Optimization of the Switch Mechanism in a Circuit Breaker Using MBD Based Simulation.
Ontology highlight
ABSTRACT:
SUBMITTER: Jang JS
PROVIDER: S-EPMC4396148 | biostudies-other | 2015
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Every quantum algorithm is represented by set of quantum circuits. Any optimization scheme for a quantum algorithm and quantum computation is very important especially in the arena of quantum computation with limited number of qubit resources. Major obstacle to this goal is the large number of elemental quantum gates to build even small quantum circuits. Here, we propose and demonstrate a general technique that significantly reduces the number of elemental gates to build quantum circuits. This is impactful for the design of quantum circuits, and we show below this could reduce the number of gates by 60% and 46% for the four- and five-qubit Toffoli gates, two key quantum circuits, respectively, as compared with simplest known decomposition. Reduced circuit complexity often goes hand-in-hand with higher efficiency and bandwidth. The quantum circuit optimization technique proposed in this work would provide a significant step forward in the optimization of quantum circuits and quantum algorithms, and has the potential for wider application in quantum computation.
| S-EPMC7518448 | biostudies-literature
Project description:An optimization-simulation strategy has been applied by coupling a commercial process simulator (Aspen HYSYS®) with a programming tool (MATLAB®) to produce a precise steady state simulation-based optimization of a whole green-field saturated gas plant as a real case study. The plant has more than 100-components and comprises interacting three-phase fractionation towers, pumps, compressors and exchangers. The literature predominantly uses this coupling to optimize individual units at small scales, while paying more attention to optimizing discrete design decisions. However, bridging the gap to scalable continuous design variables is indispensable for industry. The strategy adopted is a merge between sensitivity analysis and constrained bounding of the variables along with stochastic optimization algorithms from MATLAB® such as genetic algorithm (GA) and particle swarm optimization (PSO) techniques. The benefits and shortcomings of each optimization technique have been investigated in terms of defined inputs, performance, and finally the elapsed time for such highly complex case study. Although, both GA and PSO were satisfactory for the optimization, the GA provided greater confidence in optimization with wider ranges of constrained bounds. The implemented strategy precisely reached the best operating conditions, within the range covered, by minimizing the total annual cost while maintaining at least 92% butane recovery as a process guarantee for the whole plant. The optimization-simulation strategy applied in the current work is recommended to be used in brownfields to optimize the operating conditions since they are susceptible to continuous changes in feedstock conditions.
| S-EPMC6961219 | biostudies-literature
Project description:An improved approach for comparative study of plant cells for long term and continuous monitoring using electrical impedance spectroscopy is demonstrated for tomato and tobacco plant cells (MSK8 and BY2) in suspensions. This approach is based on the locations and magnitudes of defining features in the impedance spectra of the recently reported unified equivalent circuit model. The ultra-wide range (4 Hz to 20 GHz) impedance spectra of the cell lines were measured using custom probes, and were analyzed using the unified equivalent circuit model, highlighting significant negative phase peaks in the ~ 1 kHz to ~ 10 MHz range. These peaks differ between the tomato and tobacco cells, and since they can be easily defined, they can potentially be used as the signal for differentiating between different cell cultures or monitoring them over time. These findings were further analysed, showing that ratios relating the resistances of the media and the resistance of the cells define the sensitivity of the method, thus affecting its selectivity. It was further shown that cell agglomeration is also an important factor in the impedance modeling in addition to the overall cell concentration. These results can be used for optimizing and calibrating electrical impedance spectroscopy-based sensors for long term monitoring of cell lines in suspension for a given specific cell and media types.
