The seeded growth of graphene.
Ontology highlight
ABSTRACT:
SUBMITTER: Lee JK
PROVIDER: S-EPMC4097362 | biostudies-other | 2014
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Understanding the underlying mechanisms involved in graphene growth via chemical vapour deposition (CVD) is critical for precise control of the characteristics of graphene. Despite much effort, the actual processes behind graphene synthesis still remain to be elucidated in a large number of aspects. Herein, we report the evolution of graphene properties during in-plane growth of graphene from reduced graphene oxide (RGO) on copper (Cu) via methane CVD. While graphene is laterally grown from RGO flakes on Cu foils up to a few hundred nanometres during CVD process, it shows appreciable improvement in structural quality. The monotonous enhancement of the structural quality of the graphene with increasing length of the graphene growth from RGO suggests that seeded CVD growth of graphene from RGO on Cu surface is accompanied by the restoration of graphitic structure. The finding provides insight into graphene growth and defect reconstruction useful for the production of tailored carbon nanostructures with required properties.
| S-EPMC4785362 | biostudies-literature
Project description:A solution-phase route has been considered as the most promising route to synthesize noble nanostructures. A majority of their synthesis approaches of calcium carbonate (CaCO3) are based on either using fungi or the CO2 bubbling methods. Here, we approached the preparation of nano-precipitated calcium carbonate single crystal from salmacis sphaeroides in the presence of zwitterionic or cationic biosurfactants without external source of CO2. The calcium carbonate crystals were rhombohedron structure and regularly shaped with side dimension ranging from 33-41 nm. The high degree of morphological control of CaCO3 nanocrystals suggested that surfactants are capable of strongly interacting with the CaCO3 surface and control the nucleation and growth direction of calcium carbonate nanocrystals. Finally, the mechanism of formation of nanocrystals in light of proposed routes was also discussed.
| S-EPMC4689419 | biostudies-literature
Project description:Remote epitaxy is a promising approach for synthesizing exfoliatable crystalline membranes and enabling epitaxy of materials with large lattice mismatch. However, the atomic scale mechanisms for remote epitaxy remain unclear. Here we experimentally demonstrate that GaSb films grow on graphene-terminated GaSb (001) via a seeded lateral epitaxy mechanism, in which pinhole defects in the graphene serve as selective nucleation sites, followed by lateral epitaxy and coalescence into a continuous film. Remote interactions are not necessary in order to explain the growth. Importantly, the small size of the pinholes permits exfoliation of continuous, free-standing GaSb membranes. Due to the chemical similarity between GaSb and other III-V materials, we anticipate this mechanism to apply more generally to other materials. By combining molecular beam epitaxy with in-situ electron diffraction and photoemission, plus ex-situ atomic force microscopy and Raman spectroscopy, we track the graphene defect generation and GaSb growth evolution a few monolayers at a time. Our results show that the controlled introduction of nanoscale openings in graphene provides an alternative route towards tuning the growth and properties of 3D epitaxial films and membranes on 2D material masks.
| S-EPMC9293962 | biostudies-literature
Project description:Seeded growth of silica rods from colloidal particles has emerged as a facile method to develop novel complex particle structures with hybrid compositions and asymmetrical shapes. However, this seeded-growth technique has been so far limited to colloidal particles of only a few materials. Here, we first develop a general synthesis for the seeded-growth of silica rods from silica particles. We then demonstrate the growth of silica rods from silica-coated particles with three different cores which highlight the generality of this synthesis: fluorescently labeled organo-silica (fluorescein), metallic (Ag), and organic (PS latex). We also demonstrate the assembly of these particles into supraparticles. This general synthesis method can be extended to the growth of silica rods from any colloidal particle which can be coated with silica.
| S-EPMC6868708 | biostudies-literature
Project description:Metal-ceramic composite particles are of increasing interest due to their potential applications in photonic metamaterials as well as next-generation catalysts. The zirconia-gold system has received little attention due to the lack of controllable preparation methods. Well-known methods for the deposition of gold nanoshells on silica spheres, however, should be adaptable for similar zirconia-based materials. Here, we present a novel synthetic approach to the well-controlled deposition of gold on the surface of sol-gel derived zirconia mesoparticles by a stepwise method involving the immobilization of gold nanoparticles and repeated seeded-growth steps. We show that the immobilization efficiency is strongly enhanced by acidification with hydrochloric acid and additional employment of aminomethylphosphonic acid as coupling agent. The optimum conditions are identified and the subsequent incremental growth by seeded reduction of gold is demonstrated. The results shed light on the parameters governing the preparation of zirconia@gold composite particles and our synthetic approach provides a promising tool for future developments in complex nanomaterials design.
