture for vehicles, authentication, and authorization, traveling across the border. It is required because the existing architects rely on a single Trusted Authority (TA) for issuing certifications, which can jeopardize privacy and system integrity. Similarly, the centralized TA, if failed, can cause the whole system to collapse. Furthermore, a unique "Proof of Authenticity and Integrity" process is proposed, redirecting drivers/vehicles to their home country for authentication, ensuring the security of their credentials. Implemented with Hyperledger Fabric, BlockAuth ensures secure vehicle authentication and authorization with minimal computational overhead, under 2%. Furthermore, it opens up global access, enforces the principles of separation of duty and least privilege, and reinforces resilience via decentralization and automation.
| S-EPMC10513222 | biostudies-literature