| S-EPMC8481493 | biostudies-literature
Project description:Cell therapies based on pluripotent stem cells (PSC), have opened new therapeutic strategies for neurodegenerative diseases. However, insufficiently differentiated PSC can lead to tumor formation. Ideally, safety switch therapies should selectively kill proliferative transplant cells while preserving post-mitotic neurons. In this study, we evaluated the potential of nucleoside analogs and thymidine kinase-based suicide genes. Among tested thymidine kinase variants, the humanized SR39 (SR39h) variant rendered cells most sensitive to suicide induction. Unexpectedly, post-mitotic neurons with ubiquitous SR39h expression were killed by ganciclovir, but were spared when SR39h was expressed under the control of the cell cycle-dependent Ki67 promoter. The efficacy of six different nucleoside analogs to induce cell death was then evaluated. Penciclovir (PCV) showed the most interesting properties with an efficiency comparable to ganciclovir (GCV), but low toxicity. We tested three nucleoside analogs in vivo: at concentrations of 40 mg/kg/day, PCV and GCV prevented tumor formation, while acyclovir (ACV) did not. In summary, SR39h under the control of a cell cycle-dependent promoter appears most efficient and selective as safety switch for neural transplants. In this setting, PCV and GCV are efficient inducers of cell death. Because of its low toxicity, PCV might become a preferred alternative to GCV.
| S-EPMC8834506 | biostudies-literature
Project description:For an energy-intensive sweetening process, it is common that sour gases from different sources are sent to a single sweetening plant in industries. In our previous work, a multiple gas feed sweetening process was proposed, which can simultaneously improve the purity of H2S and reduce the energy consumption of the plant. This study aims to develop the superstructure of that process and use a simulation-based optimization framework with Aspen HYSYS as the process simulator and particle swarm optimization algorithm as the optimizer. In addition, by taking full advantage of the robustness of the built-in algorithm of the simulator, the convergence of the model is improved; meanwhile, simplification of the process and reduction of the optimization time are accessible with the proposed design specifications and assumptions. For a convergence-difficult column, a stepwise convergence adjustment was used to ensure their convergence. Based on this, the robustness and effectiveness of the method is proven through a case study, and it can also provide guidance for model selection, process simplification, and optimization of the same type of absorption process.
| S-EPMC8793078 | biostudies-literature
Project description:In evolutionary biomechanics it is often considered that gaits should evolve to minimize the energetic cost of travelling a given distance. In gait simulation this goal often leads to convincing gait generation. However, as the musculoskeletal models used get increasingly sophisticated, it becomes apparent that such a single goal can lead to extremely unrealistic gait patterns. In this paper, we explore the effects of requiring adequate lateral stability and show how this increases both energetic cost and the realism of the generated walking gait in a high biofidelity chimpanzee musculoskeletal model. We also explore the effects of changing the footfall sequences in the simulation so it mimics both the diagonal sequence walking gaits that primates typically use and also the lateral sequence walking gaits that are much more widespread among mammals. It is apparent that adding a lateral stability criterion has an important effect on the footfall phase relationship, suggesting that lateral stability may be one of the key drivers behind the observed footfall sequences in quadrupedal gaits. The observation that single optimization goals are no longer adequate for generating gait in current models has important implications for the use of biomimetic virtual robots to predict the locomotor patterns in fossil animals.
| S-EPMC5882714 | biostudies-literature
Project description:The improvement and development of blood-contacting devices, such as mechanical circulatory support systems, is a life saving endeavor. These devices must be designed in such a way that they ensure the highest hemocompatibility. Therefore, in-silico trials (flow simulations) offer a quick and cost-effective way to analyze and optimize the hemocompatibility and performance of medical devices. In that regard, the prediction of blood trauma, such as hemolysis, is the key element to ensure the hemocompatibility of a device. But, despite decades of research related to numerical hemolysis models, their accuracy and reliability leaves much to be desired. This study proposes a novel optimization path, which is capable of improving existing models and aid in the development of future hemolysis models. First, flow simulations of three, turbulent blood flow test cases (capillary tube, FDA nozzle, FDA pump) were performed and hemolysis was numerically predicted by the widely-applied stress-based hemolysis models. Afterward, a multiple-objective particles swarm optimization (MOPSO) was performed to tie the physiological stresses of the simulated flow field to the measured hemolysis using an equivalent of over one million numerically determined hemolysis predictions. The results show that our optimization is capable of improving upon existing hemolysis models. However, it also unveils some deficiencies and limits of hemolysis prediction with stress-based models, which will need to be addressed in order to improve its reliability.