| S-EPMC7353092 | biostudies-literature
Project description:In this study, multiphysics simulations were carried out to understand the convection mechanisms of the top seeded solution growth (TSSG) of SiC. Experimental melting tests and crystal growth were conducted to verify the simulation results in the growing temperatures between 1700 and 1900 °C with rf induction heating furnace. From the solidified melt of Si-Cr solution after the melting test, the melt flow in the simulation was successfully verified. In the given experimental conditions, the electromagnetic convection was found to govern the global fluid flow, while other mechanisms including the Marangoni convection, the buoyancy convection and the centrifugal forced convection influence the fluid flow near the crystal. Based on an understanding of the fluid flow obtained with the simulations, a structural flow modifier (FM) was applied to enhance the growth rate of the SiC crystal. The growth rates of SiC with/without FM were successfully estimated from simulations showing good agreements with the experimental values. After the experimental crystal growth using FM, a remarkable enhancement in the growth rate was found in an FM configuration, which suggests a way to improve the growth rate by the TSSG method based on the efficient use of the dissolved C in the melt.
| S-EPMC9070373 | biostudies-literature
Project description:We report the seeded synthesis of gold nanoparticles (GNPs) via the reduction of HAuCl4 by (L31 and F68) triblock copolymer (TBP) mixtures. In the present study, we focused on [TBP]/[Au(III)] ratios of 1-5 (?1 mM HAuCl4) and seed sizes ~20 nm. Under these conditions, the GNP growth rate is dominated by both the TBP and seed concentrations. With seeding, the final GNP size distributions are bimodal. Increasing the seed concentration (up to ~0.1 nM) decreases the mean particle sizes 10-fold, from ~1000 to 100 nm. The particles in the bimodal distribution are formed by the competitive direct growth in solution and the aggregative growth on the seeds. By monitoring kinetics of GNP growth, we propose that (1) the surface of the GNP seeds embedded in the TBP cavities form catalytic centers for GNP growth and (2) large GNPs are formed by the aggregation of GNP seeds in an autocatalytic growth process.
| S-EPMC4440571 | biostudies-literature
Project description:It was recently shown that, by controlling the O(2) concentration, the seeded-growth of CdSe nanocrystals (NC) can be manipulated to proceed either unidirectionally (from the (0001) facet) or three-dimensionally. In this contribution, we investigate two new Se precursors (i.e. SeO(2) and NaHSe) and compare them with Se obtained from etching of smaller NC seeds. Under anaerobic conditions, both precursors led to successful 3-dimensional (3D) NC growth. At high O(2) concentrations, the seeded growth of rods was enhanced by the NaHSe precursor, while impeded by the use of SeO(2). Mechanistic studies showed that the reduction of SeO(2) to Se(2-) produces an excessive amount of O(2). This leads to rod fragmentation due to etching as well as the production of deep traps that quench their luminescence. These new precursors, along with a heightened understanding of oxygen's role, expand the synthetic repertoire of the redox-assisted, seeded-growth of CdSe and better position this low temperature (125 °C) methodology towards realizing advanced NC heterostructures.
| S-EPMC3516845 | biostudies-literature
Project description:Nanoshells made of a silica core and a gold shell possess an optical response that is sensitive to nanometer-scale variations in shell thickness. The exponential red shift of the plasmon resonance with decreasing shell thickness makes ultrathin nanoshells (less than 10 nm) particularly interesting for broad and tuneable ranges of optical properties. Nanoshells are generally synthesised by coating gold onto seed-covered silica particles, producing continuous shells with a lower limit of 15 nm, due to an inhomogeneous droplet formation on the silica surface during the seed regrowth. In this paper, we investigate the effects of three variations of the synthesis protocol to favour ultrathin nanoshells: seed density, polymer additives and microwave treatment. We first maximised gold seed density around the silica core, but surprisingly its effect is limited. However, we found that the addition of polyvinylpyrrolidone during the shell synthesis leads to higher homogeneity and a thinner shell and that a post-synthetic thermal treatment using microwaves can further smooth the particle surface. This study brings new insights into the synthesis of metallic nanoshells, pushing the limits of ultrathin shell synthesis.
| S-EPMC8426366 | biostudies-literature
Project description:Gold nanoparticles are exciting materials in nanotechnology and nanoscience research and are being applied across a wide range of fields including imaging, chemical sensing, energy storage, and cancer therapies. In this experiment, students will synthesize two sizes of gold nanospheres (~20 nm and ~100 nm) and will create gold nanostars utilizing a seed-mediated growth synthetic approach. Students will compare how each sample interacts differently with light (absorption and scattering) based on the nanoparticles' size and shape. This experiment is ideal for high-school and early undergraduate students since all reagents are non-toxic, affordable, and no special characterization equipment is required.
| S-EPMC8133700 | biostudies-literature