The effect of surface wettability on water vapor condensation in nanoscale.
Ontology highlight
ABSTRACT:
SUBMITTER: Niu D
PROVIDER: S-EPMC4709718 | biostudies-other | 2016
REPOSITORIES: biostudies-other
Similar Datasets
Project description:Emulsions are widely used in many industrial applications, and the development of efficient techniques for synthesizing them is a subject of ongoing research. Vapor condensation is a promising method for energy-efficient, high-throughput production of monodisperse nanoscale emulsions. However, previous studies using this technique are limited to producing small volumes of water-in-oil dispersions. In this work, a new method for the continuous synthesis of nanoscale emulsions (water-in-oil and oil-in-water) is presented by condensing vapor on free-flowing surfactant solutions. The viability of oil vaporization and condensation is demonstrated under mild heating/cooling using diverse esters, terpenes, aromatic hydrocarbons, and alkanes. By systematically investigating water vapor and oil vapor condensation dynamics on bulk liquid-surfactant solutions, a rich diversity of outcomes, including floating films, nanoscale drops, and hexagonally packed microdrops is uncovered. It is demonstrated that surfactant concentration impacts oil spreading, self-emulsification, and such behavior can aid in the emulsification of condensed oil drops. This work represents a critical step toward advancing the vapor condensation method's applications for emulsions and colloidal systems, with broad implications for various fields and the development of new emulsion-based products and industrial processes.
| S-EPMC11022740 | biostudies-literature
Project description:Atmospheric water is emerging as an important potable water source. The present work experimentally and theoretically investigates water condensation and collection on flat surfaces with contrasting contact angles and contact angle hysteresis (CAH) to elucidate their roles on water mass collection efficiency. The experimental results indicate that a hydrophilic surface promotes nucleation and individual droplets growth, and a surface with a low CAH tends to let a smaller droplet to slide down, but the overall water mass collection efficiency is independent of both surface contact angle and CAH. The experimental results agree well with our theoretical calculations. During water condensation, a balance has to be struck between single droplet growth and droplet density on a surface so as to maintain a constant water droplet surface coverage ratio, which renders the role of both surface wettability and hysteresis insignificant to the ultimate water mass collection. Moreover, water droplets on the edges of a surface grow much faster than those on the non-edge areas and thus dominate the contribution to the water mass collection by the entire surface, directly pointing out the very important role of edge effect on water condensation and collection.
| S-EPMC6607251 | biostudies-literature
Project description:Understanding and controlling the flow of water confined in nanopores has tremendous implications in theoretical studies and industrial applications. Here, we propose a simple model for the confined water flow based on the concept of effective slip, which is a linear sum of true slip, depending on a contact angle, and apparent slip, caused by a spatial variation of the confined water viscosity as a function of wettability as well as the nanopore dimension. Results from this model show that the flow capacity of confined water is 10-1∼107 times that calculated by the no-slip Hagen-Poiseuille equation for nanopores with various contact angles and dimensions, in agreement with the majority of 53 different study cases from the literature. This work further sheds light on a controversy over an increase or decrease in flow capacity from molecular dynamics simulations and experiments.
| S-EPMC5380095 | biostudies-literature
Project description:Desert beetles and cactus plants collect water from fog in arid regions. The desert beetle uses heterogeneous wettability to transport water to its mouth. A cactus uses conical spines which provide Laplace pressure gradient to transport water to its base. In this study, bioinspired triangular patterns with various wettability and different from the surrounding regions were investigated to transport condensed water from ambient air. A low temperature of 5°C was used to decrease saturated vapour pressure to promote water condensation. Results from this study can be used to enhance the performance of water collection systems. This article is part of the theme issue 'Bioinspired materials and surfaces for green science and technology'.
| S-EPMC6335283 | biostudies-literature
Project description:Using atomic force microscopy in the pressure range of 10-10 mbar to several tens of mbar at room temperature, we demonstrate the restructuring of nanostructured KBr surfaces assisted by the presence of water, methanol, and ethanol vapors and the formation of solvation islands. On a flat KBr surface, the two-dimensional solvation islands start nucleating at the step edges and grow with time and with increasing relative pressure. Solvation islands of water wet the terraces; however, solvation islands of methanol and ethanol are localized around the step edges and do not wet the terraces. Two processes are observed on nanostructured KBr surfaces: the movement of the atomic steps and the formation of solvation islands. The first process takes place at comparatively lower pressures at around 1% relative pressure, whereas the second process starts at higher pressures at around 25% relative pressure and above. Furthermore, the second process takes place only after the complete relocation of the step edges and thereby formation of a nearly flat surface. This implies that there is a competition between the restructuring of the atomic steps and solvation layer formation, as both processes require solvated ions. Unlike in the case of a flat surface, solvation islands of alcohols wet the restructured surface due to a higher density of low-coordination sites.