| S-EPMC10097800 | biostudies-literature
Project description:This paper presents a model and experimental study of a chaotic spike oscillator based on a leaky integrate-and-fire (LIF) neuron, which has a switching element with an S-type current-voltage characteristic (S-switch). The oscillator generates spikes of the S-switch in the form of chaotic pulse position modulation driven by the feedback with rate coding instability of LIF neuron. The oscillator model with piecewise function of the S-switch has resistive feedback using a second order filter. The oscillator circuit is built on four operational amplifiers and two field-effect transistors (MOSFETs) that form an S-switch based on a Schmitt trigger, an active RC filter and a matching amplifier. We investigate the bifurcation diagrams of the model and the circuit and calculate the entropy of oscillations. For the analog circuit, the "regular oscillation-chaos" transition is analysed in a series of tests initiated by a step voltage in the matching amplifier. Entropy values are used to estimate the average time for the transition of oscillations to chaos and the degree of signal correlation of the transition mode of different tests. Study results can be applied in various reservoir computing applications, for example, in choosing and configuring the LogNNet network reservoir circuits.
| S-EPMC9689857 | biostudies-literature
Project description:Two-dimensional (2D) material based FETs are being considered for future technology nodes and high performance logic applications. However, a comprehensive assessment of 2D material based FETs has been lacking for high performance logic applications considering appropriate system level figure-of-merits (FOMs) e.g. delay, and energy-delay product. In this paper, we present guidelines for 2D material based FETs to meet sub-10 nm high performance logic requirements focusing on material requirement, device design, energy-delay optimization for the first time. We show the need for 2D materials with smaller effective mass in the transport direction and anisotropicity to meet the performance requirement for future technology nodes. We present novel device designs with one such 2D material (monolayer black-phosphorus) to keep Moore's alive for the HP logic in sub-5 nm gate length regime. With these device proposals we show that below 5 nm gate lengths 2D electrostatistics arising from gate stack design becomes more of a challenge than direct source-to-drain tunneling for 2D material-based FETs. Therefore, it is challenging to meet both delay and energy-delay requirement in sub-5 nm gate length regime without scaling both supply voltage (V DD ) and effective-oxide-thickness (EOT) below 0.5 V and 0.5 nm respectively.
| S-EPMC5504057 | biostudies-other
Project description:'Background: Large-scale sequencing of cDNA (RNA-seq) has been a boon to the quantitative analysis of transcriptomes. A notable application of significant biomedical relevance is the detection of changes in transcript usage between experimental conditions. For example, discovery of pathological alternative splicing may allow the development of new treatments or better management of patients. From an analysis perspective, there are several ways to represent RNA-seq data to unravel differential transcript usage, such as annotation-based exon-level counting, differential analysis of the `percent spliced in'' measure or quantitative analysis of assembled transcripts. The goal of this research is to compare and contrast current state-of-the-art methods, as well as to suggest improvements to commonly used workflows. Results: We assess the performance of representative workflows using synthetic data, and explore the effect of using non-standard counting bin definitions as input to a state-of-the-art inference engine (DEXSeq). Although the canonical counting provided the best results overall, several non-canonical approaches were as good or better in specific aspects, and most counting approaches outperformed the evaluated event- and assembly-based methods. We show that an incomplete annotation catalog can have a detrimental effect on the ability to detect differential transcript usage in transcriptomes with few isoforms per gene, and that isoform-level pre-filtering can considerably improve the false discovery rate (FDR) control. Conclusion: Count-based methods generally perform well in detection of differential transcript usage. Controlling the FDR at the imposed threshold is difficult, mainly in complex organisms, but can be improved by pre-filtering of the annotation catalog.'
2015-07-23 | E-MTAB-3766 | biostudies-arrayexpress