| S-EPMC9377354 | biostudies-literature
Project description:Condensing atmospheric water vapor on surfaces is a sustainable approach to addressing the potable water crisis. However, despite extensive research, a key question remains: what is the optimal combination of the mode and mechanism of condensation as well as the surface wettability for the best possible water harvesting efficacy? Here, we show how various modes of condensation fare differently in a humid air environment. During condensation from humid air, it is important to note that the thermal resistance across the condensate is nondominant, and the energy transfer is controlled by vapor diffusion across the boundary layer and condensate drainage from the condenser surface. This implies that, unlike condensation from pure steam, filmwise condensation from humid air would exhibit the highest water collection efficiency on superhydrophilic surfaces. To demonstrate this, we measured the condensation rates on different sets of superhydrophilic and superhydrophobic surfaces that were cooled below the dew points using a Peltier cooler. Experiments were performed over a wide range of degrees of subcooling (10-26 °C) and humidity-ratio differences (5-45 g/kg of dry air). Depending upon the thermodynamic parameters, the condensation rate is found to be 57-333% higher on the superhydrophilic surfaces compared to the superhydrophobic ones. The findings of the study dispel ambiguity about the preferred mode of vapor condensation from humid air on wettability-engineered surfaces and lead to the design of efficient atmospheric water harvesting systems.
| S-EPMC10116598 | biostudies-literature
Project description:Condensation of humid air is an important process in thermal and process engineering and a subject of many currently research-intensive scientific domains, such as atmospheric water harvesting and seawater desalination. The nature of (water) vapor condensation in the presence of non-condensable gas (NCG) such as air differs significantly from the case with the pure, quiescent vapor condensation. In the literature, simple models that describe the forced flow condensation of water vapor in the presence of air on a series of vertical flat plates are hard to find. Here we present a simple and computationally efficient semi-empirical correlation describing forced flow condensation from humid air inside vertical channels formed by flat plates. The correlation accounts air as a non-condensing gas, different heights of vertical plates, and different thermal-hydraulic parameters. The correlation has been experimentally validated and shows excellent agreement, as 90% of theoretically predicted values are within ±12% of experimental data.
| S-EPMC8724959 | biostudies-literature
Project description:With its high stability and well-tuned binding strength for adsorbates, platinum is an excellent catalyst for a wide range of reactions. In applications like car exhaust purification, the oxidation of hydrocarbons, and fuel cells, platinum is exposed to highly oxidizing conditions, which often leads to the formation of surface oxides. To reveal the structure of these surface oxides, the oxidation of Pt in O2 has been widely studied. However, in most applications, H2O is also an important or even dominant part of the reaction mixture. Here, we investigate the interaction of H2O with Pt surface oxides using near-ambient-pressure X-ray photoelectron spectroscopy. We find that reversible hydroxylation readily occurs in H2O/O2 mixtures. Using time-resolved measurements, we show that O-OH exchange occurs on a time scale of seconds.
| S-EPMC8802315 | biostudies-literature
Project description:A radiative vapor condenser sheds heat in the form of infrared radiation and cools itself to below the ambient air temperature to produce liquid water from vapor. This effect has been known for centuries, and is exploited by some insects to survive in dry deserts. Humans have also been using radiative condensation for dew collection. However, all existing radiative vapor condensers must operate during the nighttime. Here, we develop daytime radiative condensers that continue to operate 24 h a day. These daytime radiative condensers can produce water from vapor under direct sunlight, without active consumption of energy. Combined with traditional passive cooling via convection and conduction, radiative cooling can substantially increase the performance of passive vapor condensation, which can be used for passive water extraction and purification technologies.
| S-EPMC8040807 | biostudies-literature
Project description:Nanoscale emulsions are essential components in numerous products, ranging from processed foods to novel drug delivery systems. Existing emulsification methods rely either on the breakup of larger droplets or solvent exchange/inversion. Here we report a simple, scalable method of creating nanoscale water-in-oil emulsions by condensing water vapor onto a subcooled oil-surfactant solution. Our technique enables a bottom-up approach to forming small-scale emulsions. Nanoscale water droplets nucleate at the oil/air interface and spontaneously disperse within the oil, due to the spreading dynamics of oil on water. Oil-soluble surfactants stabilize the resulting emulsions. We find that the oil-surfactant concentration controls the spreading behavior of oil on water, as well as the peak size, polydispersity, and stability of the resulting emulsions. Using condensation, we form emulsions with peak radii around 100 nm and polydispersities around 10%. This emulsion formation technique may open different routes to creating emulsions, colloidal systems, and emulsion-based materials.
| S-EPMC5678165 | biostudies-